Labshake search
Citations for Molecular Devices :
451 - 500 of 693 citations for 2 Amino 3 chloro 5 nitro 6 picoline since 2020
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Neuroscience 2023Quote: ... a measurement (Ex412/Em480) taken every 5 sec for 600 sec on a SpectraMax M5 multimode reader (Molecular Devices).
-
bioRxiv - Neuroscience 2024Quote: ... 3 - 5 ms (DAPI), 150 - 250 ms (GFP) and 2,000 - 3,000 ms (Cy3, Cy5, mCherry) using MetaMorph software (Molecular Devices) at 0.133 µm/pixel (Figure 1) ...
-
bioRxiv - Cell Biology 2022Quote: ... Fluorescence of C11-BODIPY™ 581/591 was measured by simultaneous acquisition of the green (484/510 nm, oxidized) and red signals (581/610 nm, reduced) with FlexStation® 3 Multi-Mode Microplate Reader (Molecular Devices, Sunnyvale, CA), and the ratio of green/red fluorescence was determined as a measure of oxidation of C11-BODIPY™ 581/591.
-
bioRxiv - Pathology 2020Quote: ... and incubated at room temperature for 10 min before reading in a FlexStation 3 Benchtop Multi-Mode Microplate Reader (Molecular Devices, San Jose, California) (250-ms integration).
-
bioRxiv - Neuroscience 2023Quote: ... Recordings were done by impaling body-wall muscle 6-7 in abdominal segment 3 with a 20-25 MÙ electrode and were amplified using an Axoclamp 900A amplifier (Molecular Devices, San Jose, CA). Recordings were exported to a computer using an Axon Digidata 1550B (Molecular Devices ...
-
bioRxiv - Molecular Biology 2024Quote: ... luciferase detection reagent was added to each well 10 min prior to luminescent determination with a FlexStation 3 Multimode Microplate Reader (Molecular Devices, San Jose, CA). In the absence of a known MNRR1-inducing small molecule ...
-
bioRxiv - Cell Biology 2021Quote: ... filtered at 2 kHz with an 8-pole Bessel filter and analyzed with Clampfit 10.7 (Molecular Devices) and Origin 8 Pro (Origin Lab ...
-
bioRxiv - Neuroscience 2022Quote: ... Conventional tight-seal (>2 GΩ) whole cell patch-clamp recordings were acquired using Multiclamp 700B (Molecular Devices) amplifier ...
-
bioRxiv - Neuroscience 2021Quote: ... with Bessel filter of 2 kHz and digitized at 50 kHz using Axon DigiData 1500A (Molecular Devices). The Axon pClamp 10 (Molecular Devices ...
-
bioRxiv - Neuroscience 2020Quote: ... spike threshold in Spike 2 v7.10 (Cambridge Electronic Design) and action potential properties in pCLAMP (Molecular Devices). A total of 20 mice were used for intrinsic excitability experiments.
-
bioRxiv - Pharmacology and Toxicology 2022Quote: ... data were filtered (2 KHz) and digitized (10 KHz) using a Digidata 1550B1 (Molecular Devices, CA, USA).
-
bioRxiv - Physiology 2021Quote: ... and low pass filtered at 2 kHz using a MultiClamp 700B amplifier and Clampex (Molecular Devices, LLC). Leak currents before mechanical stimulation were subtracted offline from the current traces.
-
bioRxiv - Pharmacology and Toxicology 2020Quote: ... Data were sampled at 2 kHz using the pClamp 10.4 acquisition software (Axon Instruments, Molecular Devices, USA). The microelectrodes were pulled from glass capillaries (TW 120.3 ...
-
bioRxiv - Cell Biology 2022Quote: ... The signals were acquired at 10 kHz and filtered at 2 kHz using pClamp10 software (Molecular Devices). For nAChR recordings ...
-
bioRxiv - Neuroscience 2022Quote: ... Recordings were filtered at 2 kHz and digitized at 10 kHz using MultiClamp 700B software (Molecular Devices). Claustrum projection neuron type was determined via a 5 ms depolarization step while recording in current-clamp mode to determine burst firing properties (Type I ...
-
bioRxiv - Neuroscience 2024Quote: ... Traces were low-pass filtered at 2 kHz and digitized at 10 kHz (DigiData 1,550, Molecular Devices). Data were acquired and analyzed using Clampfit 11.0 software (Molecular Devices) ...
-
bioRxiv - Neuroscience 2024Quote: ... We acquired wingbeat amplitude data at 2 kHz using a Digidata 1550B or 1440A amplifier (Molecular Devices) for the afferents and muscles ...
-
bioRxiv - Neuroscience 2023Quote: ... at 100 kHz sampling rate and filtered at 2 kHz using a MultiClamp 700B amplifier (Molecular Devices). At the end of the recording ...
-
bioRxiv - Neuroscience 2023Quote: ... at 100 kHz sampling rate and filtered at 2 kHz using a MultiClamp 700B amplifier (Molecular Devices). 30 consecutive action potentials were recoded every 5 seconds using Clampex 10.6 (Molecular Devices ...
-
bioRxiv - Neuroscience 2024Quote: ... low-pass filtered at 2 kHz and digitally sampled at 10 kHz using a digitizer (Molecular Devices). Intrinsic excitability experiments used a K-gluconate based internal solution (in mM ...
-
bioRxiv - Cell Biology 2022Quote: ... CM-DCF fluorescence inside cells was measured at 485 nm for excitation and 538 nm for emission with FlexStation® 3 Multi-Mode Microplate Reader (Molecular Devices, Sunnyvale, CA, USA). The amount of emitted fluorescence was correlated to the quantity of reactive oxygen species (ROS) ...
-
bioRxiv - Bioengineering 2022Quote: ... was normalized to bacterial growth using optical density measured as absorbance at 600 nm (OD600) on a plate reader (Spectra Max 3, Molecular Devices, San Jose, CA, USA). Bioluminescent signals were quantified using the 8x12 grid ROI for all wells (in vitro thermocycler induction ...
-
bioRxiv - Microbiology 2021Quote: ... The plates were then incubated for 3 min at room temperature and the luminescence was assessed using a plate luminometer (Molecular Devices, San Jose, CA, USA) with 1 sec integration time ...
-
bioRxiv - Plant Biology 2023Quote: ... The plate was cooled for 3 min at room temperature before measuring the absorbance with a SpectroMax M5 UV/Vis spectrophotometer (Molecular Devices, San Jose, CA, USA) at 630 nm ...
-
bioRxiv - Plant Biology 2024Quote: ... LUC signals were measured using the Dual-Luciferase Reporter Assay Kit (Vazyme, Nanjing, China) and analyzed on a FlexStation 3 Multi-Mode Microplate Reader (Molecular Devices, San Jose, CA, USA). Relative luciferase activity was calculated based on LUC:REN ratios.
-
bioRxiv - Neuroscience 2021Quote: ... digitized at 10–20 kHz and low-pass filtered at 2–5 kHz with a Digidata 1440A analog-to-digital converter and analyzed off-line using Clampfit 10.7 software (Molecular Devices). Intrinsic excitability was determined in response to increasing depolarizing current pulses (+75 pA ...
-
bioRxiv - Biochemistry 2020Quote: ... Fluorescence intensity measurements were collected every 30 sec on a SpectraMax M5 fluorometer using Softmax Pro 5 software (Molecular Devices; excitation and emission set to 410 nm and 490 nm ...
-
bioRxiv - Neuroscience 2020Quote: ... The steady-state voltage responses were plotted against the amplitude of current injection and the slope of the linear fit between −5 pA to −30 pA was used to define Rin (Clampfit v. 11.1; Molecular Devices). Time constant (tau ...
-
bioRxiv - Microbiology 2021Quote: ... incubating 1 hour at 37ºC 5% CO2 and measuring fluorescence (λEX = 540 nm, λEM = 590 nm) on a SpectraMax M5 (Molecular Devices). The IC50 was calculated using GraphPhad Prism 9 using a non-linear regression analysis ...
-
bioRxiv - Pharmacology and Toxicology 2021Quote: ... was added and plates were gently shaken for 5 s to mix and then absorbance (O.D.) was measured at 450/620 nm on a SpectraMax M5 (Molecular Devices) instrument and data were processed by SoftMax Pro 6.4 software (Molecular Devices) ...
-
bioRxiv - Neuroscience 2021Quote: ... the data acquired at 5 kHz with a Digidata 1440A (Axon instruments) interface using pCLAMP 10 acquisition software (Molecular Devices). The Internal and external (bath ...
-
bioRxiv - Physiology 2021Quote: ... Currents were filtered at 1 kHz and digitized at 5 kHz using an Axopatch 200B amplifier and Clampex 10.4 (Molecular Devices. Offline analysis was performed using Clampfit 10.4 ...
-
bioRxiv - Neuroscience 2021Quote: ... Data were filtered at 5-10 kHz and digitized at 50 kHz using an acquisition board (Digidata 1440, Molecular Devices) attached to a personal computer running pCLAMP 10.2 software package (Molecular Devices) ...
-
bioRxiv - Immunology 2021Quote: ... DAF fluorescence intensities were measured every 5 minutes for a total of 60 minutes using a SpectraMax iD3 (Molecular Devices). All experiments were repeated at least four times per batch.
-
bioRxiv - Neuroscience 2022Quote: ... digitized at 5-20 kHz and acquired using a Digidata 1440A digitizer and pClamp 10 software (all from Molecular Devices).
-
bioRxiv - Neuroscience 2024Quote: ... Electrophysiological recordings were obtained from one neuron per slice and 4-5 slices per mouse using a Multiclamp 700B amplifier and analyzed using a digital system (pClamp version 11.2, Molecular Devices). Series and input resistances were monitored throughout the experiment using a -5 mV pulse ...
-
bioRxiv - Neuroscience 2024Quote: Currents were filtered at 5 kHz using low-pass Bessel filter of the amplifier and digitized using a Digitata 1,440 unit (Molecular Devices). All voltage clamp measurements were performed at a holding voltage of -60 mV ...
-
bioRxiv - Neuroscience 2024Quote: ... were plotted against the amplitude of current injection and the slope of the linear fit between −5 pA to −30 pA was used to define Rin (Clampfit v. 11.2; Molecular Devices). Time constant (tau ...
-
bioRxiv - Systems Biology 2022Quote: ... and the EtBr accumulation was measured by measuring the fluorescence in a microplate reader (spectramax multimode M 5, Molecular devices) at 37°C using 530 nm excitation wavelength and 585 nm as the emission wavelength ...
-
bioRxiv - Biochemistry 2023Quote: ... Data were sampled at 10 kHz and filtered at 5 kHz using a Digidata 1550A device controlled by pCLAMP 10.5 (Molecular Devices). Capacitance transients and leak currents were removed by subtracting a scaled control trace utilizing a P/4 protocol.
-
bioRxiv - Cancer Biology 2023Quote: ... Whole-cell currents were filtered at 5 kHz and digitized at 10 kHz using the software pCLAMP 10 (Molecular Devices). Micropipettes were pulled from Corning 8161 capillary glass tubes (Warner Instruments ...
-
bioRxiv - Neuroscience 2023Quote: Spontaneous IPSCs were detected and analyzed for 5-minute epochs during baseline and following drug exposure (Clampfit 11.1, Molecular Devices). For electrically-evoked IPSCs ...
-
bioRxiv - Neuroscience 2024Quote: ... Continuous current traces of 5-min duration (recorded at least 5 min after achieving whole-cell configuration) were acquired and analyzed with Clampfit 10.7 (Molecular Devices). The frequency and amplitude of recorded sIPSCs were quantified.
-
bioRxiv - Neuroscience 2024Quote: ... We detected the evoked qEPSCs 0.5-1.5s after the light onset and calculated the average number of qEPSCs from 5 sweeps using Clampfit 11 (Molecular Devices).
-
bioRxiv - Neuroscience 2021Quote: ... filtered at 2 kHz and digitized at 10 kHz with a MultiClamp 700B amplifier (Molecular Devices, CA, USA) and a Digidata 1550 digitizer (Molecular Devices) ...
-
bioRxiv - Neuroscience 2020Quote: ... low-pass filtered at 2 kHz using a Digidata 1550B low noise data acquisition system (Molecular Devices, USA). For whole-cell recordings ...
-
bioRxiv - Neuroscience 2021Quote: ... Recordings were made using an Axoclamp 2 B amplifier with HS-2A x0.1 headstage (Molecular Devices, CA, USA) and on a BX51WI Olympus microscope with a 40X LUMPlanFL/IR water immersion objective (Olympus Corporation ...
-
bioRxiv - Neuroscience 2020Quote: ... Signals were filtered at 2 kHz and sampled at 10 kHz with Digidata 1322A (Molecular Devices, Sunnyvale, CA). Patch pipettes made from thin-walled borosilicate glass (outer diameter 1.5 mm ...
-
bioRxiv - Neuroscience 2020Quote: ... Data were filtered during acquisition with a low pass filter set at 2 kHz using pClamp10 (Molecular Devices). Data analysis was performed offline with Clampfit 10.2 (Molecular Devices).
-
bioRxiv - Neuroscience 2022Quote: ... Data were filtered at 2 kHz and digitized at 20 kHz using a 1440A Digidata Digitizer (Molecular Devices). Series-resistance (<20 MΩ ...