Labshake search
Citations for Molecular Devices :
751 - 800 of 862 citations for Tert Butyldimethyl 3 4 4 5 5 Tetramethyl 1 3 2 Dioxaborolan 2 Yl Phenoxy Silane since 2020
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Biophysics 2021Quote: ... a chlorinated silver wire (0.25 mm in thickness) was used (1-HLA-005, Molecular Devices, California, USA). The electrode was regularly abraded with sandpaper and immersed in commercial bleach solution for about 30 min in order to keep it chlorinated ...
-
bioRxiv - Neuroscience 2022Quote: ... Data were sampled at 1 kHz and recordings were analyzed offline using PClamp10 software (Molecular Devices, USA). Breathing frequency was calculated on a breath-to-breath basis ...
-
bioRxiv - Microbiology 2024Quote: ... 121 sites per well were imaged using a Plan-Apochromat 40x objective (Molecular Devices, #1-6300-0412). Automated image analysis was performed using a modular image analysis workflow built with the MetaXpress software (version 6.5.4.532 ...
-
bioRxiv - Microbiology 2024Quote: ... Plate was incubated at 25°C for 1 h prior to reading using SpectraMax iD5 (Molecular Devices). Fluo-4 NW Calcium Assay Kit (excitation 494 nm and emission at 516 nm).
-
bioRxiv - Biochemistry 2024Quote: ... OD600 measurements were made on 1 mL culture aliquots each hour using Multimode microplate reader(Molecular Devices). After approximately 6 h of growth in Stage 1 (OD600 > 3) ...
-
bioRxiv - Biophysics 2024Quote: ... data were digitized at 10 kHz and filtered at 1 kHz and pCLAMP 10 suite (Molecular Devices) was used for data acquisition and analysis ...
-
bioRxiv - Neuroscience 2021Quote: ... Signals were low-pass filtered at 1 kHz and sampled at 10 kHz using Digidata 1440A (Molecular Devices). For mEPSC recordings ...
-
bioRxiv - Neuroscience 2022Quote: ... The signal was filtered at 1 kHz and digitized at 10 kHz using Axon Digidata 1550B (Molecular Devices). Recording pipettes (3.5-5 MΩ ...
-
bioRxiv - Cell Biology 2021Quote: ... 36 sites per well were imaged using a Plan-Apochromat 40x objective (Molecular Devices, cat# 1-6300-0297). Automated image analysis was performed using the MetaXpress software (version 6.5.4.532 ...
-
bioRxiv - Biophysics 2020Quote: ... The recording electrode was a chlorinated silver wire (0.25 mm thickness, 1-HLA-005, Molecular Devices, California, USA).
-
bioRxiv - Neuroscience 2021Quote: ... fEPSPs were recorded and filtered (low pass at 1 kHz) with an Axopatch 200A amplifier (Molecular Devices, LLC) and digitized at 10 kHz with an A/D converter (Digidata 1322A ...
-
bioRxiv - Developmental Biology 2023Quote: ... which is repeated every 1 h from late E2.5 to E3.5 using a custom Metamorph journal (Molecular Devices). A 60 μm z-stack with a 5 μm step size is acquired before every time lapse to discern TE and ICM cells.
-
bioRxiv - Neuroscience 2023Quote: ... Data were filtered at 1 kHz and digitized at 20 kHz using a 1440A Digidata Digitizer (Molecular Devices). Series-resistance (10-20 MΩ ...
-
bioRxiv - Synthetic Biology 2024Quote: ... The reaction was diluted 1:20 and the absorbance was measured in a spectrophotometer (Spectramax 190, Molecular Devices) in Nunc 96-well plates (ThermoFisher) ...
-
bioRxiv - Neuroscience 2022Quote: ... The plate was incubated for 1 h at RT and read on an HTRF plate reader (Molecular Devices).
-
bioRxiv - Neuroscience 2022Quote: ... The plate was read within 1 hour after cell lysis using a SpectraMax plate reader (Molecular Devices, CA). Samples were excited at 480nm ...
-
bioRxiv - Microbiology 2024Quote: ... Thirty-six sites per well were imaged using a Plan-Apochromat 40x objective (Molecular Devices, #1-6300-0297). Automated image analysis was performed using the MetaXpress software (see Supplementary Methods ...
-
bioRxiv - Biophysics 2021Quote: Recordings containing 1-9 channels were idealized through half-amplitude threshold crossing and analyzed using Clampfit software (Molecular Devices).
-
bioRxiv - Neuroscience 2020Quote: ... band-pass filtered (1-3000 Hz) and sampled at 10 kHz with a Digidata 1440A acquisition board (Molecular Devices). Spikes were sorted using Spike 2 software (CED ...
-
bioRxiv - Neuroscience 2024Quote: ... Responses to repetitive 1 s light stimuli were recorded using Axosope 10.7 and analyzed using Clampfit 10.7 software (Molecular Devices) and Igor Pro 6.37 ...
-
bioRxiv - Genetics 2022Quote: ... Absorbance at 420 nm was measured every minute for 1 hour on a SpectraMax M2 Microplate Reader (Molecular Devices). Measures taken between 20 and 35 minutes (linear range ...
-
bioRxiv - Physiology 2022Quote: BAT SNA was amplified (x 5,000–10,000) and filtered (1–300 Hz) by a CyberAmp 380 amplifier (Molecular Devices). All the physiological variables were digitized and recorded to a personal computer using Spike 2 software (version 7.10 ...
-
bioRxiv - Neuroscience 2023Quote: ... BAT SNA was amplified (× 5,000 to 10,000) and filtered (1 to 300 Hz) using a CyberAmp 380 amplifier (Molecular Devices). All the physiological variables were digitized and recorded to a personal computer using Spike2 software (version 7.10 ...
-
bioRxiv - Neuroscience 2021Quote: ... low pas filtered at 1 kHz and digitized at a sampling rate of 20 kHz using Digidata 1440A (Molecular Devices). Data was recorded on a PC using pClamp 10.6 (Molecular Devices ...
-
bioRxiv - Neuroscience 2020Quote: ... Data were low-pass filtered at 1 kHz and digitized at 10 kHz with a digitizer (Digidata 1440; Molecular Devices). Series resistance was monitored and cells that displayed > 20% change over the duration of recording were excluded.
-
bioRxiv - Neuroscience 2021Quote: ... The digital low-pass 8-pole Bessel filter with 1 kHz 3dB cut-off was applied in Clampfit 10.7 (Molecular Devices) before the current amplitudes were determined ...
-
bioRxiv - Neuroscience 2022Quote: ... electrophysiological traces were low-pass filtered offline with an 8-pole RC filter at 1 kHz using ClampFit 10.7 (Molecular Devices). Four distinct parameters were analyzed from each choline-evoked response ...
-
bioRxiv - Genetics 2021Quote: ... Optical density data were collected every 1 hour for 72 h total using a plate reader (SpectraMAX 384, Molecular Devices). Growth kinetic parameters were calculated using the MATLAB code OCHT reported by de Mello et al ...
-
bioRxiv - Neuroscience 2021Quote: ... Mechanical stimulation in cell attached patches was performed using a high-speed pressure clamp (Besch et al., 2002) (HSPC-1, ALA Scientific) controlled by pClamp 11.1 software (Molecular Devices) as described earlier (Borbiro et al. ...
-
bioRxiv - Neuroscience 2024Quote: ... sEPSC recordings were filtered post-hoc with a 1 kHz low-pass Bessel 8-pole filter in Clampfit (Molecular Devices).
-
bioRxiv - Neuroscience 2024Quote: ... Signals were filtered with a 1 kHz bezel filter and sampled at 20 kHz using Axon pClamp10 software (Molecular Devices).
-
bioRxiv - Neuroscience 2022Quote: ... Signals were filtered with a 1 kHz bezel filter and sampled at 20 kHz using Axon pClamp10 software (Molecular Devices).
-
bioRxiv - Neuroscience 2024Quote: ... low pas filtered at 1 kHz and digitized at a sampling rate of 20 kHz using Digidata 1440A (Molecular Devices). Data was recorded on a PC using pClamp 10.6 (Molecular Devices ...
-
bioRxiv - Neuroscience 2024Quote: ... The pressure waveform was digitized at 1 kHz using a MiniDigi 1B digitizer (Axon Instruments) and recorded with AxoScope 10.7 (Molecular Devices). Breaths were detected in Python 3.12 using a method similar but not identical to that described for event detection in the EEG ...
-
bioRxiv - Immunology 2024Quote: ... The reaction was then stopped with 1 N H2SO4 and the plate was read using a SpectraMax i3 (Molecular Devices) at wavelengths of 450 nm and 570 nm.
-
bioRxiv - Neuroscience 2024Quote: ... The frequency of sIPSCs for 1 min of pre- and post-NA application were quantified using Clampfit version 10.7 (Molecular Devices). We quantified averaged RMP for 1 min of pre- and post-drug application ...
-
bioRxiv - Neuroscience 2024Quote: ... and emission at 520 nm was imaged with a Hamamatsu OrcaFlash 4.0LT camera (1 fps, 100 ms exposure) and recorded using MetaFluor (Molecular Devices). The baseline intracellular Ca2+ concentration was monitored for 120Ls before adding any other stimuli and a Krebs-based solution in which the KCl concentration was increased to 45 mM by iso-osmotic substitution of NaCl was used at the end of each experiment to identify DRG neurons ...
-
bioRxiv - Molecular Biology 2021Quote: ... by 1:20 dilution with a series of commercially available pH buffers (HYDRION) using a SpectraMax-M5 plate reader (Molecular Devices) to read out fluorescence ...
-
bioRxiv - Neuroscience 2022Quote: ... filtered at 3 kHz and digitized at 10 kHz using an EPC-10 patch-clamp amplifier with PatchMaster v2x73 software (batch 1) or MultiClamp 700B amplifier (Molecular Devices) with pClamp 10 software (batch 2) ...
-
bioRxiv - Developmental Biology 2020Quote: ... A voltage-clamp protocol was employed to record whole-cell currents with and without extracellular divalent cations in response to a voltage ramp from −120 to 60 mV (1 second interval) using an Axopatch 200B amplifier with pCLAMP10 software (Molecular Devices) as previously described [71 ...
-
bioRxiv - Neuroscience 2020Quote: ... The signal for all voltage-clamp recordings was filtered at 1 kHz and digitized at 10 kHz with a digitizer (Molecular Devices). For voltage-clamp recordings ...
-
bioRxiv - Biophysics 2021Quote: ... The reaction was monitored at 650 nm (turbidity due to precipitation of the product) for 1 h at 25 °C using a Spectramax i3 (Molecular Devices). Statistical analysis was performed using unpaired t-test in Prims 9.0.
-
bioRxiv - Synthetic Biology 2021Quote: ... Reactions were monitored at 340 nm for 1 hour (30s per read) using a SpectraMax Plus 384 microplate reader (Molecular Devices). NADH concentrations were determined by its extinction coefficients ...
-
bioRxiv - Microbiology 2020Quote: ... Fluorescence was measured every 60s for 1 hour after addition of virus on a FilterMax F5 multimode microplate reader (Molecular Devices). Enzyme Vmax and Km was calculated using Prism software (GraphPad).
-
bioRxiv - Microbiology 2021Quote: ... 2021.Infected cells were imaged for 72 h with 1 h intervals with a 40x objective with the ImageXpress Micro XL high-content microscope (Molecular Devices). Different parameters ...
-
bioRxiv - Microbiology 2021Quote: ... Protein concentrations were determined using the corresponding extinction coefficient at 280 nm (ExPASy, ProtParam tool) and measured in a 1 ml quartz cuvette (Hellma Analytics) using a SpectraMax M2 spectrophotometer (Molecular Devices). Proteins were long-term stored at -80 °C in 10% glycerol.
-
bioRxiv - Biophysics 2021Quote: ... The analog current signal was low-pass filtered at 1 kHz (Bessel) and digitized at 10 kHz with a Digidata 1550A digitizer (Molecular Devices). Digitized data were recorded on a computer using the software pClamp (Molecular Devices ...
-
bioRxiv - Biophysics 2022Quote: ... Data were filtered at 1-3kHz and digitized at 10kHz using a Digidata 1321A interface board and pCLAMP 10 software (Axon; Molecular Devices). Microelectrode resistances were 0.2–0.8MΩ when filled with 3 M KCl ...
-
bioRxiv - Immunology 2020Quote: ... and the reactions were stopped by adding 1 M H2SO4 before measuring absorbance at 450 nm with a Spectramax Paradigm plate reader (Molecular Devices).
-
bioRxiv - Immunology 2020Quote: ... and the reactions were stopped by adding 1 M H2SO4 before measuring absorbance at 450 nm with a Spectramax Paradigm plate reader (Molecular Devices).