Labshake search
Citations for Molecular Devices :
301 - 350 of 476 citations for 5 Methylsulfamoylmethyl 1H indole 3 carboxylic acid methyl ester since 2020
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Neuroscience 2022Quote: ... Intracellular recordings from MNs were made with 10-20 MΩ sharp electrodes filled with 3 M potassium acetate connected to an Axoclamp 2-B amplifier (Molecular Devices). Data acquisition and analyses of resting potential ...
-
bioRxiv - Cancer Biology 2024Quote: QGP1 and NT3 cells were seeded in 96-well cell culture plates at a confluency of 30000 cells/well and the following day were assayed for [Ca2+]i measurements using a FlexStation 3 96-well multi-mode microplate reader (Molecular Devices). Before the assays ...
-
bioRxiv - Cancer Biology 2024Quote: ... BrdU incorporation was determined after addition of the peroxidase substrate by OD quantification at 370 nm and subtraction of the background measured at 492 nm by spectrometer (Flexstation 3, Molecular Devices).
-
bioRxiv - Neuroscience 2024Quote: ... Currents were digitally filtered offline by using a low-pass Gaussian filter with a −3 dB cut-off set to 2 kHz (Clampfit software; pClamp 11, Molecular Devices).
-
bioRxiv - Molecular Biology 2024Quote: ... the absorbance of NAGase /ACP was recorded at 405 nm/ 510 nm using a FlexStation 3 Multi-Mode microplate reader (Molecular Devices) respectively ...
-
Kir6.1, a component of an ATP-sensitive potassium channel, regulates natural killer cell developmentbioRxiv - Immunology 2024Quote: ... Fluorescence was recorded at excitation/emission wavelengths of 485 nm/525 nm using a microplate reader equipped with a dispenser unit for adding compounds during the recording (FlexStation 3, Molecular Devices). Fluorescence intensities were recorded every 2 s for the duration of the experiment ...
-
bioRxiv - Neuroscience 2024Quote: ... Electrical signals were acquired at 10 kHz and low-pass filtered at 3 kHz using a Multiclamp 700B or Multiclamp 700A amplifier (Molecular Devices) and Symphony Data Acquisition software (http://symphony-das.github.io) ...
-
bioRxiv - Neuroscience 2024Quote: ... Data were filtered by a low-pass Bessel filter at 3 kHz and sampled at 10 kHz using an Axon Digidata 1322A digitizer (Molecular Devices).
-
bioRxiv - Microbiology 2024Quote: ... 0.1 mL reaction buffer was added to the wells with bacterial cultures and bioluminescence was detected by a FlexStation 3 Multi-Mode Microplate Reader (Molecular Devices).
-
bioRxiv - Molecular Biology 2024Quote: ... Luminescence activities of Rluc and Fluc were collected for 3 ug of protein combined with respective substrates 10x diluted and were measured in a Spectra Max M3 (Molecular Devices) plate reader.
-
bioRxiv - Neuroscience 2024Quote: ... Signals were acquired by a MultiClamp 700B amplifier then digitized at 10 kHz and low-pass filtered at 3 kHz with an 8-pole Bessel filter using a Digidata 1550B and Clampex 11 (Molecular Devices). To generate action potential spikes ...
-
bioRxiv - Neuroscience 2024Quote: ... Signals were filtered at 3 kHz using a Bessel filter and digitized at 10 kHz with Digidata 1550 analog-to-digital interface (Molecular Devices). The recorded traces were analyzed using the Clampfit 10 software (Molecular Devices).
-
bioRxiv - Neuroscience 2024Quote: ... Electrophysiological data were sampled at 20 kHz and filtered at 3 kHz using a Digidata 1550 analogue to digital converter and pClamp 10 software (Molecular Devices). Upon the formation of a GΩ seal ...
-
bioRxiv - Neuroscience 2021Quote: ... Data (5-22 slices/condition) were analysed using the pClamp-10 Program software (CA/Molecular Devices, USA).
-
bioRxiv - Neuroscience 2020Quote: ... Signals were low-pass filtered at 5 kHz and digitized at 20 kHz (Digidata 1550B, Molecular Devices). Acquisition and subsequent analysis of the acquired data were performed using Clampex9 and Clampfit software (Axon Instruments) ...
-
bioRxiv - Biochemistry 2020Quote: ... USA) and digitized at a sampling rate of 5 kHz using a DigiData 1440A interface (Molecular Devices) and pCLAMP software (version 10.4) ...
-
bioRxiv - Microbiology 2023Quote: ... Obtained absorbance was further analyzed using SoftMAx Pro Microplate analysis software (version 5, Molecular devices, California, USA). Absorbance was normalized to the no-cell control ...
-
bioRxiv - Neuroscience 2023Quote: ... 5 HEPES—and were held by a pipette holder containing an Ag/AgCl electrode (Molecular Devices, USA) and mounted on a motorized micromanipulator (Scientifica ...
-
bioRxiv - Neuroscience 2022Quote: ... Signals were low-pass filtered at 5 kHz and digitized at 20 kHz (Digidata 1550B, Molecular Devices). In vitro data analysis was performed with the help of Clampfit 10.7 (Molecular Devices ...
-
bioRxiv - Neuroscience 2021Quote: ... spikes and potentials were sorted and counted from 3-minute gap-free recordings using the pCLAMP10 software (Molecular Devices Corporation, California, USA).
-
bioRxiv - Neuroscience 2020Quote: Signals were digitized at 10 kHz and filtered at 3 kHz using a Multiclamp 700B amplifier and analyzed using Clampfit 10.7 software (Molecular Devices, Sunnyvale, CA). For all measures ...
-
bioRxiv - Cell Biology 2022Quote: ... Eluent was transferred to a 96-well plate where absorbance at 500 nm was measured by a FlexStation® 3 microplate reader (Molecular Devices).
-
bioRxiv - Cell Biology 2022Quote: ... The assay was performed according to the manufacturer’s instructions with FlexStation® 3 Multi-Mode Microplate Reader (Molecular Devices, Sunnyvale, CA, USA). The Cyto-ID fluorescence was determined at Ex 480 nm/Em 530 nm ...
-
bioRxiv - Neuroscience 2022Quote: ... Data acquisition (digitized at 10 kHz and filtered at 3 kHz) was performed with pClamp 10.4 software (Molecular Devices, Sunnyvale, CA, USA). Input resistance and cells capacitance were measured online with the membrane test feature of the pClamp software ...
-
bioRxiv - Immunology 2020Quote: ... His-tagged RBD of SARS-CoV or SARS-CoV-2 were loaded at 3 µg/ml in KB for 15 minutes onto anti-HIS (HIS2) biosensors (Molecular Devices, ForteBio). Association of mAb and Fab was performed in KB at 15 μg/ml and 5 μg/ml respectively for 5 minutes ...
-
bioRxiv - Immunology 2022Quote: ... Caspase-3 activity was measured by Caspase-3 activity detection kit (Beyotime, China) and tested by a Flex Station II microplate reader (Molecular Devices, USA).
-
bioRxiv - Cell Biology 2023Quote: ... The effluent solutions collected from the top and bottom channels were used for fluorescence measurements using a plate reader (Flexstation 3, Molecular Devices, USA). Subsequently ...
-
bioRxiv - Neuroscience 2024Quote: ... λEM: 516 nm (F340/F380)) were measured every 4 s using a FlexStation 3 fluorescent microplate reader (Molecular Devices, Sunnyvale, CA, USA). During the measurements ...
-
bioRxiv - Neuroscience 2023Quote: ... Whole cell patch-clamp recordings from pyramidal neurons in Layer 2/3 of V1 were made using a Multiclamp 700B amplifier in voltage clamp mode and PClamp software (Molecular Devices, USA). Cells were patched with borosilicate glass electrodes with tip resistances of ∼3.5 MOhm ...
-
bioRxiv - Neuroscience 2022Quote: ... The final samples after running all the procedures were read on a multi-mode microplate reader (FlexStation 3, Molecular Devices, California, USA). The assay was performed in duplicate ...
-
bioRxiv - Neuroscience 2024Quote: Signals were digitized at 10 kHz and filtered at 3 kHz using a Multiclamp 700B amplifier and analyzed using Clampfit 10.7 software (Molecular Devices, Sunnyvale, CA). Traces were excluded from analysis of specific measures if there was spontaneous activity or instability in the section of trace needed for analysis.
-
bioRxiv - Physiology 2024Quote: ... Assays were performed following the manufacturer’s instructions in duplicate and read on a FlexStation 3 plate reader (Molecular Devices, Eugene, OR, USA). Results were determined using the FlexStation software with a 4-parameter logistic curve ...
-
bioRxiv - Neuroscience 2021Quote: ... The data was digitized at 5–500 kHz using an analog-to-digital converter (Digidata 1500; Molecular Devices). The sampling frequency was determined by the protocol used ...
-
bioRxiv - Neuroscience 2021Quote: ... The data were digitized at 5–500 kHz using an analog-to-digital converter (Digidata 1500; Molecular Devices). The whole-cell current recordings were done using pCLAMP software (version 10 ...
-
bioRxiv - Neuroscience 2021Quote: ... Signals were filtered at 5 kHz with the patch-clamp amplifier (Axopatch 1-D, Molecular Devices, Sunnyvale, CA) and sampling rate was adjusted according to the kinetics of membrane current ...
-
bioRxiv - Biophysics 2022Quote: ... The data were filtered at 5 kHz and sampled at 20 kHz (Digdata1550, Molecular Devices, Sunnyvale, CA, USA) and stored in a computer (pClamp10.6 ...
-
bioRxiv - Neuroscience 2021Quote: ... Signals were filtered at 5 kHz using a Digidata 1500A data acquisition interface (Molecular Devices, San Jose, CA) and acquired using pClamp 10.6 software (Molecular Devices) ...
-
bioRxiv - Neuroscience 2021Quote: ... Whole-cell measurements were low-pass filtered at 5 kHz using an Axopatch 200B amplifier (Molecular Devices, Inc). Recordings were digitized with the ITC-18 board (Instrutech ...
-
bioRxiv - Neuroscience 2023Quote: ... All electrophysiological data were digitized at 5-10 KHz with a Digidata 1440A data acquisition board (Molecular Devices).
-
bioRxiv - Neuroscience 2023Quote: ... The data were digitized at 5-20 kHz using an analog-to-digital converter (Digidata 1500; Molecular Devices). The whole-cell current recordings were conducted using pCLAMP software (version 10 ...
-
bioRxiv - Neuroscience 2022Quote: ... Data were acquired and filtered (at 5 kHz 4-pole Bessel filter) with MultiClamp 700B amplifier (Molecular Devices), digitized with Digidata 1440A (Molecular Devices ...
-
bioRxiv - Biochemistry 2024Quote: ... bioluminescence data were collected for ∼5 min on a SpectraMax iD3 plate reader (Molecular Devices, Sunnyvale, CA, USA). Subsequently ...
-
bioRxiv - Bioengineering 2023Quote: ... and performing an absorbance spectral scan (200–1000 nm; 5 nm increments) using a Spectramax M3 (Molecular Devices).
-
bioRxiv - Neuroscience 2022Quote: ... low-pass filtered at 5 kHz and digitally sampled at 20 kHz and analyzed with pClamp10 (Molecular Devices). Depolarizing current steps (800 msec duration ...
-
bioRxiv - Biochemistry 2023Quote: ... Samples were incubated at RT for 5 min before fluorescence was measured using a SpectraMax M5 (Molecular Devices) microplate reader with excitation/emission maxima at 490/520 nm ...
-
bioRxiv - Neuroscience 2024Quote: ... low-pass filtered (5 KHz) and digitised (Axopatch-200B, custom amplifier/filters, Digidata 1440, Clampex software; Molecular Devices). Pipettes and electrodes were positioned with Sutter MP265 and 285 manipulators with a diagonal (axial ...
-
bioRxiv - Neuroscience 2024Quote: ... Signals were filtered at 5 kHz using a Digidata 1500B data acquisition interface (Molecular Devices, San Jose, CA) and acquired using pClamp 10.6 software (Molecular Devices) ...
-
bioRxiv - Biophysics 2021Quote: ... and currents were recorded with microelectrodes filled with 3 mM KCl (pipette resistance of < 1 MΩ), OC-725C amplifier (Warner, CT, USA) and Digidata 1550 digitizer (Molecular Devices, CA, USA) at 1 kHz with 200 Hz filtering ...
-
bioRxiv - Neuroscience 2022Quote: Whole cell patch-clamp recordings were obtained from S1 layer 2/3 neurons with a Multiclamp 700B amplifier (Molecular Devices, San Jose, CA) low-pass filtered at 1.8 kHz with a four-pole Bessel filter ...
-
bioRxiv - Neuroscience 2021Quote: ... The assay involved adding 20 µL MTS reagent to each well already containing 100 µL media and incubating the plate for 3 hours before measuring the absorbance at 490 nm with a Spectra Max M2 plate reader (Molecular Devices, Sunnyvale, CA). The background absorbance of MTS in media alone was subtracted from the absorbance obtained in the presence of cells ...