Labshake search
Citations for Molecular Devices :
501 - 550 of 686 citations for 3 hydroxy 20 oxopregn 5 en 21 yl acetate since 2020
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Neuroscience 2022Quote: ... acquired at a sampling rate of 10 kHz with 20s intervals using MultiClamp 700B amplifier with pClamp 10.0 software (Molecular Devices, Sunnyvale, CA). Standard off-line analyses of the data were conducted using Clampfit 10.0 software (Molecular Devices ...
-
bioRxiv - Neuroscience 2020Quote: ... and digitized at 20 kHz using a Digi-data 1440A interface coupled to pClamp 10.5 software (Molecular Devices, San Jose, CA, USA) running on a PC computer ...
-
bioRxiv - Neuroscience 2021Quote: ... at a sampling rate of 20 kHz (low pass filtered at 10 kHz) and recorded pClamp 10 software (Molecular Devices, CA, USA). The amplifier setting of the Multiclamp 700B were controlled through Multiclamp Commander (Molecular Devices ...
-
bioRxiv - Neuroscience 2023Quote: ... The slope of the IPSC was estimated from the 20-80% rise time by means of Clampfit software (Molecular Devices, CA, USA). In some instances ...
-
bioRxiv - Neuroscience 2022Quote: ... at a sampling rate of 20 kHz (low pass filtered at 10 kHz) and recorded pClamp 10 software (Molecular Devices, CA, USA). The amplifier setting of the Multiclamp 700B were controlled through Multiclamp Commander (Molecular Devices ...
-
bioRxiv - Neuroscience 2024Quote: ... Signals were low-pass filtered at 8 kHz and digitized at 20 kHz using a Digidata 1440A and pClamp 10.2 (Molecular Devices, CA, USA). Recordings were not corrected for a liquid junction potential.
-
bioRxiv - Neuroscience 2024Quote: ... All whole-cell currents in response to voltage steps were low-pass filtered at 10 kHz with a Bessel filter and sampled at 20 kHz frequency (Axon Digidata 15B, Molecular Devices, USA). For inclusion in the final dataset ...
-
bioRxiv - Neuroscience 2024Quote: ... Voltage and current signals were filtered at 10 kHz with the built-in low-pass Bessel filter and digitized at 20 kHz using a Digidata 1440A (Molecular Devices, Sunnydale). pClamp10 software (Molecular Devices ...
-
bioRxiv - Neuroscience 2024Quote: ... Whole-cell patchclamp recordings were performed at room temperature (∼20°C) in current- and/or voltage-clamp mode using a Axopatch 200A or Multiclamp 700B amplifiers (Molecular Devices Inc.). Patch pipettes (3-7 MΩ ...
-
bioRxiv - Neuroscience 2024Quote: ... Whole-cell patch clamp recordings were obtained using a Multiclamp 700B (Molecular Devices, digitized at 20 kHz using a Digidata 1440a (Molecular Devices) controlled by pClamp 10.6 software (Molecular Devices) ...
-
bioRxiv - Bioengineering 2024Quote: ... was measured via fluorescence-indicating dye 20 h post-exposure using the SpectraMax® i3x plate reader (Molecular Devices, Product No. i3x) and the FLIPR® membrane potential assay kit (Molecular Devices ...
-
bioRxiv - Neuroscience 2021Quote: ... Data (5-22 slices/condition) were analysed using the pClamp-10 Program software (CA/Molecular Devices, USA).
-
bioRxiv - Biochemistry 2020Quote: ... USA) and digitized at a sampling rate of 5 kHz using a DigiData 1440A interface (Molecular Devices) and pCLAMP software (version 10.4) ...
-
bioRxiv - Microbiology 2023Quote: ... Obtained absorbance was further analyzed using SoftMAx Pro Microplate analysis software (version 5, Molecular devices, California, USA). Absorbance was normalized to the no-cell control ...
-
bioRxiv - Neuroscience 2023Quote: ... 5 HEPES—and were held by a pipette holder containing an Ag/AgCl electrode (Molecular Devices, USA) and mounted on a motorized micromanipulator (Scientifica ...
-
bioRxiv - Neuroscience 2021Quote: ... spikes and potentials were sorted and counted from 3-minute gap-free recordings using the pCLAMP10 software (Molecular Devices Corporation, California, USA).
-
bioRxiv - Neuroscience 2020Quote: Signals were digitized at 10 kHz and filtered at 3 kHz using a Multiclamp 700B amplifier and analyzed using Clampfit 10.7 software (Molecular Devices, Sunnyvale, CA). For all measures ...
-
bioRxiv - Cell Biology 2022Quote: ... Eluent was transferred to a 96-well plate where absorbance at 500 nm was measured by a FlexStation® 3 microplate reader (Molecular Devices).
-
bioRxiv - Cell Biology 2022Quote: ... The assay was performed according to the manufacturer’s instructions with FlexStation® 3 Multi-Mode Microplate Reader (Molecular Devices, Sunnyvale, CA, USA). The Cyto-ID fluorescence was determined at Ex 480 nm/Em 530 nm ...
-
bioRxiv - Neuroscience 2022Quote: ... Data acquisition (digitized at 10 kHz and filtered at 3 kHz) was performed with pClamp 10.4 software (Molecular Devices, Sunnyvale, CA, USA). Input resistance and cells capacitance were measured online with the membrane test feature of the pClamp software ...
-
bioRxiv - Immunology 2020Quote: ... His-tagged RBD of SARS-CoV or SARS-CoV-2 were loaded at 3 µg/ml in KB for 15 minutes onto anti-HIS (HIS2) biosensors (Molecular Devices, ForteBio). Association of mAb and Fab was performed in KB at 15 μg/ml and 5 μg/ml respectively for 5 minutes ...
-
bioRxiv - Neuroscience 2022Quote: ... The final samples after running all the procedures were read on a multi-mode microplate reader (FlexStation 3, Molecular Devices, California, USA). The assay was performed in duplicate ...
-
bioRxiv - Immunology 2022Quote: ... Caspase-3 activity was measured by Caspase-3 activity detection kit (Beyotime, China) and tested by a Flex Station II microplate reader (Molecular Devices, USA).
-
bioRxiv - Neuroscience 2024Quote: ... λEM: 516 nm (F340/F380)) were measured every 4 s using a FlexStation 3 fluorescent microplate reader (Molecular Devices, Sunnyvale, CA, USA). During the measurements ...
-
bioRxiv - Cell Biology 2023Quote: ... The effluent solutions collected from the top and bottom channels were used for fluorescence measurements using a plate reader (Flexstation 3, Molecular Devices, USA). Subsequently ...
-
bioRxiv - Neuroscience 2023Quote: ... Whole cell patch-clamp recordings from pyramidal neurons in Layer 2/3 of V1 were made using a Multiclamp 700B amplifier in voltage clamp mode and PClamp software (Molecular Devices, USA). Cells were patched with borosilicate glass electrodes with tip resistances of ∼3.5 MOhm ...
-
bioRxiv - Neuroscience 2024Quote: Signals were digitized at 10 kHz and filtered at 3 kHz using a Multiclamp 700B amplifier and analyzed using Clampfit 10.7 software (Molecular Devices, Sunnyvale, CA). Traces were excluded from analysis of specific measures if there was spontaneous activity or instability in the section of trace needed for analysis.
-
bioRxiv - Physiology 2024Quote: ... Assays were performed following the manufacturer’s instructions in duplicate and read on a FlexStation 3 plate reader (Molecular Devices, Eugene, OR, USA). Results were determined using the FlexStation software with a 4-parameter logistic curve ...
-
bioRxiv - Neuroscience 2020Quote: ... and filtered online at 2 kHz with the amplifiers 4-pole Bessel Filter and digitised at 20 kHz (Digidata1550B, Molecular Devices, CA, USA)
-
bioRxiv - Neuroscience 2021Quote: ... Signals were acquired at 20 kHz and low-pass Bessel filtered at 8 kHz with a Multiclamp 700 B amplifier (Molecular Devices, Axon Instruments). Spikes were ...
-
bioRxiv - Neuroscience 2021Quote: ... Whole cell currents were filtered at 2–5 kHz with an 8-pole low-pass Bessel filter and digitized at 10–20 kHz for later off-line analysis using the pClamp 9.0 program (Molecular Devices, Inc., Sunnyvale, CA). All experiments were carried out at room temperature (22–25°C).
-
bioRxiv - Neuroscience 2020Quote: ... Current signals were filtered at 2 kHz and sampled at 20 kHz using a Multiclamp 700B amplifier together with a Digidata 1440A interface and the pClamp10 software (Molecular Devices, Sunnyvale, CA). Data were analyzed off-line with Clampfit 10.6 (Molecular Devices ...
-
bioRxiv - Neuroscience 2020Quote: ... Data were low-pass filtered at 2 kHz and acquired at 20 kHz with an Axon Multiclamp 700B amplifier (Molecular Devices, Sunnyvale, U.S.A.) using MATLAB (Mathworks ...
-
bioRxiv - Neuroscience 2020Quote: ... Signals were filtered at 4–10 kHz and digitized at 10–20 kHz (Digidata 1322A and pClamp 10.2 Software; Molecular Devices, Sunnyvale, CA, USA). For analyses of K+-channel currents in NGFCs ...
-
bioRxiv - Neuroscience 2021Quote: ... amplifier and filtered online at 10 kHz with the built-in 4-pole Bessel filter and digitized at 20 kHz (Digidata1550B, Molecular Devices, CA, USA).)
-
bioRxiv - Neuroscience 2021Quote: ... All recordings were filtered online at 10 kHz with the built-in 4-pole Bessel Filter and digitized at 20 kHz (Digidata1440, Molecular Devices, CA, USA). Traces were recorded in pCLAMP 9 (Molecular Devices ...
-
bioRxiv - Neuroscience 2024Quote: ... Signals were filtered at 4 – 10 kHz and digitized at 10 – 20 kHz (Digidata 1322A and pClamp 10 Software; Molecular Devices, Sunnyvale, CA). For cell attached recordings pipettes were filled with our standard extracellular solution.
-
bioRxiv - Neuroscience 2021Quote: ... The data was digitized at 5–500 kHz using an analog-to-digital converter (Digidata 1500; Molecular Devices). The sampling frequency was determined by the protocol used ...
-
bioRxiv - Neuroscience 2021Quote: ... The data were digitized at 5–500 kHz using an analog-to-digital converter (Digidata 1500; Molecular Devices). The whole-cell current recordings were done using pCLAMP software (version 10 ...
-
bioRxiv - Neuroscience 2021Quote: ... Signals were filtered at 5 kHz with the patch-clamp amplifier (Axopatch 1-D, Molecular Devices, Sunnyvale, CA) and sampling rate was adjusted according to the kinetics of membrane current ...
-
bioRxiv - Neuroscience 2021Quote: ... Signals were filtered at 5 kHz using a Digidata 1500A data acquisition interface (Molecular Devices, San Jose, CA) and acquired using pClamp 10.6 software (Molecular Devices) ...
-
bioRxiv - Neuroscience 2021Quote: ... Whole-cell measurements were low-pass filtered at 5 kHz using an Axopatch 200B amplifier (Molecular Devices, Inc). Recordings were digitized with the ITC-18 board (Instrutech ...
-
bioRxiv - Neuroscience 2022Quote: ... Data were acquired and filtered (at 5 kHz 4-pole Bessel filter) with MultiClamp 700B amplifier (Molecular Devices), digitized with Digidata 1440A (Molecular Devices ...
-
bioRxiv - Bioengineering 2023Quote: ... and performing an absorbance spectral scan (200–1000 nm; 5 nm increments) using a Spectramax M3 (Molecular Devices).
-
bioRxiv - Biochemistry 2024Quote: ... bioluminescence data were collected for ∼5 min on a SpectraMax iD3 plate reader (Molecular Devices, Sunnyvale, CA, USA). Subsequently ...
-
bioRxiv - Neuroscience 2023Quote: ... All electrophysiological data were digitized at 5-10 KHz with a Digidata 1440A data acquisition board (Molecular Devices).
-
bioRxiv - Biochemistry 2023Quote: ... Samples were incubated at RT for 5 min before fluorescence was measured using a SpectraMax M5 (Molecular Devices) microplate reader with excitation/emission maxima at 490/520 nm ...
-
bioRxiv - Neuroscience 2024Quote: ... Signals were filtered at 5 kHz using a Digidata 1500B data acquisition interface (Molecular Devices, San Jose, CA) and acquired using pClamp 10.6 software (Molecular Devices) ...
-
bioRxiv - Neuroscience 2024Quote: ... low-pass filtered (5 KHz) and digitised (Axopatch-200B, custom amplifier/filters, Digidata 1440, Clampex software; Molecular Devices). Pipettes and electrodes were positioned with Sutter MP265 and 285 manipulators with a diagonal (axial ...
-
bioRxiv - Biophysics 2021Quote: ... and currents were recorded with microelectrodes filled with 3 mM KCl (pipette resistance of < 1 MΩ), OC-725C amplifier (Warner, CT, USA) and Digidata 1550 digitizer (Molecular Devices, CA, USA) at 1 kHz with 200 Hz filtering ...