Labshake search
Citations for Molecular Devices :
7751 - 7800 of 10000+ citations since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Neuroscience 2020Quote: ... and stored using pClamp 10 software (Molecular Devices). The experimental protocol involved recording baseline cell characteristics in current clamp ...
-
bioRxiv - Neuroscience 2020Quote: ... Recordings were made using a Multiclamp 700B amplifier controlled by pClamp 10.4 software via an Axon Digidata 1515 analog-to-digital converter (Molecular Devices, US). Recording pipettes were filled with internal solution containing (in mM) ...
-
bioRxiv - Neuroscience 2020Quote: ... Whole cell patch clamp recordings of GFP+ cells in the motor cortex were collected using a HEKA Patch Clamp EPC800 amplifier and pCLAMP 10.5 software (Molecular devices; RRID: SCR_011323).
-
bioRxiv - Neuroscience 2020Quote: ... All recordings swere filtered (4 kHz low-pass filter) and sampled (10 kHz) for online and later offline analysis with Multiclamp 700B amplifier (Molecular Devices, Sunnyvale, CA, USA) and Clampfit v.10.5 software (Molecular Devices).
-
bioRxiv - Neuroscience 2020Quote: ... and Clampfit v.10.5 software (Molecular Devices).
-
bioRxiv - Neuroscience 2020Quote: ... The absorbance at 530 nM was obtained using Multi-function enzyme marker workstation (Molecular Devices, USA). The concentration in the supernatant was calculated using the standard curve ...
-
bioRxiv - Neuroscience 2020Quote: ... Cone counts were computed from each individual image using MetaMorph 7.8 software (Molecular Devices, Sunnyvale, CA) and summed together to yield a whole retina count ...
-
bioRxiv - Neuroscience 2020Quote: ... and digitized using a Digidata 1440A (Molecular Devices).
-
bioRxiv - Neuroscience 2020Quote: ... Whole-cell patch clamp recordings were obtained using a Multiclamp 700B amplifier (Molecular Devices). Data were sampled at 20 kHz ...
-
bioRxiv - Neuroscience 2020Quote: ... Data were acquired and analyzed using pClamp (Molecular Devices).
-
bioRxiv - Neuroscience 2020Quote: ... The signal intensity of Nlgn3 labeling in the hippocampus was measured using the Integrated Morphometry Analysis (IMA) function in MetaMorph software (Molecular Devices). Briefly ...
-
bioRxiv - Neuroscience 2020Quote: ... amplified with an Axopatch 200B (Molecular Devices), and analyzed using ClampFit version 10 software (RRID:SCR_011323 ...
-
bioRxiv - Neuroscience 2020Quote: Electrophysiological signals were digitized with Digidata 1440A (Molecular Devices), amplified with an Axopatch 200B (Molecular Devices) ...
-
bioRxiv - Neuroscience 2020Quote: ... and analyzed using ClampFit version 10 software (RRID:SCR_011323, v10.3, Molecular Devices). Subsequently ...
-
bioRxiv - Neuroscience 2020Quote: ... Digidata 1440A and pCLAMP10 software (Molecular Devices). Signals were sampled at 20 kHz ...
-
bioRxiv - Neuroscience 2020Quote: ... A Digidata 1440A digitizer and a Multiclamp 700B amplifier (Molecular Devices) were used for data acquisition ...
-
bioRxiv - Neuroscience 2020Quote: ... Electrophysiological recordings were performed with Multiclamp 700B and Pclamp10.6 software (Molecular Devices). Signals were filtered at 3 kHz ...
-
Basolateral amygdala parvalbumin neurons report aversive prediction error to constrain fear learningbioRxiv - Neuroscience 2020Quote: ... Electrophysiological recordings were amplified using a Multiclamp amplifier (700B, Molecular Devices, California, USA), filtered at 6-10 kHz ...
-
bioRxiv - Cell Biology 2020Quote: ... and controlled by the MetaMorph 7.8 software (Molecular Devices). 491nm 100mW Calypso (Cobolt ...
-
bioRxiv - Cell Biology 2020Quote: ... and controlled by the MetaMorph 7.8 software (Molecular Devices). 491nm 100mW Calypso (Cobolt ...
-
bioRxiv - Cell Biology 2020Quote: ... and controlled by the MetaMorph 7.8 software (Molecular Devices). Stradus 405 nm (100mW ...
-
bioRxiv - Cell Biology 2020Quote: ... All hardware was controlled using MetaMorph Automation and Image Analysis Software (Molecular Devices, Sunnyvale, CA). Cells were imaged in the 491 and 561 channel at various time intervals ranging from 2 – 20 seconds.
-
bioRxiv - Neuroscience 2020Quote: ... Recordings were acquired using Clampex (Molecular Devices) and analyzed with Clampfit (Molecular Devices) ...
-
bioRxiv - Neuroscience 2020Quote: ... Signals were amplified with an Axopatch 200B amplifier (Molecular Devices, Union City, CA) digitized by a Digidata 1550 interface (Axon Instruments ...
-
bioRxiv - Neuroscience 2020Quote: ... digitized by a Digidata 1550 interface (Axon Instruments, Molecular Devices, San Jose, CA) and sampled at 10 kHz ...
-
bioRxiv - Neuroscience 2020Quote: ... and analyzed with Clampfit (Molecular Devices). Experimenters were blinded to treatment for all experiments.
-
bioRxiv - Neuroscience 2020Quote: ... and current clamped recordings were made using a MultiClamp 700B amplifier (2 kHz low-pass Bessel filter and 10 kHz digitization) with pClamp 10.3 software (Molecular Devices, Sunnyvale, CA). Firing rate was determined before breaking into the cell under cell attached mode for at least 60 seconds of continuous activity ...
-
bioRxiv - Neuroscience 2020Quote: ... Analysis was performed with the Clampex software suite (Molecular Devices).
-
bioRxiv - Neuroscience 2020Quote: ... All recordings were obtained with a Multiclamp 700B amplifier (Molecular Devices, Sunnyvale, CA), filtered at 2 kHz ...
-
bioRxiv - Neuroscience 2020Quote: ... Digidata 1440A interface and Clampex 10 data acquisition software (Molecular Devices). After the establishment of the whole-cell configuration ...
-
bioRxiv - Neuroscience 2020Quote: ... and collected on-line using pClamp 10 software (Molecular Devices). Photostimuli were applied every 45 s and 10 photo-evoked currents were averaged per neuron per condition ...
-
bioRxiv - Neuroscience 2020Quote: Data were analysed using Clampfit (pClamp 10 - Molecular Devices). Synaptic stimulations across at least 20 sweeps were averaged ...
-
bioRxiv - Neuroscience 2020Quote: ... Clampex 10.0 software (Molecular Devices, Union City, CA, USA) was used for data acquisition ...
-
bioRxiv - Neuroscience 2020Quote: ... while data analysis was performed by Clampfit 10.0 (Molecular Devices) software ...
-
bioRxiv - Neuroscience 2020Quote: ... Whole-cell patch-clamp experiments were conducted at room temperature with an Axopatch 200A amplifier (Molecular Devices, Union City, CA, USA). Clampex 10.0 software (Molecular Devices ...
-
bioRxiv - Neuroscience 2020Quote: ... The signal for all voltage-clamp recordings was filtered at 1 kHz and digitized at 10 kHz with a digitizer (Molecular Devices). For voltage-clamp recordings ...
-
bioRxiv - Neuroscience 2020Quote: ... Somatic patch-clamp recordings were obtained with an amplifier (Molecular Devices). The signal for all voltage-clamp recordings was filtered at 1 kHz and digitized at 10 kHz with a digitizer (Molecular Devices) ...
-
bioRxiv - Neuroscience 2020Quote: ... Stimulus generation and data acquisition were performed using pClamp (Molecular Devices).
-
bioRxiv - Neuroscience 2020Quote: ... Recordings were made using a Multiclamp 700B amplifier (Molecular Devices). Data were sampled at 10 kHz and filtered at 4 kHz ...
-
bioRxiv - Neuroscience 2020Quote: ... using a GeneClamp 500B amplifier (Axon Instruments) and a Digidata™ 1440A converter (Molecular Devices), as described previously43.
-
bioRxiv - Neuroscience 2020Quote: ... Traces were collected in pCLAMP 9 (Molecular Devices, CA, USA) and stored on a desktop computer ...
-
bioRxiv - Neuroscience 2020Quote: ... and filtered online at 2 kHz with the amplifiers 4-pole Bessel Filter and digitised at 20 kHz (Digidata1550B, Molecular Devices, CA, USA)
-
bioRxiv - Neuroscience 2020Quote: ... All recording was performed with a Multiclamp 700B amplifier (Molecular Devices, CA, USA) and filtered online at 2 kHz with the amplifiers 4-pole Bessel Filter and digitised at 20 kHz (Digidata1550B ...
-
bioRxiv - Neuroscience 2020Quote: ... Currents were recorded at 22–26°C using an Axopatch-700B amplifier (Molecular Devices), filtered at 5 kHz (low-pass 8-pole Bessel filter ...
-
bioRxiv - Neuroscience 2020Quote: ... Data were collected and analyzed using the Axopatch 700B amplifiers and pCLAMP10 software (Molecular Devices) and mEPSCs are analyzed using mini Analysis Program.
-
bioRxiv - Neuroscience 2020Quote: ... and recorded with Axopatch-700B amplifier (Molecular Devices, San Jose, CA). Data were low-pass filtered at 2 kHz and acquired at 5–10 kHz ...
-
bioRxiv - Neuroscience 2020Quote: ... They were stored using pClamp 10.4 software (Molecular Devices, Sunnyvale, CA, USA). The signals were digitally sampled at 10 kHz and subsequently filtered at 2 kHz for analysis ...
-
bioRxiv - Neuroscience 2020Quote: ... Signals were low-pass filtered (Bessel, 2 kHz) and collected at 10 kHz using the data acquisition software pClamp 10.5 (Molecular Devices). Optical stimulation was applied through the microscope with two LEDs (460 nm and 525 nm ...
-
bioRxiv - Neuroscience 2020Quote: ... All electrophysiological recordings were extracted using Clampfit (Molecular Devices) and analyzed with R.
-
bioRxiv - Neuroscience 2020Quote: ... connected to a Digidata (1550 LowNoise acquisition system, Molecular Devices). Signals were low-pass filtered (Bessel ...