Labshake search
Citations for Molecular Devices :
51 - 100 of 986 citations for Anion Exchange Membranes Thickness 10 13 µm since 2020
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Cell Biology 2024Quote: ... Clampfit 10 (Molecular Devices) was used for data analysis ...
-
bioRxiv - Genomics 2023Quote: ... Whole-cell recordings were performed using a Multiclamp 700B amplifier (10 kHz sampling rate, 10 kHz low-pass filter) and Digidata 1440A and pClamp 10 software (Molecular Devices). Patch pipettes (4–6 MΩ ...
-
bioRxiv - Neuroscience 2023Quote: ... Data were low-pass filtered at 10 kHz and acquired at 10 kHz using Multiclamp 700B and pClamp 10 (Molecular Devices). Series and membrane resistance was continuously monitored ...
-
bioRxiv - Pharmacology and Toxicology 2021Quote: ... The FLIPR membrane potential Blue dye was purchased from Molecular Devices (Crawley, UK) and Polyfect transfection reagent from Qiagen (West Sussex ...
-
bioRxiv - Neuroscience 2021Quote: ... Membrane currents and potentials were recorded using an Axoclamp 700B amplifier (Molecular Devices). Recordings were digitized at 20 kHz with a CED Micro 1401 Mk II and a PC running Signal ...
-
bioRxiv - Neuroscience 2020Quote: ... Membrane potential was recorded with an Axon Instruments Multiclamp 700B Amplifier (Molecular Devices) and voltages and currents were controlled and sampled using a Digidata 1322A interface using pClamp 9.2 software (Molecular Devices) ...
-
bioRxiv - Neuroscience 2022Quote: ... EJP amplitude and resting membrane potential were calculated using Clampfit 10.3 (Molecular Devices), while mEJP amplitude and frequency were calculated using MiniAnalysis (Synaptosoft Inc ...
-
bioRxiv - Physiology 2022Quote: ... The membrane voltage was recorded by Clampex 10.0 (Molecular Devices, Sunnyvale, CA, USA). At least 60 beats were recorded ...
-
bioRxiv - Bioengineering 2024Quote: ... and the FLIPR® membrane potential assay kit (Molecular Devices, Product No. R8042), following manufacturer’s instructions and using methods previously described [12 ...
-
bioRxiv - Bioengineering 2024Quote: Cell membrane permeability was quantified using a FlexStation 3 plate reader (Molecular Devices), which is equipped with an automated system that enables immediate fluorescence measurement after fluid transfer for kinetic assays ...
-
bioRxiv - Neuroscience 2024Quote: ... Signals were filtered at 4 – 10 kHz and digitized at 10 – 20 kHz (Digidata 1322A and pClamp 10 Software; Molecular Devices, Sunnyvale, CA). For cell attached recordings pipettes were filled with our standard extracellular solution.
-
bioRxiv - Neuroscience 2023Quote: ... and recorded with a 10 kHz sampling rate using pClamp 10 software (Molecular Devices). After achieving whole-cell configuration in voltage-clamp mode (−70 mV) ...
-
bioRxiv - Neuroscience 2020Quote: ... pCLAMP 10 software (Molecular Devices) was used for data acquisition and analysis ...
-
bioRxiv - Neuroscience 2021Quote: ... with Clampex 10 (Molecular Devices) and analyzed with pClamp 10 (Molecular Devices) ...
-
bioRxiv - Neuroscience 2021Quote: ... and pClamp 10 (Molecular Devices), using appropriate bridge balance and electrode-capacitance compensation ...
-
bioRxiv - Neuroscience 2023Quote: ... pClampfit 10 (Molecular Devices, U.S.A.), or MiniAnalysis (6.0.3 Synaptosoft ...
-
bioRxiv - Neuroscience 2023Quote: ... pClamp 10 software (Molecular Devices) was used for visualization and analysis of recorded traces.
-
bioRxiv - Neuroscience 2024Quote: ... with Clampex 10 (Molecular Devices) and analyzed with pClamp 10 (Molecular Devices) ...
-
bioRxiv - Developmental Biology 2024Quote: ... at z-steps of 0.275 µm with the help of MetaMorph advanced acquisition software (Molecular Devices, USA). Coverslips with the polyacrylamide gels were placed in stainless steel cell culture vessels and 500 µL of supplemented McCoy’s cell culture medium was added ...
-
bioRxiv - Neuroscience 2021Quote: ... Resting membrane potential (in mV) was read using the Multiclamp 700B Commander (Molecular Devices) while injecting no current (I = 0 ...
-
bioRxiv - Neuroscience 2021Quote: ... Resting membrane potential (in mV) was read using the Multiclamp 700B Commander (Molecular Devices) while injecting no current (I = 0 ...
-
bioRxiv - Neuroscience 2020Quote: ... Intracellular membrane voltage was recorded using a model 900A amplifier (Axon Instruments/Molecular Devices). In some cases ...
-
bioRxiv - Physiology 2022Quote: ... The membrane currents were recorded with Axopatch-200B amplifiers (Molecular Devices, Sunnyvale, CA, USA) by means of the whole-cell configuration of the patch-clamp technique ...
-
bioRxiv - Pharmacology and Toxicology 2021Quote: ... Membrane currents were recorded with a Multiclamp 700B amplifier (Molecular Devices, Sunnyvale CA, USA) controlled by Clampex 10 via Digidata 1332A (Molecular Devices ...
-
bioRxiv - Neuroscience 2020Quote: ... Membrane currents were recorded with a Multicamp 700B amplifier (Molecular Devices, Sunnyvale, CA, USA). Electrophysiological signals were low pass filtered at 3 kHz ...
-
bioRxiv - Neuroscience 2022Quote: ... Membrane currents were amplified in voltage-clamp using an Axopatch 200B amplifier (Molecular Devices) and a Digidata 1440A (Axon Instruments) ...
-
bioRxiv - Neuroscience 2023Quote: Membrane properties were calculated using Clampfit 10.7 software (Molecular Devices, Sunnyvale, CA, United States). Interspike interval (ISI ...
-
bioRxiv - Neuroscience 2023Quote: ... The membrane resistance (Rm) and capacitance (Cm) were directly measured by Clampex (Molecular Devices) in voltage-clamp mode ...
-
bioRxiv - Developmental Biology 2024Quote: ... Membrane properties and excitability were measured and analyzed with Clampfit 10.1 software (Molecular Devices).
-
bioRxiv - Cell Biology 2021Quote: ... Synaptic currents were sampled at 10 kHz and analyzed offline using Clampfit 10 (Molecular Devices) software ...
-
bioRxiv - Neuroscience 2021Quote: ... and decay slope (90%-10%) of the first action potential (pClamp 10 software, Molecular Devices). These two recording paradigms were conducted under two conditions ...
-
bioRxiv - Developmental Biology 2021Quote: ... using the Clampex 10 software and processed with Clampfit 10 (Axon Instruments, Molecular Devices, USA). Data were digitized at 10-20 kHz and filtered at 2.6 kHz ...
-
bioRxiv - Neuroscience 2020Quote: ... Data were sampled at 10 or 20 kHz and analyzed with pCLAMP 10 (Molecular Devices). To determine whether the laser stimulation-evoked EPSC is significant ...
-
bioRxiv - Neuroscience 2022Quote: ... at a sampling rate of 10 kHz and acquired using a PClamp 10 (Molecular Devices). EPSCs and IPSCs were recorded at a holding potential of −60 to −70 mV and 0 mV ...
-
bioRxiv - Neuroscience 2023Quote: ... pCLAMP 10 software and a Digidata 1440A and pCLAMP 10 software (Molecular Devices, Sunnyvale, USA). Borosilicate electrodes were pulled using a puller P-97 (Sutter Instrument ...
-
bioRxiv - Neuroscience 2024Quote: ... All recordings were made in ClampEx 10 and were analyzed with ClampFit 10 (Molecular Devices), or MiniAnalysis (Synaptosoft) ...
-
bioRxiv - Neuroscience 2021Quote: ... and pClamp 10 software (Molecular Devices). Recordings were filtered at 2 KHz for IPSC recordings and at 10 KHz for action potential recordings and sampled at 50 KHZ ...
-
bioRxiv - Neuroscience 2020Quote: ... with Clampex 10 software (Molecular Devices). Signals were sampled at 10 kHz and filtered at 2 kHz ...
-
bioRxiv - Neuroscience 2021Quote: ... and Clampex 10 software (Molecular Devices) at 10 kHz ...
-
bioRxiv - Neuroscience 2021Quote: ... and Clampex 10 software (Molecular Devices) at 5 kHz ...
-
bioRxiv - Physiology 2021Quote: ... and pCLAMP 10 software (Molecular devices). Compounds were applied to the extracellular solution and perfused the oocytes in a recording chamber ...
-
bioRxiv - Neuroscience 2022Quote: ... and Clampex 10 software (Molecular Devices). Action current detection was done using Clampfit 10.6 software ...
-
bioRxiv - Neuroscience 2021Quote: ... The Axon pClamp 10 (Molecular Devices) software was used to control the experiment ...
-
bioRxiv - Pharmacology and Toxicology 2022Quote: ... and pClamp 10 software (Molecular Devices). A 10-mV voltage jump in current clamp mode was performed during solution transitions from 20 mM LiCl to 20 mM LiOr ...
-
bioRxiv - Pharmacology and Toxicology 2020Quote: ... and pClamp 10 software (Molecular Devices). Slices from at least 3 mice are included in each group.
-
bioRxiv - Neuroscience 2021Quote: ... and Clampex 10 software (Molecular Devices). Recording pipettes were prepared from thick- walled borosilicate glass using a P-1000 micropipette puller (Sutter Instruments) ...
-
bioRxiv - Neuroscience 2022Quote: ... and pClamp 10 software (Molecular Devices). Electrode pipette was fabricated from KG-33 borosilicate glass (King Precision Glass ...
-
bioRxiv - Neuroscience 2022Quote: ... and pClamp 10 software (Molecular Devices). Standard-wall ...
-
bioRxiv - Neuroscience 2023Quote: ... with Clampex 10 software (Molecular Devices). Signals were sampled at 10 kHz and filtered at 2 kHz ...
-
bioRxiv - Neuroscience 2022Quote: ... and pClamp 10 software (Molecular Devices). Sampling rate was 10 kHz ...