Labshake search
Citations for Molecular Devices :
401 - 450 of 10000+ citations since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Biochemistry 2024Quote: Digital image analysis was done using MetaMorph software (Molecular Devices), and figure panels were prepared using FIJI software.
-
bioRxiv - Neuroscience 2024Quote: ... with a Digidata 1440 analog-to-digital converter (Molecular Devices). For current clamp recordings the intracellular solution was composed of (in mM) ...
-
bioRxiv - Neuroscience 2024Quote: ... and acquired using a Digidata 1322A digitizer (Molecular Devices), sampled at 20 kHz for current clamp ...
-
bioRxiv - Neuroscience 2024Quote: ... All data acquisitions were performed using pCLAMP 9.2 software (Molecular Devices). Light pulses were delivered with a pE-300 (CoolLed ...
-
bioRxiv - Neuroscience 2024Quote: ... Electrophysiological recordings were performed using a Axopatch 200B amplifier (Molecular Devices) and acquired using a Digidata 1322A digitizer (Molecular Devices) ...
-
bioRxiv - Biophysics 2024Quote: ... The signal was filtered using Bessel filter at 10 kHz and digitized with a Digidata 1440A (Molecular Devices) at a 100 kHz (interval 10 µs ...
-
bioRxiv - Biophysics 2024Quote: ... the signal was filtered using Bessel filter at 10 kHz and digitized with a Digidata 1550B (Molecular Devices) at a 100 kHz sampling rate (every 10 µs ...
-
bioRxiv - Biophysics 2024Quote: ... The SICM set-up utilises the AxoPatch 200B (Molecular Devices) patch-clamp amplifier in voltage-clamp mode ...
-
bioRxiv - Biophysics 2024Quote: ... The ionic current was measured using a MultiClamp 700B (Molecular Devices) patch-clamp amplifier in voltage-clamp mode ...
-
bioRxiv - Biophysics 2024Quote: ... Digitized data were recorded on a computer using the software pClamp (Molecular Devices) and analyzed using Clampfit (Molecular Devices).
-
bioRxiv - Biophysics 2024Quote: ... and analyzed using Clampfit (Molecular Devices).
-
bioRxiv - Bioengineering 2024Quote: ... Absorbance measurements were performed either on a Spectromax 190 microtiter plater reader from Molecular Devices (San Jose, CA), or a Clariostar Optima UV/Vis Spectrophotometer from BMB Labtech (Ortenberg ...
-
bioRxiv - Neuroscience 2024Quote: ... All recordings were acquired using a Digidata 1140A digitizer and a Multiclamp 700B amplifier (Molecular Devices), with a sampling rate set at 20 kHz and a lowpass 1kHz filter during recording ...
-
bioRxiv - Neuroscience 2024Quote: ... All data were collected and analyzed with pCLAMP 10.7 (Molecular Devices), n represents the number of slices and N represents the number of animals ...
-
bioRxiv - Neuroscience 2024Quote: ... iNeurons were imaged on an ImageXpress Micro Confocal High-Content Imaging System (Molecular Devices) using an Apo LWD 20X/0.95NA water immersion objective ...
-
bioRxiv - Neuroscience 2024Quote: ... Passive properties were continuously monitored using a Digidata 1140A digitizer and a Multiclamp 700B amplifier (Molecular Devices). After reaching whole-cell configuration ...
-
bioRxiv - Neuroscience 2024Quote: ... Electrical signals were filtered at 1 kHz by a Multiclamp 700B amplifier (Molecular Devices, USA), and digitized by an Axon DigiData 1550A converter with a sampling frequency of 10 kHz ...
-
bioRxiv - Neuroscience 2024Quote: ... and digitized using a Digidata 1440A (Molecular Devices). mWAKE-positive and -negative cells were visualized using infrared differential interference contrast (IR-DIC ...
-
bioRxiv - Neuroscience 2024Quote: ... Whole-cell patch clamp recordings were obtained using a Multiclamp 700B amplifier (Molecular Devices). Data were sampled at 20 kHz ...
-
bioRxiv - Neuroscience 2024Quote: ... Data were collected using a 1550B digitizer (Molecular Devices), a 700B patch-clamp amplifier (Molecular Devices ...
-
bioRxiv - Neuroscience 2024Quote: ... a 700B patch-clamp amplifier (Molecular Devices) and acquired with the pClamp 10.6 software (Molecular Devices) ...
-
bioRxiv - Neuroscience 2024Quote: ... Data was analyzed with Clampfit 10 (Molecular Devices) and Prism 10 (GraphPad Software ...
-
bioRxiv - Neuroscience 2024Quote: ... recordings were performed with a patch-clamp amplifier (Axopatch 200B, Molecular Devices, Union City, CA) and restricted to tdTomato-expressing TG neurons from MrgprA3TdTomato or MrgprA3TdTomato ...
-
bioRxiv - Neuroscience 2024Quote: ... PClamp (Molecular Devices) was used for data acquisition as well as controlling light stimulation and current and voltage-clamp protocols ...
-
bioRxiv - Neuroscience 2024Quote: ... Series resistance was fully compensated using the bridge circuit of the amplifier MultiClamp 700B (Molecular Devices, RRID: SCR_018455). Action potential threshold was estimated as the point when the slope of rising membrane potential exceeds 50 mV ms−1.
-
bioRxiv - Neuroscience 2024Quote: ... We then used the AP analysis tool in Clampfit (pClamp software v11.2, Molecular Devices) to determine the characteristics of the APs ...
-
bioRxiv - Neuroscience 2024Quote: ... amplified by a MultiClamp 700B amplifier (Molecular Devices), and low pass-filtered using a single-pole RC filter at 10 kHz ...
-
bioRxiv - Neuroscience 2024Quote: ... Data acquisition used pClamp software (v11.2, Molecular Devices) and data analysis was performed using Clampfit software (v11.2 ...
-
bioRxiv - Neuroscience 2024Quote: ... All data were digitized (Digidata 1440A, Molecular Devices), amplified by a MultiClamp 700B amplifier (Molecular Devices) ...
-
bioRxiv - Neuroscience 2024Quote: ... were plotted against the amplitude of current injection and the slope of the linear fit between −5 pA to −30 pA was used to define Rin (Clampfit v. 11.2; Molecular Devices). Time constant (tau ...
-
bioRxiv - Neuroscience 2024Quote: ... directed by MetaMorph software (Molecular Devices).
-
bioRxiv - Neuroscience 2024Quote: ... Recordings were acquired with PatchMaster v2x90.1 (HEKA Elektronik) and Clampex 10.7 (Molecular Devices). The liquid junction potential was calculated to be ∼4.3 mV and this estimate was not corrected ...
-
bioRxiv - Neuroscience 2024Quote: ... Whole-cell patch-clamp recordings were performed at room temperature (∼ 21°C) 18-30 hours after dissociation using an EPC10 USB (HEKA Elektronik) amplifier and a Multiclamp 700B (Molecular Devices). Neurons were observed at 20x magnification on an IX-71 (Olympus ...
-
bioRxiv - Neuroscience 2024Quote: ... Current- and voltage-clamp recordings were obtained with Multiclamp 700A and Digidata 1440A (Molecular Devices) or NI USB-6341 (National Instruments) ...
-
bioRxiv - Neuroscience 2024Quote: ... digitized at 10kHz using DigiData 1440A or DigiData 1550B and recorded using pClamp10 software (Molecular Devices, Sunnyvale, CA). Active and passive properties were recorded in current clamp from a holding potential of -70mV using K-Gluconate based internal solution ...
-
bioRxiv - Neuroscience 2024Quote: ... and digitized with a Digidata 1440A (Molecular Devices). Data was acquired at a sampling rate of 10 kHz ...
-
bioRxiv - Neuroscience 2024Quote: ... was induced with 0.5 s and 30 s pulses of green LED light triggered by pCLAMP 10 software (Molecular Devices). Data were excluded from the analysis if there was an absence of spiking prior to light onset ...
-
bioRxiv - Neuroscience 2024Quote: ... digitized with the Digidata 1322A interface and acquired with pClamp 10.2 software (Molecular Devices). All drugs tester (Kisspeptin 10 nM ...
-
bioRxiv - Neuroscience 2024Quote: ... Whole-cell patch-clamp recordings were made using an Axopatch 200B (Molecular Devices, USA), National Instruments A/D boards and Ephus software running in MATLAB (v2018b) ...
-
bioRxiv - Neuroscience 2024Quote: ... Data was collected using pClamp 10.2 software (Molecular Devices) and analysed using Clampex 10 software.
-
bioRxiv - Neuroscience 2024Quote: ... Data were filtered at 10 kHz and digitized at 20 kHz using a 1440A Digidata Digitizer (Molecular Devices). Series resistance (<20 MΩ ...
-
bioRxiv - Neuroscience 2024Quote: ... DNA was ejected with 12 hyperpolarizing pulses (−12 V, 0.5 ms) using an Axoporator 800A (Molecular Devices). Experiments were conducted 6 days after electroporation.
-
bioRxiv - Neuroscience 2024Quote: ... Membrane capacitance and series resistance were compensated by 70% und data filtered by low-pass Bessel filter at 3 kHz and sampled at 10 kHz using an Axon Digidata 1322A digitizer (Molecular Devices).
-
bioRxiv - Neuroscience 2024Quote: ... Signals were collected and amplified by a Multiclamp 700B amplifier (Molecular Devices) and digitized using a Digidata 1440A (Molecular Devices) ...
-
bioRxiv - Neuroscience 2024Quote: Either live recorded data or previously acquired recordings can be imported into BPE framework from HEKA amplifiers (.dat file format) and amplifiers from Molecular Devices (*.abf file format). To read *.dat files we used a modified version of the publicly available heka_reader package with pgf file reading support (github campagnola/heka reader ...
-
bioRxiv - Neuroscience 2024Quote: ... digitized at 10kHz (Digidata 1440A, Molecular Devices), and recorded (pClamp 10.0 Molecular Devices) ...
-
bioRxiv - Neuroscience 2024Quote: ... membrane potential or current was amplified (Multiclamp 700B, Molecular devices), digitized at 10kHz (Digidata 1440A ...
-
bioRxiv - Neuroscience 2024Quote: ... Somatic whole-cell voltage-clamp recordings (¿1 GΩ seal resistance, -70 mV holding potential) were performed using a Multiclamp 700B amplifier (Molecular Devices). Data were acquired using pCLAMP 10.7 on a personal computer connected to the amplifier via a Digidata-1440 interface (sampling rate ...
-
bioRxiv - Neuroscience 2024Quote: ... Data was acquired using pClamp 10 (Molecular Devices). A cesium internal solution (pH 7.30 ...
-
bioRxiv - Neuroscience 2024Quote: ... and digitized using a Digidata 1440A (Molecular Devices). Data was acquired using pClamp 10 (Molecular Devices) ...