Labshake search
Citations for Ted Pella :
1 - 50 of 304 citations for 7 Methyl 1 5 dioxo 1 2 3 5 tetrahydro indolizine 6 carbonitrile since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Microbiology 2023Quote: ... 5 minutes in 1:1 absolute ethanol (Thermo) to hexamethyldisilazane (HMDS, Ted Pella), and 5 minutes in 100% HMDS ...
-
bioRxiv - Physiology 2023Quote: ... followed by Rayon fine cloths and alumina pastes (9, 5, 3, 1, 0.5, 0.3, and 0.05 μm, Ted Pella, Inc.).
-
bioRxiv - Cancer Biology 2019Quote: ... the samples described above can also be screened via traditional SEM imaging by mounting a semi-thin 250-350 nm section of the 1 mm2 block faces onto a glow discharged 5×7 mm silicon chip (Ted Pella, Inc., cat# 16007). For the silicon chip surface activation ...
-
bioRxiv - Microbiology 2020Quote: ... at a 5:1 mole ratio to a colloidal suspension of 5 nm diameter citrate-stabilized gold nanoparticles (AuNP) (Ted Pella). The suspension was vortexed briefly and then incubated at RT for 1 h on a flat-bottom shaker ...
-
bioRxiv - Biochemistry 2020Quote: ... Incubated bacteria (5 μl) were dispersed on 5×5 mm silicon wafers (Ted Pella, USA) that had been prewashed with ethanol ...
-
bioRxiv - Neuroscience 2020Quote: ... and stained for 60-90 sec with 5 μL of 1% uranyl acetate (Ted Pella, Inc.). All samples were imaged at an accelerating voltage of 80 kV in a JEOL JSM 1400 Plus (JOEL).
-
bioRxiv - Biochemistry 2023Quote: ... the grids were blotted for 4.5-5 s (blot force of 3) using 595 filter paper (Ted Pella, Inc) before being immediately plunged into liquid ethane for vitrification ...
-
bioRxiv - Biochemistry 2023Quote: ... a few μl of these suspensions were poured on the surface of a 5×7 mm silicon chip (Ted Pella Inc, Redding, CA, USA). After evaporation of the solvent ...
-
bioRxiv - Neuroscience 2020Quote: ... The specimens were then centrifuged onto the surface of 5 x 5 mm2 silicon chips (Ted Pella), fixed ...
-
bioRxiv - Cell Biology 2019Quote: ... Samples for electron tomography included 0.5 µl of 5-nm fiducial gold (Ted Pella Inc. Cat. 82150-5) applied to the sample drop ...
-
bioRxiv - Molecular Biology 2024Quote: ... #5 Dumont fine forceps (Ted Pella, Inc.) were placed between the Drosophila head and thorax to remove the head from the remainder of the body ...
-
bioRxiv - Biophysics 2024Quote: 3-5 µl of purified kinetochores were taken directly from elutions and deposited on glow discharged (Pelco easiGlow, Ted Pella, Redding CA) 400 mesh electron microscopy grids (01754-F F/C ...
-
bioRxiv - Neuroscience 2021Quote: ... for 1 minute to equilibrate before microwave-based antigen retrieval in a PELCO BioWave Pro microwave (550W for 5 minutes; Ted Pella, Redding, California). Following antigen retrieval ...
-
bioRxiv - Neuroscience 2021Quote: ... using #5 Dumont fine forceps (Ted Pella, Inc.), for each dissection a Drosophila head was isolated in PBS (often supplemented with 0.1% Triton X-100) ...
-
bioRxiv - Bioengineering 2023Quote: 20 µL of the sample were drop casted several times until a thin film was formed on top of a 5×5 mm Si wafer (Ted Pella). A Phoibos 150 (SPECS ...
-
bioRxiv - Molecular Biology 2024Quote: ... brains were dissected using #5 Dumont fine forceps (Ted Pella, Inc.) in PBS supplemented with 0.1% Triton X-100 (0.1% PBS-T) ...
-
bioRxiv - Neuroscience 2023Quote: ... then 2 parts 100% propylene oxide per 1 part Eponate 12 resin (Ted Pella) for an 1 h ...
-
bioRxiv - Bioengineering 2023Quote: Gel purified structures (around 1 nM) were used for AFM imaging by adsorbing 6 µl of sample onto freshly cleaved mica (V1, Ted Pella). After three minutes of incubation ...
-
bioRxiv - Neuroscience 2019Quote: ... Tissue was then allowed to pre-infiltrate 2 h in a 2:1 mix of propylene oxide and Eponate resin (Ted Pella, Redding, CA), then transferred into a 1:1 mix of propylene oxide and Eponate resin and allowed to infiltrate overnight on a gentle rotator ...
-
bioRxiv - Biophysics 2019Quote: Samples (∼5 µl) were applied on glow-discharged lacey grids (Ted Pella, CA, USA), followed by blotting and vitrification of the grids using Vitrobot(tm ...
-
bioRxiv - Biophysics 2023Quote: ... 5 μL samples containing complex coacervates was loaded onto the grids (Ted Pella, Inc.). The samples on grids were negatively stained with uranyl acetate (UA) ...
-
bioRxiv - Microbiology 2020Quote: ... and excess liquid removed by blotting for 6 s with a blotting force of −1 using vitrobot filter paper (grade 595, Ted Pella Inc.) at 4.5 °C ...
-
bioRxiv - Microbiology 2020Quote: ... and excess liquid removed by blotting for 6 s with a blotting force of −1 using vitrobot filter paper (grade 595, Ted Pella Inc.) at 4.5 ºC ...
-
bioRxiv - Biophysics 2020Quote: ... Two microliters of sample (5 nM) were deposited onto freshly cleaved mica (Ted Pella Inc.), and 0.5 to 1.0 μl of NiCl2 at a concentration of 100 mM were added to the samples to fix the origami nanostructures on the mica surface ...
-
bioRxiv - Bioengineering 2022Quote: ... 5 μL of sample was applied to a 400-mesh carbon grid (Ted Pella, Inc.) that had been glow discharged for 15 seconds ...
-
bioRxiv - Microbiology 2019Quote: ... 5 µl of sample were deposited onto glow discharged lacey carbon copper grids (Ted Pella) and plunge-frozen in liquid ethane using a Leica EM-CPC ...
-
bioRxiv - Microbiology 2023Quote: ... day 5 and control ring stages) were fixed overnight in 2.5% glutaraldehyde (Ted Pella, Inc.) in PBS ...
-
bioRxiv - Evolutionary Biology 2022Quote: ... filters were cut into ~1/8 sections and placed onto an analysis bullet using adhesive and conductive tabs (#16084–6, Ted Pella, Redding, California) and sputter coated with ~5 nm gold particles ...
-
bioRxiv - Immunology 2022Quote: Purified H10ssF was applied to glow discharged Quantifoil R 2/1 300 mesh grids (Ted Pella, Redding) at a concentration of 1 mg ml-1 ...
-
bioRxiv - Biophysics 2020Quote: Capsid assembly reactions (5 μL) were applied to a Formvar/carbon Cu grid (Ted Pella, 01811), briefly incubated and wicked dry ...
-
bioRxiv - Biochemistry 2022Quote: ... were glow-discharged for 5 sec in an easiGlow Glow Discharge Cleaning System (Ted Pella Inc.). 3.5 μL sample was added to the glow-discharged grid ...
-
bioRxiv - Microbiology 2024Quote: ... were glow-discharged for 5 sec in an easiGlow Glow Discharge Cleaning System (Ted Pella Inc.). 3.5 µL sample was added to the glow-discharged grid ...
-
bioRxiv - Immunology 2023Quote: Cell monolayers were washed with PBS 1x and fixed in situ for 1 hour at room temperature (RT) with 3 % glutaraldehyde (EM Grade, Ted Pella INC) in PBS 1x ...
-
bioRxiv - Cell Biology 2019Quote: Cell pellets (2-3 μl) were loaded onto copper membrane carriers (1mm x 0.5 mm; Ted Pella Inc.) and cryofixed using the EM PACT2 high pressure freezer (Leica) ...
-
bioRxiv - Developmental Biology 2021Quote: ... Reusable molds were assembled by taping 3D-printed molds to glass slides (5” by 4”; Ted Pella). Sylgard 184 PDMS monomer and curing agent (Ellsworth Adhesives 4019862 ...
-
bioRxiv - Biochemistry 2021Quote: ... protoplasts were immediately suspended in 2 ml of W1 buffer [58] and then dispensed onto 50 x 7 mm round bottom glass dishes (Ted Pella Inc, product number 14035-120). All expressions in protoplasts utilized the UBQ10 promoter ...
-
bioRxiv - Plant Biology 2022Quote: ... The grids were blotted for 2–3 s using a pair of filter papers (55 mm, Ted Pella Inc.) at 8°C with 100% humidity and flash-frozen in liquid ethane using an FEI Vitrobot Marked IV ...
-
bioRxiv - Pathology 2023Quote: Lung tissue specimens 1×1×1 mm in size were fixed in 2.5% glutaraldehyde (Ted Pella, US) in cacodylate buffer ...
-
bioRxiv - Biochemistry 2021Quote: ... Vitrified samples of S-protein constructs with and without ACE2 were prepared by first glow discharging Quantifoil R1.2/1.3 300 mesh holey carbon copper grids for 1 minute using a Pelco easiGlow glow discharge unit (Ted Pella) and then applying 1.8 μL of protein suspension to the surface of the grid ...
-
bioRxiv - Biochemistry 2020Quote: ... 5 μl solution was spotted onto freshly glow-discharged carbon-coated electron microscopy grids (Ted Pella, Redding, CA). Grids were rinsed three times with 5 μl distilled water after 3 min incubation ...
-
bioRxiv - Synthetic Biology 2021Quote: Thiol-labeled prey-oligo (41 μM) was mixed with phosphine-treated 5 nm AuNP (200 nM, Ted Pella) in 50 mM NaCl ...
-
bioRxiv - Bioengineering 2022Quote: ... DOL samples (5 μL) were deposited on a glow-discharged formvar/carbon coated copper grid (Ted Pella, Inc.) for 1 minute ...
-
bioRxiv - Microbiology 2023Quote: ... 5 μL of filtered φNCKUH-21-induction supernatant was dropped on the TEM grid (Ted Pella Inc., USA) and incubated for 1 min at 25°C ...
-
bioRxiv - Biochemistry 2020Quote: Samples (5 μl) were applied directly onto 400-mesh copper TEM grids with Formvar/Carbon support films (Ted Pella), which were glow-discharged (PELCO easiGlow ...
-
bioRxiv - Cancer Biology 2021Quote: ... 5 μL of purified EV sample was applied to a freshly glow discharged (Pelco Easiglow, Ted Pella Redding CA) carbon coated TEM grid (Electron Microscopy Sciences ...
-
bioRxiv - Biophysics 2021Quote: ... and 3 µL of sample were deposited and incubated for 2 min on freshly cleaved bare mica V1 (Ted Pella Inc.), after which was rinsed with Milli-Q water ...
-
bioRxiv - Cell Biology 2022Quote: ... Double side Carbon conductive tape (Cat# 16084-7, Ted Pella Inc) was used to immobilize the wafer on an aluminum SEM sample holder ...
-
bioRxiv - Synthetic Biology 2020Quote: ... 20 μL (concentration of 1-2 nM) of sample was deposited on freshly cleaved mica (Grade V1, 10 mm, #50, Ted Pella, Inc.) for 5 min ...
-
bioRxiv - Neuroscience 2021Quote: ... 400 mesh copper grids covered by a Formvar/Carbon film (5-10 nm) were obtained from Ted Pella (Redding, CA) and 2% aqueous uranyl acetate was purchased from Electron Microscopy Sciences (Hatfield ...
-
bioRxiv - Biochemistry 2020Quote: Cryo-EM grids were prepared by applying 3 μl protein samples to glow-discharged (PELCO easiGlow™ Ted Pella Inc., at 15 mA for 1 minute) holey carbon grids (Quantifoil R 1.2/1.3 ...