Labshake search
Citations for Molecular Devices :
151 - 200 of 372 citations for Cow Four And A Half LIM Domains Protein 2 FHL2 ELISA Kit since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Neuroscience 2021Quote: ... with Bessel filter of 2 kHz and digitized at 50 kHz using Axon DigiData 1500A (Molecular Devices). The Axon pClamp 10 (Molecular Devices ...
-
bioRxiv - Neuroscience 2020Quote: ... spike threshold in Spike 2 v7.10 (Cambridge Electronic Design) and action potential properties in pCLAMP (Molecular Devices). A total of 20 mice were used for intrinsic excitability experiments.
-
bioRxiv - Pharmacology and Toxicology 2022Quote: ... data were filtered (2 KHz) and digitized (10 KHz) using a Digidata 1550B1 (Molecular Devices, CA, USA).
-
bioRxiv - Physiology 2021Quote: ... and low pass filtered at 2 kHz using a MultiClamp 700B amplifier and Clampex (Molecular Devices, LLC). Leak currents before mechanical stimulation were subtracted offline from the current traces.
-
bioRxiv - Pharmacology and Toxicology 2020Quote: ... Data were sampled at 2 kHz using the pClamp 10.4 acquisition software (Axon Instruments, Molecular Devices, USA). The microelectrodes were pulled from glass capillaries (TW 120.3 ...
-
bioRxiv - Cell Biology 2022Quote: ... The signals were acquired at 10 kHz and filtered at 2 kHz using pClamp10 software (Molecular Devices). For nAChR recordings ...
-
bioRxiv - Neuroscience 2022Quote: ... Recordings were filtered at 2 kHz and digitized at 10 kHz using MultiClamp 700B software (Molecular Devices). Claustrum projection neuron type was determined via a 5 ms depolarization step while recording in current-clamp mode to determine burst firing properties (Type I ...
-
bioRxiv - Immunology 2023Quote: ... and 2% phosphoric acid and measuring absorbance at 546nm with a SpectraMax M2 microplate reader (Molecular Devices).
-
bioRxiv - Neuroscience 2023Quote: ... at 100 kHz sampling rate and filtered at 2 kHz using a MultiClamp 700B amplifier (Molecular Devices). At the end of the recording ...
-
bioRxiv - Neuroscience 2023Quote: ... at 100 kHz sampling rate and filtered at 2 kHz using a MultiClamp 700B amplifier (Molecular Devices). 30 consecutive action potentials were recoded every 5 seconds using Clampex 10.6 (Molecular Devices ...
-
bioRxiv - Neuroscience 2024Quote: ... Data acquisition (filtered at 2–3 kHz and digitized at 10kHz; Digidata 1440, Molecular Devices, CA, USA) was performed using the Multiclamp 700B amplifier and the Clampex 10.9 software (Molecular Devices) ...
-
bioRxiv - Neuroscience 2024Quote: ... Traces were low-pass filtered at 2 kHz and digitized at 10 kHz (DigiData 1,550, Molecular Devices). Data were acquired and analyzed using Clampfit 11.0 software (Molecular Devices) ...
-
bioRxiv - Neuroscience 2024Quote: ... We acquired wingbeat amplitude data at 2 kHz using a Digidata 1550B or 1440A amplifier (Molecular Devices) for the afferents and muscles ...
-
bioRxiv - Neuroscience 2019Quote: ... The linear density and total gray value of each synaptic protein cluster were measured automatically using MetaMorph Software (Molecular Devices). Cultures directly compared were stained simultaneously and imaged with the same acquisition parameters ...
-
bioRxiv - Pathology 2019Quote: Protein concentration was determined using the Bio-Rad Protein Assay according to the manufacturer’s protocol with absorbance read at 595 nM on a SpectraMax ID3 spectrophotometer (Molecular Devices). Proteins were denatured in NuPage sample buffer containing 2.5 % β-mercaptoethanol and equal amounts (10-20 µg ...
-
Kinetic analysis reveals the rates and mechanisms of protein aggregation in a multicellular organismbioRxiv - Biophysics 2020Quote: Relative protein amounts in developing AM141 animals were determined from fluorescence images acquired on the ImageXpress confocal platform (Molecular Devices). Relative intracellular protein concentrations were obtained by dividing the integrated fluorescence intensity per animal by the total fluorescent volume per animal determined as described above.
-
bioRxiv - Neuroscience 2022Quote: The protein concentration of each sample was measured using the Lowry method and a SpectraMax M3 plate reader (Molecular Devices) was used to measure the colorimetric reaction ...
-
bioRxiv - Neuroscience 2019Quote: ... Signals were sampled at 10 kHz and filtered at 2 kHz in a MultiClamp 700B amplifier (Molecular Devices). Analysis was performed using custom routines in MATLAB (Mathworks ...
-
bioRxiv - Neuroscience 2021Quote: ... filtered at 2 kHz and digitized at 10 kHz with a MultiClamp 700B amplifier (Molecular Devices, CA, USA) and a Digidata 1550 digitizer (Molecular Devices) ...
-
bioRxiv - Neuroscience 2020Quote: ... low-pass filtered at 2 kHz using a Digidata 1550B low noise data acquisition system (Molecular Devices, USA). For whole-cell recordings ...
-
bioRxiv - Neuroscience 2021Quote: ... Recordings were made using an Axoclamp 2 B amplifier with HS-2A x0.1 headstage (Molecular Devices, CA, USA) and on a BX51WI Olympus microscope with a 40X LUMPlanFL/IR water immersion objective (Olympus Corporation ...
-
bioRxiv - Neuroscience 2020Quote: ... Signals were filtered at 2 kHz and sampled at 10 kHz with Digidata 1322A (Molecular Devices, Sunnyvale, CA). Patch pipettes made from thin-walled borosilicate glass (outer diameter 1.5 mm ...
-
bioRxiv - Neuroscience 2020Quote: ... Data acquisition (filtered at 2–3 kHz and digitized at 15 kHz; Digidata 1440A, Molecular Devices, CA, USA) was performed using the Axopatch 200B amplifier and the Clampex 10.6 software (Molecular Devices) ...
-
bioRxiv - Neuroscience 2020Quote: ... Data were filtered during acquisition with a low pass filter set at 2 kHz using pClamp10 (Molecular Devices). Data analysis was performed offline with Clampfit 10.2 (Molecular Devices).
-
bioRxiv - Neuroscience 2022Quote: ... Data were filtered at 2 kHz and digitized at 20 kHz using a 1440A Digidata Digitizer (Molecular Devices). Series-resistance (<20 MΩ ...
-
bioRxiv - Neuroscience 2020Quote: ... Signals were low-pass filtered at 2 kHz and sampled at 10kHz with a Digidata 1440A (Molecular Devices). All data were stored on a computer for subsequent off-line analysis ...
-
bioRxiv - Animal Behavior and Cognition 2021Quote: ... Data acquisition (filtered at 2–3 kHz and digitized at 15 kHz; Digidata 1440A, Molecular Devices, CA, USA) was performed using the Axopatch 200B amplifier and the Clampex 10.6 software (Molecular Devices) ...
-
bioRxiv - Neuroscience 2022Quote: ... low-pass filtered at 2 kHz and acquired using a Digidata 1550B and pClamp 10 software (Molecular devices). All reported voltages are corrected for a −13mV liquid junction potential calculated using Liquid Junction Potential Calculator in pClamp.
-
bioRxiv - Cell Biology 2023Quote: ... and videos were recorded at 2 frames/sec with 100ms exposure time using MetaMorph acquisition software (Molecular Devices). The excitation light was passed through a cyan excitation filter (Chroma) ...
-
bioRxiv - Biophysics 2023Quote: ... HEK293 cells were recorded at room temperature (25 ± 2 °C) using an Axopatch 200B amplifier (Molecular Devices, USA) with a holding potential of -60 mV ...
-
bioRxiv - Cell Biology 2024Quote: ... Changes in fluorescence due to rise in intracellular Ca 2+ were monitored using FlexStation®III (Molecular Devices). Cells were simultaneously excited at 340 nm and 380 nm and emission was recorded at 5s intervals at 510 nm to determine Ca 2+-bound and Ca2+-free Fura-2 respectively ...
-
bioRxiv - Neuroscience 2023Quote: Image analysis methods to quantify relative ubiquilin 2 and TDP-43 aggregate deposition were developed in MetaMorph v7.10.5.476 (Molecular Devices), similar to those previously described [8 ...
-
bioRxiv - Neuroscience 2024Quote: ... Data acquisition (filtered at 2–3 kHz and digitized at 10kHz; Digidata 1440, Molecular Devices, CA, United States) was performed using the Multiclamp 700B amplifier and the Clampex 10.6 software (Molecular Devices).
-
bioRxiv - Plant Biology 2020Quote: ... Then fluorescence intensity of 100ul filtered medium and 0.1g mycelium proteins was measured with microplate reader (Molecular Devices i3x, Shanghai, China), respectively ...
-
bioRxiv - Cancer Biology 2020Quote: ... Protein concentration was determined using a Bio-Rad protein concentration assay dye and absorbance read at 595 nm on a spectrophotometer (SpectraMax ID3, Molecular Devices). 20µg total protein in βmercaptoethanol-containing loading buffer was added per well onto 4-12% SDS-PAGE gels (NuPAGE ...
-
bioRxiv - Cell Biology 2021Quote: ... Densitometric quantification of protein expression as detected by Western blotting was essentially performed following standard procedures using MetaMorph (Molecular Devices, USA). In brief ...
-
bioRxiv - Bioengineering 2019Quote: ... the microchambers were flushed and the captured protein or metabolite on the arrays were converted into fluorescent readout and digitized by a Genepix scanner (Molecular Devices).
-
bioRxiv - Genomics 2023Quote: ... to determine the amount of protein necessary to generate signal within the linear range of the GenePix 4300B Microarray Scanner (Molecular Devices) at a resolution of 5µm ...
-
bioRxiv - Bioengineering 2019Quote: ... Currents were filtered at 2-3 kHz and sampled at 10 kHz using a Digidata 1440 A (Molecular Devices). Patch pipettes (4-6 MΩ ...
-
bioRxiv - Neuroscience 2020Quote: ... a 2 KHz Bessel filter was applied to the data during collection using the MultiClamp 700B (Molecular Devices, CA). For mPSC recordings ...
-
bioRxiv - Pharmacology and Toxicology 2021Quote: ... Data was quantified by measuring fluorescence intensity at 495 nm excitation and 517 nm emission (Flexstation 2, Molecular devices). Ter-butyl hydroperoxide was used as a positive control ...
-
bioRxiv - Physiology 2019Quote: ... and the plate was read within 2 minutes of buffer addition using a SpectraMax M5 plate reader (Molecular Devices) set to top-read chemiluminescent detection with a 500 ms integration time ...
-
bioRxiv - Neuroscience 2023Quote: ... Recordings were made using an Axoclamp 2 B amplifier with HS-2A x0.1 head stage (Molecular Devices, CA, USA) on a BX51WI Olympus microscope with a 40X LUMPlanFL/IR water immersion objective (Olympus Corporation ...
-
bioRxiv - Physiology 2023Quote: ... and the data were sampled at 2 kHz and filtered at 1 kHz using pClamp 10 software (Molecular Devices). Light stimulation was applied using LEDs and a multi-LED driver through the microscope optics (DC4100 ...
-
CDK5 activity in retinal pigment epithelium contributes to gap junction dynamics during phagocytosisbioRxiv - Cell Biology 2023Quote: ... All recordings were made in current-clamp mode with a 2-channel patch-clamp amplifier (MultiClamp 700B, Molecular Devices). To analyze the input resistance ...
-
bioRxiv - Neuroscience 2023Quote: ... The data were filtered at 2 kHz and sampled at 10 kHz via a digitizer (Digidata 1440, Molecular Devices) and recorded using Clampex 10.6 software (Molecular Devices) ...
-
bioRxiv - Neuroscience 2023Quote: ... filtered at 2 kHz and digitized at 10 kHz using a MultiClamp 700B amplifier and Digidata 1550 (Molecular Devices). Clampex version 11.4 (Molecular Devices ...
-
bioRxiv - Bioengineering 2022Quote: ... an EarlyTox Live/Dead Assay kit was used (Molecular Devices) and the microplate was imaged with a laser and GFP and TXR filters ...
-
bioRxiv - Neuroscience 2020Quote: ... and puncta size and the density of the indicated presynaptic marker proteins were analyzed in a blinded manner using MetaMorph software (Molecular Devices Corp.).
-
bioRxiv - Neuroscience 2021Quote: ... and maintained at room temperature for > 1.5 h before recording (34⁰ C; 2-3 ml/min perfusion; Olympus BX-51WI microscope; Molecular Devices Multiclamp 700B amplifier ...