Labshake search
Citations for Biotek :
551 - 600 of 868 citations for Recombinant Human H1 Histone Family Member 0 His tagged since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Pharmacology and Toxicology 2021Quote: ... Cells were rinsed with PBS containing Mg2+ and Ca2+ and the fluorescence was measured with a Synergy H1 (Biotek) fluorescence plate reader (excitation wavelength ...
-
bioRxiv - Cancer Biology 2020Quote: ... San Diego) mounted on ViaFlo 384 (Integra) and fluorescence emission was scanned immediately using microplate reader Synergy H1 (Biotek).
-
bioRxiv - Cancer Biology 2020Quote: ... cells were washed again with PBS and then plates were read in Synergy H1 Hybrid microplate reader from BioTek at excitation of 510 nm and emission of 595 nm.
-
bioRxiv - Biochemistry 2022Quote: ... Steady-state kinetics of Pi release from ATP hydrolysis was measured using a Synergy H1 microplate reader (BioTek Instruments) at 360 nm ...
-
bioRxiv - Evolutionary Biology 2022Quote: ... the reaction was initialized with the addition of ribulose 1,5-bisphosphate (RuBP) (0.5 mM) and the absorbance at 340 nm was recorded using a Synergy H1 plate reader (BioTek). RuBisCO activity was reported as the RuBP consumption rate normalized to total soluble protein content ...
-
bioRxiv - Synthetic Biology 2019Quote: ... Fluorescence (FL) and optical density (OD) at 600 nm were then measured using a Synergy H1 plate reader (Biotek). The following settings were used ...
-
bioRxiv - Cancer Biology 2019Quote: ... The optical density (OD) was determined at 490 mm wavelength using a Synergy H1 plate reader (BioTek, Winooski, USA).
-
bioRxiv - Microbiology 2019Quote: ... the green and red fluorescence intensity was determined for each sample using a Synergy H1 microplate reader by BioTek Instruments (VT ...
-
bioRxiv - Bioengineering 2019Quote: ... and the optical density was measured at 540 nm using a plate reader (Synergy H1™, Biotek, Winooski, VT).
-
bioRxiv - Genetics 2020Quote: ... Hemoglobin concentration was determined by adding 100 μL of Drabkin’s reagent (Ricca Chemical) to each well and measuring absorbance at OD540nm with a Synergy H1 plate reader (Biotek). Relative lysis was determined by normalizing to the maximum hemoglobin concentration in the 14-tube series for each sample ...
-
bioRxiv - Systems Biology 2021Quote: ... 1 mM Dithiothreitol) at 30°C in 100 μl reaction volume using a Synergy H1 plate reader from BioTek, using Corning 3881 96-well half-area clear-bottom non-binding surface plates ...
-
bioRxiv - Microbiology 2021Quote: ... the absorbance in each well was measured at 550 nm using a Synergy H1 microplate reader (Biotek, Winooski, VT). Negative control wells contained 200 μL of BHI broth supplemented with 0.25% glucose and no bacteria.
-
bioRxiv - Microbiology 2019Quote: ... Reactive oxygen species production was monitored by luminescence over 30-40 minutes in a microplate reader (Synergy H1, BioTek). At least 3 plants per construct/genotype were used in each experiment ...
-
bioRxiv - Microbiology 2020Quote: ... Luminescence and OD600 was measured over 6 h in 15 min intervals using a Synergy H1 microplate reader (BioTek). Relative light units (RLU ...
-
bioRxiv - Neuroscience 2021Quote: ... The LDH released was determined by measuring the absorbance of the samples with a Synergy H1 microplate reader (BioTek) at 450 nm.
-
bioRxiv - Evolutionary Biology 2022Quote: ... growth and fluorescence measurements were performed in the overnight plates using a Biotek H1 plate reader (Biotek, Vinooski, Vermont). Thus ...
-
bioRxiv - Microbiology 2022Quote: ... or 45°C/237 rpm (double orbital) for 20 h on a Biotek Synergy H1 microplate reader (Biotek, USA). The optical density at 600 nm (OD600 ...
-
bioRxiv - Molecular Biology 2022Quote: ... production catalyzed by SARM1 was measured after adding the reaction reagents containing 50 μM PC6 and 100 μM NAD in 50 mM Tris-HCl (pH 7.5) on a Synergy H1 Hybird Reader (BioTek). The initial rate (RFU/min ...
-
bioRxiv - Plant Biology 2022Quote: ... Measurements for each fraction were done in triplicate using a Synergy H1 Hybrid Multi-Mode Microplate Reader (Biotek, USA). All cell wall fractions were diluted to the same total sugar concentration for the glycomic experiments ...
-
bioRxiv - Microbiology 2023Quote: ... We measured the OD600 of the resuspended biofilms and their light emission using the Synergy H1 plate reader (BioTek). The RLU are calculated as arbitrary luminescence units per ml divided by OD600 of the biofilm samples ...
-
bioRxiv - Synthetic Biology 2023Quote: ... Plates were incubated at 37 °C with double-orbital shaking (Synergy H1 microplate reader, Biotek, running Gen5 3.04 software). Fluorescence was determined after 16 h with 479 nm excitation and 520 nm emission for GFP and 588 nm excitation and 633 nm emission for mKate2 ...
-
bioRxiv - Microbiology 2023Quote: ... Cell membrane fluidity was measured by polarizing spectrofluorometry using a BioTek Synergy H1 plate reader (BioTek Instruments, Winooski, VT) with the fluorescent probe ...
-
bioRxiv - Bioengineering 2023Quote: ... and placed into a monochromator-based plate reader heated to 40℃: Synergy H1 Microplate Reader (BioTek Instruments, cat# 8041000), reading every 20 seconds at excitation/emission ...
-
bioRxiv - Immunology 2023Quote: ... the reaction stopped with 1 M HCl and the plates analyzed using a Synergy H1 microplate reader (BioTek Instruments) at 450 nm ...
-
bioRxiv - Plant Biology 2023Quote: ... and then absorption was measured at 550 and 800 nM using a Synergy H1 microplate reader (BioTek Instruments, Inc). The data was exported to an Excel spreadsheet with Gen5 software version 2.01.14 (BioTek Instruments ...
-
bioRxiv - Microbiology 2023Quote: ... the HRP reaction was stopped by adding 50 μl of 0.5 M H2SO4 and optical density at 450 nm was measured using Synergy|H1 microplate reader (BioTek). Binding to 1059 SOSIP open conformation was measured in a similar manner ...
-
bioRxiv - Evolutionary Biology 2023Quote: ... with an excitation wavelength of 388 nm and an emission bandpass filter of 430-550 nm (Biotek, Synergy H1).
-
bioRxiv - Cancer Biology 2023Quote: ... or using click beetle green luciferase expressing cells and read on a BioTek Synergy H1 plate reader (BioTek Instruments). The percent cytotoxicity was calculated via manufacturer instructions as (experimental - effector spontaneous - target spontaneous)/(target maximum - target spontaneous ...
-
bioRxiv - Bioengineering 2024Quote: ... Lysed samples were read for relative luminescence units (RLU) using a Synergy H1 plate reader (BioTek, Winooski, VT, USA) that automatically injected luciferin solution consisting of the following ...
-
bioRxiv - Physiology 2024Quote: ... Total RNA was then purified according to the manufacturer’s instructions and quantified by absorbance on a BioTek Synergy H1 microplate reader (Biotek). Depending on the amount of RNA obtained ...
-
bioRxiv - Microbiology 2024Quote: ... The plate was incubated at 37 °C with orbital shaking in a Synergy H1 plate reader (BioTek Instruments, Inc,) and OD600nm and luminescence was measured every 6 minutes ...
-
bioRxiv - Microbiology 2023Quote: ... alongside a nitrite standard curve (0-36mM) and absorbance was acquired at 540nm (BioTek, Vermont, USA).
-
bioRxiv - Biophysics 2020Quote: ... Absorbance of each sample and ITO control were measured in a 96-well plate with Synergy H1 microplate reader (BioTek). Relative absorbance of biointerface samples to ITO was calculated to determine relative biocompatibility.
-
bioRxiv - Cell Biology 2020Quote: ... The absorbance of 100 μL was measured a 96-well plate and absorbance at 558 nm read on a H1 plate reader (Biotek).
-
bioRxiv - Cell Biology 2020Quote: ... Protein concentration was determined by taking OD at 280 nm in Nano drop (Synergy H1 Hybrid Multi-Mode Reader Biotek) and mass extinction co-efficient of the proteins.
-
bioRxiv - Evolutionary Biology 2021Quote: ... was added to the cells and incubated in the dark for 5 min before reading on a Synergy H1 Hybrid Multi-Mode plate reader (Biotek). Normalized cell entry levels of pseudovirus generated on different days (biological replicates ...
-
bioRxiv - Microbiology 2020Quote: ... Optical density of the cultures at 595 nm was determined by spectrophotometry using BioTek Synergy HT or H1 automated plate readers (BioTek) then diluted to an OD595 of 0.1 (200 μl of 1X M9 salts in 96-well microtiter plate (Corning #35-1172) ...
-
bioRxiv - Microbiology 2022Quote: ... The results were read in 96-well plates at 37 °C using a microplate reader at 492 nm (SYNERGY H1, BioTek). The inhibitory effects of the identified active compound on other carbapenemases (NDM-3 ...
-
bioRxiv - Genomics 2020Quote: ... were added to the samples and maintained at room temperature in the dark until reading in the Synergy H1 instrument (Biotek) at 80% gain ...
-
bioRxiv - Microbiology 2019Quote: ... The reactions were quantified after 60 min incubation at 410 nm (OD410) using a Sinergy H1 microplate reader (BioTek, USA). Samples were considered positive when OD410 values were higher than the mean of the healthy controls plus three times the standard deviations (six healthy controls per plate were used).
-
bioRxiv - Microbiology 2019Quote: ... The absorption spectrum of fractions was determined in the UV-visible region (230–800 nm) using Synergy H1 Hybrid Multimode spectrophotometer (BioTek). For in vitro anti-phytophthora activity of fractions ...
-
bioRxiv - Microbiology 2019Quote: ... Plates were incubated for another 4 hours and the absorbance of the plate was read at 560 and 590 nm wavelength with the Synergy H1 hybrid multimode plate reader (BioTek).
-
bioRxiv - Biochemistry 2019Quote: ... All absorption and fluorescence were performed using a 96-well plate reader (Synergy H1 Hybrid Reader; BioTek, Winooski, VT, USA) at specified wavelengths (see below) ...
-
bioRxiv - Synthetic Biology 2020Quote: ... Fluorescence profiles were characterized using a Synergy H1 Hybrid Multi-Mode Reader (488 nm excitation, 530/30 detection, BioTek Instruments).
-
bioRxiv - Biochemistry 2019Quote: ... transferred to one well of a 12-well plate and incubated at 37°C with continuous shaking in a Synergy H1 microplate reader (BioTek). Growth was measured as the increase in OD600 ...
-
bioRxiv - Biochemistry 2019Quote: ... All absorption/fluorescence measurements were performed using a 96-well plate reader (Synergy H1 Hybrid Reader, BioTek, Winooski, VT, USA) at specified wavelengths (see below) ...
-
bioRxiv - Microbiology 2019Quote: ... The reaction was stopped with 2M sulfuric acid and absorbance read at 450 nm with a Synergy H1 micro plate reader (BioTek).
-
bioRxiv - Cancer Biology 2021Quote: ... Fluorescent increase resulting from degradation of peptide-AMC at 37°C was monitored over time by means of a fluorometer (Synergy H1 Hybrid Multi-Mode Microplate Reader, BioTek) at 340 nm excitation and at 460 nm emission ...
-
bioRxiv - Biochemistry 2020Quote: ... The plate was incubated at 37°C and OD550 was measured automatically every fifth minute in a Synergy H1 Hybrid Reader (Biotek). For microscopic examinations of cells depleted of ectopically expressed FtsX ...
-
bioRxiv - Biochemistry 2020Quote: ... was measured at 1-minute time points for 2 h in 96-well plate reader (Synergy H1 Hybrid Multi-Mode Reader, BioTeK).