Labshake search
Citations for Eppendorf :
101 - 150 of 968 citations for 8 BROMO 2 3 4 5 TETRAHYDRO 1H PYRIDO 4 3 B INDOLE since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Cell Biology 2022Quote: ... for 10 minutes at 4°C (Eppendorf, Germany), and supernatants were transferred into fresh tubes to be evaporated to dryness in a CentreVap concentrator at 40°C (Labconco ...
-
bioRxiv - Bioengineering 2024Quote: ... 15 min at 4°C (Eppendorf, Hamburg, Germany). duRNA was generated through equimolar annealing of trRNA/crRNA in duplex buffer (IDT) ...
-
bioRxiv - Biophysics 2020Quote: ... The needle was then glued to a 6×4×2 mm Neodyn magnet (QM-06×04×02-N, Magnets4you) and attached to a motorized micromanipulator (PatchMan, Eppendorf). The magnetic needle was lowered until it touched the bottom of a dummy sample dish and raised again so that it was placed above the bottom of the sample with the very tip in focus around 100 μm above the focus of the glass surface.
-
bioRxiv - Neuroscience 2019Quote: ... Excised gel slices were incubated with 50% acetonitrile/50mM ammonium bicarbonate for 2 h at room temperature or 4°C overnight with gentle shaking at 600 rpm in a Thermomixer (Eppendorf), before being incubated in 100% acetonitrile for 15 min at room temperature ...
-
bioRxiv - Microbiology 2022Quote: ... The cell suspension was then transferred into 2 mL tubes and centrifuged at 16 000g and 4°C (Eppendorf, Germany) to pellet the cells ...
-
bioRxiv - Developmental Biology 2023Quote: ... About 6 pl dCas9-KRAB mRNA and sgRNA mixes were injected into cytoplasm of zygotes between 2-4 hpi using a Piezo impact-driven micromanipulator (Eppendorf). For all micro-injection experiments ...
-
bioRxiv - Biochemistry 2022Quote: ... and samples were vortexed at 1200 rpm for 2-3 hours at room temperature (MixMate ®, Eppendorf South Pacific, Sydney, NSW Australia). Following this ...
-
bioRxiv - Microbiology 2024Quote: ... Pellets were washed with cold 70% ethanol and centrifuged at 19,000 × g for 5 min at 4°C and air dried for 15 min in the Centrifugal Vacuum Concentrator 5301 (Eppendorf, USA). The quality of RNA was assessed using a NanoDrop (ND-1000 ...
-
bioRxiv - Microbiology 2024Quote: ... The stationary pre-cultures were then pooled and washed by centrifugation (5 min, 3,220 g and 4 °C) using a 5810 R swing-out centrifuge (Eppendorf, Hamburg, Germany). After centrifugation ...
-
bioRxiv - Biophysics 2020Quote: ... The cell suspension was subsequently centrifuged for 30 min at 4°C and 3250 × g (Eppendorf Swing-bucket rotor A-4-62). The supernatant was discarded ...
-
bioRxiv - Cell Biology 2020Quote: ... and the cells were pelleted by centrifugation at approximately 250 × g for 5 min at 4 °C (Eppendorf 5804 R, Hamburg, Germany). After resuspension ...
-
bioRxiv - Biochemistry 2022Quote: ... 4 °C for 10 sec (5424-R Eppendorf microfuge) and the pellet was resuspended with 400 μl TES Solution (10 mM Tris-HCl ...
-
bioRxiv - Biophysics 2021Quote: ... 20°C for 4 hours (Thermomixer 5355 R, Eppendorf). After incubation ...
-
bioRxiv - Molecular Biology 2022Quote: ... Reactions were performed in a Realplex 4 Thermocycler (Eppendorf) using the following program ...
-
bioRxiv - Immunology 2024Quote: ... on a MasterCycler EP Realplex 4 thermal cycler (Eppendorf) in 96-well-plate format ...
-
bioRxiv - Neuroscience 2020Quote: ... for 30 min at 4°C on centrifuge (Eppendorf #5804R) and rotor (Eppendorf #S-4-72) ...
-
bioRxiv - Cell Biology 2022Quote: ... Microneedles were manually controlled with an InjectMan 4 micromanipulator (Eppendorf). The compensation pressure set on the FemtoJet was 35hPa for the whole injection experiment to avoid damages on cells ...
-
bioRxiv - Biophysics 2022Quote: ... The probe was controlled with a micromanipulator (Injectman 4; Eppendorf) and mounted on an inverted epifluorescent microscope.
-
bioRxiv - Physiology 2023Quote: ... for 1 h at 4 □ on a ThermoMixer C (Eppendorf), 350 µl of water and 250 µl of chloroform were added to the mixture to induce phase separation ...
-
bioRxiv - Microbiology 2023Quote: ... The supernatant was centrifuged (Eppendorf 5810R, A-4-62 Rotor) for 10 minutes at 500 x g to separate the remaining blood cells from the plasma.
-
bioRxiv - Molecular Biology 2024Quote: ... followed by high-speed centrifugation (4°C, 12000rpm, Eppendorf, 5424R) for 20 minutes to collect the protein supernatant ...
-
bioRxiv - Molecular Biology 2022Quote: ... 15.76 g EDTA (pH 8)) in 2 mL Safe-Lock tubes (Eppendorf, Hamburg, Germany). The QIAamp DNA Mini Kit (QIAGEN ...
-
bioRxiv - Microbiology 2019Quote: ... four 50 mL aliquots from each trap were centrifuged at 3214 x g and 4°C for 30 minutes (Eppendorf 5810 R, S-4-104 rotor). The supernatant was decanted after centrifugation and cell pellets were stored at −80°C until ready for freeze-drying and lipid extraction ...
-
bioRxiv - Molecular Biology 2022Quote: ... Cell pellets of OD600 = 3-6 units (as measured using an Eppendorf BioPhotometer) were resuspended in 300 µL of 20 % TCA and 100 µL of acid-washed glass beads ...
-
bioRxiv - Synthetic Biology 2022Quote: ... Plates were then centrifuged at 330 rpm for 3 min (Eppendorf, Centrifuge 5810). Plates were then incubated at 37°C for 24 hours ...
-
bioRxiv - Microbiology 2019Quote: ... Loaded microfluidic chambers were centrifuged 3 min at 1000 rcf (Eppendorf centrifuge 5430R) to maximize cell adhesion.
-
bioRxiv - Bioengineering 2022Quote: ... Cells were centrifuged 3 minutes at 800-1000 RPM (Eppendorf 5810 tabletop centrifuge) and resuspended ...
-
bioRxiv - Microbiology 2023Quote: ... qPCR analysis was carried out in 96 well plates using Quantstudio 3 (Eppendorf). Amplification was carried out at 95°C for 15 min and 50 cycles at 95°C for 15s ...
-
bioRxiv - Plant Biology 2021Quote: ... samples were centrifuged (20 min, 15,000g, 4°C, in an Eppendorf 5810R centrifuge ...
-
bioRxiv - Genomics 2021Quote: ... and held at 4 C° using the Mastercycler Nexus (Eppendorf, Australia). This was then cycled a total of 40 times ...
-
bioRxiv - Pharmacology and Toxicology 2020Quote: ... and centrifuged at 13 000 rpm/15 minutes/4°C (Eppendorf Centrifuge 5415R ...
-
bioRxiv - Molecular Biology 2023Quote: ... Melting curves were obtained on a qPCR machine (Eppendorf RealPlex 4), ramping up from 25 to 95 °C ...
-
bioRxiv - Neuroscience 2023Quote: ... and 10,000 × g at 4 °C for 30 min (Eppendorf 5910R). Pre-cleared supernatants were subjected to ultracentrifugation at 29,000 rpm using a Beckman SW40 Ti rotor (RCFavg ...
-
bioRxiv - Microbiology 2023Quote: ... The resulting supernatant was centrifuged (Eppendorf 5810R, A-4-62 Rotor) for 10 minutes at 500 x g to separate the cells from plasma ...
-
bioRxiv - Microbiology 2024Quote: ... veronii cultures were centrifuged for 4 min at 12,000 rpm (Eppendorf centrifuge 5810R with an F-34-6-38 rotor ...
-
bioRxiv - Cancer Biology 2024Quote: ... or a realplex 4 qPCR 96-Well Real Time Cycler (Eppendorf) with 5% of the immunoprecipitated DNA used in a 20 ul PCR reaction ...
-
bioRxiv - Cancer Biology 2024Quote: ... in a Realplex 4 qPCR 96-Well Real Time Cycler (Eppendorf). Ct values were internally normalized to GAPDH for each sample ...
-
bioRxiv - Biophysics 2022Quote: ... The lysate was incubated for 30 min on a rotating wheel at 4°C and centrifuged at 16 000 g for 20 min at 4°C (Eppendorf centrifuge 5417-R, Rotor F45-30-11). The supernatant was transferred to a fresh 1.5 ml Eppendorf tube and the pellet was discarded ...
-
High resolution, serial imaging of early mouse and human liver bud morphogenesis in three dimensionsbioRxiv - Developmental Biology 2021Quote: ... Cells were centrifuged 3 minutes at 800-1000 RPM (Eppendorf 5810 table top centrifuge) and resuspended ...
-
bioRxiv - Genomics 2020Quote: ... 3 ml of each bacterial suspension were centrifuged at 6,000 × g (Eppendorf, Westbury, NY) for 2 mins ...
-
bioRxiv - Plant Biology 2020Quote: ... The homogenates were centrifuged at 1,000 g for 3 min (Eppendorf 5430, Hamburg, Germany). The subsequent steps of the RNA extraction were performed on the supernatants according to the manufacturer’s specifications ...
-
bioRxiv - Molecular Biology 2019Quote: ... The peptide rOv-GRN-1was concentrated using Centripep with cut-off 3 kDa (Eppendorf) and resuspended in low salt solution ...
-
bioRxiv - Systems Biology 2019Quote: ... and 74.9 °C for 3 minutes in a thermocycler (Mastercycler Pro, Eppendorf, Hamberg, Germany) system as described elsewhere (Jafari et al. ...
-
bioRxiv - Biochemistry 2022Quote: ... for 3 min and then reduced to dryness in a Vacufuge centrifugal concentrator (Eppendorf).
-
bioRxiv - Evolutionary Biology 2020Quote: ... pelleted for 10min (4°C, max speed, Eppendorf 5415 D benchtop centrifuge), dried for ~10min under vacuum ...
-
bioRxiv - Bioengineering 2022Quote: ... Cells were harvested by centrifugation (3200 g, 40 min, 4 °C; Eppendorf centrifuge 5810 R ...
-
bioRxiv - Bioengineering 2022Quote: ... By centrifugation (3200 g, 30 min, 4 °C; Eppendorf centrifuge 5810 R), soluble proteins were separated from cell fragments and insoluble proteins ...
-
bioRxiv - Bioengineering 2021Quote: ... This was followed by a 4 h centrifugation step (Eppendorf Centrifuge 5424R) at 21,130 × g and 4°C to remove SWCNT aggregates ...
-
bioRxiv - Immunology 2022Quote: ... centrifuging 400xg for 10 min (Eppendorf Centrifuge 5810R, rotor A-4-62) at room temperature to pellet the cells ...
-
bioRxiv - Microbiology 2021Quote: ... centrifuged at maximum speed for 15 min at 4°C (5804 Eppendorf) to separate phases ...