Labshake search
Citations for Molecular Devices :
151 - 200 of 864 citations for 2' Chloro 4 5 5 dimethyl 1 3 dioxan 2 yl butyrophenone since 2020
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Neuroscience 2023Quote: ... filtered at 2 kHz and digitized at 10 kHz using a MultiClamp 700B amplifier (Molecular Devices) and stored using pClamp 10 software ...
-
bioRxiv - Genetics 2023Quote: ... and low-pass filtered at 2 kHz using a MultiClamp 700B amplifier and Clampex (Molecular Devices). Leak currents before mechanical stimulation were subtracted offline from the current traces ...
-
bioRxiv - Neuroscience 2023Quote: ... filtered at 2 kHz and digitized at 10 kHz using a MultiClamp 700B amplifier (Molecular Devices) and stored using pClamp 10 software ...
-
bioRxiv - Neuroscience 2024Quote: ... for 2 h in the culture medium and washed with HBS using AquaMax 2000 (Molecular devices). The imaging experiment was carried out in an HBS buffer ...
-
bioRxiv - Neuroscience 2024Quote: Patch-clamp recordings were obtained in the whole-cell configuration using Axoclamp 2-B (Molecular Devices) and digitized at 3 KHz using 1440A Digidata (Molecular Devices) ...
-
bioRxiv - Neuroscience 2024Quote: ... λEM: 516 nm (F340/F380)) were measured every 4 s using a FlexStation 3 fluorescent microplate reader (Molecular Devices, Sunnyvale, CA, USA). During the measurements ...
-
bioRxiv - Cell Biology 2022Quote: ... Haemocytes were solubilised with dimethyl sulfoxide and read using a microplate reader set at a wavelength of 595 nm (VersaMax, Molecular Devices). The number of viable cells was directly proportional to the level of the formazan product created ...
-
bioRxiv - Cell Biology 2023Quote: ... The resulting crystalized product was dissolved in 100 µL of 100% dimethyl sulfoxide (DMSO) and absorbance was measured at 595 nm using a Filter Max F5 microplate reader (Molecular Devices).
-
bioRxiv - Neuroscience 2020Quote: ... Images were acquired at 37°C in a temperature-controlled chamber under 5% CO2 using Metamorph software (Molecular Devices), for periods of 10 min with a confocal Z-series stack of 10μm (921×1024 pixels ...
-
bioRxiv - Biophysics 2022Quote: ... Voltage clamp data were digitized at 5 kHz (Axon Digidata 1550B via a digital Axoclamp 900A commander, Molecular Devices) and collected using pClamp 10 (Axon Instruments) ...
-
bioRxiv - Biophysics 2021Quote: ... Data was filtered at 5 kHz and recorded at a 200 kHz sampling rate with program Clampex (Molecular Devices). Experiments were carried out in symmetrical 200 mM KCl ...
-
bioRxiv - Neuroscience 2022Quote: ... These signals were recorded in frequencies of 0 - 5 kHz and digitized at 50 kHz (Digidata 1322A, Molecular Devices). For assessing evoked synaptic field potentials ...
-
bioRxiv - Microbiology 2024Quote: ... The cells were stained with the FLIPR calcium indicator Calcium 5 Assay Kit (Molecular Devices Corp., Sunnyvale, CA, USA) to image the Ca2+-transients evoked by capsaicin addition ...
-
bioRxiv - Neuroscience 2024Quote: ... Current signals were low-pass filtered at 5 kHz and sampled at 20 kHz using pCIamp10.3 or 10.7 (Molecular Devices). Series resistance was compensated between 85 – 90% in experiments for Figures 1-5 ...
-
bioRxiv - Neuroscience 2024Quote: ... Data were filtered at 1 kHz and sampled at 5 kHz with Digidata 1322A interface and Clampex 9.2 and 10.6 from pClamp software (Molecular Devices). Pipettes (from borosilicate capillaries ...
-
bioRxiv - Biophysics 2024Quote: ... Voltage clamp data were digitized at 5 kHz (Axon Digidata 1550B via a digital Axoclamp 900A commander, Molecular Devices) and collected using pClamp 10 (Axon Instruments) ...
-
bioRxiv - Biophysics 2023Quote: ... Signals were filtered at 5 kHz and sampled at 20 kHz prior to acquisition with Clampex 10.6 (Molecular Devices). A voltage step protocol using a holding potential of 0 mV for 0.2 s was performed prior to 20 mV incremental voltage steps ...
-
bioRxiv - Neuroscience 2023Quote: ... a measurement (Ex412/Em480) taken every 5 sec for 600 sec on a SpectraMax M5 multimode reader (Molecular Devices).
-
bioRxiv - Neuroscience 2024Quote: ... 3 - 5 ms (DAPI), 150 - 250 ms (GFP) and 2,000 - 3,000 ms (Cy3, Cy5, mCherry) using MetaMorph software (Molecular Devices) at 0.133 µm/pixel (Figure 1) ...
-
bioRxiv - Cell Biology 2021Quote: ... filtered at 2 kHz with an 8-pole Bessel filter and analyzed with Clampfit 10.7 (Molecular Devices) and Origin 8 Pro (Origin Lab ...
-
bioRxiv - Neuroscience 2022Quote: ... Conventional tight-seal (>2 GΩ) whole cell patch-clamp recordings were acquired using Multiclamp 700B (Molecular Devices) amplifier ...
-
bioRxiv - Neuroscience 2021Quote: ... with Bessel filter of 2 kHz and digitized at 50 kHz using Axon DigiData 1500A (Molecular Devices). The Axon pClamp 10 (Molecular Devices ...
-
bioRxiv - Neuroscience 2020Quote: ... spike threshold in Spike 2 v7.10 (Cambridge Electronic Design) and action potential properties in pCLAMP (Molecular Devices). A total of 20 mice were used for intrinsic excitability experiments.
-
bioRxiv - Pharmacology and Toxicology 2022Quote: ... data were filtered (2 KHz) and digitized (10 KHz) using a Digidata 1550B1 (Molecular Devices, CA, USA).
-
bioRxiv - Physiology 2021Quote: ... and low pass filtered at 2 kHz using a MultiClamp 700B amplifier and Clampex (Molecular Devices, LLC). Leak currents before mechanical stimulation were subtracted offline from the current traces.
-
bioRxiv - Pharmacology and Toxicology 2020Quote: ... Data were sampled at 2 kHz using the pClamp 10.4 acquisition software (Axon Instruments, Molecular Devices, USA). The microelectrodes were pulled from glass capillaries (TW 120.3 ...
-
bioRxiv - Cell Biology 2022Quote: ... The signals were acquired at 10 kHz and filtered at 2 kHz using pClamp10 software (Molecular Devices). For nAChR recordings ...
-
bioRxiv - Neuroscience 2022Quote: ... Recordings were filtered at 2 kHz and digitized at 10 kHz using MultiClamp 700B software (Molecular Devices). Claustrum projection neuron type was determined via a 5 ms depolarization step while recording in current-clamp mode to determine burst firing properties (Type I ...
-
bioRxiv - Neuroscience 2024Quote: ... Traces were low-pass filtered at 2 kHz and digitized at 10 kHz (DigiData 1,550, Molecular Devices). Data were acquired and analyzed using Clampfit 11.0 software (Molecular Devices) ...
-
bioRxiv - Neuroscience 2024Quote: ... We acquired wingbeat amplitude data at 2 kHz using a Digidata 1550B or 1440A amplifier (Molecular Devices) for the afferents and muscles ...
-
bioRxiv - Neuroscience 2023Quote: ... at 100 kHz sampling rate and filtered at 2 kHz using a MultiClamp 700B amplifier (Molecular Devices). At the end of the recording ...
-
bioRxiv - Neuroscience 2023Quote: ... at 100 kHz sampling rate and filtered at 2 kHz using a MultiClamp 700B amplifier (Molecular Devices). 30 consecutive action potentials were recoded every 5 seconds using Clampex 10.6 (Molecular Devices ...
-
bioRxiv - Neuroscience 2024Quote: ... low-pass filtered at 2 kHz and digitally sampled at 10 kHz using a digitizer (Molecular Devices). Intrinsic excitability experiments used a K-gluconate based internal solution (in mM ...
-
bioRxiv - Physiology 2022Quote: ... Images were acquired at excitation of 488 nm at the same settings and the fluorescence quantified over 3-4 fields using Metamorph Software (Molecular Devices, Downington PA). For quantitation of the vascular NLRP3 and ICAM-1 ...
-
bioRxiv - Neuroscience 2023Quote: ... Recordings were made with pClamp 10.3 software using a MultiClamp 700B amplifier set with 4 kHz low-pass Bessel filter and 10 kHz digitization (Molecular Devices, Sunnydale, CA). The light beam of the same laser was directed at the preparation using an 200μm optic fiber submerged into the bath with light beam aimed at the STN ...
-
bioRxiv - Neuroscience 2021Quote: ... digitized at 10–20 kHz and low-pass filtered at 2–5 kHz with a Digidata 1440A analog-to-digital converter and analyzed off-line using Clampfit 10.7 software (Molecular Devices). Intrinsic excitability was determined in response to increasing depolarizing current pulses (+75 pA ...
-
bioRxiv - Biochemistry 2020Quote: ... Fluorescence intensity measurements were collected every 30 sec on a SpectraMax M5 fluorometer using Softmax Pro 5 software (Molecular Devices; excitation and emission set to 410 nm and 490 nm ...
-
bioRxiv - Neuroscience 2020Quote: ... The steady-state voltage responses were plotted against the amplitude of current injection and the slope of the linear fit between −5 pA to −30 pA was used to define Rin (Clampfit v. 11.1; Molecular Devices). Time constant (tau ...
-
bioRxiv - Microbiology 2021Quote: ... incubating 1 hour at 37ºC 5% CO2 and measuring fluorescence (λEX = 540 nm, λEM = 590 nm) on a SpectraMax M5 (Molecular Devices). The IC50 was calculated using GraphPhad Prism 9 using a non-linear regression analysis ...
-
bioRxiv - Pharmacology and Toxicology 2021Quote: ... was added and plates were gently shaken for 5 s to mix and then absorbance (O.D.) was measured at 450/620 nm on a SpectraMax M5 (Molecular Devices) instrument and data were processed by SoftMax Pro 6.4 software (Molecular Devices) ...
-
bioRxiv - Neuroscience 2021Quote: ... the data acquired at 5 kHz with a Digidata 1440A (Axon instruments) interface using pCLAMP 10 acquisition software (Molecular Devices). The Internal and external (bath ...
-
bioRxiv - Neuroscience 2021Quote: ... Data were filtered at 5-10 kHz and digitized at 50 kHz using an acquisition board (Digidata 1440, Molecular Devices) attached to a personal computer running pCLAMP 10.2 software package (Molecular Devices) ...
-
bioRxiv - Immunology 2021Quote: ... DAF fluorescence intensities were measured every 5 minutes for a total of 60 minutes using a SpectraMax iD3 (Molecular Devices). All experiments were repeated at least four times per batch.
-
bioRxiv - Neuroscience 2022Quote: ... digitized at 5-20 kHz and acquired using a Digidata 1440A digitizer and pClamp 10 software (all from Molecular Devices).
-
bioRxiv - Neuroscience 2024Quote: ... Electrophysiological recordings were obtained from one neuron per slice and 4-5 slices per mouse using a Multiclamp 700B amplifier and analyzed using a digital system (pClamp version 11.2, Molecular Devices). Series and input resistances were monitored throughout the experiment using a -5 mV pulse ...
-
bioRxiv - Neuroscience 2024Quote: Currents were filtered at 5 kHz using low-pass Bessel filter of the amplifier and digitized using a Digitata 1,440 unit (Molecular Devices). All voltage clamp measurements were performed at a holding voltage of -60 mV ...
-
bioRxiv - Neuroscience 2024Quote: ... were plotted against the amplitude of current injection and the slope of the linear fit between −5 pA to −30 pA was used to define Rin (Clampfit v. 11.2; Molecular Devices). Time constant (tau ...
-
bioRxiv - Systems Biology 2022Quote: ... and the EtBr accumulation was measured by measuring the fluorescence in a microplate reader (spectramax multimode M 5, Molecular devices) at 37°C using 530 nm excitation wavelength and 585 nm as the emission wavelength ...
-
bioRxiv - Biochemistry 2023Quote: ... Data were sampled at 10 kHz and filtered at 5 kHz using a Digidata 1550A device controlled by pCLAMP 10.5 (Molecular Devices). Capacitance transients and leak currents were removed by subtracting a scaled control trace utilizing a P/4 protocol.
-
bioRxiv - Cancer Biology 2023Quote: ... Whole-cell currents were filtered at 5 kHz and digitized at 10 kHz using the software pCLAMP 10 (Molecular Devices). Micropipettes were pulled from Corning 8161 capillary glass tubes (Warner Instruments ...