Labshake search
Citations for Molecular Devices :
4001 - 4050 of 10000+ citations since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Neuroscience 2022Quote: ... were determined for designated regions of interest (ROIs) using EasyRatioPro software and the Fratio traces were analysed using Clampfit 9.0 (Molecular Devices). The responses to stimulation were visually verified and confirmed if the maximum increase in Fratio was at least three times greater than the standard deviations of the baseline calculated from at least 50s prior to drug application (Figure S2) ...
-
bioRxiv - Neuroscience 2022Quote: ... Signals were amplified (Multiclamp 700A, Molecular Devices), low pass filtered at 1 kHz ...
-
bioRxiv - Neuroscience 2022Quote: ... and recorded (pClamp 9.2, Molecular Devices) for offline analysis.
-
bioRxiv - Neuroscience 2022Quote: ... or a Multiclamp 700B amplifier with pClamp software (Molecular Devices). Data was digitized at 100 kHz for current-clamp recordings and at 50 kHz for voltage-clamp recordings on the EPC-10 amplifier ...
-
bioRxiv - Neuroscience 2022Quote: ... Spontaneous IPSCs were analysed in Clampfit v10.7.0.3 (Molecular Devices) from all 3-5 minutes of baseline and the last two minutes of drug application to allow for the drug to reach maximum concentration in the recording chamber and achieve reasonable penetration into the slice ...
-
bioRxiv - Microbiology 2022Quote: ... GLuc activity was measured using SpectraMax i3 Multi-mode Detection Platform (Molecular Devices).
-
bioRxiv - Biophysics 2022Quote: ... Data are analyzed by Clampfit software (Molecular Devices) and are filtered by a boxcar filter ...
-
bioRxiv - Biophysics 2022Quote: ... Currents were recorded by GeneClamp 500 voltage patch clamp amplifier (Axon instruments) and digitized by Axon Digidata 1400A digitizer and Clampex 10.6 software (Molecular Devices). TAMRA excitation is done by illumination with a 550 nm LED (pE-4000 CoolLED ...
-
Computational and functional characterization of the PI(4,5)P2 binding site of the TRPM3 ion channelbioRxiv - Biophysics 2022Quote: ... followed by a ramp to 100 mV once every 0.5 s with a GeneClamp 500B amplifier and analyzed with the pClamp 9.0 software (Molecular Devices). Currents were recorded by thin wall glass pipettes which contained inner filament and was filled with 1% agarose in 3 M KCl ...
-
Computational and functional characterization of the PI(4,5)P2 binding site of the TRPM3 ion channelbioRxiv - Biophysics 2022Quote: ... Currents were measured by an Axopatch 200B amplifier and analyzed with the pClamp 9.0 software (Molecular Devices, Sunnyvale, CA, USA). Compounds were dissolved in the bath solution and were delivered to the inner side of cell membrane by a custom-made gravity driven perfusion system ...
-
bioRxiv - Biophysics 2022Quote: ... Clampfit V10.4 (Molecular Devices Corp.), Excel (Microsoft Office 2013 ...
-
bioRxiv - Biophysics 2022Quote: ... Fusion of liposomes was followed by content mixing of the RPLs and subsequent increase in fluorescence which was monitored in a SpectraMax M3 fluorescence plate reader (Molecular devices).
-
bioRxiv - Biophysics 2022Quote: ... All recordings were voltage-clamped at −60 mV and data collected at 5 kHz using an Axopatch 200B amplifier and Digidata 1440A (Molecular Devices, San Jose, CA). Rapid application or washout of agonist were performed using a three-barreled flowpipe mounted to and controlled by a SF-77B fast perfusion system (Warner Instrument Corporation ...
-
bioRxiv - Biophysics 2022Quote: Currents were measured under two-electrode voltage clamp mode using an OC- 725C amplifier (Warner Instruments) and pClamp10.7 software (Molecular Devices). Data were digitized at 10 kHz through Digidata1440 (Molecular Devices) ...
-
bioRxiv - Biophysics 2022Quote: ... Data were digitized at 10 kHz through Digidata1440 (Molecular Devices). The resistance of microelectrodes was adjusted to be 0.2–0.5MΩ when filled with the solution of 3M K-acetate and 10mM KCl ...
-
Computational and functional characterization of the PI(4,5)P2 binding site of the TRPM3 ion channelbioRxiv - Biophysics 2022Quote: ... Data were collected and analyzed with the PClamp10.6 (Clampex) acquisition software (Molecular Devices, Sunnyvale, CA), and further analyzed and plotted with Prism 9 (Graphpad by Dotmatics) ...
-
bioRxiv - Biophysics 2022Quote: ... Data were acquired using a GeneClamp 500B amplifier (MDS Analytical Technologies) controlled by pClamp software (Molecular Devices), and digitized at 1 kHz using Digidata 1332A digitizer (MDS Analytical Technologies).
-
bioRxiv - Biophysics 2022Quote: ... The overall tethered liposomes in the pellet fraction were determined in a SpectraMax M3 fluorescence plate reader (Molecular devices) comparing the ATTO488 fluorescent signal of the supernatant before and after sedimentation.
-
bioRxiv - Biophysics 2022Quote: ... to a computer hard drive with Clampex 10.7 software (Molecular Devices). Currents were recorded at a nominal −40 mV holding potential (−50 mV if corrected for liquid junction potential) ...
-
bioRxiv - Biophysics 2022Quote: ... Data were filtered at 1-3kHz and digitized at 10kHz using a Digidata 1321A interface board and pCLAMP 10 software (Axon; Molecular Devices). Microelectrode resistances were 0.2–0.8MΩ when filled with 3 M KCl ...
-
bioRxiv - Biophysics 2022Quote: ... Images were acquired sequentially with MetaMorph 7.8 software (Molecular Devices, San Jose, CA). The final resolution was 0.107 μm/pixel ...
-
bioRxiv - Biophysics 2022Quote: ... Image acquisition was facilitated by MetaMorph software (Molecular Devices LLC).
-
bioRxiv - Biophysics 2022Quote: ... prefiltered with the amplifier’s built in 5kHz low-pass Bessel filter and sampled at 20 kHz with Digidata 1550B digitizer (Molecular Devices) to a computer hard drive with Clampex 10.7 software (Molecular Devices) ...
-
bioRxiv - Physiology 2022Quote: ... Juxtacellular and intracellular patch clamp signals were acquired with a MultiClamp 700B amplifier (Molecular Devices), digitized at 32 kHz and saved for post hoc analysis.
-
bioRxiv - Plant Biology 2022Quote: ... and the signal was detected using SpectraMax i3x (Molecular Devices, USA).
-
bioRxiv - Animal Behavior and Cognition 2022Quote: ... Data were acquired via the pClamp 11 software (Molecular Devices). Access resistance was monitored online and changes greater than 10% would lead to exclusion of the recordings from data analysis.
-
bioRxiv - Animal Behavior and Cognition 2022Quote: ... Membrane currents were amplified with a Multiclamp 700 B amplifier (Molecular Devices, San Jose, CA, USA), filtered at 3 kHz ...
-
bioRxiv - Animal Behavior and Cognition 2022Quote: ... and sampled at 20 kHz with a Digidata 1550B digitizer (Molecular Devices). Data were acquired via the pClamp 11 software (Molecular Devices) ...
-
bioRxiv - Biochemistry 2022Quote: ... Current recordings were in a whole-cell configuration using Axopatch 200A amplifier (Axon Instruments, Molecular Devices). Data are represented as mean standard error of mean ...
-
bioRxiv - Cancer Biology 2022Quote: ... Fluorescence was then measured with a spectramax paradigm from Molecular Devices. Fluorescence values were normalized to DMSO-treated controls for each AML cell line.
-
bioRxiv - Bioengineering 2022Quote: ... the fluorescence was measured in a FlexStation® 3 Multi-Mode Microplate Reader (Molecular Devices) with excitation at 470 nm and emission at 515 nm and 590 nm.
-
bioRxiv - Bioengineering 2022Quote: ... Fluorescence was measured in a FlexStation® 3 Multi-Mode Microplate Reader (Molecular Devices) with excitation measured at 470 nm and emission at 515 nm and 590 nm ...
-
bioRxiv - Bioengineering 2022Quote: ... Bioluminescence was measured using a FlexStation® 3 Multi-Mode Microplate Reader (Molecular Devices) with NLuc emission measured at 440 nm and mScarlet-I at 590 nm ...
-
bioRxiv - Bioengineering 2022Quote: ... Bioluminescence was measured using a FlexStation® 3 Multi-Mode Microplate Reader (Molecular Devices) with NLuc emission measured at 440 nm and mScarlet-I emission at 590 nm.
-
bioRxiv - Bioengineering 2022Quote: ... Immediately we stopped the reaction by adding 50 μL of 2 N H2SO4 solution and analyzed on a microplate reader (Molecular Devices, Spectramax I3) at 450 nm wavelength ...
-
bioRxiv - Bioengineering 2022Quote: Calcium oscillatory peak detection data from FLIPR recordings was obtained through ScreenWorks 5.1 (Molecular Devices). Initial peak detection analysis occurred within ScreenWorks 5.1 via the PeakPro 2.0 module ...
-
bioRxiv - Bioengineering 2022Quote: ... Cal6 (Molecular Devices), and genetically encoded calcium indicator ...
-
bioRxiv - Bioengineering 2022Quote: ... and a spectrophotometer (Molecular Devices, SpectraMax i3). We repeated the experiment thrice and plotted the cumulative concentrations in Figure S5.
-
bioRxiv - Bioengineering 2022Quote: ... We then used colorimetric detection to measure the absorbance of each well at 450 nm wavelength with a spectrophotometer (Molecular Devices, SpectraMax i3). We compared the absorbances with a previously obtained standard curve of human insulin (Figure S6) ...
-
bioRxiv - Bioengineering 2022Quote: The FLIPR Penta (Molecular Devices) was used to assess calcium fluorescence across the 384-well plate simultaneously and to observe changes after treatment with compounds ...
-
bioRxiv - Bioengineering 2022Quote: ... Initial fluorescence was measured in a FlexStation® 3 Multi-Mode Microplate Reader (Molecular Devices) with excitation at 470 nm and emission at 515 nm and 590 nm ...
-
bioRxiv - Bioengineering 2022Quote: ... FMP2 FLIPR Membrane potential assays (Molecular Devices) were performed as previously described25 ...
-
bioRxiv - Bioengineering 2022Quote: ... one of 16 coplanar gold lines leading to MECA16-cavities (50 μm diam.) was directly contacted with a 1 cm unshielded silver wire to the head-stage of an Axopatch 200B (Molecular Devices, Sunnyvale, CA, USA) patch clamp amplifier operated in capacitive feedback mode at 50 mV/pA gain with the internal low-pass-filter set to 100 kHz cut-off (−3 dB) ...
-
bioRxiv - Bioengineering 2022Quote: ... and CFP images were acquired every 15 mins with an Olympus 60x oil objective using automated acquisition software (Metamorph, Molecular Devices, San Jose, CA), then differential interference contrast and GFP images were acquired at the beginning and the end of the movie.
-
bioRxiv - Biophysics 2022Quote: ... Action potential parameters were analyzed manually using pCLAMP 11 (Molecular Devices).
-
bioRxiv - Biophysics 2022Quote: ... Currents were analyzed using pCLAMP 11 (Molecular Devices). The single-channel event detection algorithm of pCLAMP was used to measure single-channel opening amplitudes and times ...
-
bioRxiv - Biophysics 2022Quote: ... Recordings were made at room temperature using Clampex v.10.7 data acquisition software (as part of the pClamp v.10.7 suite) with an Axopatch 200B Patch Clamp amplifier and Digidata 1550B digitizer (Molecular Devices) at a bandwidth of 1 kHz and digitized at 500 kHz ...
-
bioRxiv - Biochemistry 2022Quote: ... The luminescence mode of FLIPRTETRA (Molecular Devices) was employed using a gain of 28,000 ...
-
bioRxiv - Biochemistry 2022Quote: ... The area under the curve (AUC) was computed using ScreenWorks (Molecular Devices), with the third interval serving as the baseline for background subtraction ...
-
bioRxiv - Cell Biology 2022Quote: ... The endpoint OD570 of sample wells was measured on a Spectramax iD3 spectrometer (SpectraMax, Molecular Devices) and the total amount of ATP was determined from a standard curve constructed with 0–10 nmol ATP ...