Labshake search
Citations for Molecular Devices :
651 - 700 of 944 citations for 9 10 12 13 tetrahydroxyoctadecanoic acid since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Pharmacology and Toxicology 2021Quote: ... The fluorescence intensity of CF647 was measured within 10 min using a SpectraMax M2 plate reader (Molecular Devices, Inc.).
-
bioRxiv - Neuroscience 2020Quote: ... band-pass filtered (1-3000 Hz) and sampled at 10 kHz with a Digidata 1440A acquisition board (Molecular Devices). Spikes were sorted using Spike 2 software (CED ...
-
bioRxiv - Biophysics 2021Quote: ... Stationary currents were digitally filtered at 10 Hz and acquired at 100 Hz using a 1320 digidata (Molecular devices). Presteady-state currents were evoked by short voltage steps 200–400 ms in the range 110–−150 mV by decrements of 10 mV ...
-
bioRxiv - Pharmacology and Toxicology 2022Quote: ... Absorbance was read at 412 nm every minute for 10 minutes using a VersaMax (Molecular Devices, San Jose, CA) spectrophotometer ...
-
bioRxiv - Neuroscience 2019Quote: Whole cell somatic recordings were acquired using a Multiclamp 700B amplifier and PClamp 10 data acquisition software (Molecular Devices). Electrical signals were digitized at 20-50kHz and filtered at 2-10 kHz ...
-
bioRxiv - Neuroscience 2019Quote: ... 1 kHz low-pass filter and digital gain at 10 (MultiClamp 700B amplifier, Digidata 1400 digitizer, both Molecular Devices). Results were analyzed with the Clampfit software (Molecular Devices) ...
-
bioRxiv - Neuroscience 2020Quote: ... recording from GPe neurons was obtained with Multiclamp 700B amplifiers and pCLAMP 10 software (Molecular Devices, Sunnyvale, California, USA), and was visually guided using an Olympus BX51 microscope equipped with both transmitted and epifluorescence light sources (Olympus Corporation ...
-
bioRxiv - Neuroscience 2020Quote: ... using the PULSE software and processed with Igor Pro 6.21 (WaveMetrics) and Clampfit 10 (Axon Instruments, Molecular Devices, USA). Data were digitized at 10 kHz and filtered at 2.6 kHz.
-
bioRxiv - Neuroscience 2020Quote: Membrane potential was recorded in current clamp at 10 kHz and filtered at 3 kHz (Multiclamp 700b; Molecular Devices). For current clamp recordings electrodes (4.5-6 MΩ ...
-
bioRxiv - Neuroscience 2020Quote: Synaptic currents were recorded in voltage clamp at 10 kHz and filtered at 3 kHz (Multiclamp 700b; Molecular Devices). For voltage clamp recordings ...
-
bioRxiv - Immunology 2021Quote: ... was added and after 10 min plates were read at 405 nM on an Emax plate reader (Molecular Devices). As a control ...
-
bioRxiv - Biochemistry 2022Quote: ... bioluminescence data were immediately collected for ∼10 min on a SpectraMax iD3 plate reader (Molecular Devices, Sunnyvale, CA, USA) with an interval of 10 s ...
-
bioRxiv - Bioengineering 2022Quote: ... Intracellular voltages were digitized at a sample rate of 10 kHz (Digidata 1440 A plus pCLAMP 10.3, Molecular Devices). Voltage recording was performed at room temperature and perfused with modified Tyrode’s solution (pH 7.4 ...
-
bioRxiv - Pharmacology and Toxicology 2022Quote: ... Absorbance was read at 412 nm every minute for 10 minutes using a VersaMax (Molecular Devices, San Jose, CA) spectrophotometer ...
-
bioRxiv - Physiology 2023Quote: ... and the data were sampled at 2 kHz and filtered at 1 kHz using pClamp 10 software (Molecular Devices). Light stimulation was applied using LEDs and a multi-LED driver through the microscope optics (DC4100 ...
-
bioRxiv - Neuroscience 2022Quote: ... All recordings were obtained using a Multiclamp 700B amplifier and filtered at 10 KHz (Molecular Devices, San Jose, CA), converted with an 18-bit 200 kHz A/D board (HEKA ...
-
bioRxiv - Neuroscience 2022Quote: ... or Micro 1401-3 with Expansion ADC12 (CED, Cambridge, UK) at 10 kHz and recorded with Clampex (Molecular Devices) or Spike2 (CED) ...
-
bioRxiv - Neuroscience 2023Quote: Data were collected using a Multiclamp 700B amplifier and Digidata 1440A digitizer (Axon Instruments) with pClamp 10 (Molecular Devices). Recordings were sampled at 10kHz and filtered at 2kHz ...
-
bioRxiv - Neuroscience 2023Quote: ... Data were recorded and acquired with a Multiclamp 700B amplifier and pClamp 10 software (both Molecular Devices, Wokingham, UK), and were filtered at 4 kHz and digitised at 10 kHz.
-
bioRxiv - Neuroscience 2023Quote: ... The data were filtered at 2 kHz and sampled at 10 kHz via a digitizer (Digidata 1440, Molecular Devices) and recorded using Clampex 10.6 software (Molecular Devices) ...
-
bioRxiv - Neuroscience 2023Quote: ... filtered at 2 kHz and digitized at 10 kHz using a MultiClamp 700B amplifier and Digidata 1550 (Molecular Devices). Clampex version 11.4 (Molecular Devices ...
-
bioRxiv - Neuroscience 2023Quote: ... Signals were filtered at 6–10 kHz and sampled at 50 kHz with the Digidata 1440B digitizer (Molecular Devices). For whole-cell recordings ...
-
bioRxiv - Cell Biology 2023Quote: ... and digitized using a Digidata 1200B data acquisition system and pClamp 10 software (Axon Instruments; Molecular Devices, Sunnyvale, CA). Cell-to-cell junctional sites were identified using a sharp scanning nano-probe (40–50 MΩ) ...
-
bioRxiv - Neuroscience 2023Quote: ... Currents were recorded in voltage clamp mode at 10 kHz and filtered at 3 kHz (Multiclamp 700b; Molecular Devices). To facilitate the detection of synaptic calcium transients ...
-
bioRxiv - Neuroscience 2023Quote: ... and acquired at 20 kHz onto a personal computer using the pClamp 10 software (Molecular Devices, San Jose, USA) which was also used for further analysis ...
-
Effects of ketamine and propofol on muscarinic plateau potentials in rat neocortical pyramidal cellsbioRxiv - Neuroscience 2024Quote: Data were acquired using pCLAMP 10 software and digitised with either a Digidata 1322A or Digidata 1440 (Molecular Devices). The analysis was carried out using Clampfit software (Molecular Devices) ...
-
bioRxiv - Neuroscience 2024Quote: ... successful sweeps were averaged and the peak amplitude of consecutive EPSCs was measured using Clampfit 10 software (Molecular Devices). The amplitudes of consecutive EPSCs in a train were normalized to the amplitude of first EPSC ...
-
bioRxiv - Cell Biology 2024Quote: ... Four sites per well were imaged with 10 minutes intervals using an automated widefield microscope (ImageXpress Micro; Molecular Devices) at 37 °C ...
-
bioRxiv - Cancer Biology 2019Quote: ... D/A converter Digidata 1550B and the data were analyzed using pClamp-10 software (all from Molecular Devices, Sunnyvale, CA).
-
bioRxiv - Neuroscience 2019Quote: ... captured images were converted into binary ROIs and projected back onto the larval zebrafish brain by a digital micromirror device (DLi4130, Digital Light Innovations) for durations of 10 or 100 ms controlled by Clampex (pCLAMP 10.4, Molecular Devices). GCaMP6s ΔF/F was quantified in nuclear ROIs drawn in Fiji with the frames representing ~1 sec averaged and compared 2.72 sec after acoustic stimulation compared to those within 1 sec immediately prior ...
-
bioRxiv - Neuroscience 2019Quote: ... low-pass filtered at 6 kHz and digitized at 10 kHz using a patch-clamp amplifier (Molecular Devices, Multiclamp 700B).
-
bioRxiv - Neuroscience 2019Quote: ... Whole-cell patch-clamp recordings were made using a MultiClamp 700B amplifier (1 kHz low-pass Bessel filter and 10 kHz digitization) with pClamp 10.3 software (Molecular Devices). Voltage-clamp recordings were made using glass pipets with resistance 3-5 MOhms ...
-
bioRxiv - Neuroscience 2020Quote: ... Signals were low-pass filtered (Bessel, 2 kHz) and collected at 10 kHz using the data acquisition software pClamp 10.5 (Molecular Devices). Optical stimulation was applied through the microscope with two LEDs (460 nm and 525 nm ...
-
bioRxiv - Biochemistry 2020Quote: ... IgG1 Fc-fused sACE22 (wild type or engineered variant sACE22.v2.4) were immobilized at 100 nM for 10 minutes to anti-human IgG Fc biosensors (Molecular Devices). The assay buffer was 10 mM HEPES pH 7.6 ...
-
bioRxiv - Neuroscience 2020Quote: ... Data were low-pass filtered at 1 kHz and digitized at 10 kHz with a digitizer (Digidata 1440; Molecular Devices). Series resistance was monitored and cells that displayed > 20% change over the duration of recording were excluded.
-
bioRxiv - Neuroscience 2020Quote: ... The data were low-pass filtered at 2 kHz and digitized at 10 kHz using a Digidata 1322A (Molecular Devices) and stored using Clampex version10 ...
-
bioRxiv - Neuroscience 2019Quote: ... filtered with a low pass Bessel filter at 10 kHz and digitized at 20-50 kHz (Digidata 1440A, Molecular Devices). Series resistance was assessed during recordings and neurons showing a series resistance >30 MΩ or a change >30% were discarded ...
-
bioRxiv - Neuroscience 2020Quote: ... Signals were low-pass filtered (Bessel, 2 kHz) and collected at 10 kHz using the data acquisition software pClamp 10.5 (Molecular Devices). Electrophysiological recordings were extracted using Clampfit (Molecular Devices ...
-
bioRxiv - Bioengineering 2020Quote: ... All biochemical assays were performed in 10 μL of media and measured on a SpectraMax i3 plate reader (Molecular Devices). All sample results were calculated by interpolation of sample raw values from standard curves performed in parallel ...
-
bioRxiv - Cell Biology 2021Quote: ... Data were digitized at 10 kHz with a 2 kHz low-pass filter using a Multiclamp 700A amplifier (Molecular Devices). For all electrophysiological experiments ...
-
bioRxiv - Neuroscience 2022Quote: ... All traces were digitized using a Digidata 1332 data acquisition board and recorded in pClamp 10 software (both Molecular Devices).
-
bioRxiv - Neuroscience 2021Quote: ... Signals were low pass filtered (Bessel, 2 kHz) and collected at 10 kHz using the data acquisition software pClamp 10.5 (Molecular Devices). All the electrophysiological recordings were extracted using Clampfit (Molecular Devices ...
-
bioRxiv - Neuroscience 2021Quote: ... single-pole Bessel filter and digitized at 20 kHz using Digidata 1322A digitizer driven by PClamp 10 software (Molecular Devices). Care was taken to maintain the access resistance below 10 MΩ.
-
bioRxiv - Neuroscience 2021Quote: ... Signals were filtered at 3 kHz and digitized at 10 kHz using a Digidata 1322A or 1440A and pClamp 9.2 or 10.2 (Molecular Devices, USA). Recordings were not corrected for a liquid junction potential ...
-
bioRxiv - Neuroscience 2021Quote: ... the data acquired at 5 kHz with a Digidata 1440A (Axon instruments) interface using pCLAMP 10 acquisition software (Molecular Devices). The Internal and external (bath ...
-
bioRxiv - Neuroscience 2021Quote: Electrophysiological data were acquired and digitized at 4 kHz through a Digidata 1440a interface using Clampex 10 software (Molecular Devices). hiPSC-MNs were visualized with infrared differential interference contrast microscopy using a Nikon Eclipse E600FN upright microscope coupled with a water-immersion objective (Nikon Fluor 40X/0.8W) ...
-
bioRxiv - Developmental Biology 2022Quote: ... and area under the curve were analyzed post addition (acute and after 10-minute incubation) using ScreenWorks software (Molecular Devices) and normalized to baseline measurements ...
-
bioRxiv - Neuroscience 2022Quote: ... and the electrophysiological signals were sampled with a rate of 20 kHz (Digidata 1440A with pCLAMP 10 Software, Molecular Devices). The recording electrodes were moved down until the electrophysiological identification of the receptive field (Figure 1D) ...
-
bioRxiv - Neuroscience 2020Quote: ... filtered with a low pass Bessel filter at 10 kHz and digitized at 20-50 kHz (Digidata 1440A, Molecular Devices). Series resistance was assessed during recordings and neurons showing a series resistance > 30 MΩ or change > 30% were discarded ...
-
bioRxiv - Neuroscience 2020Quote: ... using a Multiclamp 700B amplifier and digitized at 10 kHz with Axon Digidata 1550 (Molecular Devices, Union City, California, USA). Holding current was less than 100 pA for all the recordings and the series resistance Rs was less than 30 MΩ ...