Labshake search
Citations for Molecular Devices :
701 - 750 of 986 citations for Anion Exchange Membranes Thickness 10 13 µm since 2020
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Neuroscience 2023Quote: ... and acquired at 20 kHz onto a personal computer using the pClamp 10 software (Molecular Devices, San Jose, USA) which was also used for further analysis ...
-
bioRxiv - Neuroscience 2024Quote: ... digitized at 10 kHz (DigiData 1550B) and acquired using Clampex 10.7 Software (all from Molecular Devices, San Jose, US). Patch pipettes were prepared using a P-1000 micropipette puller (Sutter Instruments ...
-
bioRxiv - Neuroscience 2024Quote: ... Currents were recorded in voltage clamp mode at 10 kHz and filtered at 3 kHz (Multiclamp 700b; Molecular Devices). To facilitate the detection of synaptic calcium transients ...
-
bioRxiv - Neuroscience 2024Quote: ... Signals were filtered at 6–10 kHz and sampled at 50 kHz with the Digidata 1440B digitizer (Molecular Devices). For whole-cell recordings ...
-
bioRxiv - Neuroscience 2024Quote: ... Data were filtered at 10 kHz and digitized at 100 kHz using an acquisition board (Digidata 1440A; Molecular Devices) attached to a personal computer running pClamp 10.7 software package (Molecular Devices) ...
-
Entorhinal cortex vulnerability to human APP expression promotes hyperexcitability and tau pathologybioRxiv - Neuroscience 2024Quote: ... Signals were filtered at 4 kHz (Bessel) and sampled at 10 kHz with the Digidata 1440B digitizer (Molecular Devices). For each session ...
-
bioRxiv - Neuroscience 2024Quote: ... filtered at 10 kHz using a Bessel filter and digitized at 20 kHz with Digidata 1440A digitizer (Molecular Devices), and stored using pClamp10 (Molecular Devices) ...
-
bioRxiv - Neuroscience 2020Quote: ... Signals were low-pass filtered (Bessel, 2 kHz) and collected at 10 kHz using the data acquisition software pClamp 10.5 (Molecular Devices). Optical stimulation was applied through the microscope with two LEDs (460 nm and 525 nm ...
-
bioRxiv - Biochemistry 2020Quote: ... IgG1 Fc-fused sACE22 (wild type or engineered variant sACE22.v2.4) were immobilized at 100 nM for 10 minutes to anti-human IgG Fc biosensors (Molecular Devices). The assay buffer was 10 mM HEPES pH 7.6 ...
-
bioRxiv - Neuroscience 2020Quote: ... Data were low-pass filtered at 1 kHz and digitized at 10 kHz with a digitizer (Digidata 1440; Molecular Devices). Series resistance was monitored and cells that displayed > 20% change over the duration of recording were excluded.
-
bioRxiv - Neuroscience 2020Quote: ... The data were low-pass filtered at 2 kHz and digitized at 10 kHz using a Digidata 1322A (Molecular Devices) and stored using Clampex version10 ...
-
bioRxiv - Neuroscience 2020Quote: ... Signals were low-pass filtered (Bessel, 2 kHz) and collected at 10 kHz using the data acquisition software pClamp 10.5 (Molecular Devices). Electrophysiological recordings were extracted using Clampfit (Molecular Devices ...
-
bioRxiv - Bioengineering 2020Quote: ... All biochemical assays were performed in 10 μL of media and measured on a SpectraMax i3 plate reader (Molecular Devices). All sample results were calculated by interpolation of sample raw values from standard curves performed in parallel ...
-
bioRxiv - Cell Biology 2021Quote: ... Data were digitized at 10 kHz with a 2 kHz low-pass filter using a Multiclamp 700A amplifier (Molecular Devices). For all electrophysiological experiments ...
-
bioRxiv - Neuroscience 2022Quote: ... All traces were digitized using a Digidata 1332 data acquisition board and recorded in pClamp 10 software (both Molecular Devices).
-
bioRxiv - Neuroscience 2021Quote: ... Signals were low pass filtered (Bessel, 2 kHz) and collected at 10 kHz using the data acquisition software pClamp 10.5 (Molecular Devices). All the electrophysiological recordings were extracted using Clampfit (Molecular Devices ...
-
bioRxiv - Neuroscience 2021Quote: ... single-pole Bessel filter and digitized at 20 kHz using Digidata 1322A digitizer driven by PClamp 10 software (Molecular Devices). Care was taken to maintain the access resistance below 10 MΩ.
-
bioRxiv - Neuroscience 2021Quote: ... Signals were filtered at 3 kHz and digitized at 10 kHz using a Digidata 1322A or 1440A and pClamp 9.2 or 10.2 (Molecular Devices, USA). Recordings were not corrected for a liquid junction potential ...
-
bioRxiv - Neuroscience 2021Quote: ... the data acquired at 5 kHz with a Digidata 1440A (Axon instruments) interface using pCLAMP 10 acquisition software (Molecular Devices). The Internal and external (bath ...
-
bioRxiv - Neuroscience 2021Quote: Electrophysiological data were acquired and digitized at 4 kHz through a Digidata 1440a interface using Clampex 10 software (Molecular Devices). hiPSC-MNs were visualized with infrared differential interference contrast microscopy using a Nikon Eclipse E600FN upright microscope coupled with a water-immersion objective (Nikon Fluor 40X/0.8W) ...
-
bioRxiv - Developmental Biology 2022Quote: ... and area under the curve were analyzed post addition (acute and after 10-minute incubation) using ScreenWorks software (Molecular Devices) and normalized to baseline measurements ...
-
bioRxiv - Neuroscience 2022Quote: ... and the electrophysiological signals were sampled with a rate of 20 kHz (Digidata 1440A with pCLAMP 10 Software, Molecular Devices). The recording electrodes were moved down until the electrophysiological identification of the receptive field (Figure 1D) ...
-
bioRxiv - Neuroscience 2020Quote: ... filtered with a low pass Bessel filter at 10 kHz and digitized at 20-50 kHz (Digidata 1440A, Molecular Devices). Series resistance was assessed during recordings and neurons showing a series resistance > 30 MΩ or change > 30% were discarded ...
-
bioRxiv - Neuroscience 2020Quote: ... using a Multiclamp 700B amplifier and digitized at 10 kHz with Axon Digidata 1550 (Molecular Devices, Union City, California, USA). Holding current was less than 100 pA for all the recordings and the series resistance Rs was less than 30 MΩ ...
-
bioRxiv - Neuroscience 2020Quote: Signals were low-pass filtered at 2 kHz and digitised at 10 kHz using an Axopatch 200B amplifier (Molecular Devices) and WinLTP v1.11 acquisition software [46].
-
bioRxiv - Neuroscience 2020Quote: Data were digitized at 10 kHz with a 2 kHz low-pass filter using a Multiclamp 700A amplifier (Molecular Devices). Data were analyzed using Clampfit 9.02 software ...
-
bioRxiv - Biochemistry 2021Quote: ... All currents were sampled at 10 kHz and low-pass filtered at 2 kHz through pCLAMP software (Molecular Devices, Sunnyvale). Origin 9.0 software (OriginLab Corp. ...
-
bioRxiv - Neuroscience 2021Quote: ... Data were filtered at 5-10 kHz and digitized at 50 kHz using an acquisition board (Digidata 1440, Molecular Devices) attached to a personal computer running pCLAMP 10.2 software package (Molecular Devices) ...
-
bioRxiv - Immunology 2021Quote: Processed slides were scanned and analyzed as described58 at 10 μm resolution with a GenePix 4000B microarray scanner (Molecular Devices) using 350 gain ...
-
bioRxiv - Biochemistry 2022Quote: ... λem = 465 nm) every 30 s for 10 min at 37 °C on a SpectraMax M2 microplate reader (Molecular Devices). All measurements were performed in triplicate and the mean was reported.
-
bioRxiv - Neuroscience 2022Quote: ... Data acquisition and analysis were performed using DigiData 1440A and 1550B digitizers and the analysis software pClamp 10 (Molecular Devices). Signals were filtered at 2 kHz and sampled at 10 kHz ...
-
bioRxiv - Neuroscience 2022Quote: ... Data were low-pass filtered at 10 kHz and collected at 20 kHz with pCLAMP 10.7 (Molecular Devices, Sunnyvale, CA), or collected at 400 Hz with PowerLab (LabChart version 5.4.2 ...
-
bioRxiv - Neuroscience 2022Quote: ... 4-pole Bessel filter) and digitized at 10 kHz using Digidata 1322A digitizer driven by PClamp 9 software (Molecular Devices). Care was taken to maintain the access resistance as low as possible (usually 6–7 MΩ and always less than 10 MΩ) ...
-
bioRxiv - Neuroscience 2022Quote: ... Signals were low-pass filtered (Bessel, 2 kHz) and collected at 10 kHz using the data acquisition software pClamp 10.5 (Molecular Devices). All the electrophysiological recordings were extracted using Clampfit (Molecular Devices ...
-
bioRxiv - Neuroscience 2022Quote: ... digitized at 5-20 kHz and acquired using a Digidata 1440A digitizer and pClamp 10 software (all from Molecular Devices).
-
bioRxiv - Neuroscience 2022Quote: Recordings were performed using a Multiclamp 700A amplifier with a Digidata 1322 and pClamp 10 software (Axon, Molecular devices, LLC). Field excitatory postsynaptic potentials (fEPSP ...
-
bioRxiv - Pathology 2022Quote: ... Currents were digitally sampled at 10 kHz using Digidata 1322A digitizer hardware and pClamp 10.2 software (Molecular Devices, California, USA). For both ACMs and VCMs ...
-
bioRxiv - Molecular Biology 2022Quote: ... filtered at 2 kHz and digitized at 5 kHz using Digidata 1440A interface with pClamp 10 software (Molecular Devices Corporation). Series resistance was typically 5–20 MΩ ...
-
bioRxiv - Neuroscience 2024Quote: ... was induced with 0.5 s and 30 s pulses of green LED light triggered by pCLAMP 10 software (Molecular Devices). Data were excluded from the analysis if there was an absence of spiking prior to light onset ...
-
bioRxiv - Neuroscience 2023Quote: ... Whole-cell patch-clamp recordings were made using a Multiclamp 700B amplifier and pCLAMP 10 software (Molecular Devices; Sunnyvale, CA). Signals were digitized at 20–40 kHz and filtered at 10 kHz by Digidata 1440A (Molecular Devices) ...
-
bioRxiv - Neuroscience 2023Quote: ... an Axopatch 200B amplifier and a Digidata 1322a digitizer (Axon Instruments) were utilized with Clampex software (version 10, Molecular Devices) for operation ...
-
bioRxiv - Neuroscience 2023Quote: ... The measured current was low-pass Bessel filtered at 1 kHz and digitized at 10 kHz with the Axon Digidata 1550B analog-digital converter and Clampex 10.2 Software (both from Molecular Devices). To stimulate the lch5 neurons ...
-
bioRxiv - Neuroscience 2023Quote: Whole-cell patch-clamp recordings were obtained with Multiclamp 700B amplifiers and pCLAMP 10 software (Molecular Devices; Sunnyvale, California, USA) and was guided using an Olympus BX51 Microscope equipped with both transmitted and epifluorescence light sources (Olympus Corporation ...
-
bioRxiv - Biochemistry 2023Quote: ... Data were sampled at 10 kHz and filtered at 5 kHz using a Digidata 1550A device controlled by pCLAMP 10.5 (Molecular Devices). Capacitance transients and leak currents were removed by subtracting a scaled control trace utilizing a P/4 protocol.
-
bioRxiv - Biochemistry 2023Quote: ... Signals were low-pass filtered at 10 kHz and sampled at 50 kHz with a Digidata 1440A digitizer (Molecular Devices). Current traces were idealized by using Clampfit 10.3 (Molecular Devices) ...
-
bioRxiv - Neuroscience 2023Quote: ... high-pass filtering at 0.2 Hz and sampling at 10 kHZ using a Digidata 1320 A/D interface (Molecular Devices). LFP data was stored on a PC computer running AxoScope 10.3 software (Molecular Devices ...
-
bioRxiv - Neuroscience 2023Quote: ... A Multiclamp 700B amplifier and Digidata 1550A Low-Noise Data Acquisition Digitizer with Clampex 10 data acquisition software (Molecular Devices) were used to monitor synaptic currents ...
-
bioRxiv - Neuroscience 2023Quote: ... Data were low-pass filtered at 10 kHz and collected at 20 kHz with pClamp 10.7 (Molecular Devices, Sunnyvale, CA), or collected at 400 Hz with PowerLab (LabChart version 5.4.2 ...
-
bioRxiv - Neuroscience 2023Quote: ... Signals were digitized at 10 kHz for field and 30 kHz for intracellular recordings (#Axoclamp2B and Digidata 1440A, Molecular Devices). For sharp intracellular recordings ...
-
bioRxiv - Neuroscience 2023Quote: ... and data were digitized at 10 kHz and filtered at 1-2 kHz using a 1440A Digidata Digitizer (Molecular Devices). Series and input resistances (10-20 MΩ ...