Labshake search
Citations for Ted Pella :
151 - 198 of 198 citations for 6H Furo 2 3 g 3 benzazepine 2 ethyl 7 8 9 10 tetrahydro 9CI since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Biochemistry 2021Quote: ... AFM imaging was performed on a JPK Nanowizard 4 (Bruker, Germany) AFM unit using Tap150Al-G cantilevers (Ted Pella Inc., USA) in air intermittent contact mode ...
-
bioRxiv - Cancer Biology 2023Quote: ... 10 μL of no-click Trast or click Trast-TCO/Trast-Tz samples (5 μg/mL in mQ water) were absorbed for 60 seconds onto carbon-coated 200-mesh copper grids (01840-F, Ted Pella), which had been glow-discharged for 30 seconds in a Solarus 950 plasma cleaner (Gatan) ...
-
bioRxiv - Cell Biology 2020Quote: ... 10 minutes in 4% paraformaldehyde (Ted Pella, Redding, CA) in 1x PBS ...
-
bioRxiv - Microbiology 2022Quote: ... 10 nm colloidal gold fiducials (Ted Pella, Redding, USA) were added to the suspension (for alignment during tomogram reconstruction from tilt series) ...
-
bioRxiv - Biochemistry 2022Quote: ... 10 mA and 0.39 mBar pressure (PELCO easiGlow, Ted Pella). Grids were incubated for 1 minute with 6 μL sample ...
-
bioRxiv - Neuroscience 2023Quote: ... PLL-coated aclar film (Ted Pella, Inc., Cat.: # 10501-10) was used for the transmission electron microscopy (TEM ...
-
bioRxiv - Bioengineering 2023Quote: ... Gel biopsy punches (1 mm diameter, #15110-10, Ted Pella) centered at each tumoroid were collected and the matrix between cells lysed with Liberase (5 mg mL-1 ...
-
bioRxiv - Neuroscience 2023Quote: ... and then embedded between flat Aclar sheets (Ted Pella #10501-10). Samples were put in a laboratory oven for at least 48 hours at 65°C for the resin to polymerize ...
-
bioRxiv - Plant Biology 2022Quote: ... and gold particles (6 nm, 10 nm) conjugated secondary antibodies (Ted Pella). Sections were post-stained and examined with a Hitachi 7400 TEM (Hitachi-High Technologies ...
-
bioRxiv - Neuroscience 2019Quote: ... The grids were coated with 10 nm colloidal gold (Ted Pella, Redding, CA) and imaged at 300 keV on a Titan TEM (FEI ...
-
bioRxiv - Microbiology 2019Quote: ... we pipetted 10 μL of the sacculi onto freshly cleaved mica (Ted Pella), dried the mica under nitrogen gas ...
-
bioRxiv - Neuroscience 2020Quote: ... Then incubated with 10 nm immunogold-conjugated secondary antibodies (Ted Pella, Redding, CA) in 1% NGS in TBST with 0.5% polyethylene glycol (20,000 MW) ...
-
bioRxiv - Neuroscience 2020Quote: ... coated #0 coverslips (0.08-0.13mm thick and 10 mm diameter; Ted Pella, USA) at 70% confluency ...
-
bioRxiv - Biochemistry 2021Quote: ... incubated with 1:20 10 nm gold-anti-mouse antibody (Ted Pella 15751), washed ...
-
bioRxiv - Microbiology 2021Quote: All coverslips were fixed for 10 min in fresh 4% paraformaldehyde (Ted Pella, 18505) at room temperature ...
-
bioRxiv - Biophysics 2021Quote: ... or 10 s in a PELCO easiGlow glow discharge cleaning system (Ted Pella Inc.). The protein mixtures (4.8 μL ...
-
bioRxiv - Genetics 2020Quote: Cells were replated onto matrigel-coated 1cm x 5mm Aclar (Ted Pella, #10501-10). After 5 days of recovery ...
-
bioRxiv - Neuroscience 2024Quote: ... coated #0 coverslips (0.08-0.13 mm thick and 10 mm diameter; Ted Pella, USA) at 70% confluency ...
-
bioRxiv - Neuroscience 2020Quote: ... 10 μl of sample were adsorbed onto carbon-coated 300-mesh copper grids (Ted Pella) and negatively stained for 30 s ...
-
bioRxiv - Biophysics 2023Quote: ... The effective tip size was calibrated with 10 nm gold nanoparticles (Ted Pella, Redding, CA) using our previously reported protocol2 ...
-
bioRxiv - Cell Biology 2023Quote: ... then incubated for 20 seconds with 20% 10 nm gold fiducials (Ted Pella#15703-20) + 0.05% BSA in water ...
-
bioRxiv - Biochemistry 2022Quote: ... was glow discharged at 10 mA for 30 seconds using a PELCO easiGlow from Ted Pella. Then 2 μl of 80 μg/μl GS solution (in TBS buffer ...
-
bioRxiv - Biochemistry 2022Quote: ... were glow discharged for 30 seconds at 10 mA using the PELCO system (Ted Pella, USA). Grids were prepared by applying a 2 μl protein sample to the glow-discharged grid ...
-
bioRxiv - Immunology 2023Quote: Protein nanoparticles (0.1 mg/mL, 10 µL) were pipetted onto a carbon-coated copper grid (Ted Pella) and incubated for five min ...
-
bioRxiv - Animal Behavior and Cognition 2024Quote: ... Then slices were infiltrated with Durcupan resin and flat embedded between Aclar sheets (Ted Pella #10501-10). Next Aclar layers were separated from the resin embedded samples ...
-
bioRxiv - Microbiology 2020Quote: ... The cell suspension was then mixed with 10‐nm colloidal gold beads (Ted Pella, Inc., Redding, CA, USA) pre-coated with 5% (w/v ...
-
bioRxiv - Neuroscience 2021Quote: ... Sections were glow discharged and coated by dipping grid briefly in 10 nm colloidal gold solution (Ted Pella). Serial tomo-graphic reconstructions were generated of parallel fiber - Purkinje cell synapses using an FEI Titan 300 kV TEM equipped with a 4k x 4k CCD camera (Gatan Ultrascan) ...
-
bioRxiv - Neuroscience 2020Quote: A 10 μL aliquot of each sample was added to formvar stabilized with carbon copper grids (Ted Pella, Inc.) for 2 minutes ...
-
bioRxiv - Biophysics 2021Quote: AFM slides were prepared by affixing 10-mm-diameter ruby muscovite mica slides (Ted Pella grade V1; Redding, CA) to metallic disks ...
-
bioRxiv - Neuroscience 2021Quote: ... 400 mesh copper grids covered by a Formvar/Carbon film (5-10 nm) were obtained from Ted Pella (Redding, CA) and 2% aqueous uranyl acetate was purchased from Electron Microscopy Sciences (Hatfield ...
-
bioRxiv - Biophysics 2021Quote: ... and glow discharged for 1 min at 10 mA with the chamber pressure set at 0.30 mBar (PELCO easiGlow; Ted Pella). The grids were mounted in the sample chamber of a Leica EM GP set at 8C and 95% relative humidity ...
-
bioRxiv - Immunology 2022Quote: ... for 10 s or were plasma discharged for 25 s at 15 mA using a PELCO easiGlow (Ted Pella Inc.). Right before applying the protein samples to the grids ...
-
bioRxiv - Microbiology 2022Quote: ... 10 μL of each of the EVs samples were dropped in 200 mesh formvar-carbon copper grids (Ted Pella, Inc) and were let stand for 1 min ...
-
bioRxiv - Neuroscience 2023Quote: ... then incubated in a secondary goat anti-rabbit antibody conjugated to 10-nm colloidal gold (Ted Pella, diluted 1:100) for 30 min at room temperature ...
-
bioRxiv - Biochemistry 2023Quote: ... The grids were then glow discharged on a PELCO easiGlow for 20-45 s at 10-25 mA (Ted Pella) (negative polarity) ...
-
bioRxiv - Biophysics 2021Quote: ... where 50 μL of the diluted sample was deposited and allowed to incubate for 20 seconds on freshly cleaved mica (Highest Grade V1 AFM Mica Discs, 10 mm, Ted Pella). The excess unbound proteins were removed by rinsing with ultra-pure water ...
-
bioRxiv - Biophysics 2021Quote: ... where 50 μL of the diluted sample was deposited and allowed to incubate for 20 seconds on freshly cleaved mica (Highest Grade V1 AFM Mica Discs, 10 mm, Ted Pella). The excess unbound proteins were removed by rinsing with ultra-pure water ...
-
bioRxiv - Synthetic Biology 2023Quote: TEM: Samples in PBS were diluted 1:10 in water and spotted onto Formvar/carbon 200 mesh copper grids (Ted Pella) that were glow discharge treated (Emitek K100X) ...
-
bioRxiv - Neuroscience 2023Quote: ... at room temperature for 10 min before proceeding for dehydration (70%, 95%, 100% ethanol, xylene twice) and coverslipping with Mount-Quick (Ted Pella).
-
bioRxiv - Microbiology 2021Quote: ... UK), after glow-discharging the grids in air (10 mA, 30 seconds) using a PELCO easiGlow™ Glow Discharge System (Ted Pella). Following application of sample ...
-
bioRxiv - Biochemistry 2021Quote: ... 5 to 10 μL of samples were then spotted onto freshly cleaved mica sheets (PELCO® Mica discs Grade V-1, thickness 0.15 mm, 10 mm diameter from Ted Pella, Inc). All mica substrates were dried at RT and analyzed using a Nanosurf NaioAFM equipped with Multi75AI-G probes (Budget sensors) ...
-
bioRxiv - Biophysics 2023Quote: UltrAuFoil 300 mesh R 1.2/1.3 grids (Electron Microscopy Services, Q350AR13A) were plasma treated in a Pelco Easiglow (25 mA, 120 s glow time, 10 s hold time, (Ted Pella, 91000)) ...
-
bioRxiv - Biophysics 2024Quote: ... samples were washed 4 times in PBST and mounted in Vectashield Antifade Mounting Medium (H-1000-10) before on glass slide/thin glass bottom dish (Pelco, Ted Pella Inc.) before performing confocal scans ...
-
bioRxiv - Neuroscience 2023Quote: ... and incubated in goat anti-mouse secondary Abs conjugated to 10 nm or 20 nm-diameter gold particles (Ted Pella, Redding CA). Grids were counterstained with 1% uranyl acetate ...
-
bioRxiv - Biochemistry 2020Quote: The aggregated CA sample were diluted 20 times and 10 μL sample were drop-casted onto freshly cleaved MICA sheet (Ted Pella, Inc, USA). After 1-hour of incubation ...
-
bioRxiv - Biochemistry 2023Quote: Quantifoil R1.2/1.3 Cu grids were glow-discharged in air for 15 s at 10 mA in a plasma cleaner (PELCO EasiGlow, Ted Pella, Inc., Redding, CA). Glow-discharged grids were prepared using Thermo Fisher Vitrobot Mark IV ...
-
bioRxiv - Microbiology 2019Quote: 10 µl cell or sacculi suspension was applied to an electron microscopy grid (Formvar/Carbon on 300 mesh; Ted Pella Inc., Cat. No. 01753-F) for 5 min at room temperature ...
-
bioRxiv - Biophysics 2023Quote: Negative stained samples were prepared at a sample concentration of 10 µg/ml using 400-mesh Cu/Pd grids (Ted Pella; prepared by floating carbon on it). The negatively stained samples were stained with uranyl formate and imaged on a Tecnai F20 TEM operating at 200 kV using a DE-20 camera at a calibrated magnification of 62,000X and a -2.0 μm defocus ...