Labshake search
Citations for Molecular Devices :
8301 - 8350 of 10000+ citations since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Neuroscience 2020Quote: ... intrinsic electrical properties were inspected immediately after gaining access to the cell and miniature excitatory synaptic currents were recorded in the presence of TTX (0.5 μm) at room temperature in voltage-clamp configuration (cells were held at −60 mV with a Multiclamp 700B amplifier, Molecular Devices). The bath solution contained (in mM) ...
-
bioRxiv - Cell Biology 2020Quote: ... controlled by MetaMorph 7.6.4 (Molecular Devices) was used ...
-
bioRxiv - Cell Biology 2020Quote: ... Absorbance (560) nm was measured using a microplate reader (SpectroMax Gemini; Molecular Devices Corp., Sunnyvale,CA).
-
bioRxiv - Neuroscience 2020Quote: ... Recordings were obtained with a MultiClamp 700A patch amplifier (Molecular Devices), digitized with Digidata 1322A and acquired using Clampex software ...
-
bioRxiv - Neuroscience 2020Quote: ... acquired at 50 KHz using a Molecular Devices 1440A A/D converter (Scientifica, UK) and recorded using Clampex 10 software (Molecular Devices, Scientifica, UK). Electrodes were pulled with a Flaming-Brown puller (P1000 ...
-
bioRxiv - Neuroscience 2020Quote: ... An Isoflex (Molecular Devices) stimulus isolator was used to deliver negative current pulses of varying amplitudes ...
-
bioRxiv - Cell Biology 2020Quote: ... The data from whole-cell patch-clamp recordings were acquired at 10 kHz and filtered at 5 kHz for analysis (Axopatch 200B amplifier with pCLAMP software, Molecular Devices). Membrane potential was clamped at 0 or −60 mV and voltage ramp-pulses from −100 to +100 mV (300 ms ...
-
bioRxiv - Cell Biology 2020Quote: ... The data were digitized with an analog-to-digital converter (Digidata 1400A; Molecular Devices, Union City, CA, U.S.A.) stored on a personal computer with a data acquisition program (Clampex software ...
-
bioRxiv - Cell Biology 2020Quote: ... and analyzed with Clampfit software (version 10.2, Molecular Devices). We searched the area on the skin where touch (with a cotton wisp ...
-
bioRxiv - Cell Biology 2020Quote: ... stored on a personal computer with a data acquisition program (Clampex software, version 10.2, Molecular Devices) and analyzed with Clampfit software (version 10.2 ...
-
bioRxiv - Bioengineering 2020Quote: ... and absorbance was measured at 450 nm on a plate reader (SpectraMax i3, Molecular Devices) Samples included a negative control consisting of HCM only (no cells ...
-
bioRxiv - Bioengineering 2020Quote: ... All biochemical assays were performed in 10 μL of media and measured on a SpectraMax i3 plate reader (Molecular Devices). All sample results were calculated by interpolation of sample raw values from standard curves performed in parallel ...
-
bioRxiv - Bioengineering 2020Quote: ... and digitized at a sample rate of 20 kHz via a Digidata 1440A A/D digitizer (both Axon Instruments/Molecular Devices, Union City, CA). All recordings were performed at room temperature ...
-
bioRxiv - Biophysics 2020Quote: Voltage and current clamp commands and data acquisition was controlled with the Clampex program from the pClamp9 software package (Molecular Devices). Fitting of exponential relaxations and other functions was done with a non-linear least squares procedure utilizing the Levenberg-Marquardt algorithm or in some cases with function fitting procedures in Excel (Microsoft ...
-
bioRxiv - Biophysics 2020Quote: ... Recordings from dissociated cells were done with an Axoclamp 2A amplifier (Molecular Devices, San Jose CA).
-
bioRxiv - Biophysics 2020Quote: Recordings were done with a Multiclamp 700B (Molecular Devices, San Jose CA). The standard extracellular solution contained (mM ...
-
bioRxiv - Biophysics 2020Quote: ... Command waveforms and data acquisition was done with the Clampex program from the pCLAMP 9.0 software package (Molecular Devices). Currents were evaluated without leak subtraction ...
-
bioRxiv - Biophysics 2020Quote: ... Whole-cell voltage-clamp recordings were accomplished with a Multiclamp 700B amplifier (Molecular Devices, Sunnyvale, CA). Command waveforms and data acquisition was done with the Clampex program from the pCLAMP 9.0 software package (Molecular Devices) ...
-
bioRxiv - Biophysics 2020Quote: ... Whole-cell patch clamp recording was performed using an Axopatch 200B amplifier (Molecular Devices) and Digidata 1440A analog-to-digital converter (Molecular Devices) ...
-
bioRxiv - Biophysics 2020Quote: ... Data were acquired using a GeneClamp 500B amplifier (MDS Analytical Technologies) controlled by pClamp software (Molecular Devices), and digitized at 1 kHz using Digidata 1332A digitizer (MDS Analytical Technologies).
-
bioRxiv - Biophysics 2020Quote: Clampfit 10 (pCLAMP 10, Molecular Devices), Origin 9.1 (OriginLab Corp. ...
-
bioRxiv - Biophysics 2020Quote: ... Data collection was performed using an Axopatch 200B amplifier (Molecular Devices) and pCLAMP 9 (Molecular Devices ...
-
bioRxiv - Biophysics 2020Quote: ... and Digidata 1440A analog-to-digital converter (Molecular Devices). Series resistance was compensated at least 85% ...
-
bioRxiv - Biophysics 2020Quote: ... and pCLAMP 9 (Molecular Devices, Sunnyvale, CA, USA).
-
bioRxiv - Biophysics 2020Quote: ... Clampex 10 (pCLAMP 10, Molecular Devices) was used to control voltage protocols and for data acquisition.
-
bioRxiv - Biophysics 2020Quote: All electrophysiological recordings used the Port-a-Patch planar patch-clamp system (Nanion Technologies) connected to an Axopatch 200B amplifier via a Digidata 1550B1 (Molecular Devices). Giga-Ohm seals formed as TREK-2 containing GUVs ruptured on contact with the chip glass surface over a microstructured aperture [25] ...
-
bioRxiv - Biophysics 2020Quote: ... The microscope system was controlled by MetaMorph software (Molecular Devices) and only center quadrant of the camera sensor was used for imaging.
-
bioRxiv - Biophysics 2020Quote: ... a Digidata 1550A interface and pCLAMP 10 (Molecular Devices). Currents were digitized at 500 Hz and filtered at 100 Hz (30-60 Hz used for display purposes) ...
-
bioRxiv - Biophysics 2020Quote: ... and absorbance was recorded at 340 nm in a SpectraMax Plus microplate spectrophotometer from Molecular Devices (Sunnyvale, CA). The steady-state myofibrillar ATPase rate was measured from NADH oxidation ...
-
bioRxiv - Biophysics 2020Quote: ... Fluorescence emission spectra from 560-590 nm (excitation 530 nm) were recorded using a SpectraMax M5 plate reader (Molecular Devices). Next ...
-
bioRxiv - Biophysics 2020Quote: Whole-cell Nav currents were recorded at room temperature 48 hours after cell isolation using an Axopatch 200B amplifier (Axon Instruments, Molecular Devices, San Jose, CA). Voltage-clamp protocols were applied using the pClamp 10.2 software package interfaced to the electrophysiological equipment using a Digidata 1440A digitizer (all Axon Instruments) ...
-
bioRxiv - Biophysics 2020Quote: ... and stored using pClamp (Molecular Devices). Current traces were analyzed with Clampfit (Molecular Devices) ...
-
bioRxiv - Biophysics 2020Quote: ... Current traces were analyzed with Clampfit (Molecular Devices). The stock solution of GABA was made in ND96 at 500 mM ...
-
bioRxiv - Biophysics 2020Quote: ... an A/D converter (Digidata 1440A) and an Axopatch 200B (all Molecular Devices) or an Alembic amplifier (Alembic Instruments) ...
-
bioRxiv - Biophysics 2020Quote: ... and absorbance was measured at 340 nm in a SpectraMax Plus microplate spectrophotometer (Molecular Devices, Sunnyvale, CA). Data points were fitted with V = V0 + Vmax/(1 + 10−n[pKCa – pCa]) ...
-
bioRxiv - Biophysics 2020Quote: ... Currents were measured with an Axopatch 200B amplifier and recorded with a Digidata 1440B A/D converter under the control of pCLAMP software (Molecular Devices). Currents were filtered at 2 kHz and recorded at 5 kHz.
-
bioRxiv - Biophysics 2020Quote: ... and voltage-clamp experiments were conducted using the Axopatch 200B amplifier (Axon Instruments/Molecular Devices). The recorded signals were filtered at 2 kHz and were digitized at 4 kHz using Digidata 1440A digitizing board (Molecular Devices/Axon Instruments) ...
-
bioRxiv - Biophysics 2020Quote: ... The recorded signals were filtered at 2 kHz and were digitized at 4 kHz using Digidata 1440A digitizing board (Molecular Devices/Axon Instruments). Occasionally ...
-
bioRxiv - Biophysics 2020Quote: ... all controlled by pClamp 10.7 software (Molecular Devices). The oocytes were perfused with OR-2 using gravity flow at an approximate rate of 5 mL/min in a 250 μL chamber ...
-
bioRxiv - Biophysics 2020Quote: ... a Digidata 1440A data interface (Molecular Devices, Sunnyvale, CA), and a MiniDigi 1B (Molecular Devices) ...
-
bioRxiv - Biophysics 2020Quote: ... and a MiniDigi 1B (Molecular Devices), all controlled by pClamp 10.7 software (Molecular Devices) ...
-
bioRxiv - Biophysics 2020Quote: ... Images were collected and analyzed using MetaFluor Fluorescence Ratio Imaging Software (Molecular Devices, USA). For statistical analysis ...
-
bioRxiv - Biophysics 2020Quote: ... Ion current data were acquired using an Axon instruments-patch clamp system (Molecular devices, USA). Measurements were recorded using the Axopatch 700b amplifier ...
-
bioRxiv - Biophysics 2020Quote: ... The fluorescence intensity was monitored with a Multifunctional Enzyme Marker (SpectraMax®i3x, Molecular Devices, U.S.A.) using wavelengths of 320 and 405 nm for excitation and emission ...
-
bioRxiv - Biophysics 2020Quote: ... and the pClamp software package (Molecular Devices). The glass pipettes were pulled from borosilicate capillaries (Sutter Instruments ...
-
bioRxiv - Biophysics 2020Quote: ... Viability of the cells was calculated from values generated in the Gen5 software (Molecular Devices) by normalizing using the mean values of the DMSO and cell only wells (100% viability ...
-
bioRxiv - Biophysics 2020Quote: ... low-pass filtered (10 kHz; Axopatch 200B) and sampled at 40 kHz (Molecular Devices; DigiData 1440A). All data were acquired with QuB software (University at Buffalo ...
-
bioRxiv - Biophysics 2020Quote: ... was added and plates were transferred to a Biotek Synergy H1 Microplate Reader and recorded using the luminescence filter and Gen5 software (Molecular Devices). Normalization was performed by calculating the mean values for reference wells containing virus ...
-
bioRxiv - Cell Biology 2020Quote: ... The tertiary siRNA screen was carried out utilising an ImageXpress Micro Confocal (Molecular Devices) using a 20x objective (NA 0.45) ...
-
bioRxiv - Cell Biology 2020Quote: ... fluorescence intensities within a region of 1 μm at the lamellipodium front of control or the corresponding cell periphery of tamoxifen-treated cells were measured using MetaMorph Software (Molecular Devices). Fitted curves were generated in Sigma plot 12.0 (Systat Software ...