Labshake search
Citations for Pall :
1 - 19 of 19 citations for FITC SA ZAP since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Biochemistry 2021Quote: ... Streptavidin (SA)-coated biosensors (Pall FortéBio) were hydrated in HKMTx for at least 30 min at 25 °C prior to use ...
-
bioRxiv - Biochemistry 2020Quote: ... Streptavidin (SA)-coated biosensors (Pall FortéBio) were hydrated in HKTTx solution for at least 10 min prior to use ...
-
bioRxiv - Biochemistry 2019Quote: ... Streptavidin (SA)-coated biosensors (Pall FortéBio) were hydrated in HKMTx for at least 30 min prior to use ...
-
bioRxiv - Biochemistry 2021Quote: ... using Streptavidin (SA)-coated biosensors (Pall FortéBio) in an assay buffer of 100 mM NaCl ...
-
bioRxiv - Biochemistry 2020Quote: ... using Streptavidin (SA)-coated biosensors (Pall FortéBio) in 20 mM HEPES pH 7.4 ...
-
bioRxiv - Biophysics 2021Quote: CSA were biotinylated and loaded onto SA sensor (Pall corporation). VAR2CSA fragments and mutant were then added for real-time association and dissociation analysis using Octet RED 96 (Fortebio ...
-
bioRxiv - Biophysics 2023Quote: ... BLI sensors coated with streptavidin (SA sensors) were purchased from Forte Bio (PALL). Prior to use ...
-
bioRxiv - Immunology 2023Quote: Recombinant human PD-1 protein was biotinylated and loaded using SA sensor (Pall Corporation). Six concentrations of Finotonlimab and Nivolumab were added for real-time association and dissociation analysis using Octet system ...
-
bioRxiv - Biochemistry 2021Quote: ... For binding analysis biotinylated antigen (1 μg/mL) were immobilized on streptavidin (SA) biosensors (Pall) for 300 sec to ensure saturation ...
-
bioRxiv - Molecular Biology 2020Quote: ... biotinylated SARS-CoV-2 S trimer protein was loaded onto streptavidin (SA) biosensors (Pall FortéBio). S-trimer-bound biosensors were dipped into wells containing varying concentrations of ACE2 protein and the interactions were monitored over a 500-sec association period ...
-
bioRxiv - Microbiology 2023Quote: ... Biotinylated VHH16 (4 μg/mL) were loaded on streptavidin SA (18–0009) biosensors (Pall ForteBio) for 1 min ...
-
bioRxiv - Bioengineering 2020Quote: Biolayer inferometry was performed using the Octet Red96 with streptavidin (SA) biosensors (Pall ForteBio, Fremont, CA), which were hydrated for 15 min in kinetics buffer prior to each run ...
-
bioRxiv - Immunology 2019Quote: ... The biotinylated peptides were diluted to 2 μM and loaded on pre-wet SA sensor from Pall ForteBio (CA ...
-
bioRxiv - Cell Biology 2024Quote: ... using ATF6⍺_LD variants as biotinylated ligands that were immobilised on streptavidin (SA)-coated biosensors (Pall FortéBio) and rat calreticulin (rCRT ...
-
bioRxiv - Biochemistry 2019Quote: ... 10 ng/mL of biotin-labeled target were loaded on Dip and Read™ Streptavidin (SA) Biosensors (Pall Fortebio) until the reading exceeded 1 nm ...
-
bioRxiv - Microbiology 2021Quote: ... to SA sensors that were prehydrated in water for at least 10 minutes and then equilibrated into 10X Kinetics Buffer (Pall). The RBDs were loaded to a level of 1 nm total shift ...
-
bioRxiv - Microbiology 2022Quote: ... Biotinylated SARS-CoV-2 RBD or S1 (4 µg/mL) were loaded on streptavidin SA (18-0009) biosensors (Pall ForteBio) for 1 min ...
-
bioRxiv - Cancer Biology 2020Quote: ... pH 7.4 and loaded onto Octet Streptavidin (SA) Biosensors (ForteBio) by following the manufacturer’s recommendations on an Octet RED384 machine (ForteBio, PALL Octet System). Biotin-249C immobilization was checked via Octet® Software prior to introduction of the entire V-ATpase complex and the individual H subunit protein diluted in blocking buffer (1X PBS + 0.05% Tween 20 + 0.2 % BSA + 10 μM Biotin ...
-
bioRxiv - Bioengineering 2020Quote: ... Affinity measurements were carried out at room temperature using an Octet RED96 system and streptavidin (SA)-coated biosensor tips (Pall ForteBio). Biotinylated ACE2 variants were diluted to 10 nM in PBS with 0.2% BSA and 0.05% Tween-20 (PBS-T) ...