Labshake search
Citations for Molecular Devices :
9451 - 9500 of 10000+ citations since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Neuroscience 2019Quote: ... and acquired by the pCLAMP software (Molecular Devices) with a PC computer ...
-
bioRxiv - Neuroscience 2019Quote: ... digitized (Digidata 1550B, Molecular Devices), and acquired by the pCLAMP software (Molecular Devices ...
-
bioRxiv - Neuroscience 2019Quote: Hippocampal CA1-PNs were recorded using the whole-cell current-clamp and voltage-clamp configurations of the patch-clamp technique using an Axopatch amplifier and pCLAMP software (Molecular Devices). Slices were visualized with an upright microscope (Zeiss Axoskop 2FS or Olympus BX51WI ...
-
bioRxiv - Neuroscience 2019Quote: ... Membrane currents and potentials were recorded using an Axoclamp 700B amplifier (Molecular Devices). Recordings were digitized at 20 kHz with a CED Micro 1401 Mk II and a PC running Signal ...
-
bioRxiv - Microbiology 2019Quote: ... Nile red fluorescence intensity was measured at an excitation wavelength of 485 and an emission wavelength of 528 using the SpectraMax i3x microplate reader (Molecular Devices, CA, USA). Detection of fluorescence intensity was commenced about 15 seconds after glucose addition (T0 ...
-
bioRxiv - Pharmacology and Toxicology 2019Quote: ... Measurements were performed using an AxoPatch 200B amplifier controlled by pClamp 9 software (Molecular Devices) at 22 °C using a ramp protocol ranging from −100 to +100 mV in 5 s from a holding potential of −40 mV ...
-
bioRxiv - Bioengineering 2019Quote: ... Currents were filtered at 2-3 kHz and sampled at 10 kHz using a Digidata 1440 A (Molecular Devices). Patch pipettes (4-6 MΩ ...
-
bioRxiv - Bioengineering 2019Quote: Somatic recordings from cultured neurons were performed at room temperature in the whole-cell voltage-clamp mode using a Multiclamp 700B controlled by pClamp 10 acquisition software (Molecular Devices). Currents were filtered at 2-3 kHz and sampled at 10 kHz using a Digidata 1440 A (Molecular Devices) ...
-
bioRxiv - Neuroscience 2019Quote: ... Electrophysiological recordings were made with a Multiclamp 700B patch clamp amplifier (Molecular Devices, Sunnyvale, CA) in voltage-clamp mode ...
-
bioRxiv - Cell Biology 2019Quote: ... Acquisition parameters were controlled by MetaMorph 7 software (Molecular Devices). For all live imaging experiments ...
-
bioRxiv - Pharmacology and Toxicology 2019Quote: Changes in membrane potential were measured using the FLIPR® blue membrane potential dye (Molecular Devices) in a FlexStation 3 ...
-
bioRxiv - Cell Biology 2019Quote: ... low-pass filtered at 10 kHz and analyzed using pCLAMP 10.4 software (Molecular Devices). In voltage-clamp mode ...
-
bioRxiv - Cell Biology 2019Quote: ... Membrane currents and Vm were digitized using a Digidata 1440A interface (Molecular Devices), low-pass filtered at 10 kHz and analyzed using pCLAMP 10.4 software (Molecular Devices) ...
-
bioRxiv - Cell Biology 2019Quote: ... Voltage- and current-clamp recordings were made using a Multiclamp 700B amplifier (Molecular Devices) at room temperature ...
-
bioRxiv - Evolutionary Biology 2019Quote: ... The plates were incubated at 37°C in a microplate reader (SpectraMax Plus 384, Molecular Devices, USA) and the growth was monitored by measuring OD at 600 nm every 15 min for 24 hrs ...
-
bioRxiv - Microbiology 2019Quote: ... on a Spectramax i3x Multi-Mode Microplate Reader (Molecular Devices).
-
bioRxiv - Microbiology 2019Quote: ... on a Spectramax i3x Multi-Mode Microplate Reader (Molecular Devices).
-
bioRxiv - Bioengineering 2019Quote: ... interfaced with patch-clamp software (Clampex, Molecular Devices). pClamp 10 software was used for data analysis.
-
bioRxiv - Bioengineering 2019Quote: ... The electrophysiological signals from the amplifier were digitized using Digidata 1440 (Molecular devices), interfaced with patch-clamp software (Clampex ...
-
bioRxiv - Bioengineering 2019Quote: The patch-clamp recording setup consists of an inverted Nikon fluorescence microscope (TS 100) platform using an amplifier system (Axon Multiclamp 700B, Molecular Devices). Micropipettes were pulled using a two-stage pipette puller (Narshinghe ...
-
bioRxiv - Bioengineering 2019Quote: ... controlled by Axon Instruments Digidata system (Molecular Devices). Cells ...
-
bioRxiv - Neuroscience 2019Quote: ... and pClamp 11.0.3 software (Molecular Devices). Electrophysiological sweeps were digitized at 10 kHz and filtered at 1 kHz.
-
bioRxiv - Systems Biology 2019Quote: ... assay plates were monitored for bacterial growth with a SPECTRAmax380 microtiter plate reader (Molecular Devices, Sunnyvale, CA) at 600 nm ...
-
bioRxiv - Animal Behavior and Cognition 2019Quote: ... were sampled at 500 kHz and identified offline (Digidata 1322A; Molecular Devices). As the non-target stimulus ...
-
bioRxiv - Neuroscience 2019Quote: Whole-cell patch-clamp recordings in voltage-clamp configuration were performed at room temperature (~25°C) on DIV14 neurons using a Multiclamp 700A amplifier and pClamp 10.5 software (Molecular Devices, Sunnyvale, CA, USA). Signals were filtered at 1 kHz and sampled at 10 kHz ...
-
bioRxiv - Neuroscience 2019Quote: ... Data acquisition and analysis were carried out with Digidata 1440A and pClamp10 software (Molecular Devices, LLC, Sunnyvale, CA).
-
bioRxiv - Neuroscience 2019Quote: All recordings were analyzed in IgorPro (WaveMetrics) or Clampfit (Molecular Devices). Graphs were made with IgorPro or Prism (Graphpad) ...
-
bioRxiv - Neuroscience 2019Quote: ... and digitized using pClamp software (20-50 kHz, Digidata 1550, Molecular Devices). Further digital filtering was performed offline ...
-
bioRxiv - Neuroscience 2019Quote: ... low-pass filtered (10 kHz Bessel, Multiclamp 700B, Molecular Devices) and digitized using pClamp software (20-50 kHz ...
-
bioRxiv - Cell Biology 2019Quote: ... All recordings were made with an Axopatch-200B amplifier (Axon Instruments, Inc., USA) equipped with Digidata 1550B and pClamp 10.6 software (Molecular Devices, USA) at room temperature ...
-
bioRxiv - Cell Biology 2019Quote: ... cell death was determined as the number of PI positive cells relative to the number of Hoechst 33342 positive cells using the MetaXpress software (Molecular Devices, San Jose, CA, USA).
-
bioRxiv - Cell Biology 2019Quote: ... The 96-well plates were placed in an environmentally controlled (37°C, 5% CO2) ImageXpress Micro high content screening system (Molecular Devices) for the duration of imaging ...
-
bioRxiv - Cell Biology 2019Quote: ... and an sCMOS camera (Zyla 5.5; Andor) manipulated by MetaMorph software (Molecular Devices). When observed mScarlet signal ...
-
bioRxiv - Cancer Biology 2019Quote: ... absorbances at 490 nm and 650 nm were recorded using a microplate reader (VersaMax™, Molecular Devices). All experiments were performed in triplicates.
-
bioRxiv - Neuroscience 2019Quote: ... filtered at 1-5 kHz and digitalized using a MultiClamp 700B (Molecular Devices). The sampling frequency was either 20 or 40 kHz ...
-
bioRxiv - Evolutionary Biology 2019Quote: ... Data acquisition and analysis were carried out with Digidata 1440A and pCLAMP™10 software (Molecular Devices, San Jose, CA, USA). Odorants were considered as active if the mean response they elicited was statistically different from 0 (Wilcoxon signed rank test) ...
-
bioRxiv - Neuroscience 2019Quote: ... Patch-clamp recordings were made at 32-34°C using a Multiclamp amplifier 700A (Molecular Devices, Sunnyvale, CA) and electrical signals were acquired at 20 kHz using the A/D board of the CCD camera ...
-
bioRxiv - Physiology 2019Quote: ... abf files produced by Clampex (Molecular Devices), MATLAB R2015a (MathWorks ...
-
bioRxiv - Physiology 2019Quote: Whole-cell currents were measured using Axopatch 200B (Molecular Devices, Sunnyvale, CA). Holding potential was −80 mV ...
-
bioRxiv - Biochemistry 2019Quote: ... The optical densities at 450 nm were read using an ELISA plate reader (Molecular Devices).
-
bioRxiv - Cancer Biology 2019Quote: ... Luminescence was measured for 500ms using a SpectraMax M3 Microplate Reader (Molecular Devices). IC50 values were calculated using GraphPad Prism 7 using three-parameter nonlinear regression analysis (except gemcitabine treated PA-TU-8902 used normalized response nonlinear regression analysis).
-
bioRxiv - Neuroscience 2019Quote: ... Recordings of thalamocortical neurons in the VB complex were performed at 34 °C in standard ACSF with an Axon Instruments Axopatch 200B Amplifier (Molecular Devices, USA) using 5–7 MΩ borosilicate pipettes ...
-
Pluripotent Stem Cells Can Be Isolated from Human Peripheral Nerves after in vitro BMP-2 StimulationbioRxiv - Cell Biology 2019Quote: ... and analyzed using a MetaMorph image analysis software (Molecular Devices, San Francisco, CA, USA). Variously stained images were overlaid by the image analysis software to illustrate the co-localization patterns.
-
bioRxiv - Biochemistry 2019Quote: ... The reaction was stopped by addition of 2 M H2SO4 (50 μl/well) and absorbance at 450 nm and 570 nm (background) was measured with a Versa max plate reader (Molecular Devices, Wokingham, UK).
-
bioRxiv - Biophysics 2019Quote: ... Data were acquired at a holding potential of −60 mV using an Axopatch 200B amplifier and Digidata 1322A digitizer with pClamp 9.0 software (Molecular Devices). Currents were digitized at 10 kHz and low-pass filtered at 1 kHz ...
-
bioRxiv - Biophysics 2019Quote: ... and light source were all controlled using pClamp 10.5 (Molecular Devices; San Jose, CA) and a DigiData 1440 A/D converter ...
-
bioRxiv - Biophysics 2019Quote: ... Data was recorded by Clampex software (Molecular Devices). Experiments were conducted at 23 °C.
-
bioRxiv - Biophysics 2019Quote: ... The signal was acquired by an analog-to-digital converter (Digidata 1440A, Molecular Devices) at a sampling rate of 50 kHz after processing with a 4-pole lowpass Bessel filter at 2 kHz ...
-
bioRxiv - Biophysics 2019Quote: ... −80 mV potential was applied across the bilayer and ionic current through nanopore was monitored in voltage-clamp mode by integrated patch clamp amplifier (Axopatch 200B, Molecular Devices). The signal was acquired by an analog-to-digital converter (Digidata 1440A ...
-
bioRxiv - Microbiology 2019Quote: ... The plates were further incubated at 37 °C under a 5 % CO2 for 6 to 8 hours before measuring the fluorescence of each culture using a Gemini Fluorescent Plate reader (Molecular Devices) set at λEX = 530 nm and λEM = 585 nm with a filter cut off at 550 nm ...