Labshake search
Citations for Molecular Devices :
8851 - 8900 of 10000+ citations since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Immunology 2020Quote: ... and kept at 37°C with 5% (v/v) CO2 incubator and Sytox Green fluorescence intensities were detected by a SpectraMax M2 fluorescence microplate reader (Molecular Devices) every 30 min for 180 min ...
-
bioRxiv - Microbiology 2020Quote: ... The optical density was measured at 490 nm on SpectraMax iD3 plate reader (Molecular Devices) and an absorbance reading greater than three standard deviations above the mean day 0 value was considered positive.
-
bioRxiv - Pharmacology and Toxicology 2020Quote: ... absorbance was measured at 450 nm and with 650 nm set as a reference wavelength (Versa max microplate reader/ Molecular Devices or EL808 microplate reader/ BioTek). After subtracting the absorbance of blank (only medium) ...
-
bioRxiv - Immunology 2020Quote: ... The plates were analyzed with a Versamax spectrophotometer equipped with Softmax Pro 7 software (Molecular Devices, Sunnyvale, CA, USA).
-
bioRxiv - Neuroscience 2020Quote: ... Current-clamp recordings were made with a MultiClamp 700B amplifier (Molecular Devices), filtered with a low pass Bessel filter at 10 kHz and digitized at 20-50 kHz (Digidata 1440A ...
-
bioRxiv - Neuroscience 2020Quote: ... Digitized data were analyzed offline using Clampfit 10 (Molecular Devices) and Igor (WaveMetrics).
-
bioRxiv - Neuroscience 2020Quote: ... pCLAMP10 software and a MultiClamp 700B amplifier was used for electrophysiology (Molecular Devices). For these recordings the intracellular solution in the patch pipette contained the following ...
-
bioRxiv - Neuroscience 2020Quote: ... a Digidata 1440 digitizer together with pClamp software (Molecular Devices). Borosilicate glass micropipettes were manufactured using a PC-100 puller (Narishige ...
-
bioRxiv - Neuroscience 2020Quote: ... Signals were low-pass filtered at 2 kHz and sampled at 10kHz with a Digidata 1440A (Molecular Devices). All data were stored on a computer for subsequent off-line analysis ...
-
bioRxiv - Neuroscience 2020Quote: ... The recordings were made with a microelectrode amplifier with bridge and voltage clamp modes of operation (Multiclamp 700B, Molecular Devices). Cell membrane potential was held at −60 mV ...
-
bioRxiv - Neuroscience 2020Quote: Data were acquired using a Multiclamp 700B amplifier (Molecular Devices) digitized at 10 kHz with an ITC-18 (Instrutech) ...
-
bioRxiv - Neuroscience 2020Quote: ... with a Bessel filter at 3kHz and Digitized at 20kHz using a Digidata 1440A (Molecular Devices). Protocols were designed ...
-
bioRxiv - Neuroscience 2020Quote: ... executed and analyzed using the pClamp 10.4 software package (Molecular Devices). Liquid junction potentials were not corrected for and series resistance compensation was not applied ...
-
bioRxiv - Neuroscience 2020Quote: ... using the PULSE software and processed with Igor Pro 6.21 (WaveMetrics) and Clampfit 10 (Axon Instruments, Molecular Devices, USA). Data were digitized at 10 kHz and filtered at 2.6 kHz.
-
bioRxiv - Cell Biology 2020Quote: ... The luminescence was read on SpectraMax Paradigm plate reader (Molecular Devices).
-
bioRxiv - Neuroscience 2020Quote: ... Whole cell recordings were performed using a Multiclamp 700B (Molecular Devices, Sunnyvale, CA) using pipettes with a resistance of 3-5 MOhm filled with a potassium-based internal solution containing 120 mM potassium gluconate ...
-
bioRxiv - Neuroscience 2020Quote: ... Data were collected with a MultiClamp 700B amplifier (Molecular Devices) and ITC-18 analog-to-digital board (HEKA ...
-
bioRxiv - Neuroscience 2020Quote: Membrane potential was recorded in current clamp at 10 kHz and filtered at 3 kHz (Multiclamp 700b; Molecular Devices). For current clamp recordings electrodes (4.5-6 MΩ ...
-
bioRxiv - Neuroscience 2020Quote: ... filtered with a low pass Bessel filter at 10 kHz and digitized at 20-50 kHz (Digidata 1440A, Molecular Devices). Series resistance was assessed during recordings and neurons showing a series resistance > 30 MΩ or change > 30% were discarded ...
-
bioRxiv - Neuroscience 2020Quote: Synaptic currents were recorded in voltage clamp at 10 kHz and filtered at 3 kHz (Multiclamp 700b; Molecular Devices). For voltage clamp recordings ...
-
bioRxiv - Neuroscience 2020Quote: ... AP parameters were analyzed from the first action potential using Clampfit 10.5 (pClamp, Molecular Devices, Union City ...
-
bioRxiv - Neuroscience 2020Quote: ... using a Multiclamp 700B amplifier and digitized at 10 kHz with Axon Digidata 1550 (Molecular Devices, Union City, California, USA). Holding current was less than 100 pA for all the recordings and the series resistance Rs was less than 30 MΩ ...
-
Cellular identity and Ca2+ signaling activity of the non-reproductive GnRH system in the Ciona larvabioRxiv - Neuroscience 2020Quote: ... The MetaMorph image analysis software system (Molecular Devices) was used for the analysis of the imaging ...
-
bioRxiv - Neuroscience 2020Quote: ... The plates were then immediately read at 450nm using a microplate reader (SpectraMax M3, Molecular Devices).
-
bioRxiv - Neuroscience 2020Quote: ... Recording were collected using a Multiclamp 700B amplifier (Molecular Devices) with a Bessel filter at 3kHz and Digitized at 20kHz using a Digidata 1440A (Molecular Devices) ...
-
bioRxiv - Neuroscience 2020Quote: ... Data were low-pass filtered at 2 kHz and acquired at 20 kHz with an Axon Multiclamp 700B amplifier (Molecular Devices, Sunnyvale, U.S.A.) using MATLAB (Mathworks ...
-
bioRxiv - Neuroscience 2020Quote: ... Data were collected with a modified electrochemical headstage (CB-7B/EC retrofit with 5 MΩ resistor) using a Multiclamp 700B amplifier (Molecular Devices) after being low-pass filtered at 10 kHz and digitized at 100 kHz using custom-written software in Igor Pro running mafPC (courtesy of M.A ...
-
bioRxiv - Synthetic Biology 2020Quote: ... both controlled with MetaMorph software (Molecular Devices). Data were collected as Z-series optical sections on a motorized stage (Prior Proscan II ...
-
bioRxiv - Immunology 2020Quote: ... Absorbance was measured at 450 nm using spectrophotometer (Spectramax M5, Molecular Devices).
-
bioRxiv - Cell Biology 2020Quote: ... Time-lapse imaging was controlled through MetaMorph software (Molecular Devices). The image visualisation and analysis was completed using the Fiji (ImageJ ...
-
bioRxiv - Immunology 2020Quote: ... All samples were tested in duplicate and quantified in SoftMax pro (version 7.0.3, Molecular Devices).
-
bioRxiv - Immunology 2020Quote: ... added for 30 min to 4hrs at 25°C and the OD was measured at 405nm in a microplate reader (Molecular Devices).
-
bioRxiv - Immunology 2020Quote: ... Absorbances were measured at 450 and 550nm in a microplate reader (Molecular Devices). Background signal (550nm ...
-
bioRxiv - Immunology 2020Quote: ... 1M HCl was used to stop conversion of TMB and optical density was measured at 450nm (OD450) and 540nm (OD540) using a Spectra Max 190 plate reader (Molecular Devices, San Jose, CA USA). Optical imperfections in assay plates were corrected through subtraction of OD540 values ...
-
bioRxiv - Neuroscience 2020Quote: ... filtered at 2 kHz and digitized using a DigiData 1440A digitizer (Molecular Devices, Sunnyvale, CA) at a sampling rate of 10 kHz ...
-
bioRxiv - Neuroscience 2020Quote: ... Recordings were done with an AxoPatch 200B amplifier (Molecular Devices, Sunnyvale, CA), filtered at 2 kHz and digitized using a DigiData 1440A digitizer (Molecular Devices ...
-
bioRxiv - Immunology 2020Quote: ... the luciferase activity in cell extracts was quantified with a SpectraMax i3x Multi-Mode plate reader (Molecular Devices, USA) after mixing 20 μl of lysate with 100 μl of substrate (Luciferase Assay System-Promega) ...
-
bioRxiv - Neuroscience 2020Quote: ... All electrical recordings were controlled by the pCLAMP™ software (Molecular Devices, Sunnyvale, CA). All whole-cell recordings had a membrane resistance of at least 500 MΩ (usual >1 GΩ ...
-
bioRxiv - Neuroscience 2020Quote: ... An Axoporator 800A (Molecular Devices) was used to deliver 50 hyperpolarizing pulses (−12 V ...
-
bioRxiv - Immunology 2020Quote: ... The optical density at 450nm was measured using a SpectraMax M2 plate reader (Molecular Devices). All wash steps were performed using a BioTek 405 Select Microplate Washer.
-
bioRxiv - Immunology 2020Quote: ... Plates were measured at 450nm by a microplate reader using Softmax Pro 6.0 software (Molecular Devices, CA, USA). PBS was used as a blank control ...
-
bioRxiv - Immunology 2020Quote: ... Optical density was measured at 450 nm with SOFTmax Pro software (Molecular Devices Corp).
-
bioRxiv - Synthetic Biology 2020Quote: ... in 96-well microtiter plates using a SpectraMax M2e microplate reader (Molecular Devices, Sunnyvale, CA, USA). In the case of the final OD600 at 24 h ...
-
bioRxiv - Biophysics 2020Quote: ... Traces were filtered by low-pass Bessel filter at 10 Hz for analyses performed with Origin Pro 8 (OriginLab) and Clampfit software (Molecular devices).
-
bioRxiv - Biophysics 2020Quote: ... The plate was loaded into a Flexstation 3 microplate reader (Molecular Devices, San Jose, CA) and incubated at 37 °C without agitation for 20 hours ...
-
bioRxiv - Cancer Biology 2020Quote: ... and the optical density at 450 nm was measured by a spectrophotometer (M5e, Molecular Devices, USA).
-
bioRxiv - Physiology 2020Quote: ... 45-60 minutes of basal nerve activity was monitored/recorded with pClamp software (version 10.2; Molecular Devices) until nerve activity stabilized ...
-
bioRxiv - Physiology 2020Quote: ... Both nerve and intracellular signals were sent to an A/D converter (Digidata 1322A, Molecular Devices, Sunnyvale, CA), digitized at 20 kHz and viewed on a computer monitor using pClamp software (version 10.2 ...
-
bioRxiv - Molecular Biology 2020Quote: ... for the Nikon microscope and MetaMorph (Molecular Devices) for the Zeiss microscope) ...
-
bioRxiv - Biochemistry 2020Quote: ... the cells were placed in a FLIPRTETRA fluorescence imaging plate reader (Molecular Devices). Drugs were diluted at 3× final concentration in drug buffer (1× HBSS ...