Labshake search
Citations for Eppendorf :
4551 - 4600 of 4996 citations since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Microbiology 2019Quote: ... Three technical replicates were prepared with the epMotion 5070 robotic pipetting system (Eppendorf), with a technical variation of <5% ...
-
bioRxiv - Microbiology 2019Quote: ... and extension at 72°C for 1 min followed by final extension was conducted at 72°C for 5 min using a PCR minicycler (Eppendorf Ltd., Germany). After amplification ...
-
bioRxiv - Microbiology 2019Quote: After 20 minutes of centrifugation at 3,000 rpm (model 5810/5810 R, Eppendorf) to remove remaining fungal cells ...
-
bioRxiv - Microbiology 2019Quote: ... The qPCR reactions were performed in duplicate and in two independent runs using MasterCycler realplex4 from Eppendorf. Statistical analysis is described in the section below.
-
bioRxiv - Microbiology 2019Quote: ... which was obtained by drying cell pellets in a Vacufuge concentrator (Eppendorf) and measuring biomass on an analytical scale (XS64 ...
-
bioRxiv - Microbiology 2019Quote: ... Two hundred microliters of supernatant were transferred to tubes containing 8 µL neutralization solution (15% NH4HCO3) and dried in a Vacufuge concentrator (Eppendorf) for 30 to 45 min ...
-
bioRxiv - Microbiology 2019Quote: ... Eight hundred microliters of homogenized mixture were transferred to a cold microcentrifuge tube and centrifuged at 16,873×g for 60 s in a bench-top centrifuge (Model 5418, Eppendorf) at 4 °C ...
-
bioRxiv - Microbiology 2019Quote: ... 100 mM NaCl for 5 days at 37°C with constant shaking at 500 rpm in a thermomixer (Eppendorf). The formation of amyloid filaments was followed by Thioflavin T (ThT ...
-
bioRxiv - Molecular Biology 2019Quote: ... After centrifugation the extract was transferred to a spectrophotometer cuvette and absorbance was measured at 647 nm and 664 nm using BioSpectrometer kinetic (Eppendorf) spectrophotometer against buffered acetone as blank ...
-
bioRxiv - Microbiology 2019Quote: ... and an EpMotion 5075 automated pipetting system (Eppendorf). The 16S rRNA sequencing library was prepared as described previously (23) ...
-
bioRxiv - Genomics 2019Quote: ... 30 seconds OFF for 1 hour in a 1.5 mL DNA LoBind microfuge tube (Eppendorf, 022431005). The DNA was then transferred to 1.5 ml TPX tubes (Diagenode ...
-
bioRxiv - Genetics 2019Quote: DNA LoBind tubes (Eppendorf) were used for all steps during the RNA preparation and ONT cDNA-PCR library construction ...
-
bioRxiv - Cancer Biology 2019Quote: ... The eluted peptides were lyophilized in a Concentrator Plus (Eppendorf), resuspended in 0.1% TFA and analysed by LC-MS/MS on a QExactive™ Hybrid Quadrupole-Orbitrap™ Mass Spectrometer or Orbitrap Fusion™ Lumos™ Tribrid™ (Thermo Fisher ...
-
bioRxiv - Bioengineering 2019Quote: ... a benchtop centrifuge (Eppendorf model 5414 D) was used and each centrifugation step was performed at 13,000 rpm for 1 minute ...
-
bioRxiv - Cell Biology 2019Quote: ... on a Mastercycler® ep realplex (Eppendorf) or Quantstudio 7 flex (Life Technologies) ...
-
bioRxiv - Microbiology 2019Quote: ... The bacteria were pelleted down by centrifugation at 3220 g and 20°C (in an Eppendorf Centrifuge 5810 R) before being resuspended in 10 times the original volume of MEM-Glutamax ...
-
bioRxiv - Developmental Biology 2019Quote: ... Injections have been performed on the imaging microscope using an InjectMan4 micromanipulator and a FemtoJet 4i microinjector from Eppendorf. Embryos were imaged either ~ 10 min (C3-transferase ...
-
bioRxiv - Genomics 2019Quote: ... The cell lysate was centrifuged at 3,000 rpm (Eppendorf #5810R), at 4 °C for 5 minutes ...
-
bioRxiv - Genomics 2019Quote: ... and the supernatant was collected and further centrifuged at 13,000 rpm (∼18,000 rcf) in a table top centrifuge (Eppendorf #5417R) at 4 °C for 10 minutes ...
-
bioRxiv - Bioengineering 2019Quote: ... 10 µl aliquots of biomaterial-VEGF were transferred into low-protein binding tubes (Eppendorf® LoBind) containing 90 µl assay diluent ...
-
bioRxiv - Plant Biology 2019Quote: ... the root extremity was introduced into a plastic tube (Eppendorf type) through a hole pierced at the tube bottom and sealed with silicon paste to collect exuded sap for 24 h ...
-
bioRxiv - Molecular Biology 2019Quote: ... 100 µl of sample was saved as input and the rest was split into 2 ml DNA LoBind tubes (Eppendorf, D1579630) and 10 ml of anti-Flag antibody was added (F1804 ...
-
bioRxiv - Immunology 2019Quote: ... for 50min (Eppendorf Centrifuge 5810 ...
-
bioRxiv - Plant Biology 2019Quote: ... the samples were centrifuged at 16,000 g (Eppendorf centrifuge 5415C, Hamburg, Germany) for 20 min at 4°C ...
-
bioRxiv - Zoology 2019Quote: ... Testicular and ovarian cell suspension was loaded into the glass capillary attached to MN-153 micromanipulator (Narishige) and FemtoJet® 4x injector (Eppendorf). Triploid recipients were injected by approximately 3000-5000 of testicular cells (TC group ...
-
bioRxiv - Microbiology 2019Quote: ... Reactions were prepared by the epMotion M5073 liquid handling system (Eppendorf, Cat. No. 5073000205D) in triplicate ...
-
bioRxiv - Microbiology 2019Quote: ... The plates were sealed with an oxygen-permeable membrane and incubated at 30°C in a shaking Thermomixer (Eppendorf) at 600 rpm ...
-
bioRxiv - Cell Biology 2019Quote: ... The cells were centrifuged down at 13,000 rpm for 30 minutes at 4° C (Eppendorf Centrifuge 5415 R). The supernatant was collected and transferred to a fresh microfuge tube ...
-
bioRxiv - Biophysics 2019Quote: ... 6 mL of the selection culture in 2 mL centrifuge tubes was pelleted at 5000 rpm for 5 minutes at 4°C in a microcentrifuge (Eppendorf, 5242R). The supernatant was removed except for the last ∼200 µL ...
-
bioRxiv - Genomics 2019Quote: ... The needle was pressurized with 22 psi through the FemtoJet (Eppendorf). Young adult Eg6699 worms were picked onto an agarose pad covered with mineral oil on a glass coverslip ...
-
bioRxiv - Molecular Biology 2019Quote: ... qPCR was performed on a Mastercycler®ep realplex PCR thermal cycler machine (Eppendorf). Primers used in qPCR are listed in Supplementary Table 1.
-
bioRxiv - Microbiology 2019Quote: ... The tube was centrifuged for 10 min at 2000 rpm using an A-4-81 swinging-bucket rotor (Eppendorf). The oil was carefully decanted ...
-
bioRxiv - Cancer Biology 2019Quote: ... The eluted peptides were lyophilized in a Concentrator Plus (Eppendorf), resuspended in 0.1% TFA and analysed by LC-MS/MS on a QExactive™ Hybrid Quadrupole-Orbitrap™ Mass Spectrometer (Thermo Fisher ...
-
bioRxiv - Molecular Biology 2019Quote: ... and centrifugation procedure for two minutes at 10,000 x g (Eppendorf 5415 D ...
-
bioRxiv - Genomics 2019Quote: ... Each sample was eluted into 50 ul of Elution Buffer in duplicate into individual DNA LoBind 1.5 ml microcentrifuge tubes (Eppendorf) for storage at 80 °C until use in sequencing.
-
bioRxiv - Neuroscience 2019Quote: ... The DNA solution was then injected into the subretinal space for 3 seconds at 300 hPa using an automatic injector (Eppendorf). Two injections were performed in the following directions ...
-
bioRxiv - Immunology 2019Quote: ... six cycles 94°C for 20 sec and a touchdown program of 15 cycles with successive annealing temperature decrement from 65°C to 60°C for 30 sec with 1°C decrement with a final extension at 72°C 10 min performed in a Mastercycler Gradient (Eppendorf). The products were monitored using 1.5 % agarose gel electrophoresis stained with ethidium bromide ...
-
bioRxiv - Genetics 2019Quote: ... FLAG-beads were collected by centrifugation (800 x g, Eppendorf Centrifuge 5810 R), and washed 10 x with 10 ml lysis buffer containing 500 mM NaCl ...
-
bioRxiv - Cancer Biology 2019Quote: ... 1.5-mL PCR clean (Eppendorf # 022431021) or 96 well plates were used to process the samples.
-
bioRxiv - Pharmacology and Toxicology 2019Quote: ... Agonist ejection was initiated manually using a pressure-ejection system (Eppendorf FemtoJet, VWR) set at 500–800 hPa during 1 s.
-
bioRxiv - Bioengineering 2019Quote: ... EBs were harvest according to the manufacturer protocol and transferred to a 10 cm tissue culture dish (Eppendorf, catalog 0030702018). On Day 5 ...
-
bioRxiv - Neuroscience 2019Quote: ... peptides were eluted with 30% acetonitrile and dried in a vacuum concentrator (SpeedVac, Eppendorf). Low-binding plastic was used throughout.
-
bioRxiv - Microbiology 2019Quote: ... 600 rpm (Thermomixer F1.5, Eppendorf) for 1h ...
-
bioRxiv - Bioengineering 2019Quote: ... for 5 minutes at 3,500 RPM (2,465 x g, Eppendorf 5810R v3.3 centrifuge with A-4-62 rotor, Eppendorf, Hamburg, Germany) with an additional 30-minute incubation on the bench ...
-
bioRxiv - Bioengineering 2019Quote: ... for 5 minutes at 3,500 RPM (2,465 x g, Eppendorf 5810R v3.3 centrifuge with A-4-62 rotor ...
-
bioRxiv - Cell Biology 2019Quote: ... were detached with Trypsin-EDTA (0.25%) and pelleted by spinning them for 5 min at 1200 rpm (Eppendorf Centrifuge 5804). Cells were then re-suspended to 105 cells/mL in desiccation medium (50 mM Hepes and 500 mM trehalose in PBS ...
-
bioRxiv - Neuroscience 2019Quote: ... and dried using SpeedVac (Eppendorf), and then stored at −20°C until use.
-
bioRxiv - Genomics 2019Quote: ... and processed into single-cell suspension by gentle intermittent pipetting while incubating in a ThermoMixer (Eppendorf) for up to 15 minutes ...
-
bioRxiv - Molecular Biology 2019Quote: ... Ct threshold was determined by Realplex software (Eppendorf). For calculating mRNA abundance ...
-
bioRxiv - Molecular Biology 2019Quote: ... using a Realplex 2 thermocycler (Eppendorf). The PCR conditions were 95°C for 3 min ...