Labshake search
Citations for Beckman :
401 - 450 of 1553 citations for 7H Cyclopenta c pyridin 7 one 5 6 dihydro 3 methyl 9CI since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Microbiology 2022Quote: ... for 90 min or for the 6-well format at 44,000 rpm using a Beckman TLA-55 fixed angle-rotor (Beckman Coulter) for 45 min at 4°C ...
-
bioRxiv - Cancer Biology 2023Quote: ... cells were seeded into 6-well plates at a concentration of 4×105 cells per well and counted cumulatively with a Coulter counter (Beckman) every three days for two weeks ...
-
bioRxiv - Biochemistry 2024Quote: ... The indicated cell lines were seeded into 6 well plates and then trypsinized and cell number counted using a Z Coulter Counter (Beckman). Approximately 200 cells were seeded into 60 mm dishes and exposed 25 ...
-
bioRxiv - Cell Biology 2024Quote: ... EVs were then placed in the bottom 36% layer of a 6-step gradient in a 13.2 ml open top polyallomer tube (331372, Beckman Coulter). A reference gradient was prepared in parallel and OptiPrep absorbance was measured at 340 nm to estimate the fraction density ...
-
bioRxiv - Biochemistry 2024Quote: ... The cells were sonicated for 6-8 cycles of 20 secs and centrifuged at 40.000 rpm in MLA 80 rotor (Beckman coulter) for 45 min ...
-
bioRxiv - Cell Biology 2021Quote: ... About 9 ml interface that came from 3×SW28 tubes (25×89 mm, Beckman Coulter) was loaded in a SW41 tube (14×89 mm ...
-
bioRxiv - Microbiology 2020Quote: ... The gradient was centrifuged at 150,000 × g for 3 hr (Beckman SW 55 Ti rotor) and subsequently ten fractions ...
-
bioRxiv - Molecular Biology 2022Quote: ... Liberated adipocytes were measured using a 400 micrometer aperture on a Multisizer 3 (Beckman Coulter).
-
bioRxiv - Neuroscience 2022Quote: ... Libraries were barcoded and pooled then underwent three 3 rounds of AMPure bead (Beckman-Coulter) cleanup at a 0.8:1 ratio of beads to library ...
-
bioRxiv - Bioengineering 2022Quote: ... or by electrozone sensing (EZS) using the Multisizer 3 (Coulter Counter, Beckman Coulter, Brea, CA). Samples of 0.5–150 µL were used for the AccuSizer and Multisizer ...
-
Phenotypic and genotypic adaptation of E. coli to thermal stress is contingent on genetic backgroundbioRxiv - Evolutionary Biology 2023Quote: ... and measuring cell density in volumetric mode on a Multisizer 3 Coulter Counter (Beckman Coulter). An isolate survived if its cell density measurements were maintained over the course of the test while allowing for fluctuations of +/− 1×106 cells.
-
bioRxiv - Cell Biology 2020Quote: ... and ultracentrifuged with a 70 Ti rotor (Beckman Coulter; 50,000 rpm, 75 min, 4°C). Supernatants after ultracentrifugation were mixed with COSMOGEL GST-Accept beads (Nacalai Tesque ...
-
bioRxiv - Molecular Biology 2021Quote: ... at 40000 rpm for 30 min at 4°C with a Ti45 rotor (Beckman, USA). Mpro-containing supernatant was applied to an immobilized metal affinity chromatography (IMAC ...
-
bioRxiv - Neuroscience 2021Quote: ... S1 was centrifuged at 30,000 rpm for 30 min at 4°C (Beckman S4180 rotor). The obtained pellet (P2 ...
-
bioRxiv - Biochemistry 2019Quote: ... After ultra-centrifugation (SW-60Ti rotor Beckman Coulter, 2 h, 100 000 rpm, 4°C) the gradient was manually fractioned in 200 μl fractions from the top to the bottom of the tube ...
-
bioRxiv - Biochemistry 2020Quote: ... the filtered cell culture fluid was ultracentrifuged (25k rpm, 4 °C, SW55Ti Rotor, Beckman Coulter) through a 20% sucrose cushion prepared in TNE buffer (10 mM Tris-HCl ...
-
bioRxiv - Biochemistry 2021Quote: ... and concentrated by ultracentrifugation (100,000 × g, 90 min 4 °C, SW41, Beckman Coulter, Brea, CA). The pellet was resuspended in reducing Laemmli SDS-PAGE sample buffer ...
-
bioRxiv - Biophysics 2021Quote: ... Cell debris was removed by centrifugation (Beckman Avanti, 45 min, 40,000 x g, 4 °C) and supernatants were diluted 3-fold in 20 mM Tris pH 8.0 ...
-
bioRxiv - Cell Biology 2020Quote: ... and ultracentrifuged with a 70 Ti rotor (Beckman Coulter; 50,000 rpm, 75 min, 4°C). The supernatants were mixed with COSMOGEL GST-Accept beads (Nacalai Tesque ...
-
bioRxiv - Bioengineering 2022Quote: ... samples (10 mL) were first centrifuged at 7000Xg at 4°C for 30 minutes (Beckman Coulter Avanti J-E Series ...
-
bioRxiv - Biochemistry 2021Quote: ... The bacterial culture was centrifuged at 4,000 × g for 15 min at 4°C (Beckman) and the cell pellet was resuspended in 30-40 mL of lysis buffer (50 mM HEPES pH 8.0 ...
-
bioRxiv - Cell Biology 2019Quote: ... and ultracentrifuged with a 70 Ti rotor (Beckman Coulter; 50,000 rpm, 75 min, 4°C). The supernatants obtained (around 40 ml each ...
-
bioRxiv - Biochemistry 2019Quote: ... All measurements were performed at 37°C by connecting the fluorimeter (DU 640 Spektrometer, Beckman) to a water bath ...
-
bioRxiv - Physiology 2019Quote: ... and spun at 100,000xg for 20m at 4°C in Optima Max ultracentrifuge (Beckman Coulter). Tubes were carefully removed from the ultracentrifuge with forceps and 30 uL of supernatant was removed to a PCR tube with every care taken to avoid the protein pellet ...
-
bioRxiv - Cancer Biology 2019Quote: ... held at 4 °C) and then cleaned up with the SPRIselect Reagent Kit (Beckman Coulter). A qualitative analysis on the amplified cDNA was performed using Agilent Bioanalyzer high sensitivity chip.
-
bioRxiv - Neuroscience 2021Quote: ... at 25000 rpm (SW28, 4°C) in an 80K ultracentrifuge (Beckman Coulter; Brea, California, USA). After centrifugation ...
-
bioRxiv - Cell Biology 2020Quote: ... for 1 h at 37°C before purification with 42 μl AMPure beads (Beckman Coulter). The sample was eluted in 20 μl water which served as input for sequencing library generation ...
-
bioRxiv - Genetics 2019Quote: ... at 20°C for 16 hours at 45,000 rpm in a VTi 65 rotor (Beckman). Ethidium bromide was extracted from the CsCl banded DNA using water-saturated n-butanol ...
-
bioRxiv - Immunology 2020Quote: ... at 5,000 g for 30 minutes at 4°C and subsequently at 10,000 g (Beckman Coulter Optima L-90K with a SW40Ti rotor) ...
-
bioRxiv - Biophysics 2021Quote: ... 2mM MgCl) centrifuged for 16 hours at 35k rpm at 4 °C (Beckman TLS-55). 80S ribosome was found to have formed a pellet at the bottom of the tube and was resuspended in 20mM HEPES pH 7.9 ...
-
bioRxiv - Neuroscience 2020Quote: ... The gradients were ultracentrifuged for 2.5 hours (4°C) in a SW41Ti rotor (Beckman Coulter) at 35000 rpm ...
-
bioRxiv - Immunology 2021Quote: ... at 23,000 rpm for 2,5h at 4°C in sterile Ultra-clear centrifuge tubes (Beckman) using an SW28 swinging bucket rotor (Beckman) ...
-
bioRxiv - Immunology 2021Quote: ... After overnight centrifugation (at 4 °C) at 100,000×g (Beckman Coulter Optima L-90 ultracentrifuge) collected 2 mL fractions were analysed by SDS-PAGE ...
-
bioRxiv - Plant Biology 2022Quote: ... 0.1 mM AEBSF) and centrifuged (270000 g, 90 min, 4°C, TLA 100.3, Beckman Coulter). The pellet was solubilized in sample buffer and subsequently applied to SDS-PAGE and Western blot analyses.
-
bioRxiv - Microbiology 2022Quote: ... then centrifuged at 175 000 g at 4°C overnight in a Sw55TI rotor (Beckman). For labelled VLPs ...
-
bioRxiv - Biochemistry 2022Quote: ... followed by ultracentrifugation at 18,000g for 35 min at 4 °C (Optima XPN, Beckman Coulter). The clarified supernatant was loaded through a sample pump of an NGC Quest 10 Chromatography System (Bio-Rad Laboratories ...
-
bioRxiv - Developmental Biology 2023Quote: ... and centrifuged at 40,000 rpm for 1 h at 4°C (Beckman SW-41Ti rotor). Supernatants were discarded ...
-
bioRxiv - Genomics 2023Quote: ... and Hi-C template DNA was purified using 1x AMPure XP beads (Beckman Coulter, A63881) and stored at 4°C until library preparation ...
-
bioRxiv - Microbiology 2023Quote: ... Supernatants were ultracentrifuged at 200,000 xg for 45 min at 4°C (TI45 Beckman rotor). Total membrane pellet was resuspended in 500 µL of buffer B (10 mM Tris-HCl pH 7.4 ...
-
bioRxiv - Biochemistry 2023Quote: ... The supernatant was collected after centrifugation at 4 °C and 4000 × g (Beckman Coulter, USA) for 30 min ...
-
bioRxiv - Immunology 2023Quote: ... at 950 rpm for 10 min at 20°C and centrifuged at 15,000 rpm (Beckman Coulter Microfuge® 22R refrigerated microcentrifuge ...
-
bioRxiv - Molecular Biology 2023Quote: ... 4 °C using the swing- out rotor TLS-55 on an Optima Max (Beckman Coulter) ultracentrifuge ...
-
bioRxiv - Molecular Biology 2023Quote: ... 4 °C using the fixed-angle rotor TLA-120.2 on an Optima TLX (Beckman Coulter) ultracentrifuge ...
-
bioRxiv - Molecular Biology 2023Quote: ... 4 °C using the fixed-angle rotor TLA-120.2 on an Optima TLX (Beckman Coulter) ultracentrifuge ...
-
bioRxiv - Molecular Biology 2023Quote: ... 4 °C using the swing-out rotor SW32 on an Optima L-90K (Beckman Coulter) ultracentrifuge ...
-
bioRxiv - Cell Biology 2023Quote: ... Upon centrifugation for 30 min at 4 °C (96,000 g, Rotor TLA-100, Beckman Coulter), the resulting supernatant yields soluble glycosomal matrix proteins while the pellet contains membrane-associated proteins ...
-
bioRxiv - Neuroscience 2024Quote: ... and centrifuged at 28,000rpm for 2h at 4 °C in a SW 41 rotor (Beckman). The virus pellet was resuspended in 60μL of PBS ...
-
bioRxiv - Biochemistry 2023Quote: ... followed by centrifugation at ∼28500g for 1h at 4°C (Beckman Coulter centrifuge, JA-14) in order to remove cell debris ...
-
bioRxiv - Cell Biology 2023Quote: ... The lysate was centrifuged at 4 °C for 15 min in a TLA55 rotor (Beckman) at 50,000 rpm to remove insoluble material ...
-
bioRxiv - Genetics 2023Quote: ... The gradients were sedimented at 35,000 rpm at 4°C in a SW41 rotor (Beckman) for 2 h 40 min ...