Labshake search
Citations for Molecular Devices :
101 - 150 of 10000+ citations since 2020
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Cell Biology 2024Quote: ... Fura-2 loaded cells were excited with a LED at 360 nm and fluorescence emission was collected at 510 nm at a frame rate of 1 image/s with Metafluor software (Molecular Devices). The quench rate of fluorescence intensity (%/min ...
-
bioRxiv - Cell Biology 2024Quote: ... and luminosity was read out using a microplate reader (SpectraMax M5, Molecular Devices). Plasmids used were ...
-
bioRxiv - Biophysics 2024Quote: ... at 37 °C in a Spectramax Gemini EM plate reader (Molecular Devices, Sunnyvale, CA). Absorbance was measured at 330 nm ...
-
bioRxiv - Biophysics 2024Quote: ... Cyclic AMP was photoreleased by a 405 nm UV LED (M405L3; Thorlabs) with a LED driver (LEDD1B; Thorlabs) controlled by Clampex 10 (Molecular Devices) through the interface Digidata 1440 ...
-
bioRxiv - Biophysics 2024Quote: Currents were measured with a Multiclamp 700B patch-clamp amplifier (Molecular Devices) in the whole-cell voltage clamp mode ...
-
bioRxiv - Biophysics 2024Quote: ... Negative pressure stimuli were applied using a high-speed pressure clamp apparatus (HSPC-1; ALA Scientific) programmed using the Clampex software (Molecular Devices). Pressure and voltage protocol programming and data acquisition were performed with the PClamp 10 suite (Axon Instruments) ...
-
bioRxiv - Biophysics 2024Quote: ... Whole cell membrane currents of oocytes were measured using a two-electrode voltage clamp (Gene Clamp 500B, Axon Instruments/Molecular Devices) under constant perfusion according to the protocols described in the figures ...
-
bioRxiv - Biophysics 2024Quote: ... The BRET signal was recorded by SpectraMax iD5 (Molecular Devices) and calculated as the ratio of light emission at 515 nm (GFP2)/410 nm (RLuc8) ...
-
bioRxiv - Biophysics 2024Quote: ... Currents were low-pass filtered at 2 kHz and acquired at 10 kHz by the analogue-to-digital interface Digidata 1440 (Molecular Devices). All experiments were performed at room temperature (20°–22°C) ...
-
bioRxiv - Biophysics 2024Quote: ... and a soSPIM acquisition module operating in MetaMorph (Molecular Devices). The microscope is equipped with an LED lamp (CooLED ...
-
bioRxiv - Biophysics 2024Quote: ... The light-sheet microscope was controlled via MetaMorph (Molecular Devices). Confocal microscopes were controlled with ZEN (Carl Zeiss ...
-
bioRxiv - Biophysics 2024Quote: ... The fluorescence signal was detected by a photodiode (S1336-BQ, Hamamatsu) and the diode current converted to a voltage using an Axopatch 200A (Molecular Devices) amplifier ...
-
bioRxiv - Biophysics 2024Quote: ... Membrane patches were obtained using borosilicate glass pipettes (Drummond) and recorded on an Axopatch 200B amplifier (Molecular Devices). Negative pressure stimuli were applied using a high-speed pressure clamp apparatus (HSPC-1 ...
-
bioRxiv - Biophysics 2024Quote: Data were analysed using Prism 9.1 (Graphpad; USA) and Clampfit 10.4 (Molecular Devices, USA). Time constants for activation were obtained from exponential fits using Clampfit routines applied to a region commencing after the initial inflexion to the end of the test pulse ...
-
bioRxiv - Biophysics 2024Quote: ... The BRET signal was recorded by SpectraMax iD5 (Molecular Devices) and calculated as the ratio of light emission at 515 nm (GFP2)/410 nm (RLuc8) ...
-
bioRxiv - Biophysics 2024Quote: ... The absorbance at a wavelength of 405 nm was measured using a microplate reader (Molecular Devices) before and after a 1-h incubation of the plates at room temperature ...
-
bioRxiv - Biophysics 2024Quote: ... The data analysis and fitting of the plots were performed in Clampfit (Molecular Devices) and Origin (Microcal Software ...
-
bioRxiv - Biophysics 2024Quote: ... The signals were digitized using Digidata 1550 (Molecular Devices). Patch pipettes were pulled from borosilicate glass and had resistances of 0.7–1.5 MΩ ...
-
bioRxiv - Cell Biology 2024Quote: ... Operational control and data collection were facilitated through Metamorph software by Molecular Devices.
-
bioRxiv - Biophysics 2024Quote: ... The currents were recorded using two- electrode voltage clamp (TEVC) technique with OC-725C amplifier (Warner Instruments) and pClamp11 software (Molecular Devices). The signals were digitized using Digidata 1550 (Molecular Devices) ...
-
bioRxiv - Biophysics 2024Quote: ... Voltage clamp control and data acquisition were under software control (pClamp version 10, Molecular Devices). All experiments were performed at 18-20 °C ...
-
bioRxiv - Biophysics 2024Quote: ... Axopatch 200B amplifier (Molecular Devices), and a Digidata 1440 acquisition board controlled with pCLAMP software ...
-
bioRxiv - Cell Biology 2024Quote: Analysis of changes in holding currents were compared between baseline and peak drug response regions (mean pA) using Clampfit software (Molecular devices, San Jose, CA). Paired student’s t-test was performed on holding currents (pA ...
-
bioRxiv - Cell Biology 2024Quote: ... µFDSS (Hamamtsu, 96-well) or FLIPR Tetra (Molecular Devices, 384-well). For 96-well plates readings were taken every 3 seconds in the PHERAstar ...
-
bioRxiv - Cell Biology 2024Quote: ... Data was converted to a relative scale (ΔF/ F0 baseline) and analyzed in Clampfit 10.4 (Molecular Devices, CA). Data is reported as mean ±SD ...
-
Macropinocytosis mediates resistance to loss of glutamine transport in triple-negative breast cancerbioRxiv - Cancer Biology 2024Quote: ... CCK8 reagent was added for 2 h and absorbance measured at 450 nm on a Spectramax® 190 Microplate Reader (Molecular Devices, CA, USA) at timepoints indicated ...
-
bioRxiv - Cancer Biology 2024Quote: ... Caspase 3/7 activity is measured as arbitrary fluorescent unit (AFU) using a SpectraMax Mini plate reader (Molecular Devices, San Jose, CA, USA).
-
bioRxiv - Cell Biology 2024Quote: ... Fiber cross-sectional area (CSA) was determined using MetaMorph software (Molecular Devices) after immunohistochemical labeling of cryostat sections with anti-laminin antibody ...
-
bioRxiv - Cancer Biology 2024Quote: ... on a SpectraMax M5 plate reader (Molecular Devices). Chemical compounds used in this work were Docetaxel (Selleck) ...
-
bioRxiv - Cell Biology 2024Quote: ... and Leica MMAF software (Metamorph, Molecular Devices). Images were processed with Image J software.
-
bioRxiv - Cell Biology 2024Quote: ... Fluorescence was quantified using an ImageXpress Micro XLS high-content imaging system at 20x magnification (Molecular Devices) with 4 fields of view per well and collagen signal normalised to cell count.
-
bioRxiv - Cell Biology 2024Quote: ... respectively (Molecular devices, San Jose, CA).
-
bioRxiv - Genetics 2024Quote: ... The Dual-Luciferase assay reagent (Molecular devices, SpectraMax iD3) was used to quantify fluorescence signals ...
-
bioRxiv - Genetics 2024Quote: ... We quantified the resulting supernatants for their protein concentrations on a SpectraMax M2 (Molecular Devices) using the DC Protein Assay Kit II (BioRad) ...
-
bioRxiv - Molecular Biology 2024Quote: ... Signals were digitized using an Axon Digidata 1550 Data Acquisition System and recorded with pClamp software (10.5.1.0, Molecular Devices). Prior to analysis ...
-
bioRxiv - Neuroscience 2024Quote: ... digitized at 10 kHz and collected using Clampex 10.5 (Molecular Devices).
-
bioRxiv - Microbiology 2024Quote: ... and the Multimode Plate Reader (Molecular Devices).
-
bioRxiv - Microbiology 2024Quote: ... Epifluorescence images were acquired using Nikon Ti-E and the imaging program Metamorph 6 (Molecular Devices). For SIM microscopy ...
-
bioRxiv - Cell Biology 2024Quote: ... Time-lapsed images were measured every 6 seconds for 6 minutes for 20 minutes using Metamorph (Molecular Devices). Change to fluorescence intensity was calculated using baseline calcium levels per cell.
-
bioRxiv - Molecular Biology 2024Quote: ... The signals were measured with SpectraMax i3x (Molecular devices) at 450 nm with 600 nm as reference wavelength ...
-
bioRxiv - Cell Biology 2024Quote: ... and controlled via pClamp11 software (Molecular Devices). Whole-cell membrane currents were measured at 100 kHz ...
-
bioRxiv - Neuroscience 2024Quote: ... evoked synaptic currents recorded in 2 min (12 sweeps) at Vh= -70 mV were averaged and analyzed using Clampfit10 (Molecular Devices). Five electrical stimuli from a Digitimer isolated stimulator (DS2A Mk.II ...
-
bioRxiv - Neuroscience 2024Quote: ... and digitized at 20 kHz using Digidata 1550A (Molecular Devices) interface and Clampex 10 software (Molecular Devices ...
-
bioRxiv - Neuroscience 2024Quote: ... interface and Clampex 10 software (Molecular Devices, USA).
-
bioRxiv - Neuroscience 2024Quote: ... Signals were recorded using Axon MultiClamp 700B amplifier (Molecular Devices), filtered at 2 kHz ...
-
bioRxiv - Neuroscience 2024Quote: ... and digitized using a Digidata 1440A (Molecular Devices). mWAKE-positive and -negative cells were visualized using infrared differential interference contrast (IR-DIC ...
-
bioRxiv - Neuroscience 2024Quote: ... were used for all recordings and whole-cell electrophysiology recordings were performed using a Multiclamp 700B amplifier (Molecular devices). Data was acquired using a Digidata 1550B amplifier and data were collected using pClamp 10 acquisition software (Molecular Devices ...
-
bioRxiv - Neuroscience 2024Quote: ... Analog signals were transferred and recorded through the Digidata 1400A board (Molecular Devices) under the control of pCLAMP10.3 (Molecular Devices) ...
-
bioRxiv - Neuroscience 2024Quote: ... and sampled at 30 kHz (Axoscope 8; Axon Instruments/Molecular Devices, Burlingame, CA). The light used for exciting V3 neurons was from a 447 nm D442001FX laser (Laserglow Technologies ...
-
bioRxiv - Neuroscience 2024Quote: ... The recorded data were analysed by Clampfit (Molecular Devices, USA), Excel (Microsoft ...