Labshake search
Citations for Bio-Rad :
1 - 50 of 4514 citations for Sodium Monofluoroacetate 90% Cp 13C2 99%; 2 2 D2 98% 1 Mg Ml In Water since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Biochemistry 2019Quote: ... 25 mg ml−1 Bio-Beads SM-2 (Bio-Rad) was added and incubated at 4°C for 1 h ...
-
bioRxiv - Molecular Biology 2022Quote: ... at a 1:5 w/w ratio for 2 hours before addition of 100 mg mL-1 Bio-Beads SM-2 resin (Bio-Rad) and then incubated overnight at 4 °C with gentle agitation to remove detergent ...
-
bioRxiv - Biochemistry 2022Quote: ... Detergent was removed by addition of 200 mg/ml SM-2 BioBeads (BioRad) followed by incubation under slow rotation for 16 h at 4°C ...
-
bioRxiv - Microbiology 2021Quote: ... 50 mg of Biobeads SM-2 (BioRad) were added to remove detergent and promote protein insertion into liposomes ...
-
bioRxiv - Biophysics 2021Quote: ... 200 mg of BioBeads (SM-2, BioRad) were added and the sample incubated for another 3 h at room temperature ...
-
bioRxiv - Immunology 2021Quote: ... 100 mg of biobeads SM-2 (BioRad) were added to the resin containing the protein of interest and the peptidiscs and incubated O/N at 4 ° C ...
-
bioRxiv - Biochemistry 2023Quote: ... then 350 mg BioBeads SM-2 (BioRad) per mL mixture (w:v ...
-
bioRxiv - Biophysics 2022Quote: ... Nanodisc reconstitution was induced by removing detergent with 0.8 mg ml-1 pre-washed Biobeads SM-2 (Bio-Rad) for 2 hours with gentle agitation at RT ...
-
bioRxiv - Systems Biology 2024Quote: ... buffer + 2% (v/v) Sodium dodecyl sulfate (SDS, Bio-Rad). Proteins were denatured at 95 °C and 600 rpm for 10 min before adding a final concentration of 2% (v/v ...
-
bioRxiv - Cell Biology 2020Quote: ... Detergent was removed by three addition of BioBeads SM-2 adsorbent resin (25 mg per 1 mL of lipid mixture) (BioRad) for 2 h each at 4°C ...
-
bioRxiv - Biochemistry 2022Quote: ... Mass calibration was done by using 2 mg/ml BSA standard (Bio-Rad, cat.5000206). PBS pH 7.4 was used as isocratic buffer ...
-
bioRxiv - Biophysics 2022Quote: ... Detergents were removed by incubation with 100 mg/ml Bio-Beads SM-2 (Bio-Rad) for 1h at 23°C ...
-
bioRxiv - Biophysics 2022Quote: ... 1 mg of post-thrombin digested claudin-4 in DDM was treated with 4 mg of amphipol (1:4 w/w) for 2 hours before removing detergent via addition of 400 mg SM-2 biobeads (Bio-Rad). Excess cCpE was added to each claudin-4 sample at a molar ratio of 1:1.5 ...
-
bioRxiv - Biophysics 2021Quote: ... The DDM/CHS detergent was then removed by overnight incubation with Bio-Beads SM-2 (15 mg per 1 ml protein/detergent/amphipols mixture, Bio-Rad) at 4 °C ...
-
bioRxiv - Pharmacology and Toxicology 2021Quote: ... were added to the control wells without cells (Lanes 1 and 12) ranging from 0.125 – 2 mg/ml (BioRad 500-0202) and treated with formalin and NaOH at the same concentrations as the cells ...
-
bioRxiv - Genetics 2024Quote: ... 4 mg/ml lyticase) and blended with 300 μl of 2% low-melt agarose (Bio-Rad). Then ...
-
bioRxiv - Biophysics 2022Quote: ... 400 mg of wet Bio-Beads SM-2 (BioRad) per 500 μL of mixture was added and the mixture continued to incubate overnight to remove detergents ...
-
bioRxiv - Biochemistry 2023Quote: ... 125 mg of Bio-Beads SM-2 (Bio-Rad) (prewashed with methanol ...
-
bioRxiv - Biophysics 2022Quote: ... 400 mg of wet Bio-Beads SM-2 (BioRad) per 500 μL of mixture was added and the mixture continued to incubate overnight to remove detergents ...
-
bioRxiv - Biochemistry 2021Quote: ... 200 mg Bio-Beads™ SM-2 Resin (Bio-Rad) was added and incubated at 4°C overnight while shaking at 650 rpm ...
-
bioRxiv - Neuroscience 2023Quote: ... 60 mg of Bio-Beads SM-2 (#1523920, Bio-Rad) was added ...
-
bioRxiv - Neuroscience 2023Quote: ... 6-diamidino- 2-phenylindole (DAPI) (1 ug/mL; Bio-Rad, Cat.# 1351303) to counterstain for confocal microscopy ...
-
bioRxiv - Bioengineering 2019Quote: ... Cells were then washed three times with DI water and stained with 2 ml hematoxylin (Bio-Rad Laboratories, Hercules, CA, USA) for 15 min at room temperature ...
-
bioRxiv - Biochemistry 2023Quote: ... 1.5 mL of 2% Bis-Acrylamide (Biorad) and 1.1 mL of water ...
-
bioRxiv - Molecular Biology 2020Quote: ... 2 mg of gel filtration protein standard (Bio-Rad 151-1901) was run after sample collection to estimate approximate molecular weight of protein peaks ...
-
bioRxiv - Molecular Biology 2020Quote: ... 2.5 mg/ml Orange G), denatured (2 min, 80°C) and run on a 10 well 10% TBE-urea gel (Biorad) (200 V ...
-
bioRxiv - Bioengineering 2020Quote: ... anti-YL1/2 (1:1000, BioRad) primary antibodies ...
-
bioRxiv - Biochemistry 2023Quote: 30% acrylamide:bis-acrylamide (99:1 ratio) solution was prepared by mixing 7.4 mL of 40% acrylamide (BioRad), 1.5 mL of 2% Bis-Acrylamide (Biorad ...
-
bioRxiv - Cell Biology 2021Quote: ... Proteins were electrophoresed in a Bio-Rad Criterion TM Vertical Electrophoresis Cell at 90-120V for 1-2 hours and then transferred to a PVDF Transfer Membrane (#88518, Bio-Rad, Hercules, CA, United States) using the Bio-Rad Trans-Blot Turbo Transfer System ...
-
bioRxiv - Cell Biology 2021Quote: ... 1 mg/mL casein (Blotting-Grade Blocker, Biorad), 1 mM ATP (Sigma Aldrich)] and then incubated with gently sonicated anti-FLAG beads to allow binding for 1 hr at 4°C on a rotator in the presence of oxygen scavenging reagents (5 mg/mL b-D-glucose (Sigma Aldrich) ...
-
bioRxiv - Biophysics 2022Quote: ... detergent was removed from the sample by the gradual addition of 400 mg/mL SM-2 polystyrene Bio-Beads (Bio-Rad) over the course of four hours ...
-
bioRxiv - Biophysics 2021Quote: ... 1.5 ml of BioBeads SM-2 slurry (Bio-Rad) was added to remove the detergents ...
-
bioRxiv - Molecular Biology 2022Quote: ... 2 mL of 10% ammonium persulfate (APS, Bio-Rad) and 70 μL of tetramethylethylenediamine (TEMED ...
-
bioRxiv - Microbiology 2023Quote: ... containing 2 mL settled Ni-NTA resin (Bio-Rad) pre-equilibrated with wash buffer (20 mM HEPES ...
-
bioRxiv - Neuroscience 2024Quote: ... the concentration of the resultant solution containing labelled αSyn was adjusted to 2 mg/mL and excess unbound dye was removed using Bio-Spin 6 size exclusion spin columns (Bio-Rad Laboratories). ATT565-αSyn was added to LUHMES cells on day six in vitro at a final concentration of 2 µM ...
-
bioRxiv - Microbiology 2021Quote: ... 40 mg ml−1 blotting-grade blocker (Bio-Rad), and 5% (v/v ...
-
bioRxiv - Microbiology 2019Quote: ... 40 mg ml-1 blotting-grade blocker (Bio-Rad), and 5% (v/v ...
-
bioRxiv - Microbiology 2020Quote: ... 40 mg ml-1 blotting-grade blocker (Bio-Rad), and 5% (v/v ...
-
bioRxiv - Biophysics 2021Quote: ... Bio-beads SM2 (10 mg ml-1, Bio-Rad) were added to initiate the reconstitution by removing detergents from the system ...
-
bioRxiv - Biochemistry 2021Quote: ... followed by detergent removal using 0.8 mg pre-washed Biobeads SM-2 (Bio-Rad) per ml of reaction mix for 2 hours at RT while slowly rolling ...
-
bioRxiv - Genetics 2022Quote: ... The samples were boiled at 65°C for 10 minutes and then loaded on 10% SDS-PAGE gel and ran at 90 volts for 2 hours and transferred to a PDVF membrane via semidry transfer (Bio-Rad) at 13 V for 3 hours ...
-
bioRxiv - Cancer Biology 2023Quote: ... Secondary antibody staining was done in 2% milk-TBST (+ 0.01% sodium azide) and detected using ChemiDoc (Biorad).
-
bioRxiv - Biophysics 2020Quote: ... Nanodisc reconstitution was achieved by incubation with 0.5 - 1 mL Bio-Beads SM-2 (Bio-Rad) for 16 hours at 4°C under constant rotation ...
-
bioRxiv - Cancer Biology 2020Quote: ... mouse anti-Drosophila AMPK1/2 (BioRad, 1:1000), rabbit anti-diphosphorylated ERK (Sigma ...
-
bioRxiv - Microbiology 2023Quote: ... ERK1/2 (1:1000, Bio-Rad Cat# MCA4695T), horseradish peroxidase-conjugated anti-rabbit (1:5000 ...
-
bioRxiv - Biophysics 2021Quote: ... we added 60 mg Bio-beads SM-2 (Bio-Rad, Hercules, CA, USA, No. 1523920) and dialyzed the samples in detergent overnight at 4°C ...
-
bioRxiv - Cell Biology 2021Quote: ... supplemented with 2 M 2-Mercaptoethanol (Bio-Rad), and boiled for 3 min ...
-
bioRxiv - Cell Biology 2021Quote: ... 2 ml bed volume (0.8 × 4 cm) empty polypropylene column (BioRad) fitted with a two-way stopcock up to the fill line ...
-
bioRxiv - Cancer Biology 2021Quote: ... 60 of High Capacity NeutrAvidin slurry (Thermo PI29204) were washed three times with 1 mL 2X RIPA/1mM EDTA buffer in 2-mL chromatography columns (Bio-Rad 7326008) attached to a vacuum manifold (Promega A7231) ...
-
bioRxiv - Molecular Biology 2023Quote: ... the sample was incubated overnight with 500 mg SM-2 Bio-Beads (Bio-Rad, Hercules, California) under the same conditions.