Labshake search
Citations for Biotek :
1 - 50 of 472 citations for Human Procollagen II C Terminal Propeptide PIICP CLIA Kit since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
ANGPTL8 R59W variant influences inflammation through modulating NF-κB pathway under TNFα stimulationbioRxiv - Biochemistry 2023Quote: ... The cell lysates were mixed with Luciferase reagent II (supplied in the kit) and was measured on Synergy Hybrid H4 plate reader (BioTek, Winooski, VT) and normalized according to protein concentration ...
-
bioRxiv - Cancer Biology 2020Quote: ... Magnetic cell sorting was performed to separate purified human versus mouse cell fractions using the Mouse Cell Depletion Kit (Miltenyi Biotek, 130-104-694). For the proteomic experiments ...
-
bioRxiv - Microbiology 2022Quote: ... and growth was measured at OD600 in 30 min intervals at either 37°C or 42°C in an Epoch2 plate reader (BioTek).
-
bioRxiv - Microbiology 2020Quote: ... and plates were incubated at static position in 30°C or 37°C for 24 hours in Synergy™ plate reader (BioTek) with the color change due to metabolic activity measured as 550 nm absorbance readings taken every 15 minutes ...
-
bioRxiv - Microbiology 2022Quote: ... followed by removal of the supernatant and storage of the precipitate at -80°C until DNA extraction using Omega Soil DNA kit (Omega BioTek, cat. no. D5625-01, Norcross GA) following the manufacturer’s protocol ...
-
bioRxiv - Microbiology 2022Quote: ... pH 7.2 at 30 °C) prewarmed to 30 °C and the absorbance at 340 nm was measured immediately using a microplate reader (SynergyMx, BioTek, VT, USA) for 1 h ...
-
bioRxiv - Microbiology 2023Quote: ... The resulting 1,472 SICs were arranged in 16 96-well plates and incubated in the anaerobic chamber at 37 °C (by setting the temperature of the chamber to 37 °C) in a plate stacker (BioTek BioStack 4) with 2 control plates containing uninoculated media at the top and bottom of the stack to minimize edge effects ...
-
bioRxiv - Microbiology 2020Quote: ... and plates were incubated at stationary position in 30°C or 37°C for 24 hours in Synergy™ plate reader (BioTek, Winooski, VT, USA) with 550 and 600 nm absorbance readings taken every 15 minutes.
-
bioRxiv - Cell Biology 2022Quote: ... and luminescence read by Epoch II plate reader and Gen5 software (BioTek Instruments; Winooski, VT).
-
bioRxiv - Cell Biology 2021Quote: ... Luciferase levels were determined using a plate reader with an injector setup (BioTek Synergy II) that allowed samples to be read directly after substrate injection ...
-
bioRxiv - Neuroscience 2019Quote: ... MitoSox fluorescence intensity was measured using the kinetic mode of a microplate reader (BioTek Synergy II), which took serial measurements of MitoSox fluorescence over time ...
-
bioRxiv - Immunology 2020Quote: ... The luminescence intensity read under the Synergy II multi-mode reader with Gen5TM software (BioTek; VT, USA) and the percentage cytotoxicity (% cytotoxicity ...
-
bioRxiv - Biochemistry 2022Quote: ... loaded into the pre- warmed 37°C plate reader (Biotek Synergy H4), and equilibrated for five minutes ...
-
bioRxiv - Cancer Biology 2021Quote: ... The measurements were performed at 25 °C on a Synergy NEO (BioTek) microplate reader using an optical module with an excitation filter at 485 nm (slit 20 nm) ...
-
bioRxiv - Cell Biology 2023Quote: ... The OD600 was continuously monitored at 30 °C using Citation 5 (Biotek) every 20 min with constant shaking ...
-
bioRxiv - Immunology 2020Quote: ... Luminescence was detected at 37°C in a Synergy Mx plate reader (Biotek) using two filters for emission at 485 ± 20 nm and 528 ± 20 nm ...
-
bioRxiv - Biophysics 2022Quote: ... Measurements were performed at 25°C on a Synergy H1 microplate reader (BioTek) using the polarization filter setting (excitation 485 nm ...
-
bioRxiv - Microbiology 2020Quote: ... and grown without lids at 37 °C in Synergy H1 plate readers (BioTek) with double-orbital shaking at 425 rpm and a 3 mm orbit and readings taken every 15 minutes (OD600 with 100 ms delay and 8 measurements per data point) ...
-
bioRxiv - Biophysics 2021Quote: ... and 7.5 mM glucose) at 35°C using SynergyH1 plate reader (Biotek, USA). L-012 (100 μM ...
-
bioRxiv - Genomics 2021Quote: ... with linear shaking at 30°C in a Synergy H1 plate reader (Biotek), by diluting each well to maintain OD<0.7 ...
-
bioRxiv - Microbiology 2023Quote: ... The plates were incubated at 37°C in an Epoch2 microplate spectrophotometer (Biotek) for OD600 measurements every 10 min for 24h ...
-
bioRxiv - Evolutionary Biology 2023Quote: ... and grown at 28°C in an Epoch 2 Microplate Spectrophotometer (Agilent BioTek). Absorbance at 600nm (OD600 ...
-
bioRxiv - Biochemistry 2023Quote: ... at 25°C in a Synergy H4 Hybrid Multi-Mode Microplate Reader (BioTek) and converted to anisotropy values ...
-
bioRxiv - Evolutionary Biology 2023Quote: ... The microplate was incubated at 37°C in a plate reader (EPOCH2, BioTek), shaking at 567 cpm (cycles per minute ...
-
bioRxiv - Biochemistry 2024Quote: ... at 25°C in a Synergy H4 Hybrid Multi-Mode Microplate Reader (BioTek) and converted to anisotropy values ...
-
bioRxiv - Cell Biology 2024Quote: ... measurement was performed at 37°C using a Synergy Neo2 Plate Reader (Biotek) using a CFP/YFP FRET filter set ...
-
Neutralizing gut-derived lipopolysaccharide as a novel therapeutic strategy for severe leptospirosisbioRxiv - Microbiology 2024Quote: ... The samples were analyzed with a fluorescence spectrophotometer (Synergy II plate reader with Gen5 software; BioTek Instruments, Winooski, VT) [21].
-
bioRxiv - Microbiology 2021Quote: ... Plates were incubated at 37°C in a preheated Epoch 2 Microplate Spectrophotometer (BioTek) under linear shaking (1 mm ...
-
bioRxiv - Cell Biology 2020Quote: ... The cultures were incubated (30 °C, 1140 rpm) in an Epoch2 plate reader (BioTek) in a sterile 96 well polystyrene round bottom microwell plate (Thermo ...
-
bioRxiv - Immunology 2022Quote: ... for 15 minutes at 37°C and imaged using a Cytation imaging reader (BioTek). Measurements from the assay were then normalized to cell number ...
-
bioRxiv - Immunology 2020Quote: ... Lung and trachea tissue were dissociated in C tubes by the GentleMACS (Miltenyi Biotek) using the Lung01.02 program ...
-
bioRxiv - Microbiology 2021Quote: ... and incubated at 37 °C with shaking in a microtiter plate reader (Epoch2, Biotek). The resulting growth curve data was analysed using Matlab (version R2019b ...
-
bioRxiv - Microbiology 2021Quote: ... at 37’C shaking at medium speed in a microplate reader (Biotek Synergy 2). Bacterial density (OD600 ...
-
bioRxiv - Microbiology 2022Quote: ... Cultures were incubated at 37°C with shaking in a microplate reader (BioTek Instruments) and absorbance at 600 nm was measured every 15 min ...
-
bioRxiv - Synthetic Biology 2023Quote: ... The culture was incubated at 30°C in a microplate reader (EPOCH 2, BioTek) in the presence of 10% CO2 in the atmosphere ...
-
bioRxiv - Biophysics 2023Quote: ... at 37°C in a Synergy HTX Multi-Mode Microplate Reader (BioTek, Winooski, VT) with excitation and emission wavelengths of 360 and 460 nm ...
-
A neural-mechanistic hybrid approach improving the predictive power of genome-scale metabolic modelsbioRxiv - Systems Biology 2023Quote: ... The temperature was set to 37°C in a plate reader (BioTek HTX Synergy), with continuous orbital shaking at maximum speed ...
-
bioRxiv - Microbiology 2023Quote: ... Experiments were carried out at 37 °C in a Synergy Neo2 plate reader (BioTek). We measured both the time until one doubling was achieved following exposure and the steady-state growth rate after recovery ...
-
bioRxiv - Biochemistry 2023Quote: ... microtiter plates were incubated at 30°C for 24h in a microplate reader (BioTek). Optical density measurements were recorded on 20-minute intervals to create a growth curve ...
-
bioRxiv - Microbiology 2023Quote: ... incubated at 30 °C and 548 rpm using a Synergy HTX plate reader (Biotek). The above conditions were used unless otherwise noted.
-
bioRxiv - Microbiology 2024Quote: ... Cultures were grown at 37 °C with orbital shaking on a plate reader (Biotek) for 6 hours ...
-
bioRxiv - Genetics 2020Quote: ... The plates were incubated (30°C with shaking) in a Synergy H1 microplate reader (BioTek), which recorded OD660 measurements at 15-min intervals for 24 h ...
-
bioRxiv - Bioengineering 2021Quote: ... All the reactions were incubated at 29 °C in a Synergy HTX plate reader (BioTek).
-
bioRxiv - Microbiology 2022Quote: ... Plates were grown at 37°C with shaking in a Synergy H1 plate reader (Biotek), and A600nm and GFP fluorescence was measured every 10 mins ...
-
bioRxiv - Synthetic Biology 2022Quote: ... and the reaction was carried out at 37°C in a plate reader (Biotek; Cytation3) to measure fluorescence over time ...
-
bioRxiv - Microbiology 2023Quote: ... and BAC was assessed after 36 hours at 30 °C (plate reader Biotek Epoch 2). The MIC was defined as the lowest concentration inhibiting liquid culture growth ...
-
bioRxiv - Microbiology 2023Quote: ... Plates were incubated at 37 °C with shaking between reads on a Synergy HTX (BioTek) plate reader and optical density was measured every 15 minutes ...
-
bioRxiv - Biochemistry 2023Quote: ... Data was acquired at 30°C in a Synergy Neo2 Multi-Mode Plate Reader (Biotek) by following the changes in fluorescence polarization ...
-
bioRxiv - Microbiology 2023Quote: ... The plate was shaken continuously at 30°C in a Synergy H1m microplate reader (Biotek) and optical density measurements at 600 nm were taken every 20 minutes ...
-
bioRxiv - Genetics 2019Quote: ... kit (Omega Biotek) according to manufacturer’s protocol ...