Labshake search
Citations for Cygnus Technologies :
1 - 26 of 26 citations since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Neuroscience 2024Quote: ... an electrical pulse was generated using a constant current source SIU91A (Cygnus Technology), triggered by an EPC-10 amplifier (HEKA Elektronik ...
-
bioRxiv - Neuroscience 2024Quote: ... Biopotentials were amplified (x10) through the active bridge circuitry of a Neurodata amplifier (Cygnus Technologies, USA), AC-coupled and further amplified (x100 ...
-
bioRxiv - Neuroscience 2024Quote: ... based on TTL signals sent from a PG4000A digital stimulator (Cygnus Technology, Delaware Water Gap, PA, USA). The airpuff was delivered through a 0.86mm diameter capillary tube placed approximately 2mm away from the finger or wrist ...
-
bioRxiv - Immunology 2023Quote: CHO cells were incubated with 1µg/mL anti-CHO antibody (Cygnus Technologies) for 30min at 4°C ...
-
bioRxiv - Neuroscience 2023Quote: ... but further filtered to 500 Hz with the gain increased two-fold (FLA-01, Cygnus Technologies). Then the signal was acquired using a data acquisition device (ITC-18 ...
-
bioRxiv - Bioengineering 2023Quote: ... flowthrough and elution fractions collected as described in Section 2.6 were determined using a HEK 293 HCP ELISA kit (Cygnus Technologies, Southport, NC) following the manufacturer’s protocol ...
-
bioRxiv - Neuroscience 2023Quote: CF inputs were stimulated with 0.2ms step pulses using an electrode connected to an isolated current source (SIU91A, Cygnus Technology) and immersed in a glass pipette filled with ACSF ...
-
bioRxiv - Bioengineering 2023Quote: ... HCP levels in the AEX flow-through of the CHO derived variant were determined by 3rd generation HCP-ELISA kit (Cygnus Technologies, Southport, NC, USA). For HEK 293 derived variants ...
-
bioRxiv - Physiology 2023Quote: ... EODs were amplified at 500x gain and low-pass filtered at 500 kHz (Cygnus FLA-01, Cygnus Tech, Delaware Water Gap, PA).
-
bioRxiv - Neuroscience 2023Quote: ... The extracellular electrophysiological signal was amplified (Neurodata IR183, Cygnus technology), filtered (band pass ...
-
bioRxiv - Neuroscience 2023Quote: ... A high-impedance amplifier (Neurodata IR-283 amplifiers; Cygnus Technology) with active bridge circuitry was used to record the membrane potential (sampled at 20 kHz ...
-
bioRxiv - Synthetic Biology 2022Quote: ... Residual host-cell proteins in Q-GRFT samples were quantified using an ELISA kit (Cat. #F410, Cygnus Technologies, Southport, NC). Residual E ...
-
Clemizole and Trazodone are Effective Antiseizure Treatments in a Zebrafish Model of STXBP1 DisorderbioRxiv - Neuroscience 2022Quote: ... were amplified at a gain of 20x and filtered at 1 kHz (−3 dB; eight-pole Bessel; Cygnus Technology, Inc.), digitized at 10 kHz using a Digidata 1320 A/D interface (Molecular Devices ...
-
bioRxiv - Microbiology 2022Quote: ... The primary antibody used was a Chlamydiaceae family-specific rabbit polyclonal antibody LPS/MOMP antibody (Cygnus Technologies, Inc., Southport, NC, USA) at a 1:1000 dilution ...
-
bioRxiv - Bioengineering 2021Quote: Residual host-cell protein (HCP) was quantified using the HEK293 HCP ELISA kit (Cygnus Technologies) according to the manufacturer’s instructions ...
-
bioRxiv - Neuroscience 2021Quote: ... Responses were collected with a recording amplifier (IR183A, Cygnus technology) in series with a second amplifier (Brownlee Precision ...
-
bioRxiv - Neuroscience 2020Quote: ... Electrodes were connected to a differential headstage and amplified using a differential Extracellular Amplifier (gain of 100, ER-1) (Cygnus Technology, Delaware, PA). The high cut filter was set at 300 Hz ...
-
bioRxiv - Neuroscience 2020Quote: ... Amplified signals were recorded with pulse code modulation (Neuro-Corder DR-484, Cygnus Technology, Inc., Delaware Water Gap, PA) on videotape at a sampling rate of 44 kHz ...
-
bioRxiv - Neuroscience 2020Quote: ... Respiratory transients were detected using a Data Sciences transducer and digitized (0.1-20 Hz) at 600 Hz in Synapse Lite (Tucker Davis Technologies) following a 100X gain amplification (Cygnus Technology Inc). Positive pressure of room air was applied to the chamber using a stable-output air pump (Tetra Whisper) ...
-
bioRxiv - Neuroscience 2020Quote: ... Juxtacellular activity was amplified (final gain 1000) with two amplifiers (IR-283, Cygnus Technologies; EX4-400, Dagan) and filtered (0.3-10 kHz) ...
-
bioRxiv - Biophysics 2020Quote: ... A 60-Hz notch filter (FLA-01, Cygnus Technology, Inc.) was used to reduce line noise ...
-
bioRxiv - Neuroscience 2020Quote: ... The signal was amplified (IR-183; Cygnus Technology, Delaware Water Gap, PA), filtered at 0.3 to 3 kHz (Brownlee amplifier ...
-
bioRxiv - Neuroscience 2020Quote: ... postsynaptic currents were evoked by electrical stimulation using a monopolar glass electrode placed dorsal to the recorded neuron controlled by a SIU91 constant current isolator (Cygnus Tech, Delaware Water Gap, PA). An internal recording solution (in mM ...
-
bioRxiv - Neuroscience 2020Quote: ... local field potential was also monitored through extracellular amplifier (ER-1, Cygnus, bandpass frequency range 1-3000 Hz, Cygnus Technology, Delaware Water Gap, PA), 50/60 Hz noise eliminator (HumBug ...
-
bioRxiv - Bioengineering 2020Quote: ... Isoelectric focusing was carried out as described previously.[35] Samples were analyzed for host cellprotein content using the Pichia pastoris 1st generation HCP ELISA kit from Cygnus Technologies (Southport, NC) according to the manufacturer’s recommended protocol ...
-
bioRxiv - Neuroscience 2019Quote: ... were acquired using a low-noise differential amplifier (DPA-2FL, npi electronic, GmbH) and an intracellular recording amplifier (NeuroData IR-283; Cygnus Technology Inc.), respectively ...