Labshake search
Citations for Molecular Devices :
251 - 300 of 10000+ citations since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Neuroscience 2024Quote: ... Data were collected with a Multiclamp 700B amplifier (Molecular Devices) and Clampex software (pClamp9 ...
-
bioRxiv - Microbiology 2024Quote: ... ADP to ATP conversion and luciferase reaction were undertaken as per manufacturer’s recommendation and luminescence was recorded on a SpectraMax M5e (Molecular Devices). RLUs were corrected for baseline luminescence measured in the absence of any protein.
-
bioRxiv - Neuroscience 2024Quote: ... Data were acquired with the pClamp software (Molecular devices). To avoid any alteration of the spontaneous firing frequency of the cell by the patch procedure 73 ...
-
bioRxiv - Neuroscience 2024Quote: ... The mean firing rate was analyzed over 110 seconds recording time window using a threshold crossing spike detection in Clampfit (Molecular devices) and calculated as the number of action potential divided by the duration of the recording.
-
bioRxiv - Neuroscience 2024Quote: Recordings were performed using a MultiClamp 700B (Molecular Devices) and Igor7 (WaveMetrics ...
-
bioRxiv - Neuroscience 2024Quote: ... and Clampex 11.2 software (Molecular Devices). Recordings were made at membrane potential of -50 mV to -65 mV ...
-
bioRxiv - Neuroscience 2024Quote: ... Signal was amplified (AxoClamp 900A, Molecular Devices), filtered (low pass ...
-
bioRxiv - Neuroscience 2024Quote: ... using a photospectrometer at 750 nm (Molecular Devices SpectraMax M5e). Samples (10-20 µg total protein ...
-
bioRxiv - Neuroscience 2024Quote: ... Experiments were performed in voltage-clamp mode using the Axopatch 200B amplifier (Molecular Devices). Visually guided patch of fluorescent labelled cells was performed on a Zeiss Axioscope using a Retiga Electro camera (01-ELECTRO-M-14-C-OC ...
-
bioRxiv - Molecular Biology 2024Quote: ... Absorbance at 505 nm was detected with a microplate reader (Molecular Devices, Sunnyvale, CA). TNF-α concentration was calculated from a standard curve based on known amounts of recombinant murine TNF-α ...
-
bioRxiv - Molecular Biology 2024Quote: ... Absorbance of the resulting solutions was read at 595 nm in a microplate reader (Molecular Devices, Sunnyvale, CA). Results are expressed as the percentage of control cells ± Standard Error of the Means (SEM).
-
bioRxiv - Neuroscience 2024Quote: ... Recordings were amplified using a MultiClamp 700B (Molecular Devices) under the 100x AC differential amplification mode with additional 20x gain ...
-
bioRxiv - Neuroscience 2024Quote: ... Signals were collected with a 0.1 kHz high-pass filter and 3 kHz Bessel filter and acquired using a Digidata 1550B (Molecular Devices) sampled at 20 kHz ...
-
bioRxiv - Neuroscience 2024Quote: ... The recorded traces were analyzed using Clampfit software (version 10.7.0, Molecular Devices) and Mini Analysis (version 6.0.7 ...
-
bioRxiv - Neuroscience 2024Quote: ... All electrical recordings were made at 33°C using a MultiClamp 700B amplifier (Molecular Devices). Electrical signals were filtered at 3 or 10 kHz using a Bessel filter and digitized at 10 or 20 kHz with a Digidata 1440A analog-digital interface (Molecular Devices) ...
-
bioRxiv - Neuroscience 2024Quote: ... Data was acquired using a Digidata 1550B (Molecular Devices) analog-to-digital converter ...
-
bioRxiv - Neuroscience 2024Quote: ... and were analyzed using Clampfit 11.2 (Molecular Devices).
-
bioRxiv - Neuroscience 2024Quote: ... Recordings of membrane potential were made with a Multiclamp 700B amplifier (Molecular Devices, Sunnyvale, CA) in current clamp configuration ...
-
bioRxiv - Neuroscience 2024Quote: ... Signals were acquired at room temperature (23 °C) in current-clamp mode with a MultiClamp 700B amplifier (Molecular Devices), lowpass-filtered at 5 kHz ...
-
bioRxiv - Neuroscience 2024Quote: ... and sampled at 20 kHz using a Digidata 1440A digitizer controlled through pCLAMP 10 (Molecular Devices). Because untransfected HEK-293 cells lacked voltage-gated conductances (Supplementary Fig ...
-
bioRxiv - Neuroscience 2024Quote: ... The bath temperature was monitored with an IT-18 T-thermocouple connected to a Physitemp BAT-12 micro-probe thermometer (Physitemp Instruments) and digitized with an Axon Digidata 1322A AD converter running Clampex 9 software (Molecular Devices).
-
bioRxiv - Neuroscience 2024Quote: ... Signals were recorded with an Axopatch 200B patch-clamp amplifier (Molecular Devices) and digitized through a Digidata 1322A (Molecular Devices) ...
-
bioRxiv - Neuroscience 2024Quote: ... and digitized through a Digidata 1322A (Molecular Devices). Stimulus delivery and data acquisition were performed using pCLAMP9 software (Molecular Devices).
-
bioRxiv - Neuroscience 2024Quote: ... Stimulus delivery and data acquisition were performed using pCLAMP9 software (Molecular Devices).
-
bioRxiv - Neuroscience 2024Quote: ... Mean fluorescence intensity ratios (F340/F380) were displayed online with TillVision (TILL Photonics) or Metafluor (Molecular Devices, San Jose, CA, USA) software ...
-
bioRxiv - Neuroscience 2024Quote: ... and other parameters were identified and analyzed using Nest-o-Patch 2.1.9.8 (https://sourceforge.net/p/nestopatch/wiki/Home/) and Clampfit 9.2 (Molecular Devices).
-
bioRxiv - Neuroscience 2024Quote: ... Recordings were obtained using Axopatch 200B amplifiers (Molecular Devices, Sunnyvale, CA) set to lowpass filter at 2–5 kHz and a custom data acquisition system written in MATLAB (Mathworks) ...
-
bioRxiv - Neuroscience 2024Quote: ... acquired and analyzed with the pClamp 11 software (Molecular Devices). Statistical analyses were performed using IBM SPSS Statistics version 27.0 and MATLAB (MATLAB R2016 ...
-
bioRxiv - Neuroscience 2024Quote: ... All the analyses were performed offline with Clampfit 10.1 software (Molecular Devices).
-
bioRxiv - Pharmacology and Toxicology 2024Quote: ... Data were recorded using a FlexStation 3 (Molecular Devices, USA) with excitation at 485 nm and emission at 525 nm ...
-
bioRxiv - Pathology 2024Quote: Whole-cell recordings were performed at room temperature using the Axopatch 200B amplifier (Molecular Devices) with a 10 kHz low-pass filter ...
-
bioRxiv - Neuroscience 2024Quote: ... The colorimetric assay was measured using a SpectraMax iD3 microplate reader (Molecular Devices, San Jose, CA, USA).
-
bioRxiv - Neuroscience 2024Quote: ... using a Multiclamp 700B amplifier under the control of a Digidata 1550 AD board and Clampex 10 software (all Molecular Devices). Data were acquired at 10 kHz and filtered at 3 kHz ...
-
bioRxiv - Pathology 2024Quote: ... after which absorbance was measured at 450 nm using a plate reader (Filter Max F5, Molecular Devices) with a reference wavelength of 620 nm ...
-
bioRxiv - Neuroscience 2024Quote: ... Electrophysiological recordings were obtained from one neuron per slice and 4-5 slices per mouse using a Multiclamp 700B amplifier and analyzed using a digital system (pClamp version 11.2, Molecular Devices). Series and input resistances were monitored throughout the experiment using a -5 mV pulse ...
-
bioRxiv - Neuroscience 2024Quote: ... Luteinizing hormone levels were read using a standard absorbance plate reader (SpectraMax ABS Plus; Molecular Devices) at 490nm and 630nm wavelengths.
-
bioRxiv - Physiology 2024Quote: ... Laser excitation and image acquisition were controlled by MetaMorph (Molecular Devices). Fluorescence dynamics of individual astrocytes was analyzed with ImageJ software (NIH) ...
-
bioRxiv - Physiology 2024Quote: ... The peak Ca2+ transient amplitude was measured at the end of each tetanus and expressed as (Fmax-F0)/F0 (ΔF/F0) using Clampfit software (Molecular Devices, Sunnyvale, CA, USA).
-
bioRxiv - Neuroscience 2024Quote: ... Voltage or current commands were delivered and signals were recorded using a Digidata 1321A data acquisition system (Molecular Devices) controlled by pCLAMP 9.2 software (Molecular Devices) ...
-
bioRxiv - Neuroscience 2024Quote: ... Voltage clamp was achieved with a dPatch amplifier run by SutterPatch or an AxoPatch 200B amplifier (Molecular Devices) controlled by PatchMaster software (v2×91 ...
-
bioRxiv - Neuroscience 2024Quote: ... Recordings were performed using an Axon Instruments Multiclamp 700B Amplifier (Molecular Devices). Voltage or current commands were delivered and signals were recorded using a Digidata 1321A data acquisition system (Molecular Devices ...
-
bioRxiv - Neuroscience 2024Quote: ... controlled by pCLAMP 9.2 software (Molecular Devices). Solutions for voltage-clamp recordings ...
-
bioRxiv - Neuroscience 2024Quote: ... Data was acquired using an amplifier (model MultiClamp 700A, Molecular Devices). Subsequent data analysis involving the measurement of slope and amplitude was performed using IgorPro software (WaveMetrics) ...
-
bioRxiv - Neuroscience 2024Quote: ... Whole–cell patch– clamp currents were recorded using an Axopatch 200B amplifier–Digidata1440A Series interface board with pClamp10 software (Molecular Devices Corporation). Recordings were conducted at room temperature (25-26°C) ...
-
bioRxiv - Neuroscience 2024Quote: ... Data were analyzed using MiniAnalysis (Synaptosoft) and Clampfit 10.2 (Molecular Devices).
-
bioRxiv - Neuroscience 2024Quote: ... filtered at 3 kHz and digitized at 10 kHz with Digidata 1440A and Clampex 10.2 software (Molecular Devices). Recordings were discarded if access resistance was greater than 30 MΩ or changed more than 15% throughout the recordings ...
-
bioRxiv - Neuroscience 2024Quote: ... with signals being recorded/analyzed using the Digidata 1550B data acquisition system and pClamp 11.2 software package (Molecular Devices).
-
bioRxiv - Neuroscience 2024Quote: ... and analyzed using pCLAMP 10 software (Molecular Devices).
-
bioRxiv - Neuroscience 2024Quote: ... Data were collected using a MultiClamp 700B amplifier (Molecular Devices). Signals were filtered at 2 kHz ...
-
bioRxiv - Neuroscience 2024Quote: ... Recordings were performed using a Multiclamp 700B amplifier and acquired using pCLAMP 10,4 software (Molecular Devices). Signals were low pass filtered at 1 kHz ...