Labshake search
Citations for 3M :
1 - 50 of 61 citations for QuantiQuik Malic Acid Quick Test Strips since 2019
Citations are collected from bioRxiv only, the total number of publications could be much larger.
-
bioRxiv - Cell Biology 2021Quote: ... The area was further sutured using steri-strip wound closure strips (3M) and covered with Tegaderm dressing film (3M ...
-
bioRxiv - Microbiology 2022Quote: ... Strips of autoclave tape (3M, Saint Paul, USA) and masking tape (Dixon ...
-
bioRxiv - Developmental Biology 2020Quote: ... of labeled peptides were then mixed with 0.1% trifluoroacetic acid (TFA) (Pierce) to generate a test mix which was desalted by StageTip fractionation with Empore C18 filters (3M) (Rappsilber et al. ...
-
bioRxiv - Bioengineering 2021Quote: ... The membrane strips were then fixed in place by 3 mm wide and 2 cm long double-sided tape strips (3M, USA) placed parallel to the longest side of the HoC ...
-
bioRxiv - Microbiology 2022Quote: ... Two strips of double-sided tape (Scotch 3M, St. Paul, MN) were placed 3 mm apart on a glass slide ...
-
bioRxiv - Biophysics 2023Quote: ... equipped with a pair of adhesive copper strips (3M, Cergy-Pontoise, France) and placed in a desiccator for 2 hours to remove residual traces of chloroform ...
-
bioRxiv - Bioengineering 2021Quote: ... The membrane strips were held in place by double-sided tape (3M, USA). The two PMMA molds were brought together and clamped with two N46 neodymium nickel-plated square magnets rated with ca ...
-
bioRxiv - Biochemistry 2023Quote: ... Silanized coverslips were attached to glass slides using two strips of double-sided tape (3M) separated by ∼5 mm.
-
bioRxiv - Physiology 2019Quote: ... Spicules were then immediately removed with a strip of lightly-adhesive paper tape (Micropore, 3M, USA). Assessments were made post-cordotomy only ...
-
bioRxiv - Cell Biology 2021Quote: ... and attaching it to a microscope slide with two strips of double-sided adhesive tape (Scotch, 3M) to form a channel approximately 3 mm wide ...
-
bioRxiv - Microbiology 2019Quote: ... One was Clean-Trace™ ATP Surface Test (suitable for N, 3M, USA), and the other was UltraSnap™ ATP Surface Test (suitable for B and P ...
-
bioRxiv - Biophysics 2024Quote: ... This involved attaching two narrow strips of double-sided tape (Scotch Double Sided Tape, 3M, Saint-Paul, USA) to an microscope slide ...
-
bioRxiv - Biophysics 2021Quote: ... using two strips (3 mm wide) of optically clear double-stick adhesive tape (50 µm thick, 3M™, #8212, USA). 50 µl of actin or actin-DNA sensor solution was carefully deposited in the middle of the chamber before closing it ...
-
bioRxiv - Biophysics 2019Quote: ... Tunnel slides for microscopy were created by laying two parallel strips of Scotch double sided tape (product number: 70071395118, 3M) spaced 2-4 mm apart on a slide and placing a functionalized coverslip on top ...
-
bioRxiv - Neuroscience 2023Quote: ... Brains were mounted onto long coverglass using 2 small strips of double-sided tape (Scotch Brand, 3M, Saint Paul, MN) as spacers and to attach the small coverglass ...
-
bioRxiv - Bioengineering 2022Quote: ... Petrifilm™ aerobic count plates and Quick Swabs were also purchased from 3M™ (London ...
-
bioRxiv - Physiology 2021Quote: ... the unweighted cart was attached to the mouse’s tail by interweaving a 10 cm long strip of vinyl tape (3M, #80610833842, Saint Paul, MN) around the tail and the nylon string of the cart (Fig ...
-
bioRxiv - Biophysics 2024Quote: ... The home-made chamber was assembled on a 22 × 40 mm2 glass cover slide with a pair of parallel copper strips (3M, Cergy-Pontoise, France) located 1 mm apart from each other (see Figure S6b) ...
-
bioRxiv - Bioengineering 2020Quote: ... The window surface was protected by applying a double layer adhesive strip made of gaffers tape over a transparent adhesive film dressing (3M: Tegaderm, 70200749201, Maplewood, MN).
-
bioRxiv - Molecular Biology 2019Quote: ... 37% phosphoric-acid gel (Scotchbond Etchant, 3M ESPE) was used for 20 s and further washed with water for 15 s ...
-
bioRxiv - Plant Biology 2020Quote: ... Then 50 μL of each sample were mixed with 115 μL of acid molybdate solution (17.55 g/L of Ammonium molybdate tetrahydrate, 3M sulfuric acid) and 700 μL of deionized water ...
-
bioRxiv - Neuroscience 2020Quote: ... A 50 µm thick PET film (Melinex, Dupont Inc.) was bonded to the PMMA frame using quick setting epoxy (ScotchWeld dp100 Plus Clear, 3M Inc.). Two circular neodymium magnets were inserted into the slots of the lateral tabs and fixed using cyanoacrylate glue ...
-
bioRxiv - Bioengineering 2023Quote: ... the biodome was then placed in an acid bath (3M HCl) overnight (≥ 10 hours) ...
-
bioRxiv - Biochemistry 2021Quote: ... Fatty acids from total lipids were released by saponification (refluxing with 3mL 0.3M KOH in 90% methanol at 80°C for 1 hour and remaining ∼300μL solvent) ...
-
bioRxiv - Genetics 2022Quote: ... pH 7 (SSC 20x: 3M NaCl and 0.3M citric acid trisodium salt dihydrate). For this suspension ...
-
bioRxiv - Neuroscience 2023Quote: ... Carbon dioxide was chemically generated using sulfuric acid (1M) and sodium carbonate (0.3M) via the reaction ...
-
bioRxiv - Molecular Biology 2019Quote: ... blots were hybridized overnight at 42°C with 5’-end P32-labelled oligonucleotides in Roti-Hybrid-Quick buffer (Roth) and washed three times at 42°C for 15min with SSC buffer (SSC 20X: 3M NaCl, 300mM sodium citrate, pH 7) containing 0.1% of SDS (5X ...
-
bioRxiv - Immunology 2020Quote: ... was added and the reaction was stopped with the addition of acid solution (3M H3PO4). Absorbance (A450 nm ...
-
bioRxiv - Molecular Biology 2023Quote: ... Samples were acidified to 0.5% formic acid (FA) and desalted using home-made C18 (3M Empore) stage tips filled with 4 μl of Poros Oligo R3 resin (Thermo Fisher) ...
-
bioRxiv - Immunology 2020Quote: ... TMB substrate was added and the reaction was stopped by the addition of acid solution (3M H3PO4). Absorbance was measured by Synergy Mx microtiter plate reader (Biotek).
-
bioRxiv - Plant Biology 2021Quote: ... 0.1% formic acid (FA) and desalted on self-packed StageTips (five disks, Ø 1.5 mm C18 material, 3M EmporeTM ...
-
bioRxiv - Genetics 2022Quote: Dot blot membranes were rinsed in 2X SSC (20x: 3M NaCl and 0.3M citric acid trisodium salt dihydrate) and pre-hybridized for 15’ with Tetramethylammonium Chloride (TMAC ...
-
bioRxiv - Molecular Biology 2022Quote: ... The digested peptides were desalted with 60% acetonitrile/0.3% formic acid through the three disks of C-18 Empore SPE disks (3M) in a 200 μl pipet tip ...
-
bioRxiv - Molecular Biology 2022Quote: ... Peptides were desalted with stage tips using the following procedure: Peptides were reconstituted with 5% acetonitrile/0.1 % formic acid and loaded onto Empore C18 disks (3M) packed into a 200 µl pipette tips pre-equilibrated with LC-MS grade methanol and water containing 0.1% formic acid ...
-
bioRxiv - Biophysics 2023Quote: ... Half of each samples was acidified (0.05% formic acid) followed by desalting and concentration by micro solid phase extracted (Empore, 3M)48 ...
-
bioRxiv - Neuroscience 2021Quote: ... layer [35] glued to a custom 3D-printed polylactic acid frame was implanted on the exposed brain and secured to the skull using VetBond (3M) and dental cement ...
-
bioRxiv - Microbiology 2021Quote: ... Digested samples were acidified to a final concentration of 0.5% formic acid and desalted with home-made high-capacity StageTips composed of 1 mg Empore™ C18 material (3M) and 5 mg of OLIGO R3 reverse phase resin (Thermo Fisher Scientific ...
-
bioRxiv - Microbiology 2021Quote: ... Digested samples were acidified to a final concentration of 0.5% formic acid and desalted with home-made high-capacity StageTips composed of 1 mg Empore™ C18 material (3M) and 5 mg of OLIGO R3 reverse phase resin (Thermo Fisher Scientific ...
-
bioRxiv - Immunology 2020Quote: ... Digested peptides were acidified with 10% formic acid (FA) to pH ∼2 and desalted using stage tips with Empore C18 SPE Extraction Disks (3M) and dried under vacuum.
-
bioRxiv - Immunology 2020Quote: ... Labeled samples were acidified using triflouroacetic acid (TFA) and cleaned-up using StageTip (3-disc plug of C18 Empore material, 3M). StageTip’s were conditioned by rinsing them with (2x ...
-
bioRxiv - Molecular Biology 2022Quote: ... Peptides were desalted using stage-tips containing a Poly-styrene-divinylbenzene copolymer modified with sulfonic acid groups (SDB-RPS; 3M) material ...
-
bioRxiv - Pharmacology and Toxicology 2022Quote: ... Digested peptides were acidified with 10% formic acid to pH ~2 and desalted using stage tips with Empore C18 SPE Extraction Disks (3M) and dried under vacuum.
-
bioRxiv - Biochemistry 2023Quote: ... The resulting peptide mixtures were collected using a magnetic rack, acidified with Buffer A* (0.1% trifluoroacetic acid, 2% acetonitrile) and desalted using C18 StageTips (Empore™, 3M) with the addition of Oligo-R3 resin reverse phase material (Thermo ...
-
bioRxiv - Cell Biology 2023Quote: ... membranes were briefly washed twice with wash buffer (0.1M Maleic acid, 3M NaCl; 0.1% Tween 20 adjusted to pH 7.5), before blocking for 30 minutes and probing with a DIG antibody for 30 minutes ...
-
bioRxiv - Microbiology 2023Quote: ... samples were acidified to 0.3% formic acid with 10% formic acid and cleaned up with an MCX STAGE tip (39) using Empore SDB-RPS extraction disks material from 3M. The eluted samples were Speedvaced to dryness.
-
bioRxiv - Cell Biology 2022Quote: ... Each sample was acidified in formic acid and subjected to SPE on an Empore SD C18 plate (3M catalogue# 6015 SD). Each sample was lyophilized and reconstituted in 140mM HEPES ...
-
bioRxiv - Biochemistry 2022Quote: ... Digests were acidified by addition of 0.5% (v/v) formic acid (FA) and desalted using self-packed StageTips (three disks per micro-column, ø 1.5mm, C18 material, 3M Empore). The peptide eluates were dried to completeness and stored at −80°C ...
-
bioRxiv - Molecular Biology 2023Quote: ... formic acid (FA) and desalted using self-packed StageTips (five disks per micro-column, ø 1.5 mm, C18 material, 3M Empore). The peptide eluates were dried to completeness and stored at −80 °C ...
-
bioRxiv - Molecular Biology 2024Quote: ... formic acid (FA) and desalted using self-packed StageTips (five disks per micro-column, ø 1.5 mm, C18 material, 3M Empore). The peptide eluates were dried to completeness and stored at −80 °C ...
-
bioRxiv - Developmental Biology 2022Quote: ... Desalted peptides were reconstituted in 0.1% formic acid in water and further separated into four fractions by strong cation exchange chromatography (SCX, 3M Purification, Meriden, CT). Eluates were first dried in a SpeedVac ...