Labshake search
Citations for Molecular Devices :
451 - 500 of 1317 citations for Copper;5 10 15 20 tetrakis 4 methylphenyl porphyrin 22 24 diide since 2020
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Neuroscience 2024Quote: Electrophysiology data was analyzed with Clampfit 10 (Molecular Devices). EPSC and IPSC amplitudes were calculated as the difference between the peak amplitude in a pre-defined window after the light stimulation onset and the mean amplitude just preceding the EPSC or IPSC ...
-
bioRxiv - Neuroscience 2024Quote: ... and acquired with the pClamp 10 software (Molecular Devices).
-
bioRxiv - Physiology 2024Quote: ... and analyzed using pClamp 10 software (Molecular Devices, USA). Experiments were conducted at room temperature (20-22 °C) ...
-
bioRxiv - Neuroscience 2024Quote: Recording data was analysed using Clampfit 10 (Molecular Devices) software ...
-
bioRxiv - Bioengineering 2022Quote: ... and CFP images were acquired every 15 mins with an Olympus 60x oil objective using automated acquisition software (Metamorph, Molecular Devices, San Jose, CA), then differential interference contrast and GFP images were acquired at the beginning and the end of the movie.
-
bioRxiv - Microbiology 2023Quote: ... The reaction was stopped with 15 uL of 1N HCl and absorbance at 450 nm was read on SpectraMax i3x plate reader (Molecular Devices, San Jose, CA)
-
bioRxiv - Immunology 2020Quote: ... An equal volume of assay loading buffer (FLIPR Calcium 4 assay kit, Molecular Devices) in Hank’s balanced salt solution supplemented with 20 mM HEPES and 2 mM probenecid was added ...
-
bioRxiv - Pathology 2022Quote: ... and currents were sampled at 20 KHz through an A/D converter (DigiData 1440, Molecular Devices, CA) and low pass filtered at 5 kHz ...
-
bioRxiv - Physiology 2020Quote: ... digitized at 20 kHz and viewed on a computer monitor using pClamp software (version 10.2; Molecular Devices).
-
bioRxiv - Neuroscience 2020Quote: ... The outside-out patches were voltage clamped at −20 mV with an Axopatch 200B amplifier (Molecular devices) and currents were recorded and low pass filtered with a 4-pole Bessel filter (5 kHz) ...
-
bioRxiv - Neuroscience 2021Quote: ... and recorded at a sampling rate of 20 kHz with pClamp software (Molecular Devices, San Jose, CA). We did not correct for the junction potential ...
-
bioRxiv - Neuroscience 2020Quote: ... and recorded at a sampling rate of 20 kHz with pClamp software (Molecular Devices, San Jose, CA). We did not correct for the junction potential ...
-
bioRxiv - Neuroscience 2020Quote: ... and digitized at 20 kHz with a 16-bit analog-to-digital converter (Digidata 1440A; Molecular Devices). Data were acquired using Clampex 10.3 software (Molecular Devices ...
-
bioRxiv - Neuroscience 2022Quote: ... digitized with Digital 1440A digitizer and acquired at 20 kHz using Clampex 10.3 (Molecular Devices, Sunnyvale, CA). Patch pipettes with a resistance between 3-5 MΩ were pulled from borosilicate glass (WPI ...
-
bioRxiv - Biophysics 2023Quote: ... Data were filtered at 1–3 kHz and digitized at 20 kHz using pClamp software (Molecular Devices) and a Digidata 1440A digitizer (Axon Instruments) ...
-
bioRxiv - Neuroscience 2024Quote: ... Signals were acquired using the MultiClamp 700B amplifier and digitized at 20 kHz using DigiData1550B (Molecular Devices). The recorded electrophysiological data were analyzed using Clampfit (Molecular Devices ...
-
bioRxiv - Cell Biology 2021Quote: Amplified whole-cell currents were low-pass filtered at 2 kHz and sampled at 10 kHz using a Molecular Devices Axopatch 200B amplifier driven with a pClamp 10 interface (Molecular Devices, Sunnyvale, CA). Pipette resistances were typically 2.0-3.0 MΩ ...
-
bioRxiv - Neuroscience 2022Quote: ... Data were low-pass filtered at 10 kHz and acquired at 10 kHz with Axopatch 700B amplifiers and CV-7B headstages (Molecular Devices, Sunnyvale CA). Data were acquired using WaveSurfer v0.953 (Janelia Research Campus) ...
-
bioRxiv - Neuroscience 2021Quote: ... Data were filtered at 5 kHz and digitized with Digidata 1320 (Molecular Devices).
-
bioRxiv - Biophysics 2022Quote: ... Voltage clamp data were digitized at 5 kHz (Axon Digidata 1440A; Molecular Devices), collected using pClamp 10 (Axon Instruments) ...
-
bioRxiv - Immunology 2022Quote: ... and analyzed using SoftMax Pro Version 5 software (Molecular Devices, San Jose, CA). Caspase-1 activity was quantified by subtracting the luminescence in the wells containing detection reagent plus YVAD from the average luminescence of the wells containing only the caspase-1 activity reagent.
-
bioRxiv - Physiology 2023Quote: ... and low-pass filtered at 5 kHz using pClamp software 10.7 (Molecular Devices). All recordings were performed at room temperature (22–25°C) ...
-
bioRxiv - Biophysics 2024Quote: ... Voltage clamp data were digitized at 5 kHz (Axon Digidata 1440A; Molecular Devices), collected using pClamp 10 (Axon Instruments).
-
bioRxiv - Systems Biology 2023Quote: A kinetic time course to monitor changes in optical density was used to measure at OD595 nm every 15 minutes using a Molecular Devices Filtermax F5 plate reader (Molecular Devices LLC, San Jose, CA) set to “high” shake speed and linear shaking mode in a 24 well microtiter dish plate sealed with a Breathe-EasyⓇ transparent membrane (Sigma-Aldrich) ...
-
bioRxiv - Cell Biology 2024Quote: ... was added and fluorescence signal emitted at 505 nm with excitation at 400 nm was recorded for 15 minutes using a SpectraMax Paradigm multimode microplate reader (Molecular Devices, San Jose, CA, USA). z-Arg-Arg-7-amino-4-frifluoromethylcoumarin (AFC ...
-
bioRxiv - Biochemistry 2024Quote: ... 7µl of samples were loaded onto 12-15% SDS-PAGE gels and subsequently imaged using the STORM 860 Molecular Imager (Molecular Devices, San Jose, CA, USA) and gel fluorescent bands were quantified using densitometric analysis through ImageQuant Software (v5.2)/ Gelanalyzer (V19.1) ...
-
bioRxiv - Microbiology 2020Quote: ... and kept in 1x PBS until imaging on an Image Xpress Micro 4 (Molecular Devices). An average of 1×103 cells were imaged across four sites per well and were analyzed for nucleocapsid (N ...
-
bioRxiv - Biophysics 2020Quote: ... and analyzed using the pClamp 10 software (Molecular Devices, USA).
-
bioRxiv - Neuroscience 2021Quote: ... 1322A digidata (Axon Instruments) and Pclamp 10 software (Molecular Devices) for acquisition and analysis ...
-
bioRxiv - Neuroscience 2021Quote: Electrophysiology analysis was conducted using Clampfit 10 software (Molecular Devices). Current amplitudes were measured as the steady-state current towards the end of the 150ms voltage step ...
-
bioRxiv - Neuroscience 2021Quote: Electrophysiological data analysis was performed using pClamp 10 (Molecular Devices) and OriginPro 2018b (Microcal ...
-
bioRxiv - Neuroscience 2020Quote: ... and sampled at 10 kHz with Digidata 1550A (Molecular Devices). Recordings were acquired using pClamp10 and analyzed using Clampfit (Molecular Devices) ...
-
bioRxiv - Neuroscience 2020Quote: ... and collected on-line using pClamp 10 software (Molecular Devices). Photostimuli were applied every 45 s and 10 photo-evoked currents were averaged per neuron per condition ...
-
bioRxiv - Biochemistry 2020Quote: ... Data were analyzed and plotted using Clampfit 10 (Molecular Devices).
-
bioRxiv - Neuroscience 2020Quote: ... and basal current was done in Clampfit 10 (Molecular Devices). For current-clamp experiments ...
-
bioRxiv - Neuroscience 2020Quote: ... digitized at 10 kHz using the Digidata 1440 (Molecular Devices), and recorded for offline analysis using pClamp 10.2 (Molecular Devices).
-
bioRxiv - Physiology 2021Quote: ... Electrophysiological traces were analyzed on Clamp fit 10 (Molecular Devices) and Origin (Origin Lab ...
-
bioRxiv - Neuroscience 2021Quote: ... digitized at 10 kHz using a Digidata 1440A (Molecular Devices) and acquired using Clampex 10.3 (Molecular Devices) ...
-
bioRxiv - Neuroscience 2020Quote: ... Data was acquired using pClamp v.10 software (Molecular Devices). Sampling frequency was 100 kHz and low pass Bessel filtered at 10 kHz (Digidata 1550 ...
-
bioRxiv - Physiology 2021Quote: ... Electrical signals were acquired using AxoScope 10 software (Molecular Devices) with a pH/ION amplifier (Model 2000 ...
-
bioRxiv - Bioengineering 2022Quote: ... Collected data were analyzed using Clampfit 10 software (Molecular Devices). Light stimulations were generated by a 635 nm laser (Thorlabs) ...
-
bioRxiv - Neuroscience 2022Quote: ... and Clampex 10 software (Molecular Devices Inc., Union City, CA), and digitized at 20 kHz using a Digidata 1440A.
-
bioRxiv - Biophysics 2022Quote: ... Data were digitized at 10 kHz through Digidata1440 (Molecular Devices). The resistance of microelectrodes was adjusted to be 0.2–0.5MΩ when filled with the solution of 3M K-acetate and 10mM KCl ...
-
bioRxiv - Neuroscience 2021Quote: ... and analyzed off-line using Clampfit 10 (Molecular Devices, LLC). Patch pipettes (3-5 MΩ ...
-
bioRxiv - Neuroscience 2020Quote: ... Data were acquired using the pCLAMP 10 software (Molecular Devices) and a Digidata 1550 digitizer (Molecular devices) ...
-
bioRxiv - Neuroscience 2020Quote: ... Data were acquired using the pCLAMP 10 software (Molecular Devices) and an Axon Digidata 1550A digitizer (Molecular Devices ...
-
bioRxiv - Neuroscience 2020Quote: ... Electrical recordings were analyzed using Clampfit 10 software (Molecular Devices) or IgorPro 4.0 software (WaveMetrics) ...
-
bioRxiv - Neuroscience 2020Quote: ... and Clampex 10 software (Molecular Devices Inc., Union City, CA), and digitized at 20 kHz using a Digidata 1440A.
-
bioRxiv - Neuroscience 2021Quote: ... and analyzed via pClamp 10 or 11 software (Molecular Devices). Input resistance and access resistance were continuously monitored throughout experiments ...
-
bioRxiv - Neuroscience 2020Quote: ... and data was collected using pCLAMP 10 software (Molecular Devices). Following an initial pipette seal resistance of ≥ 1 GΩ ...