Labshake search
Citations for Ted Pella :
1 - 50 of 155 citations for Human Cytochrome P450 Family 4 Subfamily F Member 2 CYP4F2 ELISA Kit since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Biophysics 2024Quote: ... 400 mesh electron microscopy grids (01754-F F/C, Ted Pella, Redding CA) for 1 minute ...
-
bioRxiv - Bioengineering 2024Quote: ... Copper (Ted Pella, cat# 01802-F), Carbon Type-B ...
-
bioRxiv - Cell Biology 2023Quote: ... The replica was rinsed with water and lifted with a 4 mm circular loop onto a formvar/carbon coated 75-mesh copper grid (Ted Pella 01802-F). The grid was again imaged with 20x phase contrast light microscopy to confirm that replica transfer went smoothly and identify the area of interest on the grid ...
-
bioRxiv - Developmental Biology 2022Quote: ... Rectangles of silicon wafer approximately 2×4 cm (Ted Pella, No 16015) were cut from the round plate glow discharged ...
-
bioRxiv - Neuroscience 2022Quote: ... post-fixed for 2 h in 4% PFA at 4°C and immediately sectioned in coronal slices (50 μm) using a vibratome (Ted Pella). Coronal sections were incubated with 10 mM sodium citrate (pH 6.0 ...
-
bioRxiv - Biochemistry 2023Quote: Carbon copper formvar grids (Ted Pella 01754-F) were glow discharged using a Gloqube Plus (Quorum ...
-
bioRxiv - Biochemistry 2021Quote: The EM grid was prepared by depositing particles on the Carbon-Formvar grid (01754-F F/C 400 mesh Cu from Ted Pella) activated by 30 seconds of glow discharge ...
-
bioRxiv - Biophysics 2022Quote: ... to make the surface of the support grids for electron microscopy covered with a film of amorphous carbon (01843-F / 01844-F, Ted Pella) hydrophilic ...
-
bioRxiv - Microbiology 2021Quote: ... For standard lacey carbon grids (Ted Pella #01895-F), SARS-CoV-2 spike was prepared at 1 mg/mL in TBS (30mM Tris pH 8 ...
-
bioRxiv - Cell Biology 2023Quote: Grids covered with an amorphous carbon film (01843-F, Ted Pella) were glow discharged for 15 mA and 45 sec using PELOCO easiGlow ...
-
bioRxiv - Cell Biology 2023Quote: ... and placed on 200-mesh copper finder grids (01910-F, Ted Pella). Regions of interest (ROIs ...
-
bioRxiv - Neuroscience 2023Quote: ... Samples were immersed in Karnovsky’s fix (2% glutaraldehyde, 4% PFA in 0.1M sodium cacodylate, pH 7.4) and microwaved (PELCO BioWave processing - Ted Pella) for at 100 W for 1 min ...
-
bioRxiv - Neuroscience 2022Quote: ... 400 mesh formvar/carbon film-coated copper grids (#01754-F; Ted Pella Inc) for 5 minutes and washed three times with PBS and blocked for 10 min with 5% acetylated BSA (Aurion) ...
-
bioRxiv - Microbiology 2022Quote: ... in vitro grown differentiated polarized monolayers of human ileal enteroid samples as well as mouse intestinal biopsy samples were fixed in 2% paraformaldehyde/2.5% glutaraldehyde (Ted Pella, Inc., Redding, CA) in 100 mM sodium cacodylate buffer ...
-
bioRxiv - Cell Biology 2021Quote: ... ultrathin sections collected on formvar/carbon-coated slot grids (Ted Pella Inc., 01805-F) and post-contrasted with Uranyl Acetate and Lead Citrate ...
-
bioRxiv - Genetics 2022Quote: ... embryos obtained from bleached adults were spun down at 1,000 x g for 2 minutes in a 1.5 mL Eppendorf tube and resuspended in 500 µL of fixative solution containing 50% methanol (Fisher Chemical, A412SK-4) and 2% para-formaldehyde (Ted Pella, Inc., Cat # 18505) in 1X PBS buffer ...
-
bioRxiv - Microbiology 2022Quote: ... Both samples were identically prepared on formvar/carbon film 200 mesh copper grids (Ted Pella 01803-F). First ...
-
bioRxiv - Microbiology 2021Quote: ... The purified OmRV/IC particles were loaded onto a glow-charged carbon-coated grid (TED PELLA, 01753-F) and were negatively stained using gadolinium salts ...
-
bioRxiv - Cell Biology 2022Quote: ... The replicas were lifted and placed onto Formvar/carbon-coated 75-mesh copper TEM grids (Ted Pella, 01802-F) that were freshly glow-discharged with PELCO easiGlow 91000 ...
-
bioRxiv - Cell Biology 2020Quote: ... The replicas were lifted and placed onto Formvar/carbon-coated 75-mesh copper TEM grids (Ted Pella 01802-F) that were freshly glow-discharged ...
-
bioRxiv - Microbiology 2021Quote: Unfixed cells (3µL) were spotted onto glow discharged carbon-coated 200 mesh copper grids with pinpointer grid (Ted Pella 01841-F) for 45 seconds ...
-
bioRxiv - Biochemistry 2023Quote: 3 μl of purified sample of each F constructs was applied to a glow discharged 300 mesh copper grids (Ted Pella) coved with evaporated continuous carbon on top of collodion (Electron Microscope Science ...
-
bioRxiv - Cancer Biology 2023Quote: ... 10 μL of no-click Trast or click Trast-TCO/Trast-Tz samples (5 μg/mL in mQ water) were absorbed for 60 seconds onto carbon-coated 200-mesh copper grids (01840-F, Ted Pella), which had been glow-discharged for 30 seconds in a Solarus 950 plasma cleaner (Gatan) ...
-
bioRxiv - Microbiology 2024Quote: ... protein sample was applied on a freshly glow discharged carbon coated 400 mesh copper grid (Ted Pella Inc., cat. #01754-F) and subsequently blotted off on filter paper ...
-
bioRxiv - Developmental Biology 2021Quote: ... glass slides (4’’ by 3’’; Ted Pella) and the feature-side of the PDMS slabs were thoroughly cleaned with tape to remove any dust particles ...
-
bioRxiv - Neuroscience 2020Quote: ... brains were placed in 2 x 2 x 2 inch plastic blocks filled with cryo-embedding compound (Ted Pella Inc., Redding, CA). Brains were sectioned coronally at 40 microns and sections were stored in cryoprotectant solution (30 % sucrose ...
-
bioRxiv - Neuroscience 2020Quote: ... 3.5 μL of 3% diluted rAAV empty capsid stock or positive control using viral stock of known concentration (AAV1-CAG-flexGFP) was applied to plasma etched carbon film on 200 mesh copper grids (Ted Pella, 01840-F), 4 grids per stock ...
-
bioRxiv - Cell Biology 2020Quote: ... The replicas were separated from glass coverslips using hydrofluoric acid and mounted on glow-discharged Formvar/carbon-coated 75-mesh copper TEM grids (Ted Pella 01802-F).
-
bioRxiv - Biochemistry 2022Quote: The negative stain samples for TEM analysis were prepared in the following way: 300 mesh copper grids (Ted Pella, Prod No. 01813-F) were glow discharged to enhance hydrophilicity of their surface ...
-
bioRxiv - Molecular Biology 2024Quote: ... Five microliters of fixed EVs were deposited onto glow discharged (60 secs 15 mA, negative mode) carbon formvar 400 Mesh copper grids (Ted Pella 01822-F) for 3 min ...
-
bioRxiv - Cell Biology 2021Quote: Cells were fixed with 4% paraformaldehyde (Ted Pella) in 100 mM sucrose for 20 min ...
-
bioRxiv - Neuroscience 2024Quote: ... and 4% Paraformaldehyde (PFA) (Ted Pella, Inc., USA), consecutively for immunostaining experiments ...
-
bioRxiv - Neuroscience 2024Quote: ... and 4% Paraformaldehyde (PFA) (Ted Pella, Inc., USA), consecutively for immunostaining experiments ...
-
bioRxiv - Cell Biology 2021Quote: ... and SEC fractions were fixed with an equal volume of 2x Karnovsky fixative (0.2M Na cacodylate, 4% paraformaldehyde and 4% glutaraldehyde)(Ted Pella Inc.), mixed gently and incubated on ice for 30 min ...
-
bioRxiv - Neuroscience 2020Quote: Negatively stained specimens for TEM were prepared by applying 5 μL of protein sample to hydrophilic 400 mesh carbon-coated Formvar support films mounted on copper grids (Ted Pella, Inc., 01702-F). Samples were allowed to adhere for 4 min ...
-
bioRxiv - Biochemistry 2022Quote: ... 100 mM glycine to glow-discharged C-flat CF-2/2 C-T-grids (TED PELLA).
-
bioRxiv - Cell Biology 2020Quote: ... 10 minutes in 4% paraformaldehyde (Ted Pella, Redding, CA) in 1x PBS ...
-
bioRxiv - Systems Biology 2021Quote: ... tissue sections were fixed in 4% paraformaldehyde (Ted Pella) for 10 min ...
-
bioRxiv - Pathology 2020Quote: Pancreatic lobules were fixed in 4% paraformaldehyde (Ted Pella) overnight ...
-
bioRxiv - Microbiology 2020Quote: ... Osmium Tetroxide (OsO4) (4%) and Glutaraldehyde from Ted Pella Inc ...
-
bioRxiv - Microbiology 2019Quote: 10 µl cell or sacculi suspension was applied to an electron microscopy grid (Formvar/Carbon on 300 mesh; Ted Pella Inc., Cat. No. 01753-F) for 5 min at room temperature ...
-
bioRxiv - Microbiology 2023Quote: Approximately ~5 μL of phage samples were applied to freshly glow discharged (PELCO easiGlow, 15 mA, 45 s) continuous carbon support film grids (Ted Pella, Cat. No: 1754-F) for 60 seconds ...
-
bioRxiv - Biochemistry 2022Quote: ... a fresh sample of either MceG-GFP or LucB-GFP was applied to a freshly glow discharged (30 seconds) carbon coated 400 mesh copper grid (Ted Pella Inc., cat. #01754-F) and blotted off ...
-
bioRxiv - Bioengineering 2021Quote: We plasma treated gold Quantifoil R 2/2 EM grids (657-200-AU, Ted Pella, Redding, CA) for 10 sec at 30 W (PE-50 ...
-
bioRxiv - Cell Biology 2019Quote: ... and fixed for 15 minutes with 4% formaldehyde (Ted Pella). After two PBS washes ...
-
bioRxiv - Microbiology 2020Quote: ... with pre-warmed 4% paraformaldehyde (PFA) (Ted Pella Inc., 18505) for 10 min at RT ...
-
bioRxiv - Cell Biology 2023Quote: ... lungs were fixed again using 4% PFA (Ted Pella, #18505) for 2 hours and then processed for embedding following standard procedures ...
-
bioRxiv - Cell Biology 2020Quote: ... and embedded in JB-4 Plus resin (Ted Pella, Redding, CA). Sections 4 µm thick were cut on a Leica EMUC6 Ultramicrotome (Leica Microsystems ...
-
bioRxiv - Microbiology 2022Quote: ... We removed excess liquid with filter paper after 2 minutes and stained with 2% uranyl acetate (TED Pella Cat: 19481) for 1min ...
-
bioRxiv - Biophysics 2024Quote: ... grids (Quantifoil R1.2/1.3, Cu 200 mesh, 100 holey carbon films, 2 nm carbon support film; for images of DCVs: Ted Pella, Cu 400 mesh ...