Labshake search
Citations for Molecular Devices :
101 - 150 of 200 citations for Recombinant Human Collagen Type II Alpha 1 His tagged since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Neuroscience 2021Quote: ... The digital low-pass 8-pole Bessel filter with 1 kHz 3dB cut-off was applied in Clampfit 10.7 (Molecular Devices) before the current amplitudes were determined ...
-
bioRxiv - Neuroscience 2022Quote: ... electrophysiological traces were low-pass filtered offline with an 8-pole RC filter at 1 kHz using ClampFit 10.7 (Molecular Devices). Four distinct parameters were analyzed from each choline-evoked response ...
-
bioRxiv - Cancer Biology 2019Quote: ... The cells were treated with various concentrations of BRAFi or/and CDK6i for 72 hr and then incubated with CellTiter 96 AQueous One Solution Reagent for 1-4 hr per manufacturer’s protocol before recording the absorbance at 490 nm on SpectraMax M2 (Molecular Devices). All experiments were performed in triplicate ...
-
bioRxiv - Physiology 2021Quote: ... Currents were filtered at 1 kHz and digitized at 5 kHz using an Axopatch 200B amplifier and Clampex 10.4 (Molecular Devices. Offline analysis was performed using Clampfit 10.4 ...
-
bioRxiv - Genetics 2021Quote: ... Optical density data were collected every 1 hour for 72 h total using a plate reader (SpectraMAX 384, Molecular Devices). Growth kinetic parameters were calculated using the MATLAB code OCHT reported by de Mello et al ...
-
bioRxiv - Neuroscience 2021Quote: ... Mechanical stimulation in cell attached patches was performed using a high-speed pressure clamp (Besch et al., 2002) (HSPC-1, ALA Scientific) controlled by pClamp 11.1 software (Molecular Devices) as described earlier (Borbiro et al. ...
-
bioRxiv - Neuroscience 2022Quote: ... Signals were filtered with a 1 kHz bezel filter and sampled at 20 kHz using Axon pClamp10 software (Molecular Devices).
-
bioRxiv - Bioengineering 2022Quote: Phase contrast images were taken every 1 to 3 days with a high content microscope (ImageXPress XLS-C; Molecular Devices) to monitor culture development.
-
bioRxiv - Molecular Biology 2023Quote: ... at 60°C for 1 hour with measurements recorded every 2 minutes using a Spectramax iD3 plate reader (Molecular Devices). Effective guide RNAs were identified as those that generate a signal well-distinguished from the negative control in less than 30 minutes.
-
bioRxiv - Neuroscience 2023Quote: ... and data were digitized at 10 kHz and filtered at 1-2 kHz using a 1440A Digidata Digitizer (Molecular Devices). Series and input resistances (10-20 MΩ ...
-
bioRxiv - Neuroscience 2024Quote: ... Signals were filtered with a 1 kHz bezel filter and sampled at 20 kHz using Axon pClamp10 software (Molecular Devices).
-
bioRxiv - Neuroscience 2024Quote: ... sEPSC recordings were filtered post-hoc with a 1 kHz low-pass Bessel 8-pole filter in Clampfit (Molecular Devices).
-
bioRxiv - Neuroscience 2023Quote: ... the slope of the first 1-2 ms of the fEPSP was obtained using Clampfit software (version 10.6; Molecular Devices) and averaged in 1-min bins ...
-
bioRxiv - Molecular Biology 2021Quote: ... by 1:20 dilution with a series of commercially available pH buffers (HYDRION) using a SpectraMax-M5 plate reader (Molecular Devices) to read out fluorescence ...
-
bioRxiv - Neuroscience 2022Quote: ... filtered at 3 kHz and digitized at 10 kHz using an EPC-10 patch-clamp amplifier with PatchMaster v2x73 software (batch 1) or MultiClamp 700B amplifier (Molecular Devices) with pClamp 10 software (batch 2) ...
-
bioRxiv - Biophysics 2022Quote: ... The data was passed through a low-pass filter (1 kHz cutoff frequency) and stored in PC using an analog-to-digital converter (5 kHz sampling; Digidata 1550A; Molecular Devices) and pCLAMP software (Molecular Devices).
-
bioRxiv - Pharmacology and Toxicology 2019Quote: ... Currents were recorded using an Axopatch 200B amplifier (Axon Instruments) at the sample rate of 5 kHz and filtered at 1 kHz with Digitata 1332A (Molecular Devices). Once a high resistance seal was formed ...
-
bioRxiv - Cell Biology 2019Quote: ... Signal was low-pass filtered at 1 kHz and digitized at 10 kHz with a Digidata 1440A or 1550 (Molecular Devices). Neurons with a series resistance (Rs ...
-
bioRxiv - Developmental Biology 2020Quote: ... A voltage-clamp protocol was employed to record whole-cell currents with and without extracellular divalent cations in response to a voltage ramp from −120 to 60 mV (1 second interval) using an Axopatch 200B amplifier with pCLAMP10 software (Molecular Devices) as previously described [71 ...
-
bioRxiv - Neuroscience 2020Quote: ... The signal for all voltage-clamp recordings was filtered at 1 kHz and digitized at 10 kHz with a digitizer (Molecular Devices). For voltage-clamp recordings ...
-
bioRxiv - Biophysics 2021Quote: ... The reaction was monitored at 650 nm (turbidity due to precipitation of the product) for 1 h at 25 °C using a Spectramax i3 (Molecular Devices). Statistical analysis was performed using unpaired t-test in Prims 9.0.
-
bioRxiv - Synthetic Biology 2021Quote: ... Reactions were monitored at 340 nm for 1 hour (30s per read) using a SpectraMax Plus 384 microplate reader (Molecular Devices). NADH concentrations were determined by its extinction coefficients ...
-
bioRxiv - Microbiology 2020Quote: ... Fluorescence was measured every 60s for 1 hour after addition of virus on a FilterMax F5 multimode microplate reader (Molecular Devices). Enzyme Vmax and Km was calculated using Prism software (GraphPad).
-
bioRxiv - Microbiology 2021Quote: ... 2021.Infected cells were imaged for 72 h with 1 h intervals with a 40x objective with the ImageXpress Micro XL high-content microscope (Molecular Devices). Different parameters ...
-
bioRxiv - Microbiology 2021Quote: ... Protein concentrations were determined using the corresponding extinction coefficient at 280 nm (ExPASy, ProtParam tool) and measured in a 1 ml quartz cuvette (Hellma Analytics) using a SpectraMax M2 spectrophotometer (Molecular Devices). Proteins were long-term stored at -80 °C in 10% glycerol.
-
bioRxiv - Biophysics 2021Quote: ... The analog current signal was low-pass filtered at 1 kHz (Bessel) and digitized at 10 kHz with a Digidata 1550A digitizer (Molecular Devices). Digitized data were recorded on a computer using the software pClamp (Molecular Devices ...
-
bioRxiv - Neuroscience 2022Quote: Mechanically activated currents from DRG neurons 1-3 days after culturing were recorded in whole cell patch clamp mode using a MultiClamp700A amplifier and DigiData1550 (Molecular Devices) and stored directly and digitized online using pClamp software (version 10.7) ...
-
bioRxiv - Biophysics 2022Quote: ... Data were filtered at 1-3kHz and digitized at 10kHz using a Digidata 1321A interface board and pCLAMP 10 software (Axon; Molecular Devices). Microelectrode resistances were 0.2–0.8MΩ when filled with 3 M KCl ...
-
bioRxiv - Immunology 2020Quote: ... and the reactions were stopped by adding 1 M H2SO4 before measuring absorbance at 450 nm with a Spectramax Paradigm plate reader (Molecular Devices).
-
bioRxiv - Immunology 2020Quote: ... and the reactions were stopped by adding 1 M H2SO4 before measuring absorbance at 450 nm with a Spectramax Paradigm plate reader (Molecular Devices).
-
bioRxiv - Cell Biology 2021Quote: ... The 96-well plate was spun at 700 rpm for 1 min before luminescence intensity was determined on a Flexstation 3 multi-mode microplate reader (Molecular Devices).
-
bioRxiv - Neuroscience 2021Quote: ... The signal for voltage-clamp recordings was filtered at 1 kHz and digitized at 10 kHz with a digitizer (Molecular Devices). Stimulus generation and data acquisition were performed using pClamp (Molecular Devices).
-
bioRxiv - Neuroscience 2020Quote: ... the recorded unit was stimulated by a current pulse of 250ms long (50 % duty cycle, 1-10 nA) sent through the recording electrode by axoClamp 2B (in bridge mode; Molecular Devices). Then ...
-
bioRxiv - Neuroscience 2022Quote: ... Membrane responses to 1 s current injection between 0-700 pA (100 pA increment) were collected using an Axopatch-200B amplifier (Molecular Devices). Paired pulse optogenetic and electrical stimulation (20 Hz every 30 s ...
-
bioRxiv - Cell Biology 2022Quote: ... Data was Bessel filtered online at 1 kHz and single channel currents were analyzed offline using ClampFit analysis module of pCLAMP 10 software (Molecular Devices).
-
bioRxiv - Biophysics 2022Quote: ... Absorbance at 405 nm was measured before and after a 1 h or 2 h incubation at room temperature using a microplate reader (SpectraMax 340 PC384; Molecular Devices). Ligand-induced AP-TGF-α release was calculated as described previously.26 Unless otherwise noted ...
-
bioRxiv - Developmental Biology 2019Quote: ... Bioluminescence was followed in real-time for 1 hr at 27 °C and 2 hrs at 37 °C in a Flex Station3 microplate reader (Molecular Devices).
-
bioRxiv - Biophysics 2020Quote: ... Currents were digitized at 5 kHz and low pass filtered at 1 kHz using a voltage clamp amplifier (Axopatch 200B, Molecular Devices) via a digitizer (DigiData 1440A ...
-
bioRxiv - Synthetic Biology 2020Quote: ... Purified proteins were quantified by measuring absorbance at 280 nm in a 1-cm quartz cuvette with a SpectraMax Plus384 microplate spectrophotometer (Molecular Devices), and applying Beer-Lambert’s law using extinction coefficients calculated with the ProtParam tool (https://web.expasy.org/protparam/).
-
bioRxiv - Synthetic Biology 2021Quote: ... Samples were measured via kinetic measurements (1 measurement/min) for a total of 30 minutes at 405 nm using a SpectraMax iD3 spectrophotometer (Molecular Devices).
-
Interleukin 4 controls the role of macrophages in pulmonary metastatic tumor cell seeding and growthbioRxiv - Cancer Biology 2021Quote: ... Aliquots of 100 μL from the receiving and bottom chambers were taken and diluted 1:5 in DMEM before reading using a SpectraMax M5 plate reader (emission/excitation = 557/586 nm; Molecular Devices). Concentrations were calculated using a standard curve ...
-
bioRxiv - Microbiology 2020Quote: ... Single cell ionic currents were measured in the perforated patch clamp configuration (100 μgmL−1 amphotericin) at room temperature (21–23 °C) using an IonWorks Quattro instrument (Molecular Devices). The internal solution contained (mM) ...
-
bioRxiv - Immunology 2020Quote: ... The reaction was stopped with 1% HCl and absorbance at 450 nm was read with a SpectraMax plate reader (Molecular Devices). SoftMax Pro v5.3 was used to calculate log area-under-the-curve (AUC ...
-
bioRxiv - Biophysics 2021Quote: ... Signals were filtered at 1 kHz (low-pass) and digitized using a DigiData 1550 with pClamp 10.5 software (Molecular Devices, USA). The sampling rate was 5 kHz ...
-
bioRxiv - Immunology 2022Quote: ... in a clear-bottom black-welled 96 well plate and 330nm/390nm fluorescence readings were obtained after 1 hour using a SpectraMax M2 microplate reader (Molecular Devices). Difference between treatments were assessed via One-Way Anova.
-
bioRxiv - Immunology 2022Quote: ... Cleavage of the 5-FAM/QXL™ 520 labeled elastin was measured in a clear-bottom black-welled 96 well plate and 490nm/520nm fluorescence readings were obtained after 1 hour at 37°C using a SpectraMax M2 microplate reader (Molecular Devices). Difference between treatments were assessed via One-Way Anova.
-
bioRxiv - Biochemistry 2022Quote: ... Reactions were carried out at 37° C for 1 hr and read at 412 nm using a Versamax plate reader (Molecular Devices) in triplicate ...
-
bioRxiv - Immunology 2023Quote: ... and the reactions were stopped by adding 1 M H2SO4 before measuring absorbance at 450 nm with a Spectramax Paradigm plate reader (Molecular Devices). Sera from mice immunized with PBS or an irrelevant antigen (DS-Cav1-I53_dn5 ...
-
bioRxiv - Immunology 2023Quote: ... Plates were developed for 30 minutes at room temperature before stopping with 100 μL of 1% SDS to read on a SpectraMaxiD3 plate reader (Molecular Devices) for absorbance at 405 nm.
-
bioRxiv - Biochemistry 2022Quote: ... Absorbance at 340 nm was measured at RT every 30 seconds for 1 h with a SpectraMax Plus 384 microplate reader (Molecular Devices). Data analysis was done using SoftMax Pro 7.0 and GraphPad Prism 9.3.1 software ...