Labshake search
Citations for Ted Pella :
1 - 50 of 62 citations for IL 10 Human since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Molecular Biology 2020Quote: ... a 10×5mm Aclar slab (Ted Pella cat.#10501-10) was deposited in wells to which cells adhered after standard incubation ...
-
bioRxiv - Neuroscience 2023Quote: ... and incubated in secondary antibodies (1:10 10 nm gold-conjugated IgG, TED Pella, 15796) for 1 h at room temperature and rinsed with PBST followed by water ...
-
bioRxiv - Synthetic Biology 2021Quote: ... 10 mm diameter (Ted Pella, Inc), by placing a 70 μL seed density of 2.26 × 109 cells/mL in deionized water ...
-
bioRxiv - Cell Biology 2021Quote: ... 10 nm gold fiducial markers (Ted Pella) coated in 1% BSA were diluted 1:4 or 5 in conditioned culture media and 3μl of this mixture was added on top of each grid ...
-
bioRxiv - Immunology 2021Quote: ... Grids were rinsed (4x 10’) with PBS then labeled for 2 hrs with 10 nm gold conjugated goat anti-mouse secondary antibody (Ted Pella, Inc.). Grids were again rinsed (4x 10’ ...
-
bioRxiv - Cell Biology 2020Quote: ... 10 minutes in 4% paraformaldehyde (Ted Pella, Redding, CA) in 1x PBS ...
-
bioRxiv - Microbiology 2022Quote: ... 10 nm colloidal gold fiducials (Ted Pella, Redding, USA) were added to the suspension (for alignment during tomogram reconstruction from tilt series) ...
-
bioRxiv - Biochemistry 2022Quote: ... 10 mA and 0.39 mBar pressure (PELCO easiGlow, Ted Pella). Grids were incubated for 1 minute with 6 μL sample ...
-
bioRxiv - Bioengineering 2023Quote: ... Gel biopsy punches (1 mm diameter, #15110-10, Ted Pella) centered at each tumoroid were collected and the matrix between cells lysed with Liberase (5 mg mL-1 ...
-
bioRxiv - Neuroscience 2023Quote: ... PLL-coated aclar film (Ted Pella, Inc., Cat.: # 10501-10) was used for the transmission electron microscopy (TEM ...
-
bioRxiv - Bioengineering 2020Quote: Monodispersed SWCNT nanosensors in the presence and absence of neutravidin were analyzed with atomic force microscopy using an Asylum Research MFP-3D AFM and TAP150AL-G-10 Silicon AFM probes (Ted Pella, tip radius < 10 nm). For the addition of neutravidin ...
-
bioRxiv - Neuroscience 2020Quote: ... TAP300 Aluminum reflex coating (Ted Pella, Inc. Cat# TAP300AL-G-10) at ~300 kHz resonant frequency and ~40 N/m force constant in the tapping mode.
-
bioRxiv - Neuroscience 2023Quote: ... and then embedded between flat Aclar sheets (Ted Pella #10501-10). Samples were put in a laboratory oven for at least 48 hours at 65°C for the resin to polymerize ...
-
bioRxiv - Plant Biology 2022Quote: ... and gold particles (6 nm, 10 nm) conjugated secondary antibodies (Ted Pella). Sections were post-stained and examined with a Hitachi 7400 TEM (Hitachi-High Technologies ...
-
bioRxiv - Microbiology 2022Quote: ... in vitro grown differentiated polarized monolayers of human ileal enteroid samples as well as mouse intestinal biopsy samples were fixed in 2% paraformaldehyde/2.5% glutaraldehyde (Ted Pella, Inc., Redding, CA) in 100 mM sodium cacodylate buffer ...
-
bioRxiv - Neuroscience 2019Quote: ... The grids were coated with 10 nm colloidal gold (Ted Pella, Redding, CA) and imaged at 300 keV on a Titan TEM (FEI ...
-
bioRxiv - Microbiology 2019Quote: ... we pipetted 10 μL of the sacculi onto freshly cleaved mica (Ted Pella), dried the mica under nitrogen gas ...
-
bioRxiv - Neuroscience 2020Quote: ... Then incubated with 10 nm immunogold-conjugated secondary antibodies (Ted Pella, Redding, CA) in 1% NGS in TBST with 0.5% polyethylene glycol (20,000 MW) ...
-
bioRxiv - Neuroscience 2020Quote: ... coated #0 coverslips (0.08-0.13mm thick and 10 mm diameter; Ted Pella, USA) at 70% confluency ...
-
bioRxiv - Biochemistry 2021Quote: ... incubated with 1:20 10 nm gold-anti-mouse antibody (Ted Pella 15751), washed ...
-
bioRxiv - Microbiology 2021Quote: All coverslips were fixed for 10 min in fresh 4% paraformaldehyde (Ted Pella, 18505) at room temperature ...
-
bioRxiv - Biophysics 2021Quote: ... or 10 s in a PELCO easiGlow glow discharge cleaning system (Ted Pella Inc.). The protein mixtures (4.8 μL ...
-
bioRxiv - Genetics 2020Quote: Cells were replated onto matrigel-coated 1cm x 5mm Aclar (Ted Pella, #10501-10). After 5 days of recovery ...
-
bioRxiv - Developmental Biology 2023Quote: ... 3×10 minutes and dehydrated using a Pelco BioWave Pro Microwave (Ted Pella, Inc.) as follows ...
-
bioRxiv - Neuroscience 2024Quote: ... coated #0 coverslips (0.08-0.13 mm thick and 10 mm diameter; Ted Pella, USA) at 70% confluency ...
-
bioRxiv - Neuroscience 2020Quote: ... 10 μl of sample were adsorbed onto carbon-coated 300-mesh copper grids (Ted Pella) and negatively stained for 30 s ...
-
bioRxiv - Biophysics 2023Quote: ... The effective tip size was calibrated with 10 nm gold nanoparticles (Ted Pella, Redding, CA) using our previously reported protocol2 ...
-
bioRxiv - Cell Biology 2023Quote: ... then incubated for 20 seconds with 20% 10 nm gold fiducials (Ted Pella#15703-20) + 0.05% BSA in water ...
-
bioRxiv - Biochemistry 2022Quote: ... was glow discharged at 10 mA for 30 seconds using a PELCO easiGlow from Ted Pella. Then 2 μl of 80 μg/μl GS solution (in TBS buffer ...
-
bioRxiv - Biochemistry 2022Quote: ... were glow discharged for 30 seconds at 10 mA using the PELCO system (Ted Pella, USA). Grids were prepared by applying a 2 μl protein sample to the glow-discharged grid ...
-
bioRxiv - Animal Behavior and Cognition 2024Quote: ... Then slices were infiltrated with Durcupan resin and flat embedded between Aclar sheets (Ted Pella #10501-10). Next Aclar layers were separated from the resin embedded samples ...
-
bioRxiv - Immunology 2023Quote: Protein nanoparticles (0.1 mg/mL, 10 µL) were pipetted onto a carbon-coated copper grid (Ted Pella) and incubated for five min ...
-
bioRxiv - Biochemistry 2021Quote: ... at 4°C and 100% humidity (blot 10 s, blot force 3, 595 filter paper (Ted Pella Inc.)) ...
-
bioRxiv - Microbiology 2020Quote: ... The cell suspension was then mixed with 10‐nm colloidal gold beads (Ted Pella, Inc., Redding, CA, USA) pre-coated with 5% (w/v ...
-
bioRxiv - Neuroscience 2021Quote: ... Sections were glow discharged and coated by dipping grid briefly in 10 nm colloidal gold solution (Ted Pella). Serial tomo-graphic reconstructions were generated of parallel fiber - Purkinje cell synapses using an FEI Titan 300 kV TEM equipped with a 4k x 4k CCD camera (Gatan Ultrascan) ...
-
bioRxiv - Immunology 2021Quote: ... at 4°C and 100% humidity (blot 10 s, blot force 3, 595 filter papers (Ted Pella Inc.)) ...
-
bioRxiv - Molecular Biology 2023Quote: ... were glow-discharged for 8 s at 10 mA using a PELCO easiGlow glow discharging system (Ted Pella) and loaded into the EM GP2 chamber ...
-
bioRxiv - Neuroscience 2020Quote: A 10 μL aliquot of each sample was added to formvar stabilized with carbon copper grids (Ted Pella, Inc.) for 2 minutes ...
-
bioRxiv - Biophysics 2021Quote: AFM slides were prepared by affixing 10-mm-diameter ruby muscovite mica slides (Ted Pella grade V1; Redding, CA) to metallic disks ...
-
bioRxiv - Neuroscience 2021Quote: ... 400 mesh copper grids covered by a Formvar/Carbon film (5-10 nm) were obtained from Ted Pella (Redding, CA) and 2% aqueous uranyl acetate was purchased from Electron Microscopy Sciences (Hatfield ...
-
bioRxiv - Biophysics 2021Quote: ... and glow discharged for 1 min at 10 mA with the chamber pressure set at 0.30 mBar (PELCO easiGlow; Ted Pella). The grids were mounted in the sample chamber of a Leica EM GP set at 8C and 95% relative humidity ...
-
bioRxiv - Immunology 2022Quote: ... for 10 s or were plasma discharged for 25 s at 15 mA using a PELCO easiGlow (Ted Pella Inc.). Right before applying the protein samples to the grids ...
-
bioRxiv - Microbiology 2022Quote: ... 10 μL of each of the EVs samples were dropped in 200 mesh formvar-carbon copper grids (Ted Pella, Inc) and were let stand for 1 min ...
-
bioRxiv - Neuroscience 2023Quote: ... then incubated in a secondary goat anti-rabbit antibody conjugated to 10-nm colloidal gold (Ted Pella, diluted 1:100) for 30 min at room temperature ...
-
bioRxiv - Biochemistry 2023Quote: ... The grids were then glow discharged on a PELCO easiGlow for 20-45 s at 10-25 mA (Ted Pella) (negative polarity) ...
-
bioRxiv - Cell Biology 2019Quote: ... 95% for 10 min and 100% for 30 min with 3 changes) and infiltrated with Epon-Aradite (Ted Pella, Redding, CA) for 2 days (25% of Epon-Aradite and ethanol for 2h ...
-
bioRxiv - Biophysics 2021Quote: ... where 50 μL of the diluted sample was deposited and allowed to incubate for 20 seconds on freshly cleaved mica (Highest Grade V1 AFM Mica Discs, 10 mm, Ted Pella). The excess unbound proteins were removed by rinsing with ultra-pure water ...
-
bioRxiv - Biophysics 2021Quote: ... where 50 μL of the diluted sample was deposited and allowed to incubate for 20 seconds on freshly cleaved mica (Highest Grade V1 AFM Mica Discs, 10 mm, Ted Pella). The excess unbound proteins were removed by rinsing with ultra-pure water ...
-
bioRxiv - Molecular Biology 2022Quote: ... was spotted on a Quantifoil R2/2 200 Mesh holey carbon grids which were glow discharged for 10s using the PELCO easiGlow system (Ted Pella). Grids were flash-frozen in liquid ethane using Vitrobot Mark IV (FEI ...
-
bioRxiv - Neuroscience 2023Quote: ... at room temperature for 10 min before proceeding for dehydration (70%, 95%, 100% ethanol, xylene twice) and coverslipping with Mount-Quick (Ted Pella).