Labshake search
Citations for Molecular Devices :
8401 - 8450 of 10000+ citations since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Neuroscience 2020Quote: ... Data were acquired using Multiclamp 700B amplifier (Molecular Devices) and digitized using Digidata 1440A (Molecular Devices) ...
-
bioRxiv - Neuroscience 2020Quote: ... and digitized using Digidata 1440A (Molecular Devices). All data were low-pass filtered at 10 kHz and sampled at 50 kHz ...
-
bioRxiv - Neuroscience 2020Quote: ... We performed confocal imaging with an X-Light V2 TP spinning disk unit (CrestOptics) mounted to an Axio Observer.Z1 microscope (ZEISS) using MetaMorph Premier software (Molecular Devices).
-
bioRxiv - Neuroscience 2020Quote: ... The total luminescence was normalised to the confluence percentage using the SpectraMax i3x Multi-Mode Microplate Reader i3 (Molecular Devices®, San Jose, CA, USA) that was taken on the same day of experiment prior to the addition of Rotenone or DMSO ...
-
bioRxiv - Neuroscience 2020Quote: ... Electrical signals were digitized at 20-50 kHz by a Axon Digidata 1550B (Molecular Devices) or a ITC-18 (HEKA ...
-
bioRxiv - Neuroscience 2020Quote: ... Voltage-gated sodium currents were activated by applying 20 mV steps ranging from −120 mV to +40 mV with rectangular stimuli lasting 199 ms by use of an AxoPatch 200B amplifier (Molecular Devices, California, USA). Data were acquired with PClamp11 software (Molecular Devices ...
-
bioRxiv - Neuroscience 2020Quote: ... and Clampfit (Molecular Devices). For two-group comparisons (paired and unpaired) ...
-
bioRxiv - Neuroscience 2020Quote: ... were measured offline using Clampfit 10.7 (Molecular Devices, Sunnyvale, CA). The number of spontaneous depolarization events in each SAC was counted manually over a recording time (min) ...
-
bioRxiv - Neuroscience 2020Quote: ... Data were acquired using a Digidata 1440A digitizer and Clampex 10.7 software (Molecular Devices, San Jose, CA).
-
bioRxiv - Neuroscience 2020Quote: Single cell recordings were analyzed off-line using Clampfit 11 of the pClamp11 software package (Molecular Devices). sEPSC properties were analyzed using the automated template search tool for event detection ...
-
bioRxiv - Neuroscience 2020Quote: ... Signals were recorded with a MultiClamp 700B amplifier (Molecular Devices) under voltage clamp mode at a holding voltage of –70 mV for excitatory currents and 0 mV for inhibitory currents ...
-
bioRxiv - Microbiology 2020Quote: ... Growth was measured after 48h of incubation through spectrophotometric quantification of OD600 in a SPECTRAmax® Plus 384 microplate reader (Molecular Devices). Minimal Fungicidal Concentration (MFC ...
-
bioRxiv - Microbiology 2020Quote: ... OD620 was measured on a plate reader (Molecular devices, FilterMax F3) included in an automated system (Beckman Coulter ...
-
bioRxiv - Immunology 2020Quote: ... The concentration of specific antibodies was measured using TMB substrate (SeraCare) and the absorbance at 450 nm-630 nm was detected by a Microplate Reader (Molecular Devices).
-
bioRxiv - Immunology 2020Quote: ... stop solution was added and samples were read using a SpectraMax M2 Microplate Reader (Molecular Devices) at 450nm ...
-
bioRxiv - Neuroscience 2020Quote: ... Quantification of PV+ cell optical density was performed in Image J and MetaMorph imaging software (Molecular Devices Systems, Toronto, ON), respectively ...
-
bioRxiv - Immunology 2020Quote: ... Images were acquired with a fluorescence microscope and analyzed using ImageXpress Micro XLS (Molecular Devices, Sunnyvale, CA). All experiments involving SARS-CoV-2 were performed in a biosafety level 3 laboratory.
-
The cellular basis of protease activated receptor type 2 (PAR2) evoked mechanical and affective painbioRxiv - Neuroscience 2020Quote: ... Data were acquired and analyzed using an Axopatch 200B amplifier and pCLAMP10.2 software (Molecular Devices, Sunnyvale, CA). Recorded data were filtered at 5 kHz and sampled at 30 kHz ...
-
bioRxiv - Immunology 2020Quote: ... and the reactions were stopped by adding 1 M H2SO4 before measuring absorbance at 450 nm with a Spectramax Paradigm plate reader (Molecular Devices).
-
bioRxiv - Immunology 2020Quote: ... and the reactions were stopped by adding 1 M H2SO4 before measuring absorbance at 450 nm with a Spectramax Paradigm plate reader (Molecular Devices).
-
bioRxiv - Neuroscience 2020Quote: Recordings were made with an Axopatch 700B amplifier and digitised with Digidata 1440A or 1550B (Molecular Devices). pClamp software was used to acquire electrophysiological data at a sampling rate of 20 kHz and low-pass filtered at 2 kHz (voltage clamp ...
-
bioRxiv - Microbiology 2020Quote: ... Binding intensities were measured at the 450 nm wavelength using a Spectra-Max® i3 microplate reader (Molecular Devices, LLC, CA, USA).
-
bioRxiv - Neuroscience 2020Quote: ... for acquisition (1-10 kHz) by pCLAMP10.2 software (Molecular Devices, LLC, San Jose, CA, USA). Glass recording microelectrodes were filled with aCSF (tip resistance ∼3MΩ ...
-
bioRxiv - Neuroscience 2020Quote: ... respectively (Axon Instruments, Molecular Devices) for acquisition (1-10 kHz ...
-
bioRxiv - Neuroscience 2020Quote: Current-clamp recordings were carried out using an Axon Multiclamp 700B amplifier (Molecular Devices) low-pass filtered at 3 kHz and digitized using an Axon Digidata 1440A or Instrutech ITC-18 at 10 kHz ...
-
bioRxiv - Neuroscience 2020Quote: ... An Axon Digidata 1550 acquisition system (Molecular Devices, CA) was used to program and generate a set number of trigger pulses that were sent to an arbitrary waveform generator (Tabor Electronics ...
-
bioRxiv - Microbiology 2020Quote: ... Image processing was performed with Metamorph_v 7.5 (Molecular Devices). For image analysis ...
-
bioRxiv - Biophysics 2020Quote: ... FLIPR Ca2+ 6 (Molecular Devices, San Jose, CA, USA) was used for all Ca2+ measurements except Fig ...
-
bioRxiv - Microbiology 2020Quote: ... Confocal images and Quicktime movies were generated from laser-scanning confocal microscope file data using using Metamorph software (Molecular Devices) and Imaris (bitmap ...
-
bioRxiv - Microbiology 2020Quote: ... Absorbance was measured at 490 nm and 650 nm using a VERSA max microplate reader (Molecular Devices).
-
bioRxiv - Biophysics 2020Quote: ... with exposure time of 150ms per frame were acquired using Metamorph software (Molecular Devices) and detected using sCMOS cameras (ORCA-Flash4.0 V2 ...
-
bioRxiv - Microbiology 2020Quote: ... were recorded using a SpectraMax i3x plate reader (Molecular Devices), and the MIC90 ...
-
bioRxiv - Neuroscience 2020Quote: ... All data were sampled at 5 kHz and analyzed offline using ClampFit 10.2 (Molecular Devices, USA). For graphical representation ...
-
bioRxiv - Neuroscience 2020Quote: ... Behavioral TTL pulses and imaging frame timing were digitized and recorded (Digidata 1440A; Axon CNS Molecular Devices, San Jose ...
-
bioRxiv - Developmental Biology 2020Quote: ... The combined length of the stenosed and fused regions were measured along the VS using Metamorph (version 7.7, Molecular Devices) and divided by the length of the striatal VS in each section ...
-
bioRxiv - Neuroscience 2020Quote: ... and Nuclear Translocation modules on MetaXpress® software (Molecular Devices) as previously described (48).
-
bioRxiv - Neuroscience 2020Quote: ... Z-stacks (200-250 slices, 5 μm step) of explants were then acquired using the ImageXpress high content imaging system (Molecular Devices). 2-D projections were used for analysis of positively labelled nuclei with the Custom Module Editor (image analysis pipeline described in detail in supplementary data (fig ...
-
bioRxiv - Neuroscience 2020Quote: ... All measurements were acquired using pCLAMP 10 software in conjunction with a Multiclamp 700B amplifier (Molecular Devices), digitized at 50 kHz with a Digidata 1440A ...
-
bioRxiv - Neuroscience 2020Quote: Clampfit 10 (Molecular Devices), minianalysis (Synaptosoft) ...
-
bioRxiv - Microbiology 2020Quote: ... Slides were scanned using the GenePix scanner 4000B and GenePix pro 6.0 software (Molecular Devices). The raw microarray data representing relative steady state mRNA abundance ratios between each test sample and the reference pool (Cy5/Cy3 log2 ratios ...
-
bioRxiv - Microbiology 2020Quote: ... The raw microarray data representing relative steady state mRNA abundance ratios between each test sample and the reference pool (Cy5/Cy3 log2 ratios) were subjected to lowess normalization and background filtering as implemented by the Acuity 4.0 program (Molecular Devices). Flagged features and features with either Cy3 or Cy5 intensities lower than two-fold the background were removed ...
-
bioRxiv - Microbiology 2020Quote: Binding affinities of S-D4 with SARS-CoV-2 S-RBD were performed by BLI on an Octet RED96 (Molecular Devices LLC, San Jose, CA, USA) using AR2G biosensors ...
-
bioRxiv - Microbiology 2020Quote: ... The absorbance at 450 nm and 630 nm of each well was immediately determined by SpectraMax Plus plate reader (Molecular Devices, USA). Results were plotted and fitted by GraphPad Prism 8 and EC50 value were calculated using 4-parameters nonlinear regression fitting from fitted curve.
-
bioRxiv - Microbiology 2020Quote: ... The well-absorbance at 450 nm and 630 nm was immediately recorded by SpectraMax Plus plate reader (Molecular Devices, USA).
-
bioRxiv - Molecular Biology 2020Quote: ... and absorbance at 340 nm was measured via a SpectraMax M4 plate reader (Molecular Devices, USA).
-
bioRxiv - Neuroscience 2020Quote: ... Electrophysiological recordings were conducted using an Axopatch 700B amplifier and a Digidata 1440 digitizer linked to a computer running pClamp 10.2 software (Molecular Devices, Sunnyvale, CA, USA). Recordings were sampled at 20 kHz and filtered at 10 kHz ...
-
bioRxiv - Neuroscience 2020Quote: ... 500 nM of pre-warmed labeled VAMP2 was added to start the reaction and fluorescence at 580 nm was measured in plate reader (Molecular Devices) for 60 min with 15 sec intervals ...
-
bioRxiv - Neuroscience 2020Quote: ... which were performed with an Axon Instruments Axopatch 200B amplifier (Molecular Devices, Sunnyvale, CA). Patch-clamp recording was performed using a “blind-patch” approach (Blanton et al. ...
-
bioRxiv - Neuroscience 2020Quote: Current clamp recordings were performed using an Axon Instruments Axoclamp-2B amplifier operating in “Bridge” mode and Digidata 1330A digitizer with pClamp software (Molecular Devices, Sunnyvale, CA), except for the preliminary experiments in Supplemental Figure 1 ...
-
bioRxiv - Neuroscience 2020Quote: ... Recordings were done using a CyberAmp 320 controlled by pCLAMP10 (Molecular Devices, San Jose, USA). The biological signal was amplified (×2000) ...