Labshake search
Citations for Ted Pella :
1 - 50 of 76 citations for Semicarbazide Hydrochloride Sem 13C 99%; 15N2 98% 100 Ug Ml In Methanol since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Cancer Biology 2019Quote: ... Chips are mounted to standard 12 mm SEM stubs with carbon tape for SEM viewing (Ted Pella, Inc. ...
-
bioRxiv - Microbiology 2021Quote: ... mounted onto 12mm aluminum SEM stubs (Ted Pella) with silver epoxy (Chemtronics) ...
-
bioRxiv - Cell Biology 2020Quote: SEM Specimen Stubs (12.7 mm, Ted Pella, 16111)
-
bioRxiv - Microbiology 2021Quote: ... and adhered to SEM pin mounts (16144, TED PELLA, Redding, CA) using carbon tape (16084-3 ...
-
bioRxiv - Cancer Biology 2019Quote: Samples selected for SBF-SEM are mounted on Microtome stub SEM pins (Agar Scientific, cat# 61092450) using conductive silver epoxy (Ted Pella, Inc., H2OE EPO-TEK® cat# 16014) and trimmed using a Diatome trim90 diamond knife to generate a 500×500 µm2 pillar with the block face parallel to the stub ...
-
bioRxiv - Bioengineering 2021Quote: ... Silicon wafers for scanning electron microscopy (SEM) were purchased from Ted Pella, Inc ...
-
bioRxiv - Microbiology 2023Quote: ... Specimens were mounted to clean SEM stubs using double-sided conductive tape (Ted Pella), and then coated with 12 nm platinum/palladium using a Cressington 208HR sputter coater (Ted Pella).
-
bioRxiv - Neuroscience 2020Quote: ... Tissue blocks were mounted onto standard 12.5-mm flat SEM stubs (Ted Pella, Cat#16111) using Leitsilber 200 silver paint (Ted Pella ...
-
bioRxiv - Cell Biology 2021Quote: ... the blocks were mounted on a SEM stub using silver conductive epoxy resin (Ted Pella). In case the block was later to be imaged again at the confocal to identify a second target ...
-
bioRxiv - Cell Biology 2022Quote: ... the blocks were mounted on a SEM stub using silver conductive epoxy resin (Ted Pella). After mounting ...
-
bioRxiv - Bioengineering 2022Quote: ... UEAs were air dried for 1 hour prior to affixation to SEM stubs (16111, Ted Pella, Redding, CA) with carbon tape (16073 ...
-
bioRxiv - Neuroscience 2020Quote: ... The specimen was removed from the Aclar and mounted to an aluminum scanning electron microscope (SEM) rivet with conductive silver epoxy (Ted Pella) with the exposed tissue face in contact with silver epoxy ...
-
bioRxiv - Cancer Biology 2021Quote: ... Organoids in 0.3 mL of HMDS were aspirated using a transfer pipette and the solution and suspended organoids were deposited to 12 mm diameter SEM stubs coated with carbon adhesive tabs (Ted Pella Inc) and allowed to air dry ...
-
bioRxiv - Microbiology 2023Quote: Sorted trichomonads or cecum from mono-colonized mice were prepared for scanning electron microscopy (SEM) via a Biowave microwave-assisted (Ted Pella, Inc.) protocol as described in (Jackson et al ...
-
bioRxiv - Microbiology 2022Quote: The cells of interest were located in the polymerized resin block, trimmed and attached to pre-tilt 45° SEM stubs (Agar Scientific, Stansted, UK) using colloidal silver paint (Ted Pella, Redding, CA), sputter-coated with platinum and subjected to FIB/SEM tomography ...
-
bioRxiv - Cell Biology 2020Quote: ... and 100 μg/ml streptomycin on 15mm round coverglass (Ted Pella, Inc., Redding, CA). Pipettes were manufactured by pulling 100 μL capillary tubes (VWR ...
-
bioRxiv - Genetics 2023Quote: ... pollen grains were collected by rubbing anthers on conductive adhesive carbon tape attached to SEM pin stubs (Ted Pella, Inc Product #16084-1 and #16111). Samples were then sputter coated with gold or platinum in a Denton Desk V coater and transferred to a Zeiss Crossbeam 540 field emission SEM ...
-
bioRxiv - Cell Biology 2020Quote: Cells grown on coverslips were fixed with cold methanol for 8 min at −20°C or 4% formaldehyde (Ted Pella, Inc.) for 15 min at room temperature ...
-
bioRxiv - Genetics 2022Quote: ... embryos obtained from bleached adults were spun down at 1,000 x g for 2 minutes in a 1.5 mL Eppendorf tube and resuspended in 500 µL of fixative solution containing 50% methanol (Fisher Chemical, A412SK-4) and 2% para-formaldehyde (Ted Pella, Inc., Cat # 18505) in 1X PBS buffer ...
-
bioRxiv - Cancer Biology 2024Quote: ... Grids (Ted Pella, cat. 658-300-CU-100) followed by glow discharging ...
-
bioRxiv - Genetics 2021Quote: ... and 100%), and embedded in epoxy resin through increasing concentrations (25, 50, 75, and 100%) using PELCO Biowave+ tissue processor (Ted Pella, USA), and then cured at 60°C for three days ...
-
bioRxiv - Cell Biology 2021Quote: ... Dehydration of cells was followed by clearing with propylene oxide and infiltration with the combination of 100% propylene oxide and 100% spur low viscosity resin (TED PELLA.INC, USA).
-
bioRxiv - Cell Biology 2022Quote: ... Dehydration of cells was followed by clearing with propylene oxide and infiltration with a combination of 100% propylene oxide and 100% Spurr low-viscosity resin (TED PELLA.INC, USA). Finally ...
-
bioRxiv - Bioengineering 2023Quote: ... 1.2/1.3 Quantifoil grids (Ted Pella inc., 658-200-CU-100) were glow discharged using PELCO easiGlow™ for 30 s ...
-
bioRxiv - Biochemistry 2023Quote: ... and blotted using standard Vitrobot filter paper (Ted Pella, 47000-100) on both sides for 4 seconds using a Vitrobot Mark IV (Thermo Fisher Scientific ...
-
bioRxiv - Cell Biology 2020Quote: ... Samples were embedded with 100% Epon resin in BEEM capsules (Ted Pella) for 48 hours at 60°C ...
-
bioRxiv - Biochemistry 2022Quote: ... Filter paper was used for blotting (Prod No. 47000-100, Ted Pella, INC.).
-
bioRxiv - Biophysics 2021Quote: ... and blotted for 1 second using standard Vitrobot filter paper (Ted Pella, 47000-100) before plunge freezing in liquid ethane.
-
bioRxiv - Neuroscience 2021Quote: ... sapphire disks were embedded into 100% epon-araldite resin (Ted Pella #18005, 18060, 18022) with the following schedule and conditions ...
-
bioRxiv - Neuroscience 2019Quote: ... infiltrated in graded resin (33%, 66%, and 100%; Eponate-12; Ted Pella, Redding, CA) diluted in propylene oxide ...
-
bioRxiv - Neuroscience 2023Quote: ... then 2 parts 100% propylene oxide per 1 part Eponate 12 resin (Ted Pella) for an 1 h ...
-
bioRxiv - Bioengineering 2020Quote: ... 100 µM micelle solutions in water were placed on carbon grids (Ted Pella, Redding, CA) and stained with 2 wt% uranyl acetate ...
-
bioRxiv - Plant Biology 2023Quote: ... Cross-sections (50-100 μm thickness) generated by Vibratome MicroSlicers DTK-1000 (Ted Pella, USA) and stored in fixation solution ...
-
bioRxiv - Neuroscience 2024Quote: ... dehydration through graded alcohol and 100% acetone and embedment in Eponate (Ted Pella, Redding, CA). After at least 24 hours of polymerization at 56°C ...
-
bioRxiv - Cell Biology 2023Quote: ... BDMA 0.8 ml) (Epon-Araldite kit, Ted Pella, 18028) and 30% ...
-
bioRxiv - Biochemistry 2022Quote: ... 100 mM glycine to glow-discharged C-flat CF-2/2 C-T-grids (TED PELLA).
-
bioRxiv - Microbiology 2022Quote: ... after blotting at room temperature and 100% humidity for 3s with Grade 595 filter paper (Ted Pella).
-
bioRxiv - Biophysics 2023Quote: ... The excess liquid was blotted for 4 sec using filter paper 595 (Ted Pella, Prod # 47000-100) at blot force 3 ...
-
bioRxiv - Molecular Biology 2023Quote: ... the tissue was infiltrated and embedded in 100% eponate 12 resin (Ted Pella, Inc., Redding, CA, USA). Polymerization was performed at 60 °C for 24 h ...
-
bioRxiv - Biophysics 2023Quote: ... The excess liquid was blotted for 4 sec using filter paper 595 (Ted Pella, Prod # 47000-100) at blot force 4 ...
-
bioRxiv - Biochemistry 2021Quote: ... at 4°C and 100% humidity (blot 10 s, blot force 3, 595 filter paper (Ted Pella Inc.)) ...
-
bioRxiv - Immunology 2021Quote: ... at 4°C and 100% humidity (blot 10 s, blot force 3, 595 filter papers (Ted Pella Inc.)) ...
-
bioRxiv - Pathology 2023Quote: ... Tissue was cut with the vibratome set to 100 μm sections using sapphire blade (Ted Pella, Redding, CA, USA), maximum amplitude ...
-
bioRxiv - Cell Biology 2020Quote: ... 100%) followed by propylene oxide (each step was for 15 min) and embedded in Eponate 12 (Ted Pella, Redding, CA). Ultrathin sections (80 nm ...
-
bioRxiv - Neuroscience 2023Quote: ... then incubated in a secondary goat anti-rabbit antibody conjugated to 10-nm colloidal gold (Ted Pella, diluted 1:100) for 30 min at room temperature ...
-
bioRxiv - Biophysics 2024Quote: ... grids (Quantifoil R1.2/1.3, Cu 200 mesh, 100 holey carbon films, 2 nm carbon support film; for images of DCVs: Ted Pella, Cu 400 mesh ...
-
bioRxiv - Biophysics 2021Quote: ... The filaments were flowed in chambers made by sandwiching a 100 µm thick double backed tape (Ted Pella Inc., CA, USA) between a glass slide and coverslips #1.5 of 0.17 mm thickness (VWR ...
-
bioRxiv - Cell Biology 2019Quote: ... 95% for 10 min and 100% for 30 min with 3 changes) and infiltrated with Epon-Aradite (Ted Pella, Redding, CA) for 2 days (25% of Epon-Aradite and ethanol for 2h ...
-
bioRxiv - Neuroscience 2023Quote: ... at room temperature for 10 min before proceeding for dehydration (70%, 95%, 100% ethanol, xylene twice) and coverslipping with Mount-Quick (Ted Pella).
-
bioRxiv - Immunology 2021Quote: ... at 20°C at 100% humidity on C-flat (Protochips, Morrisville NC) 1.2/1.3 grids with 80s easyGlow (Ted Pella Inc, Redding CA) glow discharge ...