Labshake search
Citations for Pall :
1 - 50 of 69 citations for Somatostatin Receptor 1 SSTR1 Rabbit Polyclonal since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Microbiology 2023Quote: Binding of virus and sialic receptor analogous was measured using an Octet Red biolayer interferometer (Pall FortéBio) as previously described (37) ...
-
bioRxiv - Microbiology 2020Quote: Purified virus binding to different sialylated receptor analogues was tested using an Octet RED bio-layer interferometer (Pall ForteBio) as described previously [21] ...
-
bioRxiv - Biophysics 2020Quote: The avidity of different S-Trimer binding to the SARS-CoV-2 receptor ACE2 were assessed by Bio-Layer Interferometry measurements on ForteBio Octet QKe (Pall, New York). ACE2-Fc (10 μg/mL ...
-
bioRxiv - Immunology 2021Quote: rS protein receptor binding kinetics was determined by bio-layer interferometry (BLI) using an Octet QK384 system (Pall Forté Bio, Fremont, CA). His-tagged human ACE2 (2 μg mL-1 ...
-
bioRxiv - Microbiology 2020Quote: S-protein receptor binding kinetics was determined by bio-layer interferometry (BLI) using an Octet QK384 system (Pall Forté Bio, Fremont, CA). Hist-tagged human ACE2 (2 μg mL−1 ...
-
bioRxiv - Neuroscience 2023Quote: ... It indicates the distribution of the expression of the vomeronasal genes from the V1R receptor family (Suárez et al. 2011; Pallé et al. 2020).
-
bioRxiv - Microbiology 2024Quote: The virus receptor binding avidities were determined by a biolayer interferometry assay with an Octet RED instrument (Pall ForteBio, Menlo Park, CA). Two biotinylated glycan analogs (3’SLN ...
-
bioRxiv - Cell Biology 2023Quote: Eluted proteins from light and heavy samples prepared with method 1 were mixed at a 1:1 ratio and added onto 10-kDa cutoff-filter (OD010C33, PALL) followed by addition of 1 µL 1mM DTT ...
-
bioRxiv - Cell Biology 2020Quote: ... 1% Ultroser G (Pall corporation ...
-
bioRxiv - Cell Biology 2023Quote: ... and 1% UltroserG (Pall Life Sciences ...
-
bioRxiv - Plant Biology 2019Quote: ... Samples were diluted 1:1 with sample diluent buffer (Pall FortéBio cat18-1091) to a concentration of 0.142 mg/ml for analysis using the BLITzⓇ system ...
-
bioRxiv - Cell Biology 2020Quote: ... A 1:1 mixture of DMEM/F12 supplemented with 2% Ultroser G (PALL Corp.) was used for the culture medium ...
-
bioRxiv - Cancer Biology 2023Quote: ... 1% of Ultroser G (Pall), and 1% Penicillin/Streptomycin (GIBCO) ...
-
bioRxiv - Physiology 2022Quote: ... 1% Ultroser G (Pall Life Sciences), antibiotic-antimycotic mix (Gibco)] and plated on uncoated dishes (NUNC) ...
-
bioRxiv - Biophysics 2022Quote: ... The data were analysed and fit to a 1:1 model using ForteBio Data Analysis 12 (Pall Fortebio).
-
bioRxiv - Molecular Biology 2023Quote: ... mixed in of 1:1 molar ratio and concentrated using a centrifugal device with 3 kDa cutoff (Pall) at 4 °C ...
-
bioRxiv - Cell Biology 2020Quote: ... 1% UltroserG (Pall Life Sciences, Washington USA) and antibiotic/antimycotic mix (Gibco/Invitrogen Inc) ...
-
bioRxiv - Cancer Biology 2021Quote: ... 1% UltroserG (Pall Life Sciences #15950-017) and 1% Pen/Strep ...
-
bioRxiv - Evolutionary Biology 2022Quote: ... 1 (AcroVent 0.2μm PTFE, Pall Corporation, 4249)
-
bioRxiv - Microbiology 2020Quote: ... then transferred to air-liquid interface where cells were maintained in 1:1 mixture of Ham’s F12/DMEM media supplemented with 2% Ultroser G (Pall Biosepra ...
-
bioRxiv - Genetics 2019Quote: ... 1 L water on a 0.45 μm cellulose filter (Pall MicroFunnel 300 ST; Pall Corporation, New York, USA; Table 1) or two replicate samples of c ...
-
bioRxiv - Cell Biology 2020Quote: ... 1% Ultroser G (Pall Life Sciences, Washington, USA), 100uM Beta-mercapto-ethanol ...
-
bioRxiv - Genomics 2022Quote: ... Sample suspensions were then centrifuged at 500 rpm (Genevac EZ-2) for 10 min before filtering through 1 mL 96 well filter plates (glass fiber, 1 μm, Pall, New York, NY) into 1 mL 96 well plates and sealed with a silicone plate mat (Agilent ...
-
bioRxiv - Molecular Biology 2021Quote: ... Eluate from column 1 above 15 mAU was flowed through a 1-mL pre-packed HyperCel STAR AX column (Pall Corporation, Port Washington, NY). Flow-through from column 2 above 15 mAU was collected.
-
bioRxiv - Bioengineering 2020Quote: ... Eluate from column 1 above 15 mAU was flowed through a 1-mL pre-packed HyperCel STAR AX column (Pall Corporation, Port Washington, NY). Flow-through from column 2 above 15 mAU was collected.
-
bioRxiv - Molecular Biology 2024Quote: ... Data were collected and globally fitted by a 1:1 stoichiometry model using the Data Acquisition and Data Analysis Software vHT 11.1 (ForteBio, Pall Life Sciences, New York, USA). The fitting met the quality criteria χ2 < 3 and R2 ≥ 0.96.
-
bioRxiv - Microbiology 2020Quote: ... a 1 µ prefilter (Acrodisc syringe glass fiber, Pall Laboratory) and a 0.2 µ polyethersulfone (PES ...
-
bioRxiv - Microbiology 2021Quote: ... at 1 μg/mL in undiluted 10X kinetics buffer (Pall) to SA sensors that were pre-hydrated in water for at least 10 minutes and then equilibrated into 10X Kinetics Buffer (Pall) ...
-
bioRxiv - Genetics 2019Quote: ... 1 L water on a 0.45 μm cellulose filter (Pall MicroFunnel 300 ST ...
-
bioRxiv - Immunology 2021Quote: ... (1) Biotinylated ACE2 (300 nM) was loaded on Streptavidin biosensors (Pall ForteBio) to a load threshold of 0.4-0.6 nm ...
-
bioRxiv - Microbiology 2021Quote: ... separated on a 1% agarose gel and transferred onto a nylon membrane (Pall membrane). For hybridisation experiments radioactively labeled PCR probes against the selected targets were generated using DECAprime II DNA labeling kit and [α-32P]dCTP (Life Technologies ...
-
bioRxiv - Microbiology 2023Quote: ... 1 mM DTT using a centrifugation column with a 3 kDa MWCO (Pall Corporation) prior to use and/or storage ...
-
bioRxiv - Immunology 2023Quote: Recombinant human PD-1 protein was biotinylated and loaded using SA sensor (Pall Corporation). Six concentrations of Finotonlimab and Nivolumab were added for real-time association and dissociation analysis using Octet system ...
-
bioRxiv - Biochemistry 2021Quote: ... For binding analysis biotinylated antigen (1 μg/mL) were immobilized on streptavidin (SA) biosensors (Pall) for 300 sec to ensure saturation ...
-
bioRxiv - Cell Biology 2019Quote: ... 1 μl of the solution was spotted on a nitrocellulose membrane (BioTrace™ NT, Pall Corporation) in quadruplicate and allowed to dry for 30 minutes ...
-
bioRxiv - Immunology 2022Quote: ... 1 mM EDTA) and concentrated to 500 ml using a Centramate tangential flow filtration system (Pall). It was loaded on a Strep-Tactin®XT Superflow® resin (IBA ...
-
bioRxiv - Cancer Biology 2022Quote: ... The cell suspension was made by diluting 300,000 cells in 1 ml of DPBS-0.01% Pluronic solution that was sterile filtered with a 0.2 μm filter (Pall). The cell suspension was loaded to a 1ml syringe (NIPRO ...
-
bioRxiv - Microbiology 2021Quote: ... the residual silica was removed by filtration in CHCl3/MeOH 2:1 v/v using a Acrodisc CR 13 mm Syringe Filter (0.2 µm PTFE membrane, PALL Life Sciences ...
-
bioRxiv - Neuroscience 2022Quote: ... and 1× PBS (incl. 130 mM NaCl) and HaPrP23-231 filtered using 100-kD centrifugal filters (Pall Nanosep OD100C34) at a concentration of 0.1 mg/ml ...
-
bioRxiv - Microbiology 2022Quote: ... Vesicles were sampled by collecting 1 mL of culture and filtering it through a 0.22 µm Supor syringe filter (Pall). The <0.22 µm fraction was stored at -20 °C until ready for analysis ...
-
bioRxiv - Microbiology 2021Quote: ... CCoV-HuPn-2018 or TGEV biotinylated RBD was immobilized at 1 μg/mL in undiluted 10X kinetics buffer (Pall) to SA sensors that were prehydrated in water for at least 10 minutes and then equilibrated into 10X Kinetics Buffer (Pall) ...
-
bioRxiv - Bioengineering 2020Quote: ... annealed at 70 °C for 1 h and allowed to equilibrate at room temperature overnight before filtering with a 0.2 μm nylon filter (Pall). SAXS measurements were performed with 5 seconds acquisition times with no observable beam damage.
-
bioRxiv - Synthetic Biology 2022Quote: ... the protein mixture was purified on 1 mL HisTrap column (Cytiva) and the pure protein was concentrated by Pall centrifugal device with MWCO 10 kDa and stored at 4°C.
-
bioRxiv - Microbiology 2022Quote: ... Protein concentrations less than 1 mg/mL were concentrated using a 10K MWCO centrifugal filter (Pall Corporation, NY, USA). Protein concentrations were determined using absorbance measurements at 280 nm (A280 ...
-
bioRxiv - Synthetic Biology 2022Quote: ... the protein mixture was repurified on 1 mL HisTrap column (Cytiva) and the pure protein was concentrated by Pall centrifugal device with MWCO 3 kDa and stored at 4°C.
-
bioRxiv - Biophysics 2024Quote: ... The purified TG2 was then concentrated to 1 mg/mL using a 10 kDa cutoff centrifugal filter (Jumbosep, PALL), flash-frozen in liquid nitrogen ...
-
bioRxiv - Cell Biology 2020Quote: ... Pure CLIK-1 fractions were pooled and concentrated by a MacroSep Centrifugal Device (molecular weight cutoff at 10K) (Pall Corporation), and stored at −80 °C ...
-
bioRxiv - Cell Biology 2019Quote: ... The worm suspension was pulled into a 1 mL syringe through a 27-gauge needle and then passed through a 5 µm Supor membrane syringe filter (Pall) into collection tubes on ice ...
-
bioRxiv - Immunology 2019Quote: ... The recombinant PD-1 protein was loaded to the surface of prewet NTA biosensors from ForteBio (Pall ForteBio, CA, USA). Subsequently ...
-
bioRxiv - Bioengineering 2022Quote: ... 1 mL was centrifuged at 6000 x g 1 min and supernatants filtered through 0.2 µm PVDF membrane filters (Pall, USA), and the filtrates were used for chemical analyses of the liquid phase ...