Labshake search
Citations for Molecular Devices :
1301 - 1350 of 1401 citations for Formaldehyde Detection Kit 1 Plate since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Neuroscience 2022Quote: ... The signal was filtered at 1 kHz and digitized at 10 kHz using Axon Digidata 1550B (Molecular Devices). Recording pipettes (3.5-5 MΩ ...
-
bioRxiv - Cell Biology 2021Quote: ... 36 sites per well were imaged using a Plan-Apochromat 40x objective (Molecular Devices, cat# 1-6300-0297). Automated image analysis was performed using the MetaXpress software (version 6.5.4.532 ...
-
bioRxiv - Biophysics 2020Quote: ... The recording electrode was a chlorinated silver wire (0.25 mm thickness, 1-HLA-005, Molecular Devices, California, USA).
-
bioRxiv - Neuroscience 2021Quote: ... fEPSPs were recorded and filtered (low pass at 1 kHz) with an Axopatch 200A amplifier (Molecular Devices, LLC) and digitized at 10 kHz with an A/D converter (Digidata 1322A ...
-
bioRxiv - Developmental Biology 2023Quote: ... which is repeated every 1 h from late E2.5 to E3.5 using a custom Metamorph journal (Molecular Devices). A 60 μm z-stack with a 5 μm step size is acquired before every time lapse to discern TE and ICM cells.
-
bioRxiv - Neuroscience 2023Quote: ... Data were filtered at 1 kHz and digitized at 20 kHz using a 1440A Digidata Digitizer (Molecular Devices). Series-resistance (10-20 MΩ ...
-
bioRxiv - Synthetic Biology 2024Quote: ... The reaction was diluted 1:20 and the absorbance was measured in a spectrophotometer (Spectramax 190, Molecular Devices) in Nunc 96-well plates (ThermoFisher) ...
-
bioRxiv - Biophysics 2021Quote: Recordings containing 1-9 channels were idealized through half-amplitude threshold crossing and analyzed using Clampfit software (Molecular Devices).
-
bioRxiv - Neuroscience 2020Quote: ... band-pass filtered (1-3000 Hz) and sampled at 10 kHz with a Digidata 1440A acquisition board (Molecular Devices). Spikes were sorted using Spike 2 software (CED ...
-
bioRxiv - Neuroscience 2019Quote: ... 1 kHz low-pass filter and digital gain at 10 (MultiClamp 700B amplifier, Digidata 1400 digitizer, both Molecular Devices). Results were analyzed with the Clampfit software (Molecular Devices) ...
-
bioRxiv - Genetics 2022Quote: ... Absorbance at 420 nm was measured every minute for 1 hour on a SpectraMax M2 Microplate Reader (Molecular Devices). Measures taken between 20 and 35 minutes (linear range ...
-
bioRxiv - Physiology 2022Quote: BAT SNA was amplified (x 5,000–10,000) and filtered (1–300 Hz) by a CyberAmp 380 amplifier (Molecular Devices). All the physiological variables were digitized and recorded to a personal computer using Spike 2 software (version 7.10 ...
-
bioRxiv - Physiology 2023Quote: ... and the data were sampled at 2 kHz and filtered at 1 kHz using pClamp 10 software (Molecular Devices). Light stimulation was applied using LEDs and a multi-LED driver through the microscope optics (DC4100 ...
-
bioRxiv - Neuroscience 2024Quote: ... Responses to repetitive 1 s light stimuli were recorded using Axosope 10.7 and analyzed using Clampfit 10.7 software (Molecular Devices) and Igor Pro 6.37 ...
-
bioRxiv - Neuroscience 2023Quote: ... BAT SNA was amplified (× 5,000 to 10,000) and filtered (1 to 300 Hz) using a CyberAmp 380 amplifier (Molecular Devices). All the physiological variables were digitized and recorded to a personal computer using Spike2 software (version 7.10 ...
-
bioRxiv - Neuroscience 2021Quote: ... low pas filtered at 1 kHz and digitized at a sampling rate of 20 kHz using Digidata 1440A (Molecular Devices). Data was recorded on a PC using pClamp 10.6 (Molecular Devices ...
-
bioRxiv - Neuroscience 2019Quote: ... Whole-cell patch-clamp recordings were made using a MultiClamp 700B amplifier (1 kHz low-pass Bessel filter and 10 kHz digitization) with pClamp 10.3 software (Molecular Devices). Voltage-clamp recordings were made using glass pipets with resistance 3-5 MOhms ...
-
bioRxiv - Neuroscience 2020Quote: ... Data were low-pass filtered at 1 kHz and digitized at 10 kHz with a digitizer (Digidata 1440; Molecular Devices). Series resistance was monitored and cells that displayed > 20% change over the duration of recording were excluded.
-
bioRxiv - Neuroscience 2021Quote: ... The digital low-pass 8-pole Bessel filter with 1 kHz 3dB cut-off was applied in Clampfit 10.7 (Molecular Devices) before the current amplitudes were determined ...
-
bioRxiv - Neuroscience 2022Quote: ... electrophysiological traces were low-pass filtered offline with an 8-pole RC filter at 1 kHz using ClampFit 10.7 (Molecular Devices). Four distinct parameters were analyzed from each choline-evoked response ...
-
bioRxiv - Cancer Biology 2019Quote: ... The cells were treated with various concentrations of BRAFi or/and CDK6i for 72 hr and then incubated with CellTiter 96 AQueous One Solution Reagent for 1-4 hr per manufacturer’s protocol before recording the absorbance at 490 nm on SpectraMax M2 (Molecular Devices). All experiments were performed in triplicate ...
-
bioRxiv - Physiology 2021Quote: ... Currents were filtered at 1 kHz and digitized at 5 kHz using an Axopatch 200B amplifier and Clampex 10.4 (Molecular Devices. Offline analysis was performed using Clampfit 10.4 ...
-
bioRxiv - Neuroscience 2021Quote: ... Mechanical stimulation in cell attached patches was performed using a high-speed pressure clamp (Besch et al., 2002) (HSPC-1, ALA Scientific) controlled by pClamp 11.1 software (Molecular Devices) as described earlier (Borbiro et al. ...
-
bioRxiv - Neuroscience 2022Quote: ... Signals were filtered with a 1 kHz bezel filter and sampled at 20 kHz using Axon pClamp10 software (Molecular Devices).
-
bioRxiv - Bioengineering 2022Quote: Phase contrast images were taken every 1 to 3 days with a high content microscope (ImageXPress XLS-C; Molecular Devices) to monitor culture development.
-
bioRxiv - Neuroscience 2024Quote: ... sEPSC recordings were filtered post-hoc with a 1 kHz low-pass Bessel 8-pole filter in Clampfit (Molecular Devices).
-
bioRxiv - Neuroscience 2024Quote: ... Signals were filtered with a 1 kHz bezel filter and sampled at 20 kHz using Axon pClamp10 software (Molecular Devices).
-
bioRxiv - Neuroscience 2023Quote: ... the slope of the first 1-2 ms of the fEPSP was obtained using Clampfit software (version 10.6; Molecular Devices) and averaged in 1-min bins ...
-
bioRxiv - Neuroscience 2023Quote: ... and data were digitized at 10 kHz and filtered at 1-2 kHz using a 1440A Digidata Digitizer (Molecular Devices). Series and input resistances (10-20 MΩ ...
-
bioRxiv - Neuroscience 2024Quote: ... low pas filtered at 1 kHz and digitized at a sampling rate of 20 kHz using Digidata 1440A (Molecular Devices). Data was recorded on a PC using pClamp 10.6 (Molecular Devices ...
-
bioRxiv - Neuroscience 2024Quote: ... The pressure waveform was digitized at 1 kHz using a MiniDigi 1B digitizer (Axon Instruments) and recorded with AxoScope 10.7 (Molecular Devices). Breaths were detected in Python 3.12 using a method similar but not identical to that described for event detection in the EEG ...
-
bioRxiv - Neuroscience 2022Quote: ... filtered at 3 kHz and digitized at 10 kHz using an EPC-10 patch-clamp amplifier with PatchMaster v2x73 software (batch 1) or MultiClamp 700B amplifier (Molecular Devices) with pClamp 10 software (batch 2) ...
-
bioRxiv - Biophysics 2022Quote: ... The data was passed through a low-pass filter (1 kHz cutoff frequency) and stored in PC using an analog-to-digital converter (5 kHz sampling; Digidata 1550A; Molecular Devices) and pCLAMP software (Molecular Devices).
-
bioRxiv - Pharmacology and Toxicology 2019Quote: ... Currents were recorded using an Axopatch 200B amplifier (Axon Instruments) at the sample rate of 5 kHz and filtered at 1 kHz with Digitata 1332A (Molecular Devices). Once a high resistance seal was formed ...
-
bioRxiv - Cell Biology 2019Quote: ... Signal was low-pass filtered at 1 kHz and digitized at 10 kHz with a Digidata 1440A or 1550 (Molecular Devices). Neurons with a series resistance (Rs ...
-
bioRxiv - Developmental Biology 2020Quote: ... A voltage-clamp protocol was employed to record whole-cell currents with and without extracellular divalent cations in response to a voltage ramp from −120 to 60 mV (1 second interval) using an Axopatch 200B amplifier with pCLAMP10 software (Molecular Devices) as previously described [71 ...
-
bioRxiv - Neuroscience 2020Quote: ... The signal for all voltage-clamp recordings was filtered at 1 kHz and digitized at 10 kHz with a digitizer (Molecular Devices). For voltage-clamp recordings ...
-
bioRxiv - Biophysics 2021Quote: ... The reaction was monitored at 650 nm (turbidity due to precipitation of the product) for 1 h at 25 °C using a Spectramax i3 (Molecular Devices). Statistical analysis was performed using unpaired t-test in Prims 9.0.
-
bioRxiv - Synthetic Biology 2021Quote: ... Reactions were monitored at 340 nm for 1 hour (30s per read) using a SpectraMax Plus 384 microplate reader (Molecular Devices). NADH concentrations were determined by its extinction coefficients ...
-
bioRxiv - Microbiology 2020Quote: ... Fluorescence was measured every 60s for 1 hour after addition of virus on a FilterMax F5 multimode microplate reader (Molecular Devices). Enzyme Vmax and Km was calculated using Prism software (GraphPad).
-
bioRxiv - Microbiology 2021Quote: ... 2021.Infected cells were imaged for 72 h with 1 h intervals with a 40x objective with the ImageXpress Micro XL high-content microscope (Molecular Devices). Different parameters ...
-
bioRxiv - Microbiology 2021Quote: ... Protein concentrations were determined using the corresponding extinction coefficient at 280 nm (ExPASy, ProtParam tool) and measured in a 1 ml quartz cuvette (Hellma Analytics) using a SpectraMax M2 spectrophotometer (Molecular Devices). Proteins were long-term stored at -80 °C in 10% glycerol.
-
bioRxiv - Biophysics 2021Quote: ... The analog current signal was low-pass filtered at 1 kHz (Bessel) and digitized at 10 kHz with a Digidata 1550A digitizer (Molecular Devices). Digitized data were recorded on a computer using the software pClamp (Molecular Devices ...
-
bioRxiv - Neuroscience 2022Quote: Mechanically activated currents from DRG neurons 1-3 days after culturing were recorded in whole cell patch clamp mode using a MultiClamp700A amplifier and DigiData1550 (Molecular Devices) and stored directly and digitized online using pClamp software (version 10.7) ...
-
bioRxiv - Biophysics 2022Quote: ... Data were filtered at 1-3kHz and digitized at 10kHz using a Digidata 1321A interface board and pCLAMP 10 software (Axon; Molecular Devices). Microelectrode resistances were 0.2–0.8MΩ when filled with 3 M KCl ...
-
bioRxiv - Cell Biology 2021Quote: ... The 96-well plate was spun at 700 rpm for 1 min before luminescence intensity was determined on a Flexstation 3 multi-mode microplate reader (Molecular Devices).
-
bioRxiv - Neuroscience 2021Quote: ... The signal for voltage-clamp recordings was filtered at 1 kHz and digitized at 10 kHz with a digitizer (Molecular Devices). Stimulus generation and data acquisition were performed using pClamp (Molecular Devices).
-
bioRxiv - Neuroscience 2020Quote: ... the recorded unit was stimulated by a current pulse of 250ms long (50 % duty cycle, 1-10 nA) sent through the recording electrode by axoClamp 2B (in bridge mode; Molecular Devices). Then ...
-
bioRxiv - Neuroscience 2022Quote: ... Membrane responses to 1 s current injection between 0-700 pA (100 pA increment) were collected using an Axopatch-200B amplifier (Molecular Devices). Paired pulse optogenetic and electrical stimulation (20 Hz every 30 s ...
-
bioRxiv - Cell Biology 2022Quote: ... Data was Bessel filtered online at 1 kHz and single channel currents were analyzed offline using ClampFit analysis module of pCLAMP 10 software (Molecular Devices).