Labshake search
Citations for Biotek :
201 - 250 of 472 citations for Human Procollagen II C Terminal Propeptide PIICP CLIA Kit since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Microbiology 2022Quote: All bacteria were incubated anaerobically in the 24-well plate at 37°C for 3 hours in an Epoch 2 Microplate Spectrophotometer (BioTek), with optical density measured at 600 nm (OD600) ...
-
bioRxiv - Bioengineering 2022Quote: ... was measured at room temperature (25 °C) in opaque black half-well plates on a Synergy H1 microplate reader (BioTek) with a filter cube (emission ...
-
bioRxiv - Microbiology 2022Quote: ... Growth following phage infection was measured in 24-well plates at 15 min intervals with orbital shaking at 37 °C on a plate reader (Biotek). Data points reported are the mean of two technical replicates each for three independent growth curve experiments.
-
bioRxiv - Microbiology 2022Quote: ... Growth was then measured in 24-well plates at 15 min intervals with orbital shaking at 37 °C on a plate reader (Biotek). Data reported are the mean of three technical replicates each of four independent growth curve experiments.
-
bioRxiv - Immunology 2022Quote: ... PI fluorescence was measured at Ex/Em: 535/617 nm at 37°C every 5 min using Cytation 5 Cell Imaging Multi-Mode Reader (BioTek). The obtained measurements were baseline corrected to DMSO at each timepoint and was presented as Ftreatment - FDMSO ...
-
bioRxiv - Microbiology 2022Quote: ... at 30°C and the bioluminescence from prey cells was quantified over time using a Synergy Neo2 plate reader (Biotek). Under these assay conditions ...
-
bioRxiv - Microbiology 2022Quote: ... Anaerobic growth was monitored by measuring absorbance (OD600) every 10 min for 24 h at 37 °C using a Cytation 3 plate reader (BioTek).
-
bioRxiv - Microbiology 2022Quote: ... 355/460 nm for ACC substrates) was measured every minute for 30 min at 37 °C on a Cytation 3 plate reader (BioTek). Initial velocities were quantified by calculating the slope of the linear phase of the reaction as relative fluorescent units (RFUs ...
-
bioRxiv - Plant Biology 2022Quote: ... The plate was sealed with parafilm and incubated at 37°C for 30 min and OD620 was measured using a Synergy H1 microplate reader (BioTek).
-
bioRxiv - Microbiology 2022Quote: ... The mixtures were incubated at 37°C before measurement of fluorescence with the Synergy H1 Microplate Reader (BioTek, Winooski, VT). The readout was performed after 6 hours for Mtb ...
-
bioRxiv - Biophysics 2022Quote: ... the plate was transferred to a prewarmed (37 °C) and 5 % CO2 Cytation V plate reader (BioTeK, Winooski, United States) and incubated for another 10 mins ...
-
bioRxiv - Pathology 2023Quote: ... The assay was performed at 37°C in 96-well format and the fluorescence recorded using Synergy H1 plate reader (BioTek). Mir05 buffer with 1 mM malate ...
-
bioRxiv - Systems Biology 2023Quote: ... 30 °C and 70% humidity using a gas-permeable film (114 µm AeraSeal Film, Omega Biotek, Cat. No. AC1201-02). For shake flask experiments ...
-
bioRxiv - Neuroscience 2023Quote: ... Equal volume of Griess reagent and supernatant from different regions of brain homogenate were incubated at 37 °C for 30 min followed by absorbance reading at 542 nm wavelengths spectrophotometrically in ELISA reader (Biotek). It was expressed as μg/mg protein.
-
bioRxiv - Microbiology 2023Quote: ... The microtiter plates were incubated at 37°C and OD600 was measured every 10 minutes using Synergy H1 Hybrid Reader (BioTek) or Hidex Sense (Hidex Oy) ...
-
bioRxiv - Cell Biology 2023Quote: ... The absorbance at 360 nm was measured every 1 min over 45 min at 37°C by using a microplate reader (Synergy H1; BioTek). The detailed protocol was deposited in protocols.io (DOI ...
-
bioRxiv - Pharmacology and Toxicology 2023Quote: ... Fluorescence intensity was measured every 42 seconds for a duration of 1 hour at 37°C with a plate reader (Synergy 2, Biotek) (Temperature 37°C ...
-
bioRxiv - Microbiology 2023Quote: ... The plate was incubated at 37 °C with continuous double orbital shaking for 16 hours in a Synergy Neo (Biotek) plate reader ...
-
bioRxiv - Molecular Biology 2023Quote: ... The culture was grown at 37 °C with continuous shaking and OD600 was measured for 16 h in Synergy Neo2 plate reader (BioTek). All readings were blank corrected ...
-
bioRxiv - Microbiology 2023Quote: ... The microtiter plates were incubated at 37°C and OD600 was measured every 10 minutes using Synergy H1 Hybrid Reader (BioTek) or Hidex Sense (Hidex Oy) ...
-
bioRxiv - Microbiology 2023Quote: ... bacterial cultures were incubated 24 h at 37°C in a plate reader (Synergy HTX Multi-Mode Reader; BioTek Instruments). During incubation ...
-
bioRxiv - Biochemistry 2022Quote: ... Cytotoxicity was evaluated with PrestoBlue Viability Reagent by incubating with cells at 37 °C for 15 minutes and reading fluorescence with excitation 550nm and emission 600nm using a Cytation 5 Plate Reader (BioTek). Luciferase activity was then measured with the Dual-Luciferase Reporter Assay System (Promega ...
-
bioRxiv - Biochemistry 2022Quote: ... Cultures were grown at 37° C with shaking and OD600 was monitored for each strain using a plate reader (BioTek). At least three biological replicates were conducted and plotted using Prism (GraphPad).
-
bioRxiv - Bioengineering 2023Quote: ... and incubation was carried out for 2 hours at 37 °C before the fluorescence signal (Ex/Em = 530/590) was measured with a Synergy H1 microplate reader (Biotek). Fluorescence intensity values were corrected for the background control (culture medium with resazurin).
-
bioRxiv - Genetics 2023Quote: ... Cultures containing luciferin were then incubated at 37°C for 30 minutes before measured using SYNERGY H1 microplate reader (BioTek). Each sample was measured three times (1 second/read ...
-
bioRxiv - Microbiology 2022Quote: ... Luminescence was measured at 1-hour intervals for 30 to 72 hours at a constant temperature of 25°C using a Synergy Mx microplate reader (Biotek).
-
bioRxiv - Microbiology 2023Quote: ... Bacterial growth was monitored during incubation at 30°C in microtiter plates in an Epoch 2 or Synergy H1M plate reader (Biotek).
-
bioRxiv - Microbiology 2023Quote: ... The OD600 was measured at 37°C every 3 minutes for 1 hour with continuous linear shaking in a Synergy H1 microplate reader (Biotek). All germinant stocks solutions were solubilized in water and filter sterilized ...
-
bioRxiv - Biochemistry 2022Quote: ... Fluorescence was measured at regular intervals at 37 °C with excitation 485nm and emission 530nm using a Synergy H1 plate reader (BioTek). Initial rates were normalized to no inhibitor control to calculate percent activity and IC50 values were obtained using [inhibitor] vs ...
-
bioRxiv - Biophysics 2023Quote: All absorption and emission measurements for both labeled A2AAR and Rec were carried out at 25 °C on a Synergy H4 (Agilent BioTek) plate reader with Take3 Microvolume Plates ...
-
bioRxiv - Microbiology 2023Quote: ... was measured after 22 h of incubation at 37 °C with strong orbital shaking every 10 min in a Synergy HTX (BioTek) plate reader to determine MIC values ...
-
bioRxiv - Microbiology 2023Quote: ... Plates were incubated at 37°C for 24h and color formation was measured every 15 min using an ELx808 Microplate Reader and Gen5 software (BioTek).
-
bioRxiv - Microbiology 2023Quote: ... The growth plate was incubated for 10 h at 30°C and fast-orbital shaking inside a Synergy H1 plate reader (BioTek). After growth ...
-
bioRxiv - Physiology 2023Quote: ... FAS activity was measured as the oxidation of NADPH at 340 nm and 37 °C using a UV/VIS spectrophotometer (Synergy H1 Multimode Reader, BioTek). A background correction was made for the oxidation of NADPH in the absence of malonyl-CoA ...
-
bioRxiv - Systems Biology 2023Quote: ... The 96-well plate was incubated at 37°C with shaking at 567 rpm in a microplate reader (Epoch2, BioTek). Cell growth was monitored at an optical density of 600 nm (OD600) ...
-
bioRxiv - Molecular Biology 2023Quote: Fluorescence polarization experiments were carried out at 25 °C in PBS supplemented by 2 mM TCEP and 0.05% Brij using a Synergy H4 (BioTek Instruments) plate reader ...
-
bioRxiv - Microbiology 2023Quote: ... The plate was shaken continuously (frequency 567 cpm (3mm)) at 30°C for 16 h in a Synergy H1m microplate reader (Biotek). Optical density measurements at 660 nm were taken every 20 minutes ...
-
bioRxiv - Microbiology 2023Quote: ... The plate was incubated at 37°C for 24 h with shaking and analyzed with a microtiter plate spectrophotometer (BioTek), measuring the OD600 nm at 30 min intervals ...
-
bioRxiv - Microbiology 2023Quote: ... The absorbance at λ420nm was measured every minute for 1-2 h to follow the kinetics of ONPG hydrolysis at 28 °C in a Synergy H1 plate reader (BioTek). The velocity of the reaction was calculated by performing linear regression using GraphPad Prism software ...
-
bioRxiv - Microbiology 2023Quote: ... supernatant or size exclusion purified vesicles were extracted with butanol (1:2) overnight at 4°C and the butanol fraction transferred to microtiter plates for absorbance measurement (Synergy, Biotek).
-
bioRxiv - Microbiology 2023Quote: ... Culture plates were incubated at 37°C for 22 hrs and kept anaerobic during the OD600 measurement in a Synergy 2 Plate Reader (Biotek Agilent Technologies Deutschland GmbH ...
-
bioRxiv - Microbiology 2023Quote: ... Cells were cultured shaking overnight at 37 °C and OD600 measured the following morning by plate reader (BioTek Synergy Neo2). Background was subtracted from each well and then each well was normalized to the OD600 of the well without drug to calculate relative growth ...
-
bioRxiv - Microbiology 2023Quote: ... The plate was incubated at 37°C with continuous double orbital shaking for 16 hours in a Synergy Neo (Biotek) plate reader ...
-
bioRxiv - Bioengineering 2023Quote: ... and grown for 32 h at 30 °C with their lids on and continuous shaking in a Cytation 5 microplate reader (BioTek). High-resolution growth curves were generated from Attenuance (D600 nm ...
-
bioRxiv - Microbiology 2024Quote: ... was monitored for up to 24 hr at 37 °C under shaking conditions using Synergy H1 (BioTek Instruments, Inc. VT) plate reader ...
-
bioRxiv - Microbiology 2023Quote: ... Plates were grown at 37°C with shaking for 18 hours and OD600 was monitored (BioTek Synergy H1, BioTek Eon). Each experiment was performed with biological triplicate or higher as indicated ...
-
bioRxiv - Microbiology 2023Quote: ... Plates were grown at 37°C with shaking for 18 hours and OD600 was monitored (BioTek Synergy H1, BioTek Eon). Each experiment was performed with biological triplicate or higher as indicated ...
-
bioRxiv - Microbiology 2024Quote: ... was added to start the sialidase reaction and fluorescence 330/440 nm was measured while incubating at 37 °C with shaking in a plate reader (Biotek).
-
bioRxiv - Microbiology 2024Quote: ... The plate was sealed with a gas permeable seal (Azenta Life Sciences 4ti-0516/96*) and incubated at 37°C and 237 cpm for indicated times in a Synergy H1 plate reader (Agilent BioTek). OD600nm was measured every 10 min ...
-
bioRxiv - Plant Biology 2020Quote: ... All enzyme assays were performed in a final volume of 0.2 mL in a 96-well microplate at 25 °C (PowerWave HT microplate spectrophotometer; BioTek, Vermont, USA). Samples and blanks were analyzed in triplicate ...