Labshake search
Citations for Pall :
1 - 50 of 73 citations for Trypsin 1 Blocking Peptide since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Immunology 2022Quote: Biotinylated peptides (100 nM) were loaded on streptavidin biosensors (Pall ForteBio) to a load threshold of 0.1 nm ...
-
bioRxiv - Microbiology 2022Quote: Biotinylated MPER peptide (30 nM) was loaded onto a streptavidin biosensor (Pall Fortebio) to a load threshold of 0.6 nm using an Octet RED96 system (Pall ForteBio) ...
-
bioRxiv - Microbiology 2021Quote: ... samples with peptides were passed through a 3 kDa molecular weight cut off filter (PALL) to remove larger peptides and undigested protein ...
-
bioRxiv - Immunology 2022Quote: MHC-I-associated peptides were purified using 10 kDa molecular weight cutoff filters (Pall NanoSep) as previously described,15 snap-frozen in liquid nitrogen ...
-
bioRxiv - Immunology 2019Quote: ... The biotinylated peptides were diluted to 2 μM and loaded on pre-wet SA sensor from Pall ForteBio (CA ...
-
bioRxiv - Bioengineering 2021Quote: ... Peptides were isolated from antibody and MHC molecules using a passivated 10K molecule weight cutoff filters (PALL Life Science), lyophilized ...
-
bioRxiv - Cancer Biology 2022Quote: ... Peptides were isolated from antibody and MHC molecules using a passivated 10K molecule weight cutoff filter (PALL Life Science), lyophilized ...
-
bioRxiv - Physiology 2024Quote: ... Around 200 μg of protein were subjected to in-filter reduction and alkylation using iodoacetamide followed by trypsin digestion (Nanosep Centrifugal Devices with Omega Membrane-10K, PALL), following the protocol from Wiśniewski et al.63 ...
-
bioRxiv - Cell Biology 2023Quote: ... samples were incubated for 7 days at 37°C with primary antibodies diluted in blocking solution after first being filtered through a 25 mm Acrodisc® 0.45 μm syringe filter (Cat. No. 4614; Pall Corporation, USA) to remove any potential artifacts such as aggregated antibody complexes ...
-
bioRxiv - Immunology 2019Quote: ... the peptide products were separated from undegraded polypeptides by ultrafiltration through a membrane with a 3-kDa cutoff (Nanosep, Pall, USA), and these samples were assessed with fluorescamine (Sigma ...
-
bioRxiv - Plant Biology 2019Quote: Binding affinity of the SCRM KiDoK full-length peptide and the scrm-D KiDoK ful-length peptide with GST-tagged MPK3 and MPK6 were measured using the Octet Red 96 (ForteBio, Pall Life Sciences) following the manufacturer’s protocols ...
-
bioRxiv - Cell Biology 2023Quote: Eluted proteins from light and heavy samples prepared with method 1 were mixed at a 1:1 ratio and added onto 10-kDa cutoff-filter (OD010C33, PALL) followed by addition of 1 µL 1mM DTT ...
-
bioRxiv - Cell Biology 2020Quote: ... 1% Ultroser G (Pall corporation ...
-
bioRxiv - Cell Biology 2023Quote: ... and 1% UltroserG (Pall Life Sciences ...
-
bioRxiv - Plant Biology 2019Quote: ... Samples were diluted 1:1 with sample diluent buffer (Pall FortéBio cat18-1091) to a concentration of 0.142 mg/ml for analysis using the BLITzⓇ system ...
-
bioRxiv - Cell Biology 2020Quote: ... A 1:1 mixture of DMEM/F12 supplemented with 2% Ultroser G (PALL Corp.) was used for the culture medium ...
-
bioRxiv - Cancer Biology 2023Quote: ... 1% of Ultroser G (Pall), and 1% Penicillin/Streptomycin (GIBCO) ...
-
bioRxiv - Physiology 2022Quote: ... 1% Ultroser G (Pall Life Sciences), antibiotic-antimycotic mix (Gibco)] and plated on uncoated dishes (NUNC) ...
-
bioRxiv - Biophysics 2022Quote: ... The data were analysed and fit to a 1:1 model using ForteBio Data Analysis 12 (Pall Fortebio).
-
bioRxiv - Molecular Biology 2023Quote: ... mixed in of 1:1 molar ratio and concentrated using a centrifugal device with 3 kDa cutoff (Pall) at 4 °C ...
-
bioRxiv - Cell Biology 2020Quote: ... 1% UltroserG (Pall Life Sciences, Washington USA) and antibiotic/antimycotic mix (Gibco/Invitrogen Inc) ...
-
bioRxiv - Cancer Biology 2021Quote: ... 1% UltroserG (Pall Life Sciences #15950-017) and 1% Pen/Strep ...
-
bioRxiv - Evolutionary Biology 2022Quote: ... 1 (AcroVent 0.2μm PTFE, Pall Corporation, 4249)
-
bioRxiv - Microbiology 2020Quote: ... then transferred to air-liquid interface where cells were maintained in 1:1 mixture of Ham’s F12/DMEM media supplemented with 2% Ultroser G (Pall Biosepra ...
-
bioRxiv - Genetics 2019Quote: ... 1 L water on a 0.45 μm cellulose filter (Pall MicroFunnel 300 ST; Pall Corporation, New York, USA; Table 1) or two replicate samples of c ...
-
bioRxiv - Cell Biology 2020Quote: ... 1% Ultroser G (Pall Life Sciences, Washington, USA), 100uM Beta-mercapto-ethanol ...
-
bioRxiv - Genomics 2022Quote: ... Sample suspensions were then centrifuged at 500 rpm (Genevac EZ-2) for 10 min before filtering through 1 mL 96 well filter plates (glass fiber, 1 μm, Pall, New York, NY) into 1 mL 96 well plates and sealed with a silicone plate mat (Agilent ...
-
bioRxiv - Molecular Biology 2021Quote: ... Eluate from column 1 above 15 mAU was flowed through a 1-mL pre-packed HyperCel STAR AX column (Pall Corporation, Port Washington, NY). Flow-through from column 2 above 15 mAU was collected.
-
bioRxiv - Bioengineering 2020Quote: ... Eluate from column 1 above 15 mAU was flowed through a 1-mL pre-packed HyperCel STAR AX column (Pall Corporation, Port Washington, NY). Flow-through from column 2 above 15 mAU was collected.
-
bioRxiv - Molecular Biology 2024Quote: ... Data were collected and globally fitted by a 1:1 stoichiometry model using the Data Acquisition and Data Analysis Software vHT 11.1 (ForteBio, Pall Life Sciences, New York, USA). The fitting met the quality criteria χ2 < 3 and R2 ≥ 0.96.
-
bioRxiv - Microbiology 2020Quote: ... a 1 µ prefilter (Acrodisc syringe glass fiber, Pall Laboratory) and a 0.2 µ polyethersulfone (PES ...
-
bioRxiv - Microbiology 2021Quote: ... at 1 μg/mL in undiluted 10X kinetics buffer (Pall) to SA sensors that were pre-hydrated in water for at least 10 minutes and then equilibrated into 10X Kinetics Buffer (Pall) ...
-
bioRxiv - Genetics 2019Quote: ... 1 L water on a 0.45 μm cellulose filter (Pall MicroFunnel 300 ST ...
-
bioRxiv - Immunology 2021Quote: ... (1) Biotinylated ACE2 (300 nM) was loaded on Streptavidin biosensors (Pall ForteBio) to a load threshold of 0.4-0.6 nm ...
-
bioRxiv - Microbiology 2021Quote: ... separated on a 1% agarose gel and transferred onto a nylon membrane (Pall membrane). For hybridisation experiments radioactively labeled PCR probes against the selected targets were generated using DECAprime II DNA labeling kit and [α-32P]dCTP (Life Technologies ...
-
bioRxiv - Microbiology 2023Quote: ... 1 mM DTT using a centrifugation column with a 3 kDa MWCO (Pall Corporation) prior to use and/or storage ...
-
bioRxiv - Immunology 2023Quote: Recombinant human PD-1 protein was biotinylated and loaded using SA sensor (Pall Corporation). Six concentrations of Finotonlimab and Nivolumab were added for real-time association and dissociation analysis using Octet system ...
-
bioRxiv - Biochemistry 2021Quote: ... For binding analysis biotinylated antigen (1 μg/mL) were immobilized on streptavidin (SA) biosensors (Pall) for 300 sec to ensure saturation ...
-
bioRxiv - Cell Biology 2019Quote: ... 1 μl of the solution was spotted on a nitrocellulose membrane (BioTrace™ NT, Pall Corporation) in quadruplicate and allowed to dry for 30 minutes ...
-
bioRxiv - Immunology 2022Quote: ... 1 mM EDTA) and concentrated to 500 ml using a Centramate tangential flow filtration system (Pall). It was loaded on a Strep-Tactin®XT Superflow® resin (IBA ...
-
bioRxiv - Cancer Biology 2022Quote: ... The cell suspension was made by diluting 300,000 cells in 1 ml of DPBS-0.01% Pluronic solution that was sterile filtered with a 0.2 μm filter (Pall). The cell suspension was loaded to a 1ml syringe (NIPRO ...
-
bioRxiv - Microbiology 2021Quote: ... the residual silica was removed by filtration in CHCl3/MeOH 2:1 v/v using a Acrodisc CR 13 mm Syringe Filter (0.2 µm PTFE membrane, PALL Life Sciences ...
-
bioRxiv - Neuroscience 2022Quote: ... and 1× PBS (incl. 130 mM NaCl) and HaPrP23-231 filtered using 100-kD centrifugal filters (Pall Nanosep OD100C34) at a concentration of 0.1 mg/ml ...
-
bioRxiv - Microbiology 2022Quote: ... Vesicles were sampled by collecting 1 mL of culture and filtering it through a 0.22 µm Supor syringe filter (Pall). The <0.22 µm fraction was stored at -20 °C until ready for analysis ...
-
bioRxiv - Microbiology 2021Quote: ... CCoV-HuPn-2018 or TGEV biotinylated RBD was immobilized at 1 μg/mL in undiluted 10X kinetics buffer (Pall) to SA sensors that were prehydrated in water for at least 10 minutes and then equilibrated into 10X Kinetics Buffer (Pall) ...
-
bioRxiv - Bioengineering 2020Quote: ... annealed at 70 °C for 1 h and allowed to equilibrate at room temperature overnight before filtering with a 0.2 μm nylon filter (Pall). SAXS measurements were performed with 5 seconds acquisition times with no observable beam damage.
-
bioRxiv - Synthetic Biology 2022Quote: ... the protein mixture was purified on 1 mL HisTrap column (Cytiva) and the pure protein was concentrated by Pall centrifugal device with MWCO 10 kDa and stored at 4°C.
-
bioRxiv - Microbiology 2022Quote: ... Protein concentrations less than 1 mg/mL were concentrated using a 10K MWCO centrifugal filter (Pall Corporation, NY, USA). Protein concentrations were determined using absorbance measurements at 280 nm (A280 ...
-
bioRxiv - Synthetic Biology 2022Quote: ... the protein mixture was repurified on 1 mL HisTrap column (Cytiva) and the pure protein was concentrated by Pall centrifugal device with MWCO 3 kDa and stored at 4°C.
-
bioRxiv - Biophysics 2024Quote: ... The purified TG2 was then concentrated to 1 mg/mL using a 10 kDa cutoff centrifugal filter (Jumbosep, PALL), flash-frozen in liquid nitrogen ...