Labshake search
Citations for Molecular Devices :
501 - 542 of 542 citations for 3' Bromo 3 3 4 5 trifluorophenyl propiophenone since 2020
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Neuroscience 2020Quote: ... with ACSF-filled glass microelectrodes (2-4 MΩ) positioned within layer II/III of the V1 using an Axopatch 200B amplifier (Molecular devices, San Jose, CA). Electric stimulation (100 μsec duration ...
-
bioRxiv - Neuroscience 2022Quote: ... band filtered at 0.1-400Hz) were collected (all in current-clamp mode) by using two multiClamp 700B amplifiers (total 4 channels, Molecular devices Inc., Union City, CA) and Clampex 10 software (Molecular Devices Inc. ...
-
bioRxiv - Bioengineering 2022Quote: ... Electrophysiological data were acquired using a MultiClamp 700B amplifier filtered at 4 kHz and digitized at 10 kHz using a Digidata 1440A digitizer in combination with pCLAMP 10 software (Molecular Devices, San Jose, CA). Voltage clamp recordings were limited to neurons that had a stable access resistance of <20 MΩ ...
-
bioRxiv - Neuroscience 2023Quote: ... Electrical signals were acquired at 20 – 50 kHz and filtered at 4 kHz using a Multiclamp 700B amplifier (Molecular Devices, San Jose, CA, USA) connected to a Digidata 1440A digitizer (Molecular Devices ...
-
bioRxiv - Neuroscience 2024Quote: ... Electrical signals were acquired at 20 – 50 kHz and filtered at 4 kHz using a Multiclamp 700B amplifier (Molecular Devices, San Jose, CA, USA) connected to a Digidata 1440A digitizer (Molecular Devices ...
-
bioRxiv - Biophysics 2023Quote: ... and the decrease in 485-nm excited fluorescence of Fluo-4 was monitored at 520 nm for 15 min using a FLIPR Tetra (Molecular Devices, San Jose, CA).
-
bioRxiv - Biophysics 2022Quote: ... The gain was optimized before each experiment and the signal was filtered with the inbuilt low-pass Bessel filter at 5 kHz and digitized using Digidata 1550B (Molecular Devices, USA). The data was acquired at a frequency of 250 kHz ...
-
bioRxiv - Neuroscience 2020Quote: ... All recordings were sampled at 10 kHz and filtered with a 5 kHz low-pass filter using an Axopatch 200B amplifier (Molecular Devices, U.S.A.) and AxoGraph ...
-
bioRxiv - Neuroscience 2020Quote: ... Data were low-pass filtered at 5 kHz before they were digitized at 20 kHz by a 16 bit A/D converter (Axon Digidata 1400A, Molecular Devices Co.), and acquired in AxoScope 10.7 (Molecular Devices Co.) ...
-
bioRxiv - Immunology 2020Quote: ... ACE2-His (Bio-Techne AG) was loaded for 30 minutes at 5 µg/ml in KB onto anti-HIS (HIS2) biosensors (Molecular Devices-ForteBio).
-
bioRxiv - Bioengineering 2021Quote: ... Cells were exposed to the transfection complexes for 24 hours at 37⍰C and 5% CO2 before GFP fluorescence was read on a plate reader (SpectraMax, Molecular Devices, USA). Fluorescence signals were normalized to untreated cells.
-
bioRxiv - Microbiology 2020Quote: ... tissue culture plates were imaged under the same conditions (37°C for 72 h in a humidified atmosphere containing 5% CO2) using an ImageXpressXL high content imager (Molecular Devices, UK) with subsequent images processed for phenotype and motility as previously reported [51].
-
bioRxiv - Immunology 2022Quote: ... stop solution (provided in the kit) was added and optical density measured within 5 minutes at 450 nm (SpectraMax iD3 Molecular Devices, USA). The inhibition rate was calculated ...
-
bioRxiv - Immunology 2023Quote: ... Absorbance was recorded at 450 nm with a reference filter at 570 nm using a Spectramax 5 plate reader (Molecular Devices, USA). Baseline sera from each animal served as negative control and optical density (OD ...
-
bioRxiv - Neuroscience 2021Quote: ... All recordings were performed using a Multiclamp 700B amplifier and filtered at 4 kHz and digitized with a Digidata 1440 with pClamp 10 software for data acquisition (Axon, Molecular Devices, LLC, Sunnyvale, CA, USA). Recording pipette was filled with the same extracellular solution as the perfusion bath (2-4 MΩ resistance).
-
bioRxiv - Neuroscience 2020Quote: ... data along with one channel EMG recordings(400 Hz) were collected by using two multiClamp 700B amplifiers (total 4 channels, Molecular devices Inc., Union City, CA) and Clampex 10 software (Molecular Devices Inc. ...
-
bioRxiv - Molecular Biology 2021Quote: ... of fluorescent hydrolysate of Boc-Gln-Ala-Arg-MCA (7-amino-4-methylcoumarin) were read using SpectraMax M5 plate reader (Molecular Devices, San Jose, CA, USA) with excitation of 380 nm and emission of 460 nm ...
-
bioRxiv - Neuroscience 2022Quote: ... Electrical signals were acquired at 20 – 50 kHz and filtered at 4 kHz using a Multiclamp 700B amplifier connected to a Digidata 1440A digitizer (Molecular Devices, San Jose, CA, USA) with pClamp10 software (Molecular Devices) ...
-
bioRxiv - Pharmacology and Toxicology 2022Quote: ... cells were incubated with 100 μL of a Ca2+-sensitive dye-loading buffer (FLIPR calcium 5 assay kit, Molecular Devices; Sunnyvale, CA, USA) containing 2.5 mM probenecid (Sigma-Aldrich ...
-
bioRxiv - Neuroscience 2020Quote: ... 5% CO2 for 1h before plates were read at 450 nm on a SpectraMax M3 Microplate Reader (Molecular Devices, San Jose, CA, USA). As indicated in figures ...
-
bioRxiv - Neuroscience 2022Quote: ... Signals were low-pass filtered at 5 kHz and sampled at 10 kHz using a digitizer (Digidata 1440A; Molecular Devices, Sunnyvale, CA, USA). In ex vivo slice recordings ...
-
bioRxiv - Pharmacology and Toxicology 2020Quote: Changes in intracellular calcium ([Ca]i) were measured using a fluorometric imaging plate reader (FLIPR) and using Calcium 5 membrane potential assay kit (Molecular Devices Sunnyvale, CA). Briefly ...
-
bioRxiv - Neuroscience 2021Quote: ... Data were low-pass filtered at 5 kHz and acquired at 10 kHz with Axopatch 200B amplifiers and CV-7B headstages (Molecular Devices, Sunnyvale, CA). Data were acquired using an in-house program written either in Igor Pro (Wavemetrics ...
-
bioRxiv - Neuroscience 2021Quote: ... sIPSCs were recorded at −70 mV in the presence of the glutamate receptor antagonists (20 μM 6-cyano-7-nitroquinoxaline-2,3-dione +50 μM D-(2R)-amino-5-phosphonopentanoic acid) using a Multiclamp 700B amplifier and pClamp 10.0 software (Molecular devices; California, United States). A 1 min period after 5 min application of the glutamate receptor antagonists was used for statistical analysis (Igor software ...
-
bioRxiv - Immunology 2020Quote: ... Samples were incubated for 1 hour at 37°C with 5% CO2 and OD440nm & OD650nm were then measured using a 96-well plate spectrophotometer (Molecular Devices or BioTek). OD650nm was subtracted from OD440nm then percent viability was calculated relative to the no treatment condition.
-
bioRxiv - Biophysics 2024Quote: ... Data were digitized at 5 kHz using a 16-bit A/D converter data acquisition system (Axon Digidata 1550B, Axon Instruments, Molecular Devices, CA, US), and recorded using Clampex 11 acquisition software (Axon Instruments ...
-
bioRxiv - Biophysics 2021Quote: ... Currents were digitized at a sampling rate of 5 kHz with an Axon CNS 1440A Digidata system using pCLAMP 10 (Molecular Devices, Sunnyvale, CA, USA). Each pH response was measured as the peak current after 1 minute exposure to activation buffer ...
-
bioRxiv - Neuroscience 2020Quote: Voltage- and current-clamp recordings from boutons as well a subset of somatic recordings (Figure 5 and Figures S1 and S4) were performed with quartz glass pipettes using a Multiclamp 700A patch-clamp amplifier (Molecular Devices, San Jose, USA). Quartz glass pipettes (without filament ...
-
bioRxiv - Biophysics 2022Quote: ... All recordings were voltage-clamped at −60 mV and data collected at 5 kHz using an Axopatch 200B amplifier and Digidata 1440A (Molecular Devices, San Jose, CA). Rapid application or washout of agonist were performed using a three-barreled flowpipe mounted to and controlled by a SF-77B fast perfusion system (Warner Instrument Corporation ...
-
bioRxiv - Neuroscience 2022Quote: ... Signals were recorded using a 5 KHz low-pass filter at a sampling frequency of 20 KHz using the Digidata 1440A digitizer (Molecular devices, Sunnyvale, CA, USA) with Clampex (v10.6 ...
-
bioRxiv - Neuroscience 2022Quote: ... Signals were recorded using a 5 KHz lowpass filter at a sampling frequency of 20 kHz using the Digidata 1440A digitizer (Molecular devices, Sunnyvale, CA, USA) with Clampex (v10.6 ...
-
bioRxiv - Neuroscience 2022Quote: ... Recordings were filtered at 5 kHz with the amplifier internal filter and digitized at 50 kHz using a Digidata 1550B digitizer (Molecular Devices, San Jose, CA). The recording pipette was filled with (in mM) ...
-
Development of monoclonal antibody-based blocking ELISA for detecting SARS-CoV-2 exposure in animalsbioRxiv - Microbiology 2023Quote: ... MA) in 5 min and color intensity was quantified at 405 nm using a SpectraMax® iD5 microplate reader (Molecular Devices, San Jose, CA). The percentage of inhibition was calculated using the following formula:
-
bioRxiv - Neuroscience 2023Quote: ... Signals were filtered at 5 kHz and sampled at 10 kHz with a Digidata 1440A digitizer and pClamp10 software (Molecular Devices, San Jose, CA). Series resistance (3–5MΩ ...
-
bioRxiv - Immunology 2021Quote: ... The concentration of both mouse and simian IgG antibodies was calculated relative to the standard using a 5-parameter fit curve (Softmax, Molecular Devices, Sn Jose, CA, USA) and results are expressed as µg/mL of HIV-specific antibodies (IgG ...
-
bioRxiv - Immunology 2021Quote: ... Plates were incubated for 5-15 minutes at room temperature and luminescence was measured on a Spectramax i3x plate reader (Molecular Devices, San Jose, CA, USA). Data analysis was performed using the Softmax Pro (Molecular Devices ...
-
bioRxiv - Physiology 2021Quote: Whole-cell membrane currents were filtered at 2 kHz using the low-pass Bessel filter of the Axopatch 200B amplifier and digitized (5-10 kHz) using a Digidata 1440 unit and pCLAMP 10 software (Molecular Devices, San Jose, CA, USA). Patch electrodes were pulled from borosilicate glass and heat-polished to a final resistance between 3 and 5 MΩ ...
-
bioRxiv - Microbiology 2021Quote: ... The reaction was stopped with 3M sulfuric acid 5-10 minutes after OPD addition and absorbance values were measured at a wavelength of 492nm on a spectrophotometer (Molecular Devices Emax system, Sunnyvale, CA). Absorbance values were normalized by subtracting normal/uncoated wells from antigen-coated wells at the corresponding serum dilution ...
-
bioRxiv - Microbiology 2020Quote: ... The reaction was stopped with 3M sulfuric acid 5-10 minutes after OPD addition and absorbance values were measured at a wavelength of 492nm on a spectrophotometer (Molecular Devices Emax system, Sunnyvale, CA). Absorbance values were normalized by subtracting normal wells from antigen-coated wells at the corresponding serum dilution ...
-
bioRxiv - Immunology 2023Quote: ... The optical density was read at 450 nm using a Versamax microplate reader with SoftMax Pro Version 5 (both from Molecular Devices; San Jose, CA, USA), and endpoint titers were calculated with a cutoff three times the optical density over background ...
-
bioRxiv - Cell Biology 2024Quote: ... was obtained for ratiometric analysis at 37 °C with sampling every 5 minutes for two hours in a microtiter plate reader (Molecular Devices ID3, San Jose CA, USA). The calcium ionophore ionomycin (10 µM ...
-
bioRxiv - Evolutionary Biology 2022Quote: ... background reaction rates were measured by tracking the change in absorbance at 412 nm over 5 min using a SpectraMax® iD3 Multi-Mode Microplate Reader (Molecular Devices, LLC., San Jose, CA, USA). After the addition of oxaloacetate to start the reaction ...