Labshake search
Citations for Molecular Devices :
601 - 650 of 1010 citations for tert Butyl 10 oxo 4 9 diazaspiro 4.5 decane 4 carboxylate since 2020
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Neuroscience 2021Quote: ... and optogenetic LED triggers were all digitized at 10 kHz on a Digidata 1440A (Molecular Devices) and saved to a computer (Axoscope ...
-
bioRxiv - Bioengineering 2021Quote: ... The luminescence was read within 10 minutes on Spectramax i3x or iD3 plate readers (Molecular Devices) with the following settings ...
-
bioRxiv - Biochemistry 2020Quote: ... The signals were digitized with a Digidata 1440A using pClamp 10 software (both from Molecular Devices). Patch pipettes with resistances of 2-4 MΩ were fabricated from borosilicate glass ...
-
All-trans retinoic acid induces synaptopodin-dependent metaplasticity in mouse dentate granule cellsbioRxiv - Neuroscience 2021Quote: ... pre-amplifier (Astro-Med) and digitized at a 10 kHz sampling rate (Digidata 1440A, Molecular Devices). Extracellular stimulation was performed using a STG1004 stimulator (Multichannel Systems) ...
-
bioRxiv - Neuroscience 2021Quote: Data was acquired using Clampex 10 and Axon Digidata 1440 digitizer (Molecular Devices, Union City, CA) at 20 kHz and were low-pass filtered at 2 kHz with a four-pole Bessel filter ...
-
bioRxiv - Neuroscience 2021Quote: ... The voltage signals were recorded with MultiClamp 700B and Clampex 10 data acquisition software (Molecular Devices). After establishment of the whole-cell configuration and equilibration of the intracellular pipette solution with the cytoplasm ...
-
bioRxiv - Neuroscience 2020Quote: ... Data were acquired using 10 kHz sampling rate and amplified x10 by Axoclamp 2A (Molecular Devices). The signal was further amplified x100 and low-pass filtered at 1kHz (LPBF-48DG ...
-
bioRxiv - Neuroscience 2020Quote: ... All signals were sampled at 10 kHz 16-bit (Digidata 1440A with pCLAMP10 Software, Molecular Devices).
-
bioRxiv - Neuroscience 2020Quote: ... Recordings were sampled at 10 KHz with a Multiclamp 700B amplifier Digidata 1400 digitizer (Molecular Devices) and were rejected if IHolding exceeded ± 100 pA from −70 mV in voltage camp or if Vm changed more than 15% in current clamp ...
-
bioRxiv - Biophysics 2020Quote: ... low-pass filtered (10 kHz; Axopatch 200B) and sampled at 40 kHz (Molecular Devices; DigiData 1440A). All data were acquired with QuB software (University at Buffalo ...
-
bioRxiv - Neuroscience 2022Quote: ... Data were collected and analyzed offline with pClamp 10 software (Molecular Devices, San Jose, CA, USA). To generate LTP ...
-
bioRxiv - Neuroscience 2022Quote: ... Data were collected and analyzed offline with pClamp 10 software (Molecular Devices, San Jose, CA, USA).
-
bioRxiv - Developmental Biology 2022Quote: ... Data processing and analysis were performed using MiniAnalysis (Synaptosoft, Decatur, GA) and Clampfit 10 (Molecular Devices). Events were detected by setting the threshold value ...
-
bioRxiv - Neuroscience 2020Quote: ... and digitized at 10 kHz using a Digidata 1440 A-D converter (Axon Instruments/ Molecular Devices). Data were recorded using pClamp data acquisition software (Axon Instruments/Molecular Devices ...
-
bioRxiv - Neuroscience 2021Quote: ... Electrode signals were amplified (10×) through the bridge circuitry of an Axoprobe-1A amplifier (Molecular Devices), AC-coupled ...
-
bioRxiv - Neuroscience 2020Quote: ... Ca2+ transients (CaTs) were detected using a template-matching algorithm implemented in pClamp 10 (Molecular Devices), and their times of peak were defined as the times of CaT occurrence ...
-
bioRxiv - Neuroscience 2020Quote: ... Data were acquired at 20 KHz and filtered at 2 KHz with pCLAMP 10 (Molecular Devices). Brain slices were perfused with recording aCSF at 1-2 mL/min with constant oxygenation ...
-
bioRxiv - Neuroscience 2020Quote: ... Analog signals were digitized (10-20 kHz) using either a Digidata 1440 (Axon Instruments/Molecular Devices) or a Micro 1401 A/D board (Cambridge Electronic Design) ...
-
bioRxiv - Synthetic Biology 2020Quote: ... The luminescence was read within 10 minutes on Spectramax i3x or iD3 plate readers (Molecular Devices) with the following settings ...
-
bioRxiv - Synthetic Biology 2020Quote: ... The luminescence was read within 10 minutes on Spectramax i3x or iD3 plate readers (Molecular Devices) with the following settings ...
-
bioRxiv - Biochemistry 2020Quote: ... The signals were digitized with a Digidata 1440A using pClamp 10 software (both from Molecular Devices). Patch pipettes with resistances of 2-4 MΩ were fabricated from borosilicate glass ...
-
bioRxiv - Neuroscience 2020Quote: ... Signals were filtered at 3 kHz and digitized at 10 kHz with DigiData 1550 (Molecular Devices).
-
bioRxiv - Neuroscience 2023Quote: ... All recorded data were digitized at 10 kHz (Digidata 1322A 16 Bit DAQ, Molecular Devices, U.S.A.) with Clampex acquisition software (v ...
-
bioRxiv - Neuroscience 2023Quote: ... filtered at 2 kHz and digitized at 10 kHz using a MultiClamp 700B amplifier (Molecular Devices) and stored using pClamp 10 software ...
-
bioRxiv - Neuroscience 2023Quote: ... Data were acquired and analyzed using a Multiclamp 700B amplifier and pClamp 10 software (Molecular Devices).
-
bioRxiv - Neuroscience 2024Quote: ... and sampled at 20 kHz using a Digidata 1440A digitizer controlled through pCLAMP 10 (Molecular Devices). Because untransfected HEK-293 cells lacked voltage-gated conductances (Supplementary Fig ...
-
bioRxiv - Neuroscience 2024Quote: ... and sampled at 10 kHz using a Digidata 1440 digitizer and Clampex 10.2 software (Molecular Devices). Series resistance compensation was not used ...
-
bioRxiv - Neuroscience 2023Quote: ... Recordings were digitized on-line and filtered at 10 kHz (Digidata 1322A or 1440A, Molecular Devices). Pipette and neuronal capacitive currents were canceled ...
-
bioRxiv - Neuroscience 2022Quote: ... The amplitudes of evoked currents were quantified using Clampfit (version 10, Molecular Devices, Sunnyvale, CA, USA)
-
bioRxiv - Neuroscience 2022Quote: ... digitized at 10 kHz with a Digidata 1440A and acquired in pClamp (Axon Instruments, Molecular Devices) in parallel with transistor-transistor logic (TTL ...
-
bioRxiv - Bioengineering 2022Quote: ... Currents were recorded at sampling rates of 10 kHz and analyzed using Clampfit 10.7 (Molecular Devices). Current-voltage (I-V ...
-
bioRxiv - Immunology 2022Quote: ... Bright-field and fluorescence images were acquired using the 10× objective using MetaXpress software (Molecular Devices). Microscopy images were analyzed using the ImageJ softwares ...
-
bioRxiv - Neuroscience 2023Quote: Data analysis: Evoked EPSCs and IPSCs were analyzed with pClamp 10 (Molecular Devices, California, Sunnyvale, USA) program ...
-
bioRxiv - Neuroscience 2023Quote: ... filtered at 2 kHz and digitized at 10 kHz using a MultiClamp 700B amplifier (Molecular Devices) and stored using pClamp 10 software ...
-
bioRxiv - Neuroscience 2023Quote: ... and digitized at 10 kHz with a Digidata 1440A analog-to-digital converter (Molecular Devices, USA).
-
bioRxiv - Biophysics 2024Quote: ... filtered at 8 kHz and digitized at 10 kHz using a Digidata 1550A digitizer (Molecular Devices). Neurons were held at –60 mV ...
-
bioRxiv - Neuroscience 2024Quote: Resting membrane potential and input resistance were calculated using ClampFit 10 (Molecular Devices, San Jose, CA) whereas firing properties were analyzed with StimFit90 ...
-
bioRxiv - Neuroscience 2024Quote: ... DSFs were detected in 30-s recordings sampled at 10 kHz with Multiclamp 700B (Molecular Devices) and filtered with a 10 kHz Bessel filter ...
-
bioRxiv - Molecular Biology 2021Quote: ... Cells were then treated with 10 μL per well of 3× drug using a FLIPR (Molecular Devices). After 15 min ...
-
bioRxiv - Neuroscience 2021Quote: ... and sequences (200–500 ms) were acquired at 10–20 kHz with pClamp (Axon Instruments, Molecular Devices) version 10 ...
-
bioRxiv - Neuroscience 2021Quote: ... Signals were filtered at 10 kHz and sampled at 50 kHz using a Digidata 1440B (Molecular Devices) digitizer ...
-
bioRxiv - Neuroscience 2021Quote: ... Data (5-22 slices/condition) were analysed using the pClamp-10 Program software (CA/Molecular Devices, USA).
-
bioRxiv - Neuroscience 2020Quote: ... Sampling frequency was 100 kHz and low pass Bessel filtered at 10 kHz (Digidata 1550, Molecular Devices). A holding current was injected to maintain membrane potential at approximately -70 mV ...
-
bioRxiv - Neuroscience 2020Quote: ... The raw data was collected and analyzed by using pClamp 10 software (Molecular Devices, Sunnyvale, CA, USA).
-
bioRxiv - Neuroscience 2020Quote: ... pre-amplifier (Astro-Med, West Warwick) and digitized at 10 kHz sampling rate (Digidata 1440A, Molecular Devices). Extracellular stimulation was performed using a STG1004 stimulator (Multichannel Systems ...
-
bioRxiv - Neuroscience 2021Quote: ... Signals were digitized at 10 kHz using an Axon Digidata 1322 A digitizer (Molecular Devices, CA, USA) and low pass filtered at 1 kHz using an LPBF-48DG output filter (NPI Electronic ...
-
bioRxiv - Bioengineering 2022Quote: ... Traces are low-pass filtered at 2.6 kHz and digitized at 10 kHz (DigiData 1440, Molecular Devices). The data are acquired and analyzed using Clampfit 10.0 software (Molecular Devices) ...
-
bioRxiv - Biochemistry 2022Quote: ... cells were further incubated at 37°C for 10 min in the Flex Station 3 (Molecular Devices) before the assay was initiated ...
-
bioRxiv - Neuroscience 2021Quote: ... The signals were sampled at 10 kHz and digitized using Digidata 1550B with Axon pCLAMP (Molecular Devices). Data was analyzed using custom scripts in IGOR Pro (WaveMetrics).
-
bioRxiv - Neuroscience 2020Quote: ... All measurements were acquired using pCLAMP 10 software in conjunction with a Multiclamp 700B amplifier (Molecular Devices), digitized at 50 kHz with a Digidata 1440A ...