Labshake search
Citations for Bio-Rad :
851 - 900 of 1482 citations for pIEXBac c EGFP 3 since 2020
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Neuroscience 2022Quote: ... The supernatants were stored at −80°C until used and lysate protein concentration was determined using the DCTM Protein assay (Biorad).
-
bioRxiv - Neuroscience 2022Quote: ... The supernatants were stored at −80°C until used and lysate protein concentration was determined using the DCTM Protein assay (Biorad).
-
bioRxiv - Neuroscience 2022Quote: ... The supernatants were stored at −80°C until used and lysate protein concentration was determined using the DCTM Protein assay (Biorad).
-
bioRxiv - Neuroscience 2022Quote: ... The supernatants were stored at −80°C until used and lysate protein concentration was determined using the DCTM Protein assay (Biorad).
-
bioRxiv - Neuroscience 2022Quote: ... The supernatants were stored at −80°C until used and lysate protein concentration was determined using the DCTM Protein assay (Biorad).
-
bioRxiv - Biochemistry 2023Quote: ... and flash-frozen in liquid nitrogen for storage at −80°C The protein concentration was determined using the DC protein assay (BioRad) per the manufacturer’s instructions.
-
bioRxiv - Neuroscience 2023Quote: ... Proteins were separated by SDS-PAGE then transferred to nitrocellulose membrane at 4°C (0.45 μm pore size, Bio-Rad). Membranes were blocked overnight at 4° in Intercept tris-buffered saline (TBS ...
-
bioRxiv - Cancer Biology 2023Quote: ... Lysates were cleared by centrifugation at 14,000 g for 15 min at 4°C and protein concentration was determined using the Bradford assay (Bio-Rad). Sodium dodecyl sulfate (SDS ...
-
bioRxiv - Microbiology 2023Quote: ... and 0.2M DTT) for 10 minutes at 95°C before loading in a 10% SDS-PAGE Gel (Bio-Rad 4561034). Sample proteins were separated in 1X SDS Running Buffer (25mM Tris ...
-
bioRxiv - Molecular Biology 2023Quote: ... These mixtures were then heated up to 95 °C for 5 minutes and slowly cooled to room temperature at the rate of 1 °C per minute using a thermal cycler (BioRad).
-
bioRxiv - Cell Biology 2023Quote: ... Protein samples were boiled for 8 min at 95 °C in 1X Laemmli buffer (LB) with β-Mercaptoethanol (BioRad, 1610747), resolved on 10% polyacrylamide gels or pre-cast 4-12% Bis-Tris gradient gels (Thermo Scientific ...
-
bioRxiv - Molecular Biology 2023Quote: ... Binding was performed with gentle mixing for 1 hour at 4°C and loaded onto a Poly Prep Chromatography Column (BioRad). The loaded resin was then washed 3-4 times with 6 ml Wash Buffer (50 mM sodium phosphate ...
-
bioRxiv - Molecular Biology 2023Quote: ... Obtained samples were denatured in a 1xLaemmli buffer at 95°C for 10 min and proteins separated using electrophoresis on a 4-15% mini-protean-TGX-precast-gel (BioRad). Proteins were then transferred on nitrocellulose membranes by a semi-dry method using transblot turbo transfer system (BioRad) ...
-
bioRxiv - Microbiology 2023Quote: ... Membranes were stained with primary antibody in blocking buffer at 4°C overnight: anti-NP (1:5000, OBT1555, Bio-Rad), anti-PA ...
-
bioRxiv - Neuroscience 2023Quote: ... using pre-treated (95°C for 10 min to reduce adherence) PCR tubes and optical flat caps (Bio-rad, Belgium). The final reaction volume was 20 µL (10 µM of miniMeCP2 or 20 µM of miniMeCP2T158M) ...
-
bioRxiv - Microbiology 2024Quote: Protein samples were incubated at 95°C for 10 minutes before being resolved on TGX Stain-free gels (Bio-Rad). The proteins were transferred onto 0.2 μm nitrocellulose membranes using Trans-Blot Turbo Transfer (Bio-Rad) ...
-
bioRxiv - Neuroscience 2022Quote: ... Regional lysates were centrifuged at 21,000 x g for 20 minutes at 4 °C and the supernatant was removed and suspended in 4X laemmli buffer (BioRad) with 2-mercaptaethanol (BioRad ...
-
bioRxiv - Synthetic Biology 2022Quote: ... All reagents except the double-stranded beacon were first assembled in a total volume of 9 μL and run at 37 °C in a CFX96 real-time PCR detection system (Biorad). Both WT SpCas9 and SpCas9-NG are highly active at this temperature ...
-
bioRxiv - Molecular Biology 2022Quote: ... The reaction mixtures were held at 10°C until the PCR tubes were removed from the thermocycler (C1000 Touch, BioRad). After ...
-
bioRxiv - Molecular Biology 2022Quote: ... The plates were incubated at 30°C and pictures were taken with the setting “Blots: Colorimetric” using a ChemiDoc (BioRAD).
-
bioRxiv - Cell Biology 2022Quote: ... PIK3CA c.1633G>A (p.E545K) and PIK3CA c.1624G>A (p.E542K) point mutations were performed on the QX200 ddPCR system (Bio-Rad Laboratories) by using PrimePCR ddPCR Mutation assays according to manufacturer’s instructions (Bio-Rad Laboratories) ...
-
bioRxiv - Developmental Biology 2022Quote: ... Protein lysates in Laemmli buffer were separated by electrophoresis on 12% SDS-PAGE gels and transferred for 2 hours at 4°C on to a PVDF membrane (BioRad). After blocking for an hour in 5% dry milk ...
-
bioRxiv - Biochemistry 2024Quote: ... The samples were heated from 35 °C to 79°C at a rate of 0.3 °C per 15 s in a CFX96 Touch Real-Time PCR Detection System (Bio-Rad). Fluorescence intensity was determined using excitation (λem=525/20 nm ...
-
bioRxiv - Bioengineering 2024Quote: ... The proteins were incubated for one hour at 65 and 70°C in a thermocycler with heated lid (T100, BioRad) Binding to D25 and MPE8 antibodies was measured afterwards following the protocol described above.
-
bioRxiv - Bioengineering 2024Quote: ... Samples in 8-well tubes were heat-shocked for three minutes at 72 °C (C1000 Touch Thermal Cycler, Bio-Rad), placed on wet ice for two minutes ...
-
bioRxiv - Cell Biology 2024Quote: ... eluate was incubated at 70 °C then run on 4-12% NuPAGE gell and transferred to LF PVDF membrane (BioRad). Western-blot analysis were done with the next antibodies ...
-
bioRxiv - Physiology 2023Quote: ... Protein extracts were denatured at 95 °C for 10 min and separated on 10% SDS-PAGE gels (1610156, Bio-Rad) at 80 V for ∼40 min followed by 110 V for ∼70 min ...
-
bioRxiv - Microbiology 2024Quote: ... 7.5 mg of proteins was diluted in ChIP buffer supplemented with 0.01% SDS and precleared for 1 hr at 4°C with 50 μl of SureBeads Protein A Magnetic Beads (BioRad) and 100 μg bovine serum albumin (BSA) ...
-
bioRxiv - Molecular Biology 2024Quote: ... 95 °C) and 1.25 µg sample was resolved on a 4-12% acrylamide Criterion XT Bis-Tris gel (Bio-Rad) in MOPS buffer at 100 V for 20 min and subsequently at 150V for 190 min on ice along with PageRuler™ Plus Prestained Protein Ladder (Thermo Scientific ...
-
bioRxiv - Molecular Biology 2024Quote: ... 0.01% bromophenol blue) and denaturated 5 min at 95°C before protein separation by SDS–PAGE on 4-15% precast gels (Biorad).
-
bioRxiv - Microbiology 2024Quote: ... the samples were boiled at 95°C for 10 minutes and resolved on a TGX stain-free gel (Bio-Rad) for SDS-PAGE analysis ...
-
bioRxiv - Molecular Biology 2024Quote: ... and heat denatured at 95°C for 10 min before loading onto a 4-15% Tris-glycine gel (Bio-Rad) and electrophoresed at 125 V ...
-
bioRxiv - Neuroscience 2024Quote: ... Samples were denatured for 10 minutes at 70°C and proteins were separated (55min, 200V) on a Midi 4-12% Bis-Tris gel (BioRad) in 1x MOPS buffer (BioRad ...
-
bioRxiv - Microbiology 2023Quote: ... cells and plasmids in 10% glycerol were first heat-shocked at 56°C for 2 min followed by immediate electroporation in 0.1-cm cuvette (Bio-Rad) using electroporation program of 2.5 kV and time constant of 2.3-2.5 ms on the Bio-Rad Micropulser ...
-
bioRxiv - Immunology 2024Quote: 96-well flat-bottom NUNC Maxisorp plates were coated overnight at 4 °C with 0.5 mg/mL recombinant HBsAg (BIO-RAD). Plates were washed with PBS/T ...
-
bioRxiv - Genetics 2024Quote: ... chromosomal DNA was prepared in 1.3% of low-melting point agarose plugs as described in 74 and run at 14 °C with 1X TBE buffer in a CHEF DR-III apparatus (BioRad) using the field 6V/cm at a 120°angle for 48 h ...
-
bioRxiv - Biochemistry 2024Quote: ... denatured for 10 min at 96°C before it was separated at a 4-20 % PROTEAN TGX stain-free gel (BioRad) at 200 V for 30 min ...
-
bioRxiv - Cell Biology 2023Quote: ... and boiled for 5 min at 95 C and loaded onto an or 4-20% TGX stain-free polyacrylamide gels (Biorad), followed by standard western blotting procedures ...
-
bioRxiv - Plant Biology 2023Quote: ... Linearized plasmid was mixed with 250 μL of cells at 15°C in a 0.4 cm gap electroporation cuvette and transformed immediately by electroporation using a Gene Pulser II (Bio-Rad) set to 800V and 25 μF ...
-
bioRxiv - Neuroscience 2023Quote: ... The samples were eluted by heating at 100°C for 5 min in Laemmli sample loading buffer (Bio-Rad, USA), and resolved on an SDS/PAGE ...
-
bioRxiv - Molecular Biology 2024Quote: ... DNA was then eluted and reverse-crosslinked by incubating the beads at 95°C for 10 min in presence of 100 µl of 10 % Chelex resin (BioRad), treated with Proteinase K (Roche ...
-
bioRxiv - Neuroscience 2023Quote: ... The samples adjusted to contain equal amounts of protein (10 μg or 12 μg) were next denatured (5 min at 95°C) in loading buffer (#1610747, BioRad) and run on 10% TGX (#4561034 ...
-
bioRxiv - Microbiology 2023Quote: Protein samples were centrifuged (150,000 × g for 10 min at 4°C) and loaded onto an Enrich SEC 650 10 × 300 column (Bio-Rad) using the AKTA explore system (GE Healthcare ...
-
bioRxiv - Microbiology 2023Quote: ... the plates were developed at 100 °C for 20 min and further analyzed with the ChemiDoc-System (Bio-Rad, USA).
-
bioRxiv - Molecular Biology 2023Quote: ... Samples were boiled 5min at 90°C and 10µl was loaded on a 4-20% gradient SDS-PAGE gel (Biorad #4561096). Gel was stained with Coomassie brilliant blue R.
-
bioRxiv - Biochemistry 2023Quote: ... Samples were boiled at 95 °C for 5 minutes and separated on precast 4-20% Criterion TGX gels (Bio-Rad). The competition of IA-rhodamine was analyzed by in-gel fluorescent signal using a ChemiDoc MP (Bio-Rad) ...
-
bioRxiv - Bioengineering 2023Quote: ... and the supernatant was incubated at 95°C for 10 minutes in the presence of Laemmli sample buffer (Bio-Rad). Proteins (20 μg per sample ...
-
bioRxiv - Cell Biology 2023Quote: ... and boiled for 5 min at 95 C and loaded onto an or 4-20% TGX stain-free polyacrylamide gels (Biorad), followed by standard western blotting procedures ...
-
bioRxiv - Molecular Biology 2023Quote: ... Lysates were boiled at 95 °C for 5 min before being loaded onto a polyacrylamide gel (Cat# 4561094, Bio-Rad). Proteins were blotted onto a PVDF membrane (Bio-Rad ...
-
bioRxiv - Microbiology 2023Quote: ... All samples collected were heated to 95°C for 5 minutes before resolving on a 12% mini-PROTEAN precast gel (BioRad). A Western blot using polyclonal EssR antiserum was conducted following the protocol outlined in the Western blot method section below ...