Labshake search
Citations for Molecular Devices :
6351 - 6400 of 10000+ citations since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Neuroscience 2021Quote: ... Voltage clamp control and data acquisition were obtained using pCLAMP v8.10 software (Molecular Devices, USA). All recordings were performed at 18-20°C ...
-
bioRxiv - Neuroscience 2021Quote: ... driven by the Metamorph® software (Molecular Devices). The number of PSD-95 and VGLUT1 puncta per dendrite neuron length was measured using a custom macro written in Metamorph ...
-
bioRxiv - Neuroscience 2021Quote: ... four-pole low-pass Bessel filter and digitally sampled at 20 kHz using a commercially available data acquisition system (Digidata 1550A with pClamp 10.5 software; Molecular Devices). Data were recorded using pClamp and stored on a computer for offline analysis ...
-
bioRxiv - Neuroscience 2021Quote: ... Cell capacitance was measured using the membrane test function in pClamp 10.5 (Molecular Devices, Sunnyvale, CA, USA). All measurements of intrinsic membrane excitability were taken from RMP ...
-
bioRxiv - Neuroscience 2021Quote: ... membrane voltages were adjusted for liquid junction potentials (approximately –14 mV) calculated using JPCalc software (P. Barry, University of New South Wales, Sydney, Australia; modified for Molecular Devices). Signals were filtered at 4–6 kHz through a –3 dB ...
-
bioRxiv - Neuroscience 2021Quote: Whole-cell patch clamp recordings were obtained from layer V pyramidal neurons in the mPFC using a MultiClamp 700B amplifier (Molecular Devices, Sunnyvale, CA). Pyramidal neurons were easily identifiable in the slice based on soma morphology and the presence of a prominent apical dendrite ...
-
bioRxiv - Neuroscience 2021Quote: ... Current clamp recordings were analyzed using Clampfit (Molecular Devices). For studies examining synaptic transmission ...
-
bioRxiv - Neuroscience 2021Quote: Electrophysiological traces were analyzed with pClamp 10.7 (Molecular Devices) and IGOR Pro 8 (Wavemetrics ...
-
bioRxiv - Neuroscience 2021Quote: ... Analyses were performed off-line using pCLAMP 10.5 and Axograph 1.7.2 (Molecular devices; RRID:SCR_014284) software packages.
-
bioRxiv - Neuroscience 2021Quote: ... digitized (20 kHz) online using Digidata 1440A or 1550B interfaces and acquired using pCLAMP 10.5 software (Molecular Devices, USA). Analyses were performed off-line using pCLAMP 10.5 and Axograph 1.7.2 (Molecular devices ...
-
bioRxiv - Neuroscience 2021Quote: ... low-pass filtered (14 kHz Bessel, Multiclamp 700B, Molecular Devices) and digitized using pClamp software (50-80 kHz ...
-
bioRxiv - Neuroscience 2021Quote: ... digitized at 5 kHz and analyzed with pClamp 10 software (Molecular Devices). LTP of L4 to L2/3 synapses was elicited using a pairing-protocol in which presynaptic stimulation of L4 was paired with brief postsynaptic depolarization of L2/3 neurons situated within the same column as described previously (26) ...
-
bioRxiv - Neuroscience 2021Quote: ... Offline analysis was conducted with Clampfit software (Molecular Devices). Mean EPSC amplitudes were normalized to their respective averaged baseline values ...
-
bioRxiv - Neuroscience 2021Quote: ... Subsequent recordings were carried out in voltage-clamp mode with a Multiclamp 700B amplifier (Molecular Devices). Analog signals were low-pass filtered at 2 kHz ...
-
bioRxiv - Neuroscience 2021Quote: ... and Clampex software (Molecular Devices, CA, USA). Traces were analyzed using pCLAMP 10 software (Molecular Devices ...
-
bioRxiv - Neuroscience 2021Quote: ... Recordings were performed using a MultiClamp 700B amplifier (Molecular Devices, CA, USA), and Clampex software (Molecular Devices ...
-
bioRxiv - Neuroscience 2021Quote: ... Recordings were made at 22–25°C using an Axopatch 200A amplifier (Molecular Devices, USA). Voltage ramp currents were low-pass filtered at 500 Hz and digitized at 2 kHz using an NI USB-6341 (National Instruments ...
-
bioRxiv - Neuroscience 2021Quote: ... The density and distribution of immunogold particles were quantitatively analyzed on electron micrographs using MetaMorph software (Molecular Devices; n = 2 mice). The density of SIPA1L1 on excitatory nerve terminals and dendritic spines was calculated by measuring the number of immunogold particles ...
-
bioRxiv - Neuroscience 2021Quote: ... Data were digitized at 10 kHz and analyzed on-line using pClamp software (Molecular Devices). All values were reported as means ± standard errors of the mean ...
-
bioRxiv - Neuroscience 2021Quote: ... and pClamp (Molecular Devices). For current-clamp recordings ...
-
bioRxiv - Neuroscience 2021Quote: ... a digitizer (Molecular Devices), and pClamp (Molecular Devices) ...
-
bioRxiv - Neuroscience 2021Quote: ... Stimulus generation and data acquisition were performed using an amplifier (Molecular Devices), a digitizer (Molecular Devices) ...
-
bioRxiv - Neuroscience 2021Quote: ... fluorescence images were thresholded offline using MetaMorph software (Molecular Devices/Visitron Systems), and a low pass filter was applied to remove single pixel noise ...
-
bioRxiv - Neuroscience 2021Quote: ... and 40x/1.3 oil objective using MetaVue or Visiview software (Molecular Devices/Visitron Systems) unless mentioned ...
-
bioRxiv - Neuroscience 2021Quote: ... Recording data were acquired using a Multiclamp 700B amplifier (Molecular Devices, Palo Alto, CA, USA) with Bessel filter of 2 kHz and digitized at 50 kHz using Axon DigiData 1500A (Molecular Devices) ...
-
bioRxiv - Neuroscience 2021Quote: ... filtered at 2 kHz and sampling rate at 20 kHz with an Axon Digidata 1550B plus HumSilencer digitizer (Molecular Devices). Slices were maintained under continuous perfusion of aCSF at 32-33°C with a 2-3 mL/min flow ...
-
bioRxiv - Neuroscience 2021Quote: ... The Axon pClamp 10 (Molecular Devices) software was used to control the experiment ...
-
bioRxiv - Neuroscience 2021Quote: ... Recordings were performed with an Axon MultiClamp 700B amplifier (Molecular Devices) and data were acquired using pClamp 11.1 software at the normal RMP or a fixed potential of −80 mV ...
-
bioRxiv - Neuroscience 2021Quote: ... sampled at 20 kHz and filtered at 10 kHz using Clampex10 (Molecular Devices).
-
bioRxiv - Neuroscience 2021Quote: ... with Bessel filter of 2 kHz and digitized at 50 kHz using Axon DigiData 1500A (Molecular Devices). The Axon pClamp 10 (Molecular Devices ...
-
bioRxiv - Neuroscience 2021Quote: ... and analyzed off-line using Clampfit 10 (Molecular Devices, LLC). Patch pipettes (3-5 MΩ ...
-
bioRxiv - Neuroscience 2021Quote: ... acquired using pClamp 10.0 software (Molecular Devices) and analyzed off-line using Clampfit 10 (Molecular Devices ...
-
bioRxiv - Neuroscience 2021Quote: ... synaptic currents were filtered at 2 kHz and digitized at 10 kHz (amplifier in-built 8-pole low-pass Bessel filter and Molecular Devices Digidata 1322A, respectively). Recordings used for analysis were post-hoc filtered at 1 kHz.
-
bioRxiv - Neuroscience 2021Quote: ... (Molecular Devices) with a 10x and 60x PlanApo l oil objective (1.4 numerical aperture ...
-
bioRxiv - Neuroscience 2021Quote: ... Data were analyzed off-line with Clampfit 10 software (Molecular Devices, LLC).
-
bioRxiv - Neuroscience 2021Quote: ... We recorded spontaneous and evoked excitatory postsynaptic currents (EPSCs) from hippocampal CA1 pyramidal neurons at -70 mV using a patch clamp amplifier (Axopatch 200A, Molecular Devices, LLC). Data were filtered at 2 kHz ...
-
bioRxiv - Neuroscience 2021Quote: ... CA1 or CA3 neurons were visualized using the IR-DIC optics of an upright Leica DMLSF microscope and current- or voltage clamp recordings were obtained using a MultiClamp 700B amplifier and the pClamp9 suite (Molecular Devices). All recordings were performed at room temperature (24 ± 1 °C) ...
-
bioRxiv - Neuroscience 2021Quote: ... All the electrophysiological recordings were extracted using Clampfit (Molecular Devices) and analyzed with R.
-
bioRxiv - Neuroscience 2021Quote: ... Signals were low pass filtered (Bessel, 2 kHz) and collected at 10 kHz using the data acquisition software pClamp 10.5 (Molecular Devices). All the electrophysiological recordings were extracted using Clampfit (Molecular Devices ...
-
bioRxiv - Neuroscience 2021Quote: ... Whole-cell recordings were performed using a patch-clamp amplifier (Axoclamp 200B, Molecular Devices) connected to a Digidata (1550 LowNoise acquisition system ...
-
bioRxiv - Neuroscience 2021Quote: ... Whole-cell voltage-clamp recording techniques were used to measure synaptic responses using a Multiclamp 700B (Molecular Devices, Sunnyvale, CA). Signals were collected and stored using a Digidata 1440A converter and pCLAMP 10.2 software (Molecular Devices ...
-
bioRxiv - Neuroscience 2021Quote: ... Data were analyzed on a personal computer using pCLAMP 10.7 software (Molecular Devices), Origin 2019 (OriginLab ...
-
bioRxiv - Neuroscience 2021Quote: ... Signals were collected and stored using a Digidata 1440A converter and pCLAMP 10.2 software (Molecular Devices, CA). AMPA-R/NMDA-R ratio was assessed using an internal solution containing (in mM ...
-
bioRxiv - Neuroscience 2021Quote: Electrophysiological signals were recorded using a MultiClamp 700B amplifier (Molecular Devices, Sunnyvale, CA, USA), filtered at 10 kHz ...
-
bioRxiv - Neuroscience 2021Quote: ... and then sampled at 10 kHz and recorded using a Multiclamp 700B amplifier and pClamp 10 software (Molecular Devices). Recordings with series resistances >20 MΩ were discarded and series resistance compensation was not applied to the recorded cell ...
-
bioRxiv - Neuroscience 2021Quote: ... and digitized using a Digidata 1440A and the Clampex 10 program suite (Molecular Devices). Voltage-clamp signals were filtered at 3 kHz and recorded with a sampling rate of 10 kHz ...
-
bioRxiv - Neuroscience 2021Quote: Passive and active membrane properties were recorded in current clamp mode by applying a series of hyperpolarizing and depolarizing current steps and the analysis was done in Clampfit (Molecular Devices). The cell input resistance was calculated from the peak of the voltage response to a 100 pA hyperpolarizing 1 second long current step according to Ohm’s law ...
-
bioRxiv - Neuroscience 2021Quote: Recordings were performed using a Multiclamp 700B amplifier (Molecular Devices) and digitized using a Digidata 1440A and the Clampex 10 program suite (Molecular Devices) ...
-
bioRxiv - Neuroscience 2021Quote: Data analysis was performed off-line using the Clampfit module of pClamp (Molecular Devices) and Prism 8 (GraphPad) ...
-
bioRxiv - Neuroscience 2021Quote: ... and reading with a Spectramax microplate reader (Molecular devices). iN cytotoxicity was measured using lactate dehydrogenase (LDH ...