Labshake search
Citations for Molecular Devices :
351 - 400 of 1067 citations for 6H Dipyrido 3 2 b 2' 3' e 1 4 diazepin 6 one 11 ethyl 5 11 dihydro 8 2 hydroxyethyl 5 methyl since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Biophysics 2020Quote: ... Currents were filtered at 2 kHz using low-pass Bessel filter of the amplifier and digitized using a Digidata 1440 unit (Molecular Devices). All measurements were performed with extracellular (EC ...
-
bioRxiv - Neuroscience 2021Quote: ... Currents were filtered at 2 kHz using low-pass Bessel filter of the amplifier and digitized using a Digidata 1440 unit (Molecular Devices). Mechanical stimulation in cell attached patches was performed using a high-speed pressure clamp (Besch et al. ...
-
bioRxiv - Molecular Biology 2022Quote: ... NADH oxidation rate was determined by kinetic absorbance at 340 nm which was collected every 2 min for 30 min using SpectraMax M5 plate reader (Molecular Devices). To determine LDH activity ...
-
bioRxiv - Bioengineering 2022Quote: ... Membrane currents were low pass filtered at 2 kHz and digitized with a sampling rate of 10 kHz (Digidata 1440 A, Molecular Devices).
-
bioRxiv - Neuroscience 2022Quote: ... low-pass filtered at 2 KHz and digitized at 10-20 KHz using a Digidata 1322A interface driven by pClamp 10 software (Molecular Devices). Patch pipettes (4-6 MΩ ...
-
bioRxiv - Biochemistry 2023Quote: ... The detection system consisted of 2 µM Safraine O and fluorescence was monitored using a microplate reader (SpectraMax Paradigm, Molecular Devices) at Λexcitation= 495 nm ...
-
bioRxiv - Physiology 2023Quote: ... The current was induced with a 500 ms depolarization step at 0 mV from the holding potential of −60 mV using barium as the charge carrier and was sampled at 10 kHz and filtered at 2 kHz in the whole-cell voltage patch-clamp configuration with an Axopatch 200B amplifier (Molecular Devices). Peak and residual currents were obtained with Clampfit software (Molecular Devices) ...
-
bioRxiv - Neuroscience 2023Quote: ... Voltage and current signals were low pass-filtered (10 kHz) and sequences of 2 s were acquired at 20 kHz with pClamp (Axon Instruments, Molecular Devices). Intrinsic excitability was tested with injection of current pulses (150-250 nA ...
-
bioRxiv - Neuroscience 2023Quote: ... with the analog signals filtered at 2-10 kHz and sampled at 20-50 kHz using a Digidata 1440 digitizer (Molecular Devices). Data was collected using pClamp 10 software (Molecular Devices) ...
-
bioRxiv - Biochemistry 2023Quote: ... The reaction was initiated by the addition of 300 μM GTP and the fluorescence was recorded after every 2 min over 60 min at 30 °C using a plate reader FlexStation3 (Molecular devices). For measuring the activity of RdRp in the condensates the same reaction was setup in 96 Well glass bottom plates (Cellvis ...
-
bioRxiv - Biophysics 2023Quote: ... and 95 % relative humidity for 2 h in 200 µL dye buffer according to the manufacturer’s protocol (Molecular Devices, ref: R8190). Just before the assay ...
-
bioRxiv - Cell Biology 2022Quote: ... Images were acquired at the 2-week endpoint (day 14 of CSE treatment) at 4X magnification using the ImageXpress confocal microscope (Molecular Devices) to observe changes to spheroid size due to compound treatment ...
-
bioRxiv - Neuroscience 2023Quote: ... Data was acquired using Clampex 10.7 software with an Axoclamp 700B amplifier and digitized at 20 kHz with a Digidata 1440A interface and filtered at 2 kHz (Molecular Devices). Recordings where access was greater than 30MW or that changed by >20% were discarded ...
-
bioRxiv - Pharmacology and Toxicology 2023Quote: ... Fluorescence was measured every 2 seconds (λexcitation = 470 nm, λemission = 515 nm) using a high-throughput FLIPRTETRA cellular screening system (Molecular Devices). Peptides were added after at least 2 min of background recording ...
-
bioRxiv - Neuroscience 2023Quote: ... Locomotion and imaging triggers were synchronously acquired and digitized using a 1440A Digidata (Axon instrument, 2 kHz sampling) and the pClamp 10 software (Molecular Devices).
-
bioRxiv - Neuroscience 2024Quote: ... low-pass filtered at 2 kHz and digitized at 20 kHz using the Digidata 1440A interface and pClamp 10 software (Molecular Devices). Putative 5-HT neurons were identified on the basis of their characteristic response to a series of hyper-and depolarizing current pulses (duration ...
-
bioRxiv - Neuroscience 2024Quote: ... evoked synaptic currents recorded in 2 min (12 sweeps) at Vh= -70 mV were averaged and analyzed using Clampfit10 (Molecular Devices). Five electrical stimuli from a Digitimer isolated stimulator (DS2A Mk.II ...
-
bioRxiv - Biophysics 2024Quote: ... Currents were digitized at a sampling rate of 2 kHz and lowpass filtered at 10 Hz with an Axon CNS 1440A Digidata system controlled by pCLAMP 10 (Molecular Devices).
-
bioRxiv - Biophysics 2024Quote: ... Currents were low-pass filtered at 2 kHz and acquired at 10 kHz by the analogue-to-digital interface Digidata 1440 (Molecular Devices). All experiments were performed at room temperature (20°–22°C) ...
-
bioRxiv - Neuroscience 2021Quote: ... Signals were filtered at 5 kHz with the patch-clamp amplifier (Axopatch 1-D, Molecular Devices, Sunnyvale, CA) and sampling rate was adjusted according to the kinetics of membrane current ...
-
bioRxiv - Neuroscience 2021Quote: ... Signals were acquired at 20 kHz and low-pass Bessel filtered at 8 kHz with a Multiclamp 700 B amplifier (Molecular Devices, Axon Instruments). Spikes were ...
-
bioRxiv - Neuroscience 2020Quote: ... 5) and a Multiclamp 700B and Digidata 1322A (Molecular Devices). Illumination (∼560nm ...
-
bioRxiv - Neuroscience 2020Quote: ... and current clamped recordings were made using a MultiClamp 700B amplifier (2 kHz low-pass Bessel filter and 10 kHz digitization) with pClamp 10.3 software (Molecular Devices, Sunnyvale, CA). Firing rate was determined before breaking into the cell under cell attached mode for at least 60 seconds of continuous activity ...
-
bioRxiv - Neuroscience 2022Quote: ... Signal acquisition was performed at 10 kHz, filtered with a lowpass (Bessel, 2 kHz) and collected by the acquisition software pClamp 10.5 (Molecular Devices, Sunnyvale, CA). Nicotine tartrate (30 μM in aCSF ...
-
bioRxiv - Cell Biology 2022Quote: ... Whole-cell current-clamp recording was carried out at room temperature (22 ± 2 °C) using an Axopatch 200B amplifier (Molecular Devices, USA). Pipette (Intracellular ...
-
bioRxiv - Genetics 2020Quote: ... 100 µL of the supernatant were transferred in another transparent plate before reading absorbance at 450 ± 2 nm on SpectraMax® 190 microplate reader (Molecular Devices). For β-arrestin2 recruitment assays ...
-
bioRxiv - Neuroscience 2022Quote: ... Traces were digitized using an Axon 1440A Digitizer at 10 kHz and filtered at 2 kHz using Clampex 10 software (Molecular Devices, USA). After achieving a stable whole-cell recording ...
-
bioRxiv - Biophysics 2023Quote: ... Current traces were filtered at 2 kHz and acquired at 10 kHz via a Digidata 1550B interface and pCLAMP software (Molecular Devices, USA). The membrane potential was held at -60 mV during the recording ...
-
bioRxiv - Biophysics 2024Quote: ... Both dye uptake and electrophysiological recordings were acquired at a 2 kHz sample rate and analyzed using pClamp 10 software (Molecular Devices, USA).
-
bioRxiv - Neuroscience 2023Quote: ... with a low-pass filtered at 2 kHz and digitized at 10k Hz through Axon Digidata 1440A interface (Molecular Devices, CA, USA) running Clampex software (Molecular Devices ...
-
bioRxiv - Neuroscience 2023Quote: ... Membrane voltage and current were sampled at 10-25 kHz and low-pass filtered at 2-10 kHz using the patch clamp amplifier MultiClamp 700B (Molecular Devices, LLC), digitized and sampled by Micro 1401 with Spike2 software (Cambridge Electronic Design ...
-
bioRxiv - Microbiology 2021Quote: ... The reading was performed on the ELISA reader (FlexStation® 3, Molecular Devices, USA) at a wavelength of 540 nm ...
-
P2RX7 inhibition reduces breast cancer induced osteolytic lesions - implications for bone metastasisbioRxiv - Cancer Biology 2022Quote: ... and the fluorescence measured using FlexStation-3 Multimode Microplate reader (Molecular Devices, Wokingham, UK) with excitation at 494nm and emission at 506nm ...
-
bioRxiv - Cell Biology 2021Quote: ... The fluorescent signal was determined using the Flexstation® 3 Plate Reader (Molecular Devices) for fluorescence reading (Excitation λ ...
-
bioRxiv - Cancer Biology 2020Quote: ... Bioluminescence was assessed by optical top reading via FlexStation 3 microplate reader (Molecular Devices).
-
bioRxiv - Bioengineering 2022Quote: ... Bioluminescence was measured using a FlexStation® 3 Multi-Mode Microplate Reader (Molecular Devices) with NLuc emission measured at 440 nm and mScarlet-I emission at 590 nm ...
-
bioRxiv - Bioengineering 2022Quote: ... Fluorescence was measured in a FlexStation® 3 Multi-Mode Microplate Reader (Molecular Devices) with excitation measured at 470 nm and emission at 515 nm and 590 nm ...
-
bioRxiv - Bioengineering 2022Quote: ... Bioluminescence was measured using a FlexStation® 3 Multi-Mode Microplate Reader (Molecular Devices) with NLuc emission measured at 440 nm and mScarlet-I at 590 nm ...
-
bioRxiv - Bioengineering 2022Quote: ... Bioluminescence was measured using a FlexStation® 3 Multi-Mode Microplate Reader (Molecular Devices) with NLuc emission measured at 440 nm and mScarlet-I emission at 590 nm.
-
bioRxiv - Cancer Biology 2022Quote: ... Luminescence intensity values were measured by FlexStation-3 (Molecular Devices, San José, CA, USA).
-
bioRxiv - Bioengineering 2022Quote: ... The images of these droplets (n ≥ 3) were acquired with Metamorph software (Molecular Devices) with a 30-s interval and a 100-ms exposure time.
-
bioRxiv - Neuroscience 2020Quote: ... Fluorescence (λexc/em 485/540) was acquired with either a FlexStation 3 (Molecular Devices) equipped with automatic injectors or with an INFINITY 500 (TECAN ...
-
bioRxiv - Neuroscience 2022Quote: ... Recordings were filtered at 3–10 kHz using an Axoclamp 2A Amplifier (Molecular Devices), and collected for online analysis at a sampling rate of 20kHz (Nguyen ...
-
bioRxiv - Cancer Biology 2022Quote: ... and fluorescence measured at 450 nM after 60 minutes using FlexStation 3 (Molecular Devices). PP4 activity is shown as percentage of untreated control.
-
bioRxiv - Cell Biology 2022Quote: ... Fluorescence was monitored on a FlexStation 3 microplate reader (Molecular Devices, Sunnyvale, CA, USA) by alternately exciting the Ca2+ indicator at 340 and 380 nm and collecting emitted fluorescence above 510 nm ...
-
bioRxiv - Neuroscience 2023Quote: ... and filtered at 3 kHz using a Digidata 1440A (Molecular devices, San Jose, CA). Cells were excluded if the access resistance (Ra ...
-
bioRxiv - Cell Biology 2023Quote: ... Bioluminescence was measured using a FlexStation® 3 Multi-Mode Microplate Reader (Molecular Devices) with NLuc emission measured at 440 nm and mScarlet-I emission at 590 nm.
-
bioRxiv - Neuroscience 2024Quote: ... and filtered at 3 kHz using a Digidata 1440A (Molecular Devices, San Jose, CA). Cells were excluded if the access resistance (Ra ...
-
bioRxiv - Neuroscience 2024Quote: ... Recordings were filtered at 3–10 kHz using an Axoclamp 2A Amplifier (Molecular Devices), and collected for online analysis at a sampling rate of 20 kHz using WinLTP software [43].
-
bioRxiv - Microbiology 2019Quote: ... The plates were further incubated at 37 °C under a 5 % CO2 for 6 to 8 hours before measuring the fluorescence of each culture using a Gemini Fluorescent Plate reader (Molecular Devices) set at λEX = 530 nm and λEM = 585 nm with a filter cut off at 550 nm ...