Labshake search
Citations for IDEX :
1 - 23 of 23 citations for 5 OXO 5 6 7 8 TETRAHYDRO NAPHTHALENE 1 CARBOXYLIC ACID since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Bioengineering 2019Quote: ... Adaptors to the flow system (NanoPort Std 6-32 Coned 1/32, IDEX, USA) were fixed to in- and outlets ...
-
bioRxiv - Neuroscience 2021Quote: ... The white light was spectrally filtered for green light with a bandpass filter (BP1, BrightLine HC 520/5, Semrock, IDEX Health & Science, Rochester, NY) for selective excitation of EYFP or Citrine at 520 nm (Exc2 ...
-
bioRxiv - Cell Biology 2021Quote: ... connected to a 6-port valve (Part # V-451, IDEX Health and Science, Oak Harbor, WA) to produce up to six separate solutions ...
-
bioRxiv - Biophysics 2020Quote: ... an MX Series II 2 Position/6 Port UltraLife Switching Valve (IDEX Health & Science, Oak Harbor, WA, USA) was used (see Figure S3) ...
-
bioRxiv - Biophysics 2022Quote: ... Injection was accomplished using an MX Series II 2-position/6-port Ultralife™ switching valve with maximum pressure rating 103 MPa (IDEX Health & Science, LLC, Oak Harbor, WA). The valve was configured as a standard chromatography system with a 100 µl sample loop that could be loaded at room pressure using a syringe then switched inline without interrupting column flow ...
-
bioRxiv - Plant Biology 2022Quote: ... and 1/16” stainless steel tubing were acquired from IDEX Health & Sciences (Oak Harbor ...
-
bioRxiv - Biochemistry 2023Quote: ... connected to capillaries and the 1/16’’ OD steel tubing (IDEX, part no. U-145), was connected to the nozzle holder using a F333N fitting (IDEX ...
-
bioRxiv - Biochemistry 2023Quote: ... The 1 m of PEEK tubing was interrupted by a stainless steel union (IDEX-HS) that was electrically charged at +3.1 kV (Stanford Research Systems ...
-
bioRxiv - Biophysics 2022Quote: ... carries sample solution in while a wider (0.04” i.d., 1/16” o.d.) PEEK tube (IDEX Health and Science) carries used solution away from the tip around the outside of the thinner inner tube ...
-
bioRxiv - Biochemistry 2019Quote: ... Ions were introduced via a stainless-steel tube (1/16 x 0.020’’, IDEX Health Science, Oak Harbor, WA) held at room temperature into the TIMS cell ...
-
bioRxiv - Biophysics 2022Quote: ... Peptides were desalted for 4 minutes on a trap column (1 mM ID x 2 cm, IDEX C-128) manually packed with POROS R2 reversed-phase resin (Thermo Scientific 1112906) ...
-
bioRxiv - Microbiology 2022Quote: ... and the analytical column tip was fitted in the Bruker spray tip holder using a piece of 1/16” x 0.015 PEEK tubing (IDEX), an 1/16” metal two way connector and a 16-004 Vespel ferrule ...
-
bioRxiv - Systems Biology 2019Quote: ... and the analytical column tip was fitted in the Bruker spray tip holder using a piece of 1/16 in × 0.015 PEEK tubing (IDEX), an 1/16 in metal two-way connector and a 16-004 Vespel ferrule ...
-
bioRxiv - Biochemistry 2019Quote: ... and the analytical column tip was fitted in the Bruker spray tip holder using a piece of 1/16” x 0.015 PEEK tubing (IDEX), an 1/16” metal two way connector and a 16-004 Vespel ferrule ...
-
bioRxiv - Biochemistry 2023Quote: ... tubing and custom #10-32 UNF steel fitting with 1/16’’ through-hole (similar to part no. F-354, IDEX). Using ThorLab ½” mounting rods ...
-
bioRxiv - Immunology 2022Quote: ... The suspension of T cells was loaded into a 1 mL syringe attached to a syringe pump and connected by PEEK-tubing (IDEX Health & Science) to a microfluidic chip made of PDMS bonded on cover glass ...
-
bioRxiv - Biophysics 2021Quote: ... peptides were desalted for 4 minutes on a hand-packed trap column (Thermo Scientific POROS R2 reversed-phase resin 1112906, 1 mm ID x 2 cm, IDEX C-128). Peptides were then separated with a C8 analytical column (Thermo Scientific BioBasic-8 5 μm particle size 0.5 mm ID x 50 mm 72205-050565 ...
-
bioRxiv - Biophysics 2021Quote: ... The cell suspension was loaded into a 1 ml syringe, attached to a syringe pump (neMESYS, Cetoni GmbH) and connected by PEEK-tubing (IDEX Health & Science LLC) to a microfluidic chip made of PDMS bonded on cover glass ...
-
bioRxiv - Bioengineering 2022Quote: Fully assembled adapters containing precision printed 3D protein scaffolds were connected to pressure-based flow control (FlowEZ, 345 mbar, Fluigent) by MicroTight adapters to interface 1/32inch tubing (IDEX Health & Science LLC) with 360 μm OD HPLC capillary tubing (PolyMicro).
-
bioRxiv - Neuroscience 2022Quote: ... The laser power at the tip of the fiber was set to 1 mW using a power meter (Melles Griot 13PM001, IDEX Inc., Rochester, NY). Air puffs were delivered using a pressure injector (Toohey Spritzer ...
-
bioRxiv - Biochemistry 2022Quote: ... peptides were desalted for 4 minutes on a hand-packed trap column (Thermo Scientific POROS R2 reversed-phase resin 1112906, 1 mm ID × 2 cm, IDEX C-128). Peptides were then separated with a C8 analytical column (Thermo Scientific BioBasic-8 5-μm particle size 0.5 mm ID × 50 mm 72205-050565 ...
-
bioRxiv - Biophysics 2023Quote: ... peptides were desalted by flowing across a hand-packed trap column (Thermo Scientific POROS R2 reversed-phase resin 1112906, 1 mm ID × 2 cm, IDEX C-128) at 5 °C ...
-
bioRxiv - Biophysics 2023Quote: ... and samples were desalted on a hand-packed trap column (Thermo Scientific POROS R2 reversed-phase resin 1112906, 1 mm ID × 2 cm, IDEX C-128) as described ...