Labshake search
Citations for IDEX :
1 - 50 of 138 citations since 2020
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Systems Biology 2024Quote: ... The inlet tube was connected to a 50 mL glass syringe via connector assemblies (P-200x, P-658, IDEX, WA, USA). Syringe pumps (PHD 2000 ...
-
bioRxiv - Synthetic Biology 2024Quote: ... The custom-made automated fluid sampler was used to transfer readout probes in hybridization buffer from a 2.0 mL 96 well plate through a fluidic valve (IDEX Health & Science EZ1213-820-4) to the custom-made flow cell using a syringe pump (Hamilton Company 63133-01) ...
-
bioRxiv - Microbiology 2024Quote: ... and then mixed in a PEEK micro static mixing tee (IDEX Health & Science). The reacting mixture flowed through a sample loop of pre-defined length and then was quenched by a four-fold molar excess of ascorbic acid (A61-100 ...
-
bioRxiv - Cell Biology 2024Quote: ... Semrock filters (IDEX Health & Science LLC) were used ...
-
bioRxiv - Biochemistry 2024Quote: ... and 2 cycles or 5 x 105 photon counts at a pixel dwell time of 16.38 μs passing through a 550 ±49 nm bandpass filter (Semrock, F37-551, IDEX Health & Science ...
-
bioRxiv - Biochemistry 2024Quote: ... Online digestion (20 °C) was performed at a constant flow rate of 200 µl/min in a separate chamber using a column (IDEX) with immobilized pepsin on agarose resin beads (Thermo Scientific ...
-
bioRxiv - Bioengineering 2024Quote: ... and waste reservoirs with 0.007-inch-inner-diameter fluorinated ethylene propylene tubing (IDEX Health & Science). Pressurized house air was used to drive the fluidics ...
-
bioRxiv - Bioengineering 2024Quote: ... and connected via PEEK tubing (IDEX, cat. no. 1569XL) into the vLAMPS inlets ...
-
bioRxiv - Biochemistry 2024Quote: ... hand packed into a trap column (1 mm ID × 2 cm, IDEX C-128) at 2°C ...
-
bioRxiv - Biochemistry 2024Quote: ... Proteins were digested on-column by flowing quenched samples at 200 μL/min in 0.1 % formic acid over in-house prepared protease columns (2mm ID × 2 cm, IDEX C-130B) at 10°C ...
-
bioRxiv - Biochemistry 2024Quote: ... along with fittings and ferrules from IDEX Health & Science LLC (Oak Harbor ...
-
bioRxiv - Molecular Biology 2024Quote: ... and AF750 were imaged using a Semrock penta filter (AHF-LED-DFC3C5C7-5-SBM; AHF, Tübingen-Pfrondorf, Germany / Semrock / IDEX Health & Science ...
-
bioRxiv - Biochemistry 2024Quote: ... Nanoports (IDEX) were attached around the holes to link the flowcell with a syringe pump-based fluidic system ...
-
bioRxiv - Biophysics 2024Quote: ... self-packed in a 2.0 × 20 mm column (IDEX Upchurch guard column, WA, USA) at 20°C ...
-
bioRxiv - Bioengineering 2024Quote: ... in which an Ismatec 78017-10 (IDEX Corporation, Northbrook, IL, USA) pump was used on the dialysate side ...
-
bioRxiv - Neuroscience 2024Quote: ... hosted by RPBS and funded by the Université Paris Cité (IDEX). RNAseq data from this manuscript have been deposited to the NCBI Sequence Read Archive data repository (https://www.ncbi.nlm.nih.gov/sra/PRJNA1137105) ...
-
bioRxiv - Biophysics 2024Quote: ... displacing and pushing out old solution through a wider outer PEEK tube (0.04” i.d., 1/16” o.d., IDEX Health and Science). We prepare Ag/AgCl electrodes by placing a length of 0.5 mm diameter silver wire (Alfa-Aesar ...
-
bioRxiv - Biophysics 2024Quote: ... PEEK tube (IDEX Health and Science) carries fresh sample solution into the tip ...
-
bioRxiv - Neuroscience 2024Quote: ... Optical emission filters (ET525/50M, Chroma Technology Corp., Bellows Falls, VT, USA; BrightLine Basic Fluorescence Filter 525/39, IDEX Corporation, North-brook, IL, USA) were inserted in the vertically-positioned and horizontally-positioned fluorescence microscopes ...
-
bioRxiv - Immunology 2024Quote: ... using a MicroTee union formatted for 360μm outer diameter columns (IDEX) and a liquid junction ...
-
bioRxiv - Systems Biology 2024Quote: ... the automated sampler moves to the well of the designated hybridization buffer and moves the 100 μl hybridization buffer through a multichannel fluidic valve (EZ1213-820-4; IDEX Health & Science) to the flow cell (requires ∼25 μl ...
-
Stepwise Isolation of Diverse Metabolic Cell Populations Using Sorting by Interfacial Tension (SIFT)bioRxiv - Bioengineering 2024Quote: ... The microscope filter cube contained a dual-edge dichroic mirror (Di03-R488/561-t1-25 × 36, Semrock, IDEX Health & Science LLC Rochester, NY) and dual-band emission filter (FF01−523/610-25 ...
-
bioRxiv - Biophysics 2024Quote: ... 1.5 mm Teflon tubing (TECHLAB GmbH) and flangeless fittings (IDEX Health & Science LLC) connected the chips to the pump modules ...
-
bioRxiv - Biophysics 2024Quote: ... Fluo-4 fluorescence was excited and collected through a GFP set (472/30 excitation filter and 544/47 emission filter from Semrock Brightline GFP-3035B-OMF filter set, Semrock Optical filters, IDEX Health & Science LLC. ...
-
bioRxiv - Synthetic Biology 2024Quote: ... Semrock filter cubes (IDEX Health & Science), a 10x objective ...
-
bioRxiv - Biochemistry 2024Quote: ... Two high-pressure switching valves (Rheodyne MXP7970, IDEX Health and Science, West Henrietta, NY) were used to swap between water ...
-
bioRxiv - Biochemistry 2024Quote: ... The supply line is secured (Microtight and Nanotight, IDEX Health and Science, Oak Harbor, WA) into custom a PEEK holder83 ...
-
bioRxiv - Biochemistry 2024Quote: ... and 1/16’’ stainless steel tubing were acquired from IDEX Health & Sciences (Oak Harbor ...
-
bioRxiv - Biophysics 2024Quote: ... A shut-off valve (P-732, IDEX) is mounted on the lectin flow line to allow the delayed mounting of the lectin syringe.
-
bioRxiv - Biophysics 2024Quote: ... The streams from the two syringes are joined by a Y connector (P-514, IDEX) located before the channel inlet ...
-
bioRxiv - Biophysics 2024Quote: ... This is achieved by incorporating an additional Y connector (P-514, IDEX) before the channel inlet ...
-
bioRxiv - Biochemistry 2024Quote: ... and microtees were purchased from IDEX Health & Science (Oak Harbor ...
-
bioRxiv - Pharmacology and Toxicology 2023Quote: ... ∼2.4 μL inner volume) is inserted through the injection hole and is sealed by a fluidic fitting (IDEX P-259). The outlet of the injection catheter is positioned at the center of the model blood vessel.
-
bioRxiv - Biophysics 2023Quote: ... equipped with a UHMWPE frit (IDEX Health & Science, Oak Harbor, WA, USA). The resulting mixed solution was brought to the MS source through PEEK tubing of varying volumes to produce different mixing times ...
-
bioRxiv - Neuroscience 2023Quote: ... 12-port valves (IDEX, EZ1213-820-4) and a peristaltic pump (Gilson ...
-
bioRxiv - Microbiology 2023Quote: ... The inlet port of the FL was connected to the medium bottle that was closed with a pressure lid (Fluigent) and flangeless fittings (IDEX Health & Science), which were connected to a Tygon tubing (Saint-Gobain) ...
-
bioRxiv - Pharmacology and Toxicology 2023Quote: ... flow system consists of a 25 mL syringe pump SP1 that provides model blood flow and two 100 μL syringe pumps SP2 and SP3 whose flow streams are combined in a low-volume mixing T (IDEX U-466S, 2.2 μL swept volume) to introduce compound at a user specified concentration into the model blood vessel ...
-
bioRxiv - Molecular Biology 2023Quote: ... and platinum wire used to deliver electrospray source voltage were connected via a stainless-steel cross (360 mm, IDEX Health & Science, UH-906x). The column was heated to 50 °C using a column heater sleeve (Phoenix-ST) ...
-
bioRxiv - Genomics 2023Quote: ... The hybridization buffer and other buffers were moved through a multichannel fluidic valve (IDEX Health & Science EZ1213-820-4) to the custom-made flow cell with a syringe pump (Hamilton Company 63133-01) ...
-
bioRxiv - Biophysics 2023Quote: ... which includes a home packed pepsin column (IDEX guard column with 60 μl Porozyme immobilized pepsin beads ...
-
bioRxiv - Biochemistry 2023Quote: ... was connected to the nozzle holder using a F333N fitting (IDEX) (Weierstall ...
-
bioRxiv - Biochemistry 2023Quote: ... tubing and custom #10-32 UNF steel fitting with 1/16’’ through-hole (similar to part no. F-354, IDEX). Using ThorLab ½” mounting rods ...
-
bioRxiv - Bioengineering 2023Quote: ... The various tubular fluidic resistors were made using 0.01-inch inner diameter FEP tubing (1527L, IDEX-HS). The specific resistor lengths and other component details for each circuit are provided in Extended Data Table 1 ...
-
bioRxiv - Bioengineering 2023Quote: ... all fluidic connections were made with 0.03-inch inner diameter fluorinated ethylene propylene (FEP) tubing (1520XL, IDEX-HS) and PEEK fittings purchased from IDEX Health & Sciences ...
-
bioRxiv - Biochemistry 2023Quote: ... connected to capillaries and the 1/16’’ OD steel tubing (IDEX, part no. U-145), was connected to the nozzle holder using a F333N fitting (IDEX ...
-
bioRxiv - Genomics 2023Quote: ... Three 0.5 m-long PFA tubing (IDEX Health & Science, 1622L) connected to three syringes were loaded with 100 μl of the nuclei suspension ...
-
bioRxiv - Physiology 2023Quote: ... a NIRF filter set (Semrock ICG-B, IDEX Health & Science LLC, Rochester, NY) and camera (Basler acA3088-57um USB 30 ...
-
bioRxiv - Bioengineering 2023Quote: ... and PEEK fittings purchased from IDEX Health & Sciences ...
-
bioRxiv - Bioengineering 2023Quote: ... The Rload resistance was made using 20 cm of 0.01 in diameter FEP tubing (1527L, IDEX-HS). The “Input” pressure source was swept from 0 kPa to 150 kPa over the course of 300 s and the flow was recorded.
-
bioRxiv - Bioengineering 2023Quote: ... The Rload resistance was made using 20 cm of 0.01 in diameter FEP tubing (1527L, IDEX-HS). To simulate a poorly regulated pressure source ...