Labshake search
Citations for Molecular Devices :
1 - 50 of 1001 citations for 10 Undecenamide N N bis 2 hydroxyethyl since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Neuroscience 2021Quote: ... The density and distribution of immunogold particles were quantitatively analyzed on electron micrographs using MetaMorph software (Molecular Devices; n = 2 mice). The density of SIPA1L1 on excitatory nerve terminals and dendritic spines was calculated by measuring the number of immunogold particles ...
-
bioRxiv - Neuroscience 2023Quote: ... and pClamp 11 software (n = 146) (Axon Instruments, Molecular Devices, Sunnyvale, CA), with low-pass Bessel filtering set at 10 kHz and sampling interval set at 5 μs ...
-
bioRxiv - Bioengineering 2022Quote: ... Immediately we stopped the reaction by adding 50 μL of 2 N H2SO4 solution and analyzed on a microplate reader (Molecular Devices, Spectramax I3) at 450 nm wavelength ...
-
bioRxiv - Bioengineering 2022Quote: ... The images of these droplets (n ≥ 3) were acquired with Metamorph software (Molecular Devices) with a 30-s interval and a 100-ms exposure time.
-
bioRxiv - Synthetic Biology 2019Quote: ... Plates grown O/N at 30°C were placed in a colony picker Getenetix QPix (Molecular Devices, San José, California) that took and inoculated clones in 96-well microtiter plates containing 200 µL of LB in each well ...
-
bioRxiv - Immunology 2022Quote: ... the reaction was stopped using 2 N sulfuric acid and the optical density (O.D) was read at 492nm in a multiplate reader (FilterMax F3, Molecular Devices, USA). For antibody response measured in sera data was represented in the graphics as log10 titers ...
-
bioRxiv - Neuroscience 2020Quote: ... Purified F-MAPA linked N-glycans were then resuspended in 200 μL of water and detected using a fluorescence spectrophotometer (SpectraMax i3x, Molecular Devices) with excitation wavelength of 265 nm and emission wavelength 315 nm and quantified (SoftMax Pro Software ...
-
bioRxiv - Microbiology 2021Quote: ... Reaction was terminated using 1 N sulfuric acid and the absorbance was read at 450 nm in a multi-mode plate reader (Molecular devices, USA).
-
bioRxiv - Neuroscience 2023Quote: ... at 2-10 kHz sampling rate and Clampex 10.7 software (Molecular Devices). For voltage-clamp recordings ...
-
bioRxiv - Neuroscience 2021Quote: ... filtered 2 kHz and digitized at 10 kHz with Digidata 1440A (Molecular Devices). Excitatory afferent fibers located between the NAc core and cortex dorsal to the anterior commissure were stimulated with bipolar concentric electrode (FHC ...
-
bioRxiv - Neuroscience 2023Quote: ... filtered to 2 kHz and digitized at 10 kHz (pClamp10 software, Molecular Devices). Data were analyzed using IGOR Pro (Wavemetrics ...
-
bioRxiv - Neuroscience 2021Quote: ... Light-evoked action potentials from ChR2-mCherry+ neurons in the SC were triggered by a light-pulse train (473 nm, 2 ms, 10 Hz or 20 Hz, 20 mW) synchronized with Clampex 10 data acquisition software (Molecular Devices).
-
bioRxiv - Neuroscience 2020Quote: ... Light-evoked action potentials from ChR2-mCherry+ neurons in the SC were triggered by a light-pulse train (473 nm, 2 ms, 10 Hz, 20 mW) synchronized with Clampex 10 data acquisition software (Molecular Devices). Light-evoked postsynaptic currents from SNc neurons were triggered by single light pulses (2 ms ...
-
bioRxiv - Biophysics 2021Quote: ... 10 kHz or by-pass setting and digitized with a Digidata 1550B at a 100 kHz (10 μs bandwidth) or 500 kHz (2 μs bandwidth) sampling rate and recorded using the software pClamp 10 (Molecular Devices). The current trace was analysed using a custom written MATLAB script provided by Prof Joshua B ...
-
bioRxiv - Neuroscience 2022Quote: ... low-pass filtered at 2 KHz and digitized at 10-20 KHz using a Digidata 1322A interface driven by pClamp 10 software (Molecular Devices). Patch pipettes (4-6 MΩ ...
-
bioRxiv - Biophysics 2024Quote: ... Currents were digitized at a sampling rate of 2 kHz and lowpass filtered at 10 Hz with an Axon CNS 1440A Digidata system controlled by pCLAMP 10 (Molecular Devices).
-
bioRxiv - Neuroscience 2022Quote: ... Traces were digitized using an Axon 1440A Digitizer at 10 kHz and filtered at 2 kHz using Clampex 10 software (Molecular Devices, USA). After achieving a stable whole-cell recording ...
-
bioRxiv - Neuroscience 2023Quote: ... Membrane voltage and current were sampled at 10-25 kHz and low-pass filtered at 2-10 kHz using the patch clamp amplifier MultiClamp 700B (Molecular Devices, LLC), digitized and sampled by Micro 1401 with Spike2 software (Cambridge Electronic Design ...
-
bioRxiv - Biophysics 2020Quote: ... Data were acquired at 2 kHz and analyzed using the pClamp 10 software (Molecular Devices, USA). Because extracellular divalent cations (such as ...
-
bioRxiv - Neuroscience 2020Quote: ... Data were acquired at 20 KHz and filtered at 2 KHz with pCLAMP 10 (Molecular Devices). Brain slices were perfused with recording aCSF at 1-2 mL/min with constant oxygenation ...
-
bioRxiv - Neuroscience 2023Quote: ... filtered at 2 kHz and digitized at 10 kHz using a MultiClamp 700B amplifier (Molecular Devices) and stored using pClamp 10 software ...
-
bioRxiv - Neuroscience 2023Quote: ... filtered at 2 kHz and digitized at 10 kHz using a MultiClamp 700B amplifier (Molecular Devices) and stored using pClamp 10 software ...
-
bioRxiv - Pharmacology and Toxicology 2022Quote: ... data were filtered (2 KHz) and digitized (10 KHz) using a Digidata 1550B1 (Molecular Devices, CA, USA).
-
bioRxiv - Cell Biology 2022Quote: ... The signals were acquired at 10 kHz and filtered at 2 kHz using pClamp10 software (Molecular Devices). For nAChR recordings ...
-
bioRxiv - Neuroscience 2022Quote: ... Recordings were filtered at 2 kHz and digitized at 10 kHz using MultiClamp 700B software (Molecular Devices). Claustrum projection neuron type was determined via a 5 ms depolarization step while recording in current-clamp mode to determine burst firing properties (Type I ...
-
bioRxiv - Neuroscience 2024Quote: ... Traces were low-pass filtered at 2 kHz and digitized at 10 kHz (DigiData 1,550, Molecular Devices). Data were acquired and analyzed using Clampfit 11.0 software (Molecular Devices) ...
-
bioRxiv - Neuroscience 2019Quote: ... Signals were sampled at 10 kHz and filtered at 2 kHz in a MultiClamp 700B amplifier (Molecular Devices). Analysis was performed using custom routines in MATLAB (Mathworks ...
-
bioRxiv - Neuroscience 2021Quote: ... filtered at 2 kHz and digitized at 10 kHz with a MultiClamp 700B amplifier (Molecular Devices, CA, USA) and a Digidata 1550 digitizer (Molecular Devices) ...
-
bioRxiv - Neuroscience 2020Quote: ... Signals were filtered at 2 kHz and sampled at 10 kHz with Digidata 1322A (Molecular Devices, Sunnyvale, CA). Patch pipettes made from thin-walled borosilicate glass (outer diameter 1.5 mm ...
-
bioRxiv - Neuroscience 2022Quote: ... low-pass filtered at 2 kHz and acquired using a Digidata 1550B and pClamp 10 software (Molecular devices). All reported voltages are corrected for a −13mV liquid junction potential calculated using Liquid Junction Potential Calculator in pClamp.
-
bioRxiv - Bioengineering 2019Quote: ... Currents were filtered at 2-3 kHz and sampled at 10 kHz using a Digidata 1440 A (Molecular Devices). Patch pipettes (4-6 MΩ ...
-
bioRxiv - Physiology 2023Quote: ... and the data were sampled at 2 kHz and filtered at 1 kHz using pClamp 10 software (Molecular Devices). Light stimulation was applied using LEDs and a multi-LED driver through the microscope optics (DC4100 ...
-
bioRxiv - Neuroscience 2023Quote: ... filtered at 2 kHz and digitized at 10 kHz using a MultiClamp 700B amplifier and Digidata 1550 (Molecular Devices). Clampex version 11.4 (Molecular Devices ...
-
bioRxiv - Neuroscience 2023Quote: ... The data were filtered at 2 kHz and sampled at 10 kHz via a digitizer (Digidata 1440, Molecular Devices) and recorded using Clampex 10.6 software (Molecular Devices) ...
-
bioRxiv - Neuroscience 2020Quote: ... Signals were low-pass filtered (Bessel, 2 kHz) and collected at 10 kHz using the data acquisition software pClamp 10.5 (Molecular Devices). Optical stimulation was applied through the microscope with two LEDs (460 nm and 525 nm ...
-
bioRxiv - Neuroscience 2020Quote: ... The data were low-pass filtered at 2 kHz and digitized at 10 kHz using a Digidata 1322A (Molecular Devices) and stored using Clampex version10 ...
-
bioRxiv - Neuroscience 2020Quote: ... Signals were low-pass filtered (Bessel, 2 kHz) and collected at 10 kHz using the data acquisition software pClamp 10.5 (Molecular Devices). Electrophysiological recordings were extracted using Clampfit (Molecular Devices ...
-
bioRxiv - Cell Biology 2021Quote: ... Data were digitized at 10 kHz with a 2 kHz low-pass filter using a Multiclamp 700A amplifier (Molecular Devices). For all electrophysiological experiments ...
-
bioRxiv - Neuroscience 2021Quote: ... Signals were low pass filtered (Bessel, 2 kHz) and collected at 10 kHz using the data acquisition software pClamp 10.5 (Molecular Devices). All the electrophysiological recordings were extracted using Clampfit (Molecular Devices ...
-
bioRxiv - Neuroscience 2020Quote: Signals were low-pass filtered at 2 kHz and digitised at 10 kHz using an Axopatch 200B amplifier (Molecular Devices) and WinLTP v1.11 acquisition software [46].
-
bioRxiv - Neuroscience 2020Quote: Data were digitized at 10 kHz with a 2 kHz low-pass filter using a Multiclamp 700A amplifier (Molecular Devices). Data were analyzed using Clampfit 9.02 software ...
-
bioRxiv - Biochemistry 2021Quote: ... All currents were sampled at 10 kHz and low-pass filtered at 2 kHz through pCLAMP software (Molecular Devices, Sunnyvale). Origin 9.0 software (OriginLab Corp. ...
-
bioRxiv - Neuroscience 2022Quote: ... Signals were low-pass filtered (Bessel, 2 kHz) and collected at 10 kHz using the data acquisition software pClamp 10.5 (Molecular Devices). All the electrophysiological recordings were extracted using Clampfit (Molecular Devices ...
-
bioRxiv - Molecular Biology 2022Quote: ... filtered at 2 kHz and digitized at 5 kHz using Digidata 1440A interface with pClamp 10 software (Molecular Devices Corporation). Series resistance was typically 5–20 MΩ ...
-
bioRxiv - Neuroscience 2023Quote: ... and data were digitized at 10 kHz and filtered at 1-2 kHz using a 1440A Digidata Digitizer (Molecular Devices). Series and input resistances (10-20 MΩ ...
-
bioRxiv - Neuroscience 2020Quote: ... and were digitized off-line at 10 kHz (low-pass filtered at 2 kHz with an 8-pole Bessel filter) using pCLAMP9 software (Molecular Devices).
-
bioRxiv - Neuroscience 2022Quote: ... and analog signals were low-pass filtered at 2 kHz and digitized at 10 kHz with a Digidata 1550 interface (Molecular Devices). Clampex (v 11.4 ...
-
bioRxiv - Neuroscience 2022Quote: ... Signals were low pass filtered (Bessel, 2 kHz) and collected at 10 kHz using the data acquisition software pClamp 11 (Molecular Devices). Electrophysiological recordings were extracted using Clampfit (Molecular Devices) ...
-
bioRxiv - Neuroscience 2019Quote: ... The data were low-pass filtered at 2 kHz and digitized at 10 kHz with an A/D converter (Digidata 1322A, Molecular Devices) and stored using a data acquisition program (Clampex version 10 ...
-
bioRxiv - Neuroscience 2019Quote: ... Signals were low-pass filtered at 2 kHz and sampled at 10-20 kHz with a Digidata 1440A (Molecular Devices LLC), and data were stored on a computer for subsequent off-line analysis ...