Labshake search
Citations for Molecular Devices :
101 - 150 of 917 citations for 6 chloro 2 N 2 N diethyl 4 N propan 2 yl 1 3 5 triazine 2 4 diamine since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Neuroscience 2024Quote: ... Traces were low-pass filtered at 2 kHz and digitized at 10 kHz (DigiData 1,550, Molecular Devices). Data were acquired and analyzed using Clampfit 11.0 software (Molecular Devices) ...
-
bioRxiv - Neuroscience 2024Quote: ... We acquired wingbeat amplitude data at 2 kHz using a Digidata 1550B or 1440A amplifier (Molecular Devices) for the afferents and muscles ...
-
bioRxiv - Immunology 2023Quote: ... and 2% phosphoric acid and measuring absorbance at 546nm with a SpectraMax M2 microplate reader (Molecular Devices).
-
bioRxiv - Neuroscience 2023Quote: ... at 100 kHz sampling rate and filtered at 2 kHz using a MultiClamp 700B amplifier (Molecular Devices). At the end of the recording ...
-
bioRxiv - Neuroscience 2023Quote: ... at 100 kHz sampling rate and filtered at 2 kHz using a MultiClamp 700B amplifier (Molecular Devices). 30 consecutive action potentials were recoded every 5 seconds using Clampex 10.6 (Molecular Devices ...
-
bioRxiv - Neuroscience 2019Quote: ... Signals were sampled at 10 kHz and filtered at 2 kHz in a MultiClamp 700B amplifier (Molecular Devices). Analysis was performed using custom routines in MATLAB (Mathworks ...
-
bioRxiv - Neuroscience 2021Quote: ... filtered at 2 kHz and digitized at 10 kHz with a MultiClamp 700B amplifier (Molecular Devices, CA, USA) and a Digidata 1550 digitizer (Molecular Devices) ...
-
bioRxiv - Neuroscience 2020Quote: ... low-pass filtered at 2 kHz using a Digidata 1550B low noise data acquisition system (Molecular Devices, USA). For whole-cell recordings ...
-
bioRxiv - Neuroscience 2021Quote: ... Recordings were made using an Axoclamp 2 B amplifier with HS-2A x0.1 headstage (Molecular Devices, CA, USA) and on a BX51WI Olympus microscope with a 40X LUMPlanFL/IR water immersion objective (Olympus Corporation ...
-
bioRxiv - Neuroscience 2020Quote: ... Signals were filtered at 2 kHz and sampled at 10 kHz with Digidata 1322A (Molecular Devices, Sunnyvale, CA). Patch pipettes made from thin-walled borosilicate glass (outer diameter 1.5 mm ...
-
bioRxiv - Neuroscience 2020Quote: ... Data were filtered during acquisition with a low pass filter set at 2 kHz using pClamp10 (Molecular Devices). Data analysis was performed offline with Clampfit 10.2 (Molecular Devices).
-
bioRxiv - Neuroscience 2022Quote: ... Data were filtered at 2 kHz and digitized at 20 kHz using a 1440A Digidata Digitizer (Molecular Devices). Series-resistance (<20 MΩ ...
-
bioRxiv - Neuroscience 2020Quote: ... Signals were low-pass filtered at 2 kHz and sampled at 10kHz with a Digidata 1440A (Molecular Devices). All data were stored on a computer for subsequent off-line analysis ...
-
bioRxiv - Neuroscience 2022Quote: ... low-pass filtered at 2 kHz and acquired using a Digidata 1550B and pClamp 10 software (Molecular devices). All reported voltages are corrected for a −13mV liquid junction potential calculated using Liquid Junction Potential Calculator in pClamp.
-
bioRxiv - Cell Biology 2024Quote: ... Changes in fluorescence due to rise in intracellular Ca 2+ were monitored using FlexStation®III (Molecular Devices). Cells were simultaneously excited at 340 nm and 380 nm and emission was recorded at 5s intervals at 510 nm to determine Ca 2+-bound and Ca2+-free Fura-2 respectively ...
-
bioRxiv - Cell Biology 2023Quote: ... and videos were recorded at 2 frames/sec with 100ms exposure time using MetaMorph acquisition software (Molecular Devices). The excitation light was passed through a cyan excitation filter (Chroma) ...
-
bioRxiv - Neuroscience 2023Quote: Image analysis methods to quantify relative ubiquilin 2 and TDP-43 aggregate deposition were developed in MetaMorph v7.10.5.476 (Molecular Devices), similar to those previously described [8 ...
-
bioRxiv - Biophysics 2024Quote: ... HEK293 cells were recorded at room temperature (25 ± 2 °C) using an Axopatch 200B amplifier (Molecular Devices, USA) with a holding potential of -60 mV ...
-
bioRxiv - Neuroscience 2020Quote: ... a 2 KHz Bessel filter was applied to the data during collection using the MultiClamp 700B (Molecular Devices, CA). For mPSC recordings ...
-
bioRxiv - Pharmacology and Toxicology 2021Quote: ... Data was quantified by measuring fluorescence intensity at 495 nm excitation and 517 nm emission (Flexstation 2, Molecular devices). Ter-butyl hydroperoxide was used as a positive control ...
-
bioRxiv - Physiology 2019Quote: ... and the plate was read within 2 minutes of buffer addition using a SpectraMax M5 plate reader (Molecular Devices) set to top-read chemiluminescent detection with a 500 ms integration time ...
-
bioRxiv - Neuroscience 2023Quote: ... Recordings were made using an Axoclamp 2 B amplifier with HS-2A x0.1 head stage (Molecular Devices, CA, USA) on a BX51WI Olympus microscope with a 40X LUMPlanFL/IR water immersion objective (Olympus Corporation ...
-
bioRxiv - Neuroscience 2023Quote: ... filtered at 2 kHz and digitized at 10 kHz using a MultiClamp 700B amplifier and Digidata 1550 (Molecular Devices). Clampex version 11.4 (Molecular Devices ...
-
CDK5 activity in retinal pigment epithelium contributes to gap junction dynamics during phagocytosisbioRxiv - Cell Biology 2023Quote: ... All recordings were made in current-clamp mode with a 2-channel patch-clamp amplifier (MultiClamp 700B, Molecular Devices). To analyze the input resistance ...
-
bioRxiv - Neuroscience 2023Quote: ... The data were filtered at 2 kHz and sampled at 10 kHz via a digitizer (Digidata 1440, Molecular Devices) and recorded using Clampex 10.6 software (Molecular Devices) ...
-
bioRxiv - Neuroscience 2019Quote: ... filtered at 2 kHz and digitized at 20 kHz with a DigiData 1440 data acquisition board (Molecular Devices, Sunnyvale, CA). Analysis of electrophysiological parameters was done using Clampfit (Molecular Devices ...
-
bioRxiv - Neuroscience 2019Quote: ... Data were low-pass filtered at 2 kHz and acquired via an Axopatch 700B amplifier (Molecular Devices, Foster City, CA) and later analyzed using pClamp 10 software (Molecular Devises ...
-
bioRxiv - Neuroscience 2020Quote: ... Signals were low-pass filtered (Bessel, 2 kHz) and collected at 10 kHz using the data acquisition software pClamp 10.5 (Molecular Devices). Optical stimulation was applied through the microscope with two LEDs (460 nm and 525 nm ...
-
bioRxiv - Neuroscience 2020Quote: ... The data were low-pass filtered at 2 kHz and digitized at 10 kHz using a Digidata 1322A (Molecular Devices) and stored using Clampex version10 ...
-
bioRxiv - Cell Biology 2021Quote: ... Fluorescence was measured after 2 hours of incubation at 37°C using the SpectraMax® iD3 microplate reader (Molecular Devices). To compare growth rates ...
-
bioRxiv - Neuroscience 2020Quote: ... Signals were low-pass filtered (Bessel, 2 kHz) and collected at 10 kHz using the data acquisition software pClamp 10.5 (Molecular Devices). Electrophysiological recordings were extracted using Clampfit (Molecular Devices ...
-
bioRxiv - Cell Biology 2021Quote: ... Data were digitized at 10 kHz with a 2 kHz low-pass filter using a Multiclamp 700A amplifier (Molecular Devices). For all electrophysiological experiments ...
-
bioRxiv - Cell Biology 2022Quote: Multi-well calcium flux assays were performed with the Fura-2 QBT Calcium Kit (R8197, Molecular Devices, Inc., Sunnyvale, CA). 10,000 – 20,000 cells/well were plated into a 96-well plate to achieve confluence when analyzed ...
-
bioRxiv - Neuroscience 2021Quote: ... filtered at 2 kHz and sampling rate at 20 kHz with an Axon Digidata 1550B plus HumSilencer digitizer (Molecular Devices). Slices were maintained under continuous perfusion of aCSF at 32-33°C with a 2-3 mL/min flow ...
-
bioRxiv - Neuroscience 2021Quote: ... Signals were low pass filtered (Bessel, 2 kHz) and collected at 10 kHz using the data acquisition software pClamp 10.5 (Molecular Devices). All the electrophysiological recordings were extracted using Clampfit (Molecular Devices ...
-
bioRxiv - Developmental Biology 2021Quote: ... 340/386 nm image pairs were acquired every 2 s with the MetaFluor software (Molecular Devices Corp, Downington, PA, USA). [Ca2+]i was calculated from the background-corrected Fura-2 LR 340/380 nm fluorescence excitation ratio from manually defined cell-sized regions of interest ...
-
bioRxiv - Neuroscience 2020Quote: Signals were low-pass filtered at 2 kHz and digitised at 10 kHz using an Axopatch 200B amplifier (Molecular Devices) and WinLTP v1.11 acquisition software [46].
-
bioRxiv - Neuroscience 2020Quote: Data were digitized at 10 kHz with a 2 kHz low-pass filter using a Multiclamp 700A amplifier (Molecular Devices). Data were analyzed using Clampfit 9.02 software ...
-
bioRxiv - Biochemistry 2021Quote: ... All currents were sampled at 10 kHz and low-pass filtered at 2 kHz through pCLAMP software (Molecular Devices, Sunnyvale). Origin 9.0 software (OriginLab Corp. ...
-
bioRxiv - Neuroscience 2022Quote: ... Signals were low-pass filtered (Bessel, 2 kHz) and collected at 10 kHz using the data acquisition software pClamp 10.5 (Molecular Devices). All the electrophysiological recordings were extracted using Clampfit (Molecular Devices ...
-
bioRxiv - Cell Biology 2023Quote: ... Dual channel live acquisition was performed using 2 EMCCD cameras (QuantEM Model 512SC, Princeton Instruments) controlled by Metamorph 7.10 software (Molecular Devices). The gain of the EMCCD cameras was kept constant at 600 ...
-
bioRxiv - Cell Biology 2020Quote: ... incubated for 2 hours with 100 nM Coelenterazine Cp and washed before initiating measurements using a spectrophotometer (SpectraMax M, Molecular Devices) equipped with injectors allowing the detection of luminescence in a kinetic mode.
-
bioRxiv - Neuroscience 2021Quote: ... in time-lapse mode either at 1 fps (for imaging in response to 200-APs stimulation) or 2 fps (for imaging in response to 50-APs stimulation) under the control of MetaMorph software (Molecular Devices). SEP fluorescence was imaged with 470/22 nm excitation and 514/30 nm emission filters ...
-
bioRxiv - Genomics 2020Quote: ... Luciferase activity was measured 48-hours post-transfection with a 2-second integration time on a LMax II 384 Luminometer (Molecular Devices). Background subtracted luminescence values for each SNV were z-scored ...
-
bioRxiv - Cell Biology 2019Quote: ... Signals were recorded at 10 kHz and low-pass filtered at 2 kHz with an Axopatch 200B amplifier and digitized with a Digidata 1440 (Molecular Devices). Recording pipettes were pulled from borosilicate capillary glass (0.86 OD ...
-
bioRxiv - Cell Biology 2019Quote: ... and 2) a Nikon Eclipse 80i microscope using a 100X/1.4NA oil objective lens and Metamorph (Molecular Devices, San Jose, CA). Yeast were grown in SD media to log phase ...
-
bioRxiv - Neuroscience 2020Quote: ... and were digitized off-line at 10 kHz (low-pass filtered at 2 kHz with an 8-pole Bessel filter) using pCLAMP9 software (Molecular Devices).
-
bioRxiv - Neuroscience 2021Quote: ... Light-evoked action potentials from ChR2-mCherry+ neurons in the SC were triggered by a light-pulse train (473 nm, 2 ms, 10 Hz or 20 Hz, 20 mW) synchronized with Clampex 10 data acquisition software (Molecular Devices).
-
bioRxiv - Neuroscience 2022Quote: ... and analog signals were low-pass filtered at 2 kHz and digitized at 10 kHz with a Digidata 1550 interface (Molecular Devices). Clampex (v 11.4 ...
-
bioRxiv - Neuroscience 2020Quote: ... Light-evoked action potentials from ChR2-mCherry+ neurons in the SC were triggered by a light-pulse train (473 nm, 2 ms, 10 Hz, 20 mW) synchronized with Clampex 10 data acquisition software (Molecular Devices). Light-evoked postsynaptic currents from SNc neurons were triggered by single light pulses (2 ms ...