Labshake search
Citations for BioSpec :
1 - 50 of 123 citations for Mouse Chemokine C X3 C Motif Receptor 1 CX3CR1 Protein since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Molecular Biology 2023Quote: ... Cells were disrupted for 1 minute at 4 °C in a Mini BeadBeater (BioSpec Products) with acid-washed glass beads ...
-
bioRxiv - Microbiology 2022Quote: Immediately after the fluorescence microscopy measurements (section 2.4), we dried (60 °C, 24 h) and ground (1 min, Mini bead beater 16; Biospec products) the 1.5 BSC disks used for the cyanobacteria/liverwort cover analysis and stored them at -80 °C for up to four months for DNA extraction ...
-
bioRxiv - Microbiology 2019Quote: ... a 96 well plate (Axygen P-DW-20-C) was loaded with 1 mL of 0.1 mm Zirconia Silica beads (Biospec 11079101Z) using a loading device (Biospec 702L) ...
-
bioRxiv - Molecular Biology 2022Quote: ... was homogenized at 4°C using 700 µL zirconia beads (BioSpec, 110791) in Precellys 24 homogenizer (Bertin Technologies ...
-
bioRxiv - Immunology 2023Quote: ... per kit instructions and included 2 cycles of 1 minute of bead beating at 4°C on a Mini-Bead-Beater 16 (BioSpec Products). The V3 and V4 regions of the 16S rRNA gene was amplified with a single round of PCR using primers that contained (described 3’ to 5’ ...
-
bioRxiv - Plant Biology 2020Quote: ... Samples were incubated at 80°C for 30 min with 0.5 mm zirconia/silica beads (Biospec) and vortexed several times at full speed for 10 min each to favour tissues disruption ...
-
bioRxiv - Molecular Biology 2022Quote: ... 10 mM β-mercaptoethanol) and lysed at 4 °C with glass beads in a BeadBeater (BioSpec). After centrifugation ...
-
bioRxiv - Microbiology 2020Quote: ... 2 min at 4°C between individual beating steps) using a Mini-Beadbeater-16 (Biospec Products, Bartlesville OK). Homogenized samples were centrifuged (12,000 x g ...
-
bioRxiv - Molecular Biology 2021Quote: ... Cells were pelleted at 6000 rpm for 2 minutes at 4°C and the pellet was resuspended in FA lysis buffer and Zirconia beads (0.7 mm diameter, Biospec). Cells were broken using a cell homogenizer (Bertin Instruments ...
-
bioRxiv - Genomics 2022Quote: ... Cells were lysed at 4°C by repeated vigorous agitation with 0.5mm zirconia/silica beads in a bead beater (Biospec) using 4 cycles of 60 s with 75 s of rest in between cycles ...
-
bioRxiv - Genomics 2022Quote: ... Tubes were thawed at 70°C in a water bath after which 200 µL of 0.5 mm zirconia/silica beads (BioSpec Products) were added ...
-
bioRxiv - Genetics 2020Quote: ... were resuspended in 1 ml of 155 mM ammonium formate and lysed at 4 °C with 400 µl of acid-washed glass beads using a Mini-Beadbeater (Biospec). Lysates corresponding with 0.4 OD units were subsequently spiked with internal lipid standards and subjected to two-step lipid extraction [68] ...
-
bioRxiv - Genetics 2023Quote: ... Cells were lysed using a FastPrep (MP) bead beater (5 x 90 second runs at 4°C) and acid-washed glass beads (BioSpec), centrifuged ...
-
bioRxiv - Microbiology 2019Quote: ... This included a combination of 5 min of heat (65°C) followed by 5 min of bead-beating for cell disruption on a Mini-Beadbeater-24 (Biospec, U.S.A.). After extraction the DNA was checked for quality by gel electrophoresis and quantified using a Qubit 4 (Thermo Fisher Scientific ...
-
bioRxiv - Biochemistry 2023Quote: ... 4 °C) and then resuspended in 350 μl of Buffer A x Protease Inhibitors and ∼450 μl glass beads (1mm, BioSpec Products). The buffer solution should be enough to cover the beads by a thin layer ...
-
bioRxiv - Immunology 2023Quote: ... some mice were anesthetized and mouse lungs were harvested and homogenized using a Mini-Beadbeater-1 (Biospec, Bartlesville, OK). The lung homogenates were used to count lung colony-forming units (CFUs) ...
-
bioRxiv - Cell Biology 2019Quote: ... Protein extracts were generated by pulverization using a Mini-Beadbeater-96 (BioSpec). The samples were then treated with 50 µl of 3X SDS sample buffer (187.5 mM Tris pH 6.8 ...
-
bioRxiv - Cell Biology 2020Quote: ... total protein was homogenized from the tails using BioVortexer (BioSpec Products, Bartlesville, OK, USA) and 120 μg of protein was resolved on an SDS/PAGE ...
-
bioRxiv - Microbiology 2021Quote: ... Mouse fecal pellets were homogenized with bead beating for 5 min (Mini-Beadbeater-96, BioSpec) using the ZR BashingBead lysis matrix containing 0.1 and 0.5 mm beads (ZR-96 BashingBead Lysis Rack ...
-
bioRxiv - Cell Biology 2022Quote: ... Whole-cell protein extracts were prepared by bead-beating the pellets with 0.5 mm zirconia/silica beads (BioSpec) in 20% trichloroacetic acid (Scharlau ...
-
bioRxiv - Biochemistry 2020Quote: ... Protein lysates were prepared by mechanically disrupted in the presence of lysis buffer using glass beads and a beadbeater (Biospec Products). Lysed cells were resuspended in buffer H (BH ...
-
bioRxiv - Cell Biology 2023Quote: ... Protein lysates were prepared by mechanical disruption in the presence of lysis buffer using glass beads and a beadbeater (Biospec Products). Lysed cells were resuspended in buffer H (BH ...
-
bioRxiv - Animal Behavior and Cognition 2024Quote: ... 1 mm zirconia (BioSpec Products) and approx ...
-
bioRxiv - Neuroscience 2022Quote: MR images of one mouse brain was acquired on a 30-cm bore 9.4T magnet (Bruker BioSpec 94/30, Billerica, MA). A high-sensitivity cryogenic RF surface receive-only coil was used for signal reception (Bruker CryoProbe) ...
-
bioRxiv - Evolutionary Biology 2023Quote: ... five 1 mm zirconia (BioSpec Products) and ~100 mg of 425-600 μm glass beads ...
-
bioRxiv - Microbiology 2021Quote: ... bladders and kidneys were removed from each mouse and homogenized in tubes containing 1.0mm diameter zirconia/silica beads (Biospec Products, catalog no. 11079110z) using a MagNA Lyser (Roche Diagnostics) ...
-
bioRxiv - Neuroscience 2020Quote: ... with 1 mm Zirconia beads (BioSpec Products). RNA was isolated following the manufacturers’ protocol and resuspended in ultra-pure ddH2O ...
-
bioRxiv - Microbiology 2021Quote: ... and ~20 1-mm glass beads (BioSpec). Samples were homogenized for 30 sec at 6,000 rpm in a Precellys 24 grinder (Bertin Technologies) ...
-
bioRxiv - Immunology 2020Quote: ... containing 1 mm zirconia/silica beads (BioSpec). Tissue was homogenized for 30 seconds using a Mini-bead beater (BioSpec) ...
-
bioRxiv - Microbiology 2021Quote: ... with ~20 1-mm glass beads (BioSpec) in a Precellys 24 grinder (Bertin Technologies ...
-
bioRxiv - Microbiology 2022Quote: ... and ~20 1-mm glass beads (BioSpec). Samples were homogenized for 30 sec at 6,000 rpm in a Precellys 24 grinder (Bertin Technologies) ...
-
bioRxiv - Microbiology 2019Quote: ... except that two cycles of two-minute bead beating with 1 ml of 0·1 mm silica beads in a mini bead-beater (BioSpec) were used to disrupt cell walls ...
-
bioRxiv - Immunology 2022Quote: ... with 1-mm-diameter zirconia/silica beads (Biospec). Samples were frozen and stored at −80C until RNA extraction ...
-
bioRxiv - Biochemistry 2023Quote: ... Six 1-mm diameter Zirconia/silica beads (BioSpec) and 15 µM ThT were added to each well and the plates were sealed (TempPlate RT Select Optical Film ...
-
bioRxiv - Microbiology 2022Quote: ... Lungs were disrupted in 1 ml of 8% cMEM using 1 mm zirconia beads in a bead beater (Biospec, Bartlesville, OK) and analyzed by plaque assays as described above.
-
bioRxiv - Microbiology 2023Quote: ... Lungs were disrupted in 1 ml of 8% cMEM using 1 mm zirconia beads in a bead beater (Biospec, Bartlesville, OK) and plated on NIH 3T12 cells ...
-
bioRxiv - Microbiology 2021Quote: ... 4 % (w/v)) with sequential bead-beating 3 × 1 min with 1 min intervals on ice in a mini bead-beater (Biospec, Bartlesville, USA). Samples were incubated for 15 min ...
-
bioRxiv - Microbiology 2021Quote: ... and 1-mm diameter zirconia/silica beads (BioSpec Products) followed by the QIAamp Fast DNA Stool Mini Kit (Qiagen ...
-
bioRxiv - Microbiology 2021Quote: ... mechanically disrupted using 1 mm diameter Zirconia beads (BioSpec), and the lysate filtered through 5 μm filters (Millipore Sigma™ ...
-
bioRxiv - Systems Biology 2022Quote: ... 200 μL of 1 mm zirconia beads (BioSpec Products) were added to each sample and homogenized at 420 rcf for 90 seconds in a FastPrep-96 homogenizer and subsequently placed on dry ice for 90 seconds to avoid overheating ...
-
bioRxiv - Immunology 2022Quote: ... mechanically homogenized using 1 mm zirconia/silica beads (Biospec) for 30 seconds using a Mini-BeadBeater 16 (BioSpec) ...
-
bioRxiv - Microbiology 2019Quote: ... 1 g of glass beads (0.5 mm, Biospec Products), 700 μL of cold methanol and 140 μL of EDTA 0.1M were added and vigorously mixed (4 x 45 s ...
-
bioRxiv - Cell Biology 2020Quote: ... and glass beads (1 mm Zirconia/Silica beads, BioSpec), the embryos were thawed on ice and homogenized on a BeadBeater (BioSpec ...
-
bioRxiv - Microbiology 2022Quote: ... and 1 large stainless steel bead (BioSpec Products 11079132ss) suspended in 20% SDS buffer (200 mM Tris·HCl ...
-
bioRxiv - Biochemistry 2021Quote: ... Approximately 200 μL of 1 mm Zirconia beads (BioSpec products) were added to each dry sample and homogenized at 1800 rpm for a total of 270 seconds (FastPrep 96 - MPBIO) ...
-
bioRxiv - Immunology 2022Quote: ... then were homogenized with 1 mm zirconia beads (BioSpec Products) in a Precellys 24 (Bertin Instruments ...
-
bioRxiv - Evolutionary Biology 2023Quote: ... with a mixture of five 1 mm zirconia (BioSpec Products) and ~100 mg of 425-600 μm glass beads ...
-
bioRxiv - Microbiology 2024Quote: ... with 1-mm-diameter zirconia/silica beads (Biospec, Bartlesville, OK). Stool and tissues were either processed on the same day or stored at −80°C.
-
bioRxiv - Microbiology 2021Quote: ... 0.1% Triton X-100) and ~20 1-mm glass beads (BioSpec) in a Precellys 24 grinder (Bertin Technologies ...
-
bioRxiv - Developmental Biology 2022Quote: ... Tissues were homogenized for 1-2 min (Mini Bead beater, Biospec) and spun at 12,000g for 10 min to eliminate cell remnants (4ºC) ...