Labshake search
Citations for Molecular Devices :
301 - 350 of 10000+ citations since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Neuroscience 2024Quote: ... and stored using Digidata 1322A and pCLAMP 10,4 software (Molecular Devices, CA, USA).
-
bioRxiv - Neuroscience 2024Quote: SNr neuron identity was confirmed by characteristic electrophysiology (. Up to three cells were recorded simultaneously. Recordings were performed with MultiClamp 700B amplifiers (Molecular Devices, U.S.A.), filtered at either 4 kHz (voltage clamp ...
-
bioRxiv - Neuroscience 2024Quote: ... Image acquisition was driven by Metamorph software (Molecular devices, USA) and one image stack contained 40,000 frames ...
-
bioRxiv - Neuroscience 2024Quote: ... successful sweeps were averaged and the peak amplitude of consecutive EPSCs was measured using Clampfit 10 software (Molecular Devices). The amplitudes of consecutive EPSCs in a train were normalized to the amplitude of first EPSC ...
-
bioRxiv - Neuroscience 2024Quote: ... To calculate the EPSCx/EPSC1 ratio successful sweeps were averaged and the peak amplitude of consecutive EPSCs was measured using Clampfit 10 software (Molecular Devices). To quantify HF-STP profiles ...
-
bioRxiv - Neuroscience 2024Quote: ... Signal was amplified and low-pass filtered on a Multiclamp 700b amplifier (Molecular devices; 6kHz), and digitized on a Digidata 1550B digitizer at 100kHz (Molecular devices ...
-
Effects of ketamine and propofol on muscarinic plateau potentials in rat neocortical pyramidal cellsbioRxiv - Neuroscience 2024Quote: ... Recordings were made using either a Dagan BVC-700A patch-clamp amplifier (Dagan Corporation, Minneapolis, MN, USA) or a Multiclamp 700A (Molecular Devices, San Jose, CA, USA), low-pass filtered at 10 kHz ...
-
Effects of ketamine and propofol on muscarinic plateau potentials in rat neocortical pyramidal cellsbioRxiv - Neuroscience 2024Quote: ... The analysis was carried out using Clampfit software (Molecular Devices), and results were plotted and statistical analysis performed in Origin 2020 (OriginLab Corp ...
-
Effects of ketamine and propofol on muscarinic plateau potentials in rat neocortical pyramidal cellsbioRxiv - Neuroscience 2024Quote: Data were acquired using pCLAMP 10 software and digitised with either a Digidata 1322A or Digidata 1440 (Molecular Devices). The analysis was carried out using Clampfit software (Molecular Devices) ...
-
bioRxiv - Neuroscience 2024Quote: Data were acquired using a MultiClamp 700B amplifier and digitized using a Digidata 1550B acquisition system (Molecular Devices). Signals were further filtered at 2 kHz and digitized at 10 kHz ...
-
bioRxiv - Immunology 2024Quote: ... Absorbance was read at 405 nm (Molecular Devices, SpectraMax iD5). Wells that contained no primary antibody were used as a background measurement ...
-
bioRxiv - Neuroscience 2024Quote: ... and sampled at 20 or 50 kHz using Digidata 1440A or 1550B digitizers controlled through pCLAMP 10 or 11 (Molecular Devices). For photostimulation of miniSOG during whole-cell recordings18 ...
-
bioRxiv - Immunology 2024Quote: ... and the signal was read at OD 450 nm by an automatic microplate reader SpectraMax (Molecular Devices).
-
bioRxiv - Molecular Biology 2024Quote: ... Formazan concentration was quantified on a multi-mode microplate reader (Molecular Devices, SpectraMax M3) using a 575 nm wavelength for formazan spectrophotometric absorbance and 650 nm for reference ...
-
bioRxiv - Molecular Biology 2024Quote: ... The microscope was controlled with Metamorph 7.8 (Molecular Devices, LLC.) acquisition software.
-
bioRxiv - Molecular Biology 2024Quote: ... version 7.8.13.0 (Molecular Devices). 16 Z-stack images ...
-
bioRxiv - Pharmacology and Toxicology 2024Quote: ... was added at 250 µM to increase worm movement at least 1 hour prior to imaging on an ImageXpress Nano (Molecular Devices). Time lapse recordings were acquired for each well (15 second videos at a rate of 4 frames / second ...
-
bioRxiv - Neuroscience 2024Quote: ... and data analysis was performed using Clampfit software (v11.2, Molecular Devices), as described further below.
-
bioRxiv - Neuroscience 2024Quote: ... digitized at 5 kHz and recorded using the pCLAMP 9 program (Molecular Devices, USA). The inhibitory effect of the studied compounds was analyzed at steady-state conditions using the Clampfit 10.7 program (Molecular Devices ...
-
bioRxiv - Neuroscience 2024Quote: ... The inhibitory effect of the studied compounds was analyzed at steady-state conditions using the Clampfit 10.7 program (Molecular Devices, USA).
-
bioRxiv - Neuroscience 2024Quote: Whole-cell patch-clamp recordings were performed using an Axopatch 200B amplifier (Molecular Devices, USA) at a holding membrane potential of -60 mV and +40 mV in the human embryonic kidney 293 (HEK293 ...
-
bioRxiv - Neuroscience 2024Quote: ... Cells were patch-clamped at 22–23 °C and at 37 °C after 24h from transfection using a Multiclamp 700B amplifier (Molecular Devices, US) and either voltage stepped for 1s starting from a holding potential of −70 mV to voltages between −200 and +120 mV and back or voltage-clamped using in vivo somatic measured mouse hippocampal CA1-area pyramidal neuron action-potential burst waveforms ...
-
bioRxiv - Neuroscience 2024Quote: ... Both the patch-clamp amplifier and the stimulus isolator were controlled by a digitizer (Digidata 1550B, Molecular Devices, CA, US). Pipettes containing plasmid and saline solution mix were mounted on a micromanipulator (PatchStar ...
-
bioRxiv - Neuroscience 2024Quote: ... Layer V pyramidal neurons in the PrL or IL were visually identified and whole-cell patch-clamp recordings were performed using an amplifier (Axopatch 200 B, Molecular Devices, San Jose, CA, USA) at room temperature ...
-
bioRxiv - Neuroscience 2024Quote: ... PClamp (Molecular Devices) was used for data acquisition as well as controlling light stimulation and current and voltage-clamp protocols ...
-
bioRxiv - Neuroscience 2024Quote: ... Series resistance was fully compensated using the bridge circuit of the amplifier MultiClamp 700B (Molecular Devices, RRID: SCR_018455). Action potential threshold was estimated as the point when the slope of rising membrane potential exceeds 50 mV ms−1.
-
bioRxiv - Neuroscience 2024Quote: ... We then used the AP analysis tool in Clampfit (pClamp software v11.2, Molecular Devices) to determine the characteristics of the APs ...
-
bioRxiv - Neuroscience 2024Quote: ... amplified by a MultiClamp 700B amplifier (Molecular Devices), and low pass-filtered using a single-pole RC filter at 10 kHz ...
-
bioRxiv - Neuroscience 2024Quote: ... Data acquisition used pClamp software (v11.2, Molecular Devices) and data analysis was performed using Clampfit software (v11.2 ...
-
bioRxiv - Neuroscience 2024Quote: ... All data were digitized (Digidata 1440A, Molecular Devices), amplified by a MultiClamp 700B amplifier (Molecular Devices) ...
-
bioRxiv - Neuroscience 2024Quote: ... were plotted against the amplitude of current injection and the slope of the linear fit between −5 pA to −30 pA was used to define Rin (Clampfit v. 11.2; Molecular Devices). Time constant (tau ...
-
bioRxiv - Neuroscience 2024Quote: ... directed by MetaMorph software (Molecular Devices).
-
bioRxiv - Neuroscience 2024Quote: ... Recordings were acquired with PatchMaster v2x90.1 (HEKA Elektronik) and Clampex 10.7 (Molecular Devices). The liquid junction potential was calculated to be ∼4.3 mV and this estimate was not corrected ...
-
bioRxiv - Neuroscience 2024Quote: ... Whole-cell patch-clamp recordings were performed at room temperature (∼ 21°C) 18-30 hours after dissociation using an EPC10 USB (HEKA Elektronik) amplifier and a Multiclamp 700B (Molecular Devices). Neurons were observed at 20x magnification on an IX-71 (Olympus ...
-
bioRxiv - Neuroscience 2024Quote: ... Current- and voltage-clamp recordings were obtained with Multiclamp 700A and Digidata 1440A (Molecular Devices) or NI USB-6341 (National Instruments) ...
-
bioRxiv - Neuroscience 2024Quote: ... digitized at 10kHz using DigiData 1440A or DigiData 1550B and recorded using pClamp10 software (Molecular Devices, Sunnyvale, CA). Active and passive properties were recorded in current clamp from a holding potential of -70mV using K-Gluconate based internal solution ...
-
bioRxiv - Neuroscience 2024Quote: ... The stimulus timing trigger and recording were done using Multiclamp 700B amplifier (Molecular devices, USA). Each Ulla recording was either acquired at 1 kHz as 80 pixel x 80 pixel or at 5 kHz as 26 pixel x 26 pixel fluorescence intensity time-lapse images using an upright epifluorescence microscope (Slicescope ...
-
bioRxiv - Neuroscience 2024Quote: ... Intrinsic properties were analyzed using pClamp software 10.7 (Molecular Devices, Sunnyvale, CA) and synaptic currents were detected using template search feature in Easy Electrophysiology (version 2.6).
-
bioRxiv - Neuroscience 2024Quote: ... sampled at 5 kHz using Digidata 1550 (Molecular Devices), and recorded using pCLAMP 10.7 software (Axon Instruments) ...
-
bioRxiv - Neuroscience 2024Quote: Data were acquired with a Multiclamp 700B (Molecular Devices), filtered at 3 kHz and digitized at 10 kHz with Digidata 1440A and Clampex 10.2 software (Molecular Devices) ...
-
A combinatory genetic strategy for targeting neurogliaform neurons in the mouse basolateral amygdalabioRxiv - Neuroscience 2024Quote: ... Signals were low-pass filtered at 4 kHz (four-pole Bessel) and sampled at 10 kHz using a digitizer (Digidata 1440A; Molecular Devices).
-
A combinatory genetic strategy for targeting neurogliaform neurons in the mouse basolateral amygdalabioRxiv - Neuroscience 2024Quote: The electrophysiological data were recorded with pCLAMP 10.6 software (Molecular Devices). The electrophysiological recordings were analyzed by custom-written Matlab scripts (MathWorks) ...
-
A combinatory genetic strategy for targeting neurogliaform neurons in the mouse basolateral amygdalabioRxiv - Neuroscience 2024Quote: ... Whole-cell patch-clamp recordings were made with a Multiclamp 700B amplifier (Molecular Devices). Recording electrodes (3–6 MΩ ...
-
bioRxiv - Neuroscience 2024Quote: ... Membrane capacitance and series resistance were compensated by 70% und data filtered by low-pass Bessel filter at 3 kHz and sampled at 10 kHz using an Axon Digidata 1322A digitizer (Molecular Devices).
-
bioRxiv - Neuroscience 2024Quote: ... and digitized with a Digidata 1440A (Molecular Devices). Data was acquired at a sampling rate of 10 kHz ...
-
bioRxiv - Neuroscience 2024Quote: ... was induced with 0.5 s and 30 s pulses of green LED light triggered by pCLAMP 10 software (Molecular Devices). Data were excluded from the analysis if there was an absence of spiking prior to light onset ...
-
bioRxiv - Neuroscience 2024Quote: ... digitized with the Digidata 1322A interface and acquired with pClamp 10.2 software (Molecular Devices). All drugs tester (Kisspeptin 10 nM ...
-
bioRxiv - Neuroscience 2024Quote: ... Current and voltage were recorded using a MultiClamp 700B amplifier (Molecular Devices), digitized with 16-bit resolution and sampled at 10KHz (Axon Digidata 1550B) ...
-
bioRxiv - Neuroscience 2024Quote: ... Whole-cell patch-clamp recordings were made using an Axopatch 200B (Molecular Devices, USA), National Instruments A/D boards and Ephus software running in MATLAB (v2018b) ...
-
bioRxiv - Neuroscience 2024Quote: ... Data was collected using pClamp 10.2 software (Molecular Devices) and analysed using Clampex 10 software.